• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제12권12호
• /
• pp.5898-5916
• /
• 2018

In this paper, the downlink performance of multi-cell distributed antenna systems (DAS) with a single user in each cell is investigated. Assuming the channel state information is available at the transmitter, four transmission modes are formulated as combinations of remote antenna units (RAUs) selection and cooperative transmission, namely, non-cooperative transmission without RAU selection (NCT), cooperative transmission without RAU selection (CT), non-cooperative transmission with RAU selection (NCT_RAUS), and cooperative transmission with RAU selection (CT_RAUS). By using probability theory, the cumulative distribution function (CDF) of a user's signal to interference plus noise ratio (SINR) and the system ergodic capacity under the above four modes are determined, and their closed-form expressions are obtained. Furthermore, the system energy efficiency (EE) is studied by introducing a realistic power consumption model of DAS. An expression for determining EE is formulated, and the closed-form tradeoff relationship between spectral efficiency (SE) and EE is derived as well. Simulation results demonstrate their consistency with the theoretical analysis and reveal the factors constraining system EE, which provide a scientific basis for future design and optimization of DAS.

• 전기학회논문지
• /
• 제61권10호
• /
• pp.1461-1470
• /
• 2012

This paper reports the contamination performance of transmission line porcelain insulators tested under five different contaminant conditions - clean and ESDD (equivalent salt deposit density) level (A, B, C, and D) through measurement of their leakage current under drop of potential method. To estimate the contamination for transmission line porcelain insulators, leakage current waveform and its maximum value were measured under step-up power test. In the clean insulators test, % distortion factors decreased with increasing step-up power, and as the ESDD level increased, some characteristics such as frequency analysis, harmonics and % distortion facotor could be used for contamination diagnosis of the transmission line porcelain insulators.

• 대한기계학회논문집A
• /
• 제21권11호
• /
• pp.1943-1949
• /
• 1997

In this paper, the analysis of the shift transient characteristics for the Ravigneaux type automatic transmission has been carried out using dynamic models of the automatic trnasmission. It is necessary to understand the overall system including multi-plate clutch, band brake, one way clutch, and planetary gears. The equations of motion are derived from the dynamic models of the automatic transmission. The GUI computer simulation program has been developed to analyze the shift transient characteristics of the vehicle equipped with the Ravigneaux type automatic transmission.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2002년도 추계학술대회논문집
• /
• pp.505-510
• /
• 2002

The attenuation of waves transmitted through non-conservative joints that are shown in many paractical structures, is affected by the impedance and the orientation of the joint. In this paper, the joints between plate structures are assumed to be modeled as linear spring-dashpot systems and the transmission and reflection of vibration energy in the medium to high frequency ranges are investigated. The calculated power transmission and reflection coefficients are applied to the PFA method for the prediction of energy density and intensity in structures.

• 전자공학회논문지A
• /
• 제33A권7호
• /
• pp.15-22
• /
• 1996

In the soliton transmission system for a long-length and high bit rate data transmission systme using the nonlinear/dispersive optical fibers, the improtant problem is the loss characteristics and is the limited transmission rate by interaction forces. In this paper, It is explained the reasons of moved time position for the soliton peak value due to interaction force sof adjacent solitons. And for the analysis of interaction force affection level in the losslessmedia, we define the percent parameter of error rate due to the interaction forces and propose the optimum time distance of adjacent solitons by peak value tracking methods. With the results, initial percent of error is approximately 50% when itme difference between adjacent solitons is 5 times of funddametnal soliton pulse width. And it is confirmed that maximum transmission length of th esolitons is approximately 38 times of fundamental soliton period, which the maximum allowable percoent of error is 50%.

• 전자공학회논문지A
• /
• 제33A권6호
• /
• pp.11-22
• /
• 1996

We address an issue of channel sharing among users by using a random assignment-transmitter-based (RA-T) spread-spectrum transmission scheme which permits the contention mode only in the transmission of a header while avoiding collision during the data packet transmission. Once the header being successfully received, the data packet is ready for reception by switching to one of programmable matched-filters. But the receoption may be blocked due to limited number of matched-filters so that this effect is taken into account in our analysis. For realistic analysis, we integrate detection performance at the physical level with channel activity at the link level through a markov chain model. We also consider an acknowledgement scheme to notify whether the header is correctly detcted and the data packet can be processed continuously, which aims at reducing the interference caused unwanted data transmission. It is shown that receiver complexity can be greatly reduced by choosing a proper number of RA codes at the cost of only a little throughput degradation.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 춘계학술대회논문집
• /
• pp.770-773
• /
• 2004

The transmission loss coefficient is very important acoustic property in parallel with absorption and acoustic impedance categorizing the acoustical materials, which can control the acoustical problems. At the same time, the transmission loss coefficient is a key parameter to choose the optimum material for the analysis of acoustical characteristics of material using SEA(Statistical Energy Analysis). In this paper, the acoustic transmission loss measurement system using 4-microphone TL tube is applied to the exhaust system, which is one of the most important acoustic control parameters in a car, based on the idea calculating the full transfer matrix. The theoretical background and measurement system are introduced, and finally the measurement results are verified.

• 조명전기설비학회논문지
• /
• 제26권1호
• /
• pp.75-81
• /
• 2012

In this paper, the wireless power transfer system using the magnetic resonance was designed, analyzed by circuit analysis methode and the calculated transfer function was compared with the measured one. The self-resonant coil was made up of the commonly used capacitor which had the lumped capacitance and it enabled the stable magnetic resonance not to be affected by the circumstance. The transmission efficiency of this system was 70[%] at the 15[cm] between the transmission and receiving coil and the measured transfer function was similar to the calculated one, which means the circuit analysis methode is valid in this system. When the intermediate coils were added between the transmission and receiving coil, the transmission efficiency was increased, which produced the increase of transfer distance. In the case of the five intermediate coils adding, the 35[%] transmission efficiency was achived at the 90[cm] distance.

• 한국기계가공학회지
• /
• 제11권2호
• /
• pp.40-46
• /
• 2012

In this study, numerical analysis was conducted to understand the flow characteristics of lubrication system in a manual transmission installed in a commercial vehicle. Also, the analysis was conducted with the purpose of improving the heat and lubricative condition of the transmission. Discharging flow rates on each oil hole outlet according to various engine rotating speed and the length of oil hole branch was calculated. In conclusion, as engine rotating speed is high and the length of oil hole branch is long, the discharging flow rate is high by virtue of the centrifugal force. In addition, this study proposed data for optimal design of lubrication system in manual transmission for a commercial vehicle.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 추계학술대회 논문집 전력기술부문
• /
• pp.375-377
• /
• 2002

In many parts of the world. the electricity industry is undergoing unprecedented changes. Hence, in order to reform the electricity industry readily and efficiently and minimize the confusion by these restructuring, it is required the systematic studies related to transmission pricing and transmission cost allocation issues. However, even now the basis of transmission cost allocation rate is not equipped so that the regulation body has determined the allocating rate under the common practice. In this paper it is demonstrated that the decision of transmission cost allocation rate is the regulation body's own right. For the analysis, game theory is applied to the procedure determining this rate and the competition to determine this rate between generators and distributors is modeled as the arbitration game.