• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.2
• /
• pp.207-212
• /
• 2008

This study focused on shorten the period of the struvite crystal birth and development by adding seed materials. For this purpose, three different seed materials were selected: sand, anthracite and struvite. The experiments has been conducted to evaluate the effect of the particle size of the selected seed material on the struvite crystallization, and to study the mixing effect which can be expressed by the value of $G{\cdot}t_d$(the multiple of mean velocity gradient(G) and mixing time($t_d$)). It was observed in this study that the removal efficiency of ammonia nitrogen increased by 9%, 11%, and 20% for sand, anthracite, and struvite added as the seed material, respectivley. This indicated that the struvite crystallization efficiency had a close correlation with the specific surface area of the seed particle. It was found that when struvite was selected as the seed material, the struvite crystallization proceeded at lower $G{\cdot}t_d$ value as compared with other seed materials. This observation implied that the secondary crystal birth would be dominated in this reaction. It was concluded in this study that the particle size was not significant factor on the struvite crystallization, while the $G{\cdot}t_d$ value was a considerably important factor in terms of the theory of the struvite crystal birth.

• Journal of Korean Society of Environmental Engineers
• /
• v.39 no.8
• /
• pp.462-469
• /
• 2017

Eutrophication and shortage of phosphate ore raise the necessity of phosphate removal and recovery from wastewater treatment plants. Especially, a sludge treatment system containing highly concentrated phosphate should be targeted for phosphate removal and recovery. This study thus aimed to evaluate the capability of the struvite crystallization process for phosphate removal and recovery from a sludge treatment system of a wastewater treatment plant. Analysis on phosphate concentrations and masses in the sludge treatment system revealed that digested sludge and centrate have phosphate concentrations and masses, high enough to adopt the struvite crystallization process. Chemical equilibrium modeling indicated that the struvite crystallization reaction substantially occurred with pH higher than 8 and $Mg^{2+}$ concentration 1.2 times higher than its theoretical requirement. A series of batch tests with digested sludge and centrate indicated that the phosphate removal reaction by struvite crystallization followed a first-order kinetics and reached over 80% removal efficiency at equilibrium. Aeration in the batch tests was found to purge $CO_2$ in sludge or centrate and increase pH up to 8.7, without adding NaOH. Thus, we concluded that the struvite crystallization process could be an efficient and economical process for phosphate removal and recovery from a wastewater treatment plant.

• Korean Journal of Materials Research
• /
• v.12 no.12
• /
• pp.924-929
• /
• 2002

To recycle waste materials, this work was focused on development of glass-ceramic from incinerator fly ash with a large content of Cl and its physical property was evaluated. In the process, water washing as a pre-treatment before melting the fly ash was used to remove large amount of Cl component in the ash and to reduce melting temperature. As a result, glass was obtained at below $100^{\circ}C$ compared to the melting temperature before washing the ash. Also, internal crystallization occurred under single stage heat treatment (at $850-950^{\circ}C$ for 20-340min) without adding other materials into the ash. It was shown that the glass-ceramic was composed of four crystals, diopside, anorthite, akermanite, and unknown phase. Hardness of 8.3GPa was found in the glass-ceramic, which is a high value compared to reported others. Thus, the present process suggests that a good glass-ceramic produced from an incinerator ash could be applicable for structural materials in terms of economic and environmental points.

• Electrical & Electronic Materials
• /
• v.8 no.1
• /
• pp.95-101
• /
• 1995

Crystallizable glasses with precipitation of celsian, anorthite, wollastonite and gahnite were prepared for the purpose of insulating dielectric layers in devices such as integrated circuit substrates. The starting glasses were prepared by melting the batches for 1 hour at 1450.deg. C and then Quenching to a distilled water. And crystallization behavior of these glasses were studied by DTA, TMA, XRD analysis and by the measurement of dielectric properties. The overall composition of the glass-ceramic consists in weight percent of 30-35% A1$_{2}$O$_{3}$, 13-26% BaO, 5-21% CaO, 10-24% ZnO, 4.5-9.0% TiO$_{2}$ and 4-8% B$_{2}$O$_{3}$. As a result, in barium-rich glasses only celsian phase was developed in the range of 850-900.deg. C. Also, the thermal expansion coefficient, dielectric constant and quality factor of these glass-ceramics were 68*10$^{-7}$ /.deg. C, about 9 and more than 1000, respectively.

• Korean Journal of Crystallography
• /
• v.14 no.1
• /
• pp.35-38
• /
• 2003

A simple multistep-concentration setting in capillaries was used to control the water-evaporation rate in vapor-diffusion protein crystallization. In the method used, a variety of evaporation rate curves were obtained by using the secondary precipitant solution referred to as “regulatory solution”, which is not directly exposed to the protein solution. The curves were applied to the crystallization of lysozyme as a model protein. The results clearly showed that crystal growth is dependent on the evaporation rate. Especially, the decoupling curves in which precipitant concentration in protein solutions increases to a certain point and then decreases to the equilibrium concentration gave the best crystals.

• Korean Chemical Engineering Research
• /
• v.51 no.6
• /
• pp.760-765
• /
• 2013

Lysozyme crystallization was performed by using flow-focusing chip in droplet-based microfluidic system. Water-in-oil droplets were formed in the system and collected on petri-dish and cross type mold. Liquid-liquid reaction of lysozyme and sodium chloride occurred in the droplet and crystals were observed through microscope. Solution pH was varied as 4.8 and 7.2. Crystals of polyhedron and plate-like shape were obtained at pH 4.8, while needle structure crystals formed at pH 7.2. Lysozyme in single droplet for two pHs were crystallized with constant or decreased droplet size. However, crystals at pH 4.8 were only obtained in the droplet of which size was increased by the interaction between droplets. Droplet volume did not change at pH 7.2 and crystals formed in both droplets.

• Journal of Korean Society on Water Environment
• /
• v.37 no.6
• /
• pp.442-448
• /
• 2021

Seawater desalination is a technology through which salt and other constituents are removed from seawater to produce fresh water. While a significant amount of fresh water is produced, the desalination process is limited by the generation of concentrated brine with a higher salinity than seawater; this imposes environmental and economic problems. In this study, characteristics of seawater from three different locations in South Korea were analyzed to evaluate the feasibility of crystallization to seawater desalination. Organic and inorganic substances participating in crystal formation during concentration were identified. Then, prediction and economic feasibility analysis were conducted on the actual water flux and obtainable salt resources (i.e. Na2SO4) using membrane distillation and energy-saving crystallizer based on multi-stage flash (MSF-Cr). The seawater showed a rather low salinity (29.9~34.4 g/L) and different composition ratios depending on the location. At high concentrations, it was possible to observe the participation of dissolved organic matter and various ionic substances in crystalization. When crystallized, materials capable of forming various crystals are expected. However, it seems that different salt concentrations should be considered for each location. When the model developed using the Aspen Plus modular was applied in Korean seawater conditions, relatively high economic feasibility was confirmed in the MSF-Cr. The results of this study will help solve the environmental and economic problems of concentrated brine from seawater desalination.

• The Journal of Advanced Prosthodontics
• /
• v.16 no.3
• /
• pp.174-188
• /
• 2024

PURPOSE. The purpose of this study was to investigate the effects of surface treatments, liquids, and aging on color, translucency, and surface properties of monolithic ceramics. MATERIALS AND METHODS. Lithium disilicate (LDS) and zirconia-reinforced lithium silicate (ZLS) ceramics (n = 135 each) were cut and divided into three groups [crystallization+glaze (single stage), crystallization-glaze (two stages), and crystallization-polish (two stages)]. One sample from each group was examined using scanning electron microscopy (SEM). Remaining samples were divided into four subgroups (distilled water, coffee, grape juice, and smoothie) (n = 11 each), stored for 12 d in the respective liquids, and thermally aged. One sample from each subgroup was analyzed using SEM. The color, gloss, and roughness values of the samples were analyzed after surface treatment (initial) and storage under different liquids+aging conditions. The initial data and both the aged data and data change values were analyzed using robust two- and three-way analyses of variance. RESULTS. The glazed groups exhibited smoother surfaces. Ceramic type and ceramic-surface treatment interactions affected the initial translucency parameter (TP) (P < .001) and the initial and aged roughness values (P ≤ .001). Surface treatment type affected the color change (P < .001), and ceramic type affected the aged TP values (P < .001). Type of ceramic, surface treatment, and their interactions affected both the initial and aged gloss (P ≤ .001) and TP change values (P ≤ .015). Surface treatment type and ceramic-surface treatment interactions affected the gloss change values (P ≤ .001). CONCLUSION. Although both ceramics and all surface treatments are clinically applicable, crystallization-glaze is recommended. When gloss and smoothness are important or when translucency is important, ZLS or LDS may be preferred, respectively.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.2
• /
• pp.174-180
• /
• 2004

This study is a fundamental research to test the applicability of abandoned eggshell as seed material for crystallization reaction. Eggshell was calcinated at $850^{\circ}C$ and ground to lesser than 0.42mm. The calcination characteristics of eggshell were examined by X-ray diffraction (XRD). The effect of initial calcium concentration, alkalinity, reaction temperature condition, seed dosage were studied by batch test. For the low concentration sample(P concentration is under 50mg/L), more than 90% of P can be removed. The effect of initial calcium concentration(0~120mg/L) was performed. At the result of the test, more than 50mg/L calcium concentration has high removal efficiency. Alkalinity effect was studied for synthetic solution(100mg/L initial P, 50mg/L calcium, 0.025% seed dosage) with 0~300mg/L bicarbonate alkalinities. For synthetic solution(100mg/L initial P, 50mg/L calcium, 100mg/L bicarbonate alkalinity, 0.025% seed dosage), the phosphorus concentration was examined with $10{\sim}35^{\circ}C$. In addition, calcinated eggshell was injected to swine wastewater to test the applicability to actual wastewater.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.4
• /
• pp.291-297
• /
• 2019

Phosphorus is a vital resource for sustaining agriculture and nutrition, but a limited non-renewable resource. Thus, the recovery of phosphorus from waste activated sludge(WAS) was attempted by microwave heating and magnesium ammonium phosphorus(MAP) crystallization. Polyphosphate-accumulating organisms(PAOs) in WAS release phosphate from the cell when they are exposed to high temperature environments. Microwave heating caused phosphorus and ammonia to release from WAS. The amount was increased with increasing temperature, showing that 88.5% of polyphosphate present in the cells were released in the form of phosphate at $80^{\circ}C$. A similar result was also observed in the release of ammonia. On the other hand, both phosphorus and ammonia were crystallized with magnesium, and then was harvested as MAP. Phosphorus recovery rate reached almost 97.8%, but the ammonia was about 13.4%. These results cleary indicate that phosphorus could be recovered from WAS using a physiological trait of PAOs. Heavy metal analyses also show that the MAP crystal is useful and safe as a phosphorus fertilizer.