• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.776-779
• /
• 2004

The dielectric and electrical characteristics of Ce doped (Ba0.6Sr0.4)TiO3 (BST) thin films were investigated as a function of Ce content. Both atomic force microscopy (AFM) and x-ray diffraction (XRD) analysis showed that increasing the Ce doping ratio causes the decrease in grain size while the surface remains smooth and crack-free. The dielectric properties of the Ce doped BST films were found to be strongly dependent on the Ce contents. The dielectric constant and dielectric loss of the BST films decreased with increasing Ce content. However, it was also found that, compared with undoped films, the increase of Cecontent improves the leakage-current characteristics. The improvement of the electrical properties of Ce-doped BST films may be related to the decrease in the concentration of oxygen vacancies. The figure of merit (FOM) reached the maximum value of 48.9 at the 1 mol % of Cedoping. The dielectric constant, loss factor, and tunability of the 1 mol% Ce doped Ba0.6Sr0.4TiO3 thin films were 320, 0.011, and 46.3%, respectively.

• Journal of electromagnetic engineering and science
• /
• v.6 no.1
• /
• pp.1-9
• /
• 2006

A sandwich structure of dielectric material and air gap inside a rectangular waveguide is proposed as a fast electrically tunable low-loss phase shifter. As the dielectric material is shifted up and down by piezoelectric actuator and, thereby, the thickness of air gap is changed, the effective dielectric constant of the sandwich structure is varied. Phase shifters based on the sandwich structure with different dielectric materials showed phase shift of $20{\sim}200^{\circ}/cm$ at X-band as the thickness of air gap varied up to $30{\mu}m$. The idea can be extended toward low-loss millimeter wave phase shifters since modem microwave ceramics have been developed to show very low dielectric loss$(tan\;{\delta}{\sim}10^{-4})$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.4
• /
• pp.730-735
• /
• 2003

In this paper, four different types of BSTO tunable bandpass filters with ferroelectrics are proposed. The achievement of the tunability is based on the fact that the increase in the bias voltage leads to the reduction of the effective dielectric constant. Therefore, the center frequency shifts to the higher value with the higher bias voltage. The most frequently used and well-known ferroelectrics are STO and BSTO materials where the STO is mainly used below 100K while the BSTO is used at room temperature. The proposed technology seems very useful and promising for the development of the next-generation wireless communications.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.9 s.112
• /
• pp.860-865
• /
• 2006

In this paper, a novel tunable inter-digital capacitor using dielectric tunable $Bi_2O_3-ZnO-Nb_2O_5(BZN)$ pyrochlore thin films is proposed. In order to improve the tunability and reduce DC bias voltage using the fringing electric field, the electrodes of the inter-digital capacitor are embedded in the thin film. Designed results using a 2.5 D simulator show that the tunability of the proposed inter-digital capacitor improves by 10 %, compared to the conventional inter-digital capacitor. The proposed IDC, which is based on the simulation results, was fabricated, using the BZN thin film deposited by a reactive RF magnetron sputtering on the on the silicon substrate. The fabricated inter-digital capacitor shows the maximum tunability of 50 % at 5.8 GHz and 18 V DC applied.

• Proceedings of the KIEE Conference
• /
• 2006.07c
• /
• pp.1353-1354
• /
• 2006

The dielectric properties of $Ba_{0.5}Sr_{0.5}TiO_3$(BST) and MgO-doped BST ceramics were investigated for tunable microwave applications by sol-gel method. The effects of MgO mixing with BST. It is observed that Mg substitution into BST causes a shift in the cubic-tetragonal BST Phase transition peak to a lower temperature. MgO-substituted BST and MgO-mixed phases exhibit homogeneous and broadened BST phase transition peaks. Mg substitution into BST has a significant effect on the grain sife reduction. Dielectric constant and loss is inhanced with decrease MgO dopant.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.581-584
• /
• 2002

In this work, a CPW resonator was designed and fabricated to investigate the basic microwave properties, such as effective dielectric constant, of BST thin films. Their properties were used as basic data to simulate and design CPW tunable bandpass filter. We also report on gold/$Ba_{0.5}Sr_{0.5}TiO_3$(BST) ferroelectric thin film C-band tunable bandpass filters(BPFs) designed and fabricated on magnesium oxide substrates using CPW structure. The 2 pole filter was designed for a center frequency of 5.88 GHz with a bandwidth of 9 %. The BST based CPW filter offers a high sensitivity parameter as well as a low loss parameter. The tuning range for the bandpass filter with CPW structure was determined to be 170 MHz.

• Journal of Electrical Engineering and Technology
• /
• v.2 no.3
• /
• pp.391-395
• /
• 2007

MgO enhanced $(Ba_{0.6}Sr_{0.4})$ $TiO_3$ thick films have been fabricated by a tape casting and firing method for tunable devices on the microwave frequency band. In order to improve ferroelectric properties, the composite thick films enhanced with MgO on BST have been asymmetrically annealed by a focused halogen beam method. Dielectric constants of composite thick films are changed from 1050 to 1300 at 100 kHz after 60 s and 150 s annealing by the focused halogen beam. Even though no prominent changes were previously observed from the thick films before and after annealing in terms of chemical composition and surface morphology, it is clear that the average particle size of the thick films calculated by Scherrer's formula were increased by annealing. Furthermore, a strong correlation between particle size and dielectric constant of the composite thick films has been observed; dielectric constant increases with increased particle size. This has been attributed to the increased volume of ferroelectric domain due to increased particle sizes. As a result, the tuning range was improved by halogen beam annealing.

• Journal of Information Display
• /
• v.11 no.2
• /
• pp.84-90
• /
• 2010

This paper presents the effects of a dielectric layer and an electrolyte on the driving performance of an electrowetting on dielectric (EWOD)-based liquid lens. The range of tunable focal length of the EWOD-based liquid lens was highly dependent on the conditions of the dielectric layer, which included an inorganic oxide layer and an organic hydrophobic layer. Moreover, experiments on the physical and optical durability of electrolyte by varying temperature conditions, were conducted and their results were discussed. Finally, the lens with a truncated-pyramid silicon cavity having a sidewall dielectrics and electrode was fabricated by anisotropic etching and other micro-electromechanical systems (MEMS) technologies in order to demonstrate its performance. The lens with $0.6-{\mu}m$-thick $SiO_2$ layer and 10 wt% LiCl-electrolyte exhibited brilliant focal-length tunability from infinity to 3.19 mm.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.115-116
• /
• 2006

Dielectric PST (20/80) / PST (80/20) heterolayered thin films structures were created by a consequent deposition of the PST (20/80) and PST (80/20) thin films on the $Pt/Ti/SiO_2/Si$ substrate using alkoxide-based sol-gel method. Both structural and dielectric properties of heterolayered PST thin films were investigated for the tunable microwave device applications. As the number of coating increases, the lattice distortion decreased. It can be assumed that the lower PST layer affects a nucleation site or a seeding layer for the formation of the upper PST layer. The dielectric constant, dielectric loss and tunability of the PST-6 heterolayered structure measured at 100 kHz were 399, 0.022 and 57.9%, respectively. All these parameters showed an increase with increasing number of coatings due to the decrease in lattice distortion.

• Rubber Technology
• /
• v.9 no.1
• /
• pp.25-28
• /
• 2008

By combining the multi-faceted environmental responsiveness of polymer hydrogels with photonically active structures, there has been a significant effort to create color-tunable photonic crystal sensors by changing either the periodic spacing of the structure or the dielectric constants of the materials. Here, we show that reversible spiral and helical opal switches with both dimensional and optical functionalities that respond to environmental chemistry can be constructed. When the transparent opal switch is swollen in hydrophilic acetic acid, right-handed spirals and helices that exhibit angularly dependent colors from Bragg diffraction are formed. When the transparent opal switch is swollen in hydrophobic hexane, left-handed spirals which exhibit angularly dependent colors from Bragg diffraction are formed. When the transparent opal switch is swollen in hydrophobic hexane solvent, a left-handed spiral and helix with an angularly independent bluish color is formed. After deswelling, all switches returned back to the transparent planar state. These color-tunable, reversible spiral and helical opal switches can be useful as mechanical actuators, and electrical devices as well as optical components.