• Wind and Structures
• /
• v.9 no.3
• /
• pp.245-254
• /
• 2006

The pressure and drag measurements were carried out in the wind tunnel to investigate the drag reduction of the disk by using an interference rod placed upstream. The results indicate that there is a pair of standing vortices in the front stagnation region of the disk induced by the rod. The standing vortices can decrease the pressure on the disk upwind side; hence it can reduce the drag of the disk. With an increasing rod diameter, the standing vortices are strengthened and more drag reduction can be achieved for the disk. With rod diameter d/D = 0.05 (d, D are the diameters of rod and disk, respectively), the total drag of the disk can be reduced by about 9% compared with that of the bare disk.

• Wind and Structures
• /
• v.11 no.4
• /
• pp.291-302
• /
• 2008

Three-dimensional engineering simulations of momentum-driven tornado-like vortices are conducted to investigate the flow dynamics dependency on swirl ratio and the possible relation with real tornado Fujita scales. Numerical results are benchmarked against the laboratory experimental results of Baker (1981) for a fixed swirl ratio: S = 0.28. The simulations are then extended for higher swirl ratios up to S = 2 and the variation of the velocity and pressure flow fields are observed. The flow evolves from the formation of a laminar vortex at low swirl ratio to turbulent vortex breakdown, followed by the vortex touch down at higher swirls. The high swirl ratios results are further matched with full scale data from the Spencer, South Dakota F4 tornado of May 30, 1998 (Sarkar, et al. 2005) and approximate velocity and length scales are determined.

• 한국연소학회:학술대회논문집
• /
• 2000.05a
• /
• pp.189-196
• /
• 2000

A numerical simulation was conducted to analyze the interaction of flame and vortices. The characteristic scales of flame and vortices were limited in the thin laminar flamelet regime. Within this regime, flame is assumed as discontinuity surface and its motion in flow field was described by G-equation instead of full governing equations. Additional approximations include distribution of line volume sources on flame surface to simulate effect of volume expansion. Contrast to previous calculations, current study employed vortex transport equation to evaluate attenuation and smearing of vortices. Two extreme conditions of frozen vortex and frozen flame were considered to validate the current method. Comparison with direct numerical simulation resulted in satisfactory quantitative agreement with higher computational efficiency which warrants the usefulness of the present model in more complex situation.

• 한국전산유체공학회:학술대회논문집
• /
• 1998.11a
• /
• pp.1-6
• /
• 1998

From surface flow visualization on a MIRA notchback reference model using oil flow technique, the topology of the singular points of the skin friction lines are delineated. Separation and reattachment lines at the front screen, at the A-pillar, at the C-pillar and on the rear side of the car including the trunk have been identified. It is worth to mention that two vortices emerging from the top of the trunk coil in the opposite direction as that vortices starting from the C-pillar edge. The positions of the singular points and the separation and reattachment lines and the foci of the vortices provide a sensitive database for validation of CFD-codes

• 한국전산유체공학회:학술대회논문집
• /
• 2010.05a
• /
• pp.308-314
• /
• 2010

In this study, NASA test model with four cruciform fins is utilized to validate the in-house code. Sur face pressure distribution and aerodynamic coefficients are compared with experimental data. Through extensive validation work, it is verified that the code has capability to predict aerodynamic characteristics of missile configuration. In inviscid analysis through a relatively low computational time, analysis result close to experimental data can be confirmed. However, at high angle of attack more than 20 degree, the accuracy of analysis is gradually decreased due to massive separation. In addition, it has been seen that Reynolds number, turbulence model and numerical method have effects on body vortices and aerodynamic characteristics.

• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.237-240
• /
• 2002

In the present study, we perform LES of turbulent flow and temperature fields in a circular impinging jet at Re=5000 for two cases of H/D=2 and 6 (H denotes the distance between the jet exit and flat plate, and D does the diameter of the jet exit). In the case of H/D=2, the regular vortical structures observed in free jet do not exist because of the smaller distance than the potential core. The Nusselt number on the wall is largest at $r/D{\cong}10.67$ where vortex rings Impinge. At $r/D{\cong}1.5{\~}2.0$, the vortex rings induce the secondary vortices, resulting in a secondary peak in the Nusselt number there. In the case of H/D=6, the vortex rings change into three-dimensional vortical structures and the small-scale vortices impinge on the flat plate. The increase of turbulent intensity due to small-scale vortices results in the largest Nusselt number at the stagnation point.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.21 no.11
• /
• pp.1518-1526
• /
• 1997

The dynamic properties of a ship's propulsion mechanism of Weis-Fogh type are studied by the discrete vortex method. The wing in the channel is approximated by a finite number of bound vortices and free vortices representing the separated flow are introduced from the trailing edge of the wing. The time histories of the thrust, the drag, and the moment acting on the wing are calculated, including the unsteady force due to the change of strength of the bound vortices. These calculated results show a similar tendency to the experimental ones qualitatively and the dynamic properties of this propulsion mechanism are numerically clarified.

• Wind and Structures
• /
• v.4 no.2
• /
• pp.131-146
• /
• 2001

A full-scale synchronized data acquisition system was set up on the roof of the experimental building at the Texas Tech University Wind Engineering Research Field Laboratory to simultaneously collect approaching wind data, conical vortex images, and roof corner suction pressure data. One-second conditional sampling technique has been applied in the data analysis, which makes it possible to separately evaluate the influencing effects of the horizontal wind angle of attack, ${\theta}$, and the vertical wind angle of attack, ${\varphi}$. Results show a clear cause-and-effect relationship between the incident wind, conical vortices, and the induced roof-corner high-suction pressures. The horizontal wind angle of attack, ${\theta}$, is shown to be the most significant factor in influencing the overall vortex structure and the suction pressures beneath. It is further revealed that the vertical wind angle of attack, ${\varphi}$, plays a critical role in generating the instantaneous peak suction pressures near the roof corner.

• 한국가시화정보학회:학술대회논문집
• /
• 2001.12a
• /
• pp.108-122
• /
• 2001

In a continuing effect to study the mixmg enhancement by large-scale streamwise vortices in lobed mixing flows, an advanced PIV system named as dual-plane stereoscopic PIV system was used in the present study to conduct simultaneous vorticity (all three components) measurement of an air jet exhausted from a lobed nozzle. Unlike 'classical' 2-D PIV system or conventional 'single-plane' stereoscopic PIV system, the dual-plane stereoscopic PIV system used in the present study can obtain the flow velocity (all three components) fields at two spatially separated planes simultaneously. Therefore, it can provide the distributions of all the three components of vorticity vectors instantaneously and simultaneously. The evolution and interaction characteristics of the large-scale streamwise vortices and azimuthal Kelvin-Helmholtz vortices in the lobed jet mixing flow were revealed instantaneously and quantitatively from the measurement results of the dual-plane stereoscopic PIV system. The characteristics of the mixing process in the lobed jet mixing flow were analyzed based on the simultaneous measurement results of the steamwise vorticity and azimuthal Kelvin-Helmholtz vorticity distributions.

• Wind and Structures
• /
• v.27 no.2
• /
• pp.111-121
• /
• 2018

Experiments were conducted in a large-scale Ward-type tornado simulator to study tornado-like vortices. Both flow velocities and the pressures at the surface beneath the vortices were measured. An interpretation of these measurements enabled an assessment of the mean flow field as well as the mean and fluctuating characteristics of the surface pressure deficit, which is a manifestation of the flow fluctuation aloft. An emphasis was placed on the effect of the aspect ratio of the tornado simulator on the characteristics of the simulated flow and the corresponding surface pressure deficit, especially the evolution of these characteristics due to the transition of the flow from a single-celled vortex to a two-celled vortex with increasing swirl ratio.