• Smart Structures and Systems
• /
• 제13권2호
• /
• pp.281-303
• /
• 2014

In order to suppress the wind-induced vibrations of the Canton Tower, a pair of active mass driver (AMD) systems has been installed on the top of the main structure. The structural principal directions in which the bending modes of the structure are uncoupled are proposed and verified based on the orthogonal projection approach. For the vibration control design in the principal X direction, the simplified model of the structure is developed based on the finite element model and modified according to the field measurements under wind excitations. The AMD system driven by permanent magnet synchronous linear motors are adopted. The dynamical models of the AMD subsystems are determined according to the open-loop test results by using nonlinear least square fitting method. The continuous variable gain feedback (VGF) control strategy is adopted to make the AMD system adaptive to the variation in the intensity of wind excitations. Finally, the field tests of free vibration control are carried out. The field test results of AMD control show that the damping ratio of the first vibration mode increases up to 11 times of the original value without control.

• 융합신호처리학회논문지
• /
• 제14권2호
• /
• pp.95-98
• /
• 2013

LMS(Least Mean Square)알고리즘은 강인성, 높은 추적성, 구현의 단순성 때문에 아직도 많이 사용되는 알고리즘이다. 하지만, LMS알고리즘은 비균일적인 수렴율과 EMSE(Excess mean square error)사이에 trade-off를 가진다. 이러한 단점을 극복하기 위해, 많은 가변 스텝 사이즈 알고리즘이 연구되고 있다. 빠른 수렴속도를 위하여 복잡한 가변스텝 방식을 사용 하는데 많은 계산량을 필요로 한다. IGC(Instantaneous Gain Control) 알고리즘은 원신호와 잡음신호의 순시이득값을 사용하여 계산량은 줄이고 높은 성능을 유지한다. 하지만 IGC 알고리즘은 이득값 계산시 log함수에 의해 실행시간이 오래 걸리는 단점을 가진다. 제안하는 변형 IGC알고리즘은 실행시간을 지연하는 log 함수를 제거하여, 실시간 소음제거 처리에 맞게 변형하여 성능 개선을 이룰 수 있었다.

• Journal of Power Electronics
• /
• 제14권1호
• /
• pp.105-114
• /
• 2014

The sliding mode control (SMC) strategy is applied to a permanent magnet synchronous machine vector control system in this study to improve system robustness amid parameter changes and disturbances. In view of the intrinsic chattering of SMC, a current sliding mode control method with a load sliding mode observer is proposed. In this method, a current sliding mode control law based on variable exponent reaching law is deduced to overcome the disadvantage of the regular exponent reaching law being incapable of approaching the origin. A load torque-sliding mode observer with an adaptive switching gain is introduced to observe load disturbance and increase the minimum switching gain with the increase in the range of load disturbance, which intensifies system chattering. The load disturbance observed value is then applied to the output side of the current sliding mode controller as feed-forward compensation. Simulation and experimental results show that the designed method enhances system robustness amid load disturbance and effectively alleviates system chattering.

• 대한전자공학회논문지SD
• /
• 제46권1호
• /
• pp.92-97
• /
• 2009

저 전력 소모는 의료용 이식 장치에서 매우 중요한 요소가 된다. 본 논문에 제안된 이식형 심장 박동 조절기의 감지 단에 필요한 저 전력 4차 Gm-C 필터는 다단 증폭 단으로 구현 되었다. 매우 큰 시상수를 구현하기 위해서 전류 분할 및 플로팅-게이트 기법이 적용된 OTA가 사용되었다. 측정 결과, 필터는 50 dB의 SFDR을 가지며, $1.8{\mu}$, W의 전력이 소모되었다. 전원 전압은 1.5 V가 공급되었고, 코어는 $2.4\;mm{\times}1.3\;mm$의 실리콘 면적을 차지한다. 제안된 필터는 1-poly 4-metal $0.35-{\mu}m$ CMOS 공정에서 제작되었다.

• 한국연소학회지
• /
• 제13권2호
• /
• pp.1-6
• /
• 2008

An experimental study of the flame response in a turbulent premixed combustor has been conducted with room temperature, atmospheric pressure inlet conditions using premixed natural gas. The fuel is premixed with the air upstream of a choked inlet to avoid equivalence ratio fluctuations. Therefore the observed flame response is only the result of the imposed velocity fluctuations, which are produced using a variable speed siren. Measurements are made of the velocity fluctuation in the nozzle using hot wire anemometry and of the heat release fluctuation in the combustor using chemiluminescence emission. The results are analyzed to determine the phase and gain of the flame transfer function as a function of the modulation frequency. Of particular interest is the effect of flame structure on the flame response predictions and measurements. The results show that both the gain and the phase of flame transfer function are closely associated with the flame length and structure, which is dependent upon the upstream flow perturbation as well as equivalence ratio in the current study.

• 조명전기설비학회논문지
• /
• 제14권1호
• /
• pp.38-46
• /
• 2000

본 연구에서는 브러시리스 직류모터의 적합한 수학적 동가 모텔링을 구성하였으며 제어대상 BLOC 모터에 스 웹입력이 있는 상태로 역기전력의 측정에 의한 모터 파라미터를 측정하였다. 그리고 제시된 측정법의 타당성은 스템웅답의 실험결과에 의해서 확인하였다. 또한 훌센서로된 BLOC 모터의 오픈루프 전달함수로부터 얻은 근궤 적법의 결과에 따라 적합한 디지털제어기를 셜계하였으며 속도제어 가변을 위한 제어이득을 결정하였다. 여기서 수정된 Ziegler-Nichols의 동조법은 적합한 디지털 게인 설정을 위해서 적용되었으며 시스템의 안정성은 보드선 도와 실험으로 주파수영역의 해석에 의해서 입증하였다.

• Journal of Power Electronics
• /
• 제18권2호
• /
• pp.343-355
• /
• 2018

A wide-voltage-conversion range bidirectional DC-DC converter is proposed in this paper. The topology is comprised of one typical LC energy storage component and a special common grounded asymmetric H-bridge with four active power switches/anti-parallel diodes. The narrow output PWM voltage is generated from the voltage difference between two normal (wider) output PWM voltages from the asymmetric H-bridge with duty cycles close to 0.5. The equivalent switching frequency of the output PWM voltage is double the actual switching frequency, and a wide step-down/step-up ratio range is achieved. A 300W prototype has been constructed to validate the feasibility and effectiveness of the proposed bidirectional converter between the variable low voltage side (24V~48V) and the constant high voltage side (200V). The slave active power switches allow ZVS turn-on and turn-off without requiring any extra hardware. The maximum conversion efficiency is 94.7% in the step-down mode and 93.5% in the step-up mode. Therefore, the proposed bidirectional topology with a common ground is suitable for energy storage systems such as renewable power generation systems and electric vehicles with a hybrid energy source.

• ETRI Journal
• /
• 제29권4호
• /
• pp.421-429
• /
• 2007

This paper presents a direct-conversion CMOS transceiver for fully digital DS-UWB systems. The transceiver includes all of the radio building blocks, such as a T/R switch, a low noise amplifier, an I/Q demodulator, a low pass filter, a variable gain amplifier as a receiver, the same receiver blocks as a transmitter including a phase-locked loop (PLL), and a voltage controlled oscillator (VCO). A single-ended-to-differential converter is implemented in the down-conversion mixer and a differential-to-single-ended converter is implemented in the driver amplifier stage. The chip is fabricated on a 9.0 $mm^2$ die using standard 0.18 ${\mu}m$ CMOS technology and a 64-pin MicroLead Frame package. Experimental results show the total current consumption is 143 mA including the PLL and VCO. The chip has a 3.5 dB receiver gain flatness at the 660 MHz bandwidth. These results indicate that the architecture and circuits are adaptable to the implementation of a wideband, low-power, and high-speed wireless personal area network.

• Journal of the Korean Statistical Society
• /
• 제33권4호
• /
• pp.381-399
• /
• 2004

Statistical process control (SPC) and engineering process control (EPC) are based on different strategies for process quality improvement. SPC re-duces process variability by detecting and eliminating special causes of process variation, while EPC reduces process variability by adjusting compensatory variables to keep the quality variable close to target. Recently there has been need for an integrated process control (IPC) procedure which combines the two strategies. This paper considers a scheme that simultaneously applies SPC and EPC techniques to reduce the variation of a process. The process model under consideration is an IMA(1,1) model with a step shift. The EPC part of the scheme adjusts the process, while the SPC part of the scheme detects the occurrence of a special cause. For adjusting the process repeated adjustment is applied according to the predicted deviation from target. For detecting special causes the exponentially weighted moving average control chart is applied to the observed deviations. It was assumed that the adjustment under the presence of a special cause may increase the process variability or change the system gain. Reasonable choices of parameters for the IPC procedure are considered in the context of the mean squared deviation as well as the average run length.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권12호
• /
• pp.4432-4450
• /
• 2014

It is widely observed that in practical wireless cooperative communication systems, different links may experience different fading characteristics. In this paper, we investigate into the outage probability and channel capacity of two-way amplify-and-forward (TWAF) relaying systems operating over a mixed asymmetric Rician and Rayleigh fading scenario, with different amplification policies (AP) adopted at the relay, respectively. As TWAF relay network carries concurrent traffics towards two opposite directions, both end-to-end and overall performance metrics were considered. In detail, both uniform exact expressions and simplified asymptotic expressions for the end-to-end outage probability (OP) were presented, based on which the system overall OP was studied under the condition of the two source nodes having non-identical traffic requirements. Furthermore, exact expressions for tight lower bounds as well as high SNR approximations of channel capacity of the considered scenario were presented. For both OP and channel capacity, with different APs, effective power allocation (PA) schemes under different constraints were given to optimize the system performance. Extensive simulations were carried out to verify the analytical results and to demonstrate the impact of channel asymmetry on the system performance.