• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.47 no.3
• /
• pp.248-256
• /
• 2011

The inherent efficiency of a ship would be prior to any other quality factors in ship's safety, because lack of it may give rise to a serious sea casuality even if it were a light mistake in operation. And the representative casualty comes from a deficiency of stability and an operating error combined would be capsizing. The Korean offshore large purseiner looks to have a structural weak point with small range of stability in spite of her big initial metacentric height, and have various type of roll reduction devices in order to cover up the defect. The aim of this study is to grasp for the roll reduction characteristics of the purseiner with bilge keel only and a stern keel additionally attached. The results are summarized as follows; The rolling angle of the model ship was increased in accordance with increase of the wave period and height, especially at close to the natural wave period of her, and the trends were more distinguished in the situation of bilge keel only installation than in the stern keel additionally installed. And stern keel has not noticeable effect on the reduction of the roll in the light ship condition, but has a little effect in full load condition.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.44 no.3
• /
• pp.218-228
• /
• 2008

This paper describes on the real-time tracking of ship's dynamic behavior by AIS information in the coastal waters. The AIS data was received at a land station by using the antenna of AIS receiver mounted on the rooftop of the laboratory, Pukyong National University (PKNU), Busan, Korea, and stored as a NMEA format of serial output sentence of VDM(VHF Data-Link Message) and displayed on the ENC(Electronic Navigational Chart) of a PC-based ECDIS. In this study, the AIS receiver was mainly used to obtain the dynamic information that is necessary to evaluate and track the movement situation of training ship "KAYA" of PKNU in the coastal waters. The change of position with time for the ship turning under the rudder angle of port $30^{\circ}$ was correctly tracked with the turning circle of 940 m in diameter on the ENC of a PC-based ECDIS. Then, the dynamic information of the AIS system was updated every 6.29 seconds under the turning situation for the speed of 10.9 knots and every 21.65 seconds under the situation running at the speed of 11.05 knots on the straight line route of $155^{\circ}$, respectively. In case of AIS target tracking in the inshore zone behind large topographical obstructions, such as mountain and apartment buildings, the update rate of dynamic information was irregularly changed by the existence of land obstacles. However, the position tracking by AIS information under the situation existing no sea obstructions was achieved in real or near real-time and the instant presentation of course alternations for the ship was correctly monitored by using a PC-based ECDIS. From these results, we concluded that the PC-based ECDIS technology and methodology combined with the AIS information can be easily extended and applied to the surveillance and management for the fishing operation of fishing vessels in the coastal zone and in the EEZ fishing grounds.

• Journal of Navigation and Port Research
• /
• v.32 no.5
• /
• pp.321-326
• /
• 2008

Recently the large sea bridge's construction crossing harbor and main ship's route have been propelled in the domestic so that it is active for the smoothly traffic flow of inland transportation and road user's convenience. However, it can bring about the trouble to ensure marine traffic safety if it is built that sea bridge's construction sets to an economy principle in the extension of the land road system. We're adopting Ship Handling Simulation in representative method for the influence assessment of marine traffic safety and danger elements beforehand. This research attempts to show the problems through the comparison and analysis of the reports relating to the sea bridge construction for 4 organization possessing Ship Handling Simulation. Finally, We offer the necessity of standardization on performing and assessment method of simulations.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.41 no.2
• /
• pp.156-164
• /
• 2005

The size of the ship's turning circle is influenced by various factors, such as block coefficient, underwater side shape, rudder area ratio, draft, trim and Froude's number. Most of them are already fixed on departure from a port. However, the ship's speed and the rudder angle are controllable factors which operations are able to change optionally during sailing. The DGPS measured the turning circles according to the ship's speed and the rudder angle. The maximum advances by slow and full ahead were 302m and 311m, and the maximum transfers were 460m and 452m, respectively. There occurs almost no difference in size of the turning circle by variation of the ship's speeds. When the rudder angles were changed to $10^{\circ}$, $20^{\circ}$ and $30^{\circ}$, the maximum advances were 447m, 271m and 202m, and then also the maximum transfers 657m, 426m and 285m, respectively. The diameter of the tuning circle was decreased exponentially when the rudder angle was increased. The maneuverability was better when the direction of turning and propulsion of propeller are in the opposite direction rather than in the same one togetherm. The distance of the maximum transfer was always bigger than that of the maximum advance.

• Journal of Navigation and Port Research
• /
• v.31 no.5 s.121
• /
• pp.427-434
• /
• 2007

Indoor air pollution has been a critical issue as a new environmental problem and a significant amount of research has been performed on the indoor air pollution in buildings as well us those in mean of transport such as automobiles, subways, and buses. The actual condition of indoor air pollution in ships, however, was not investigated. Because airtightness of a ship is very higher than a general building and the crew spend almost all the time in indoor space of the ship during underway, indoor air quality(IAQ) of the ship is very important for their comfortableness and health. In this paper, indoor air quality of a new ship is measured and analyzed for the improvement of IAQ in ships.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.18 no.1
• /
• pp.41-47
• /
• 2012

Recently, due to the rapid rise of the international oil price, the burden of fuel oil expense is relatively increasing in a ship. And the international restriction of the greenhouse gas which was generated from the burning of fuel oil is also rapidly strengthened. Therefore, to reduce the greenhouse gas and fuel oil consumption, many shipping company adopted the low speed navigation and it was focused on the improvement of fuel consumption efficiency and the usage of alternative energy in the marine engine development field. In this paper, the fuel oil consumption according to the ship's speed was measured in the actual seas and analyzed the shop test results in the shipyard and the ship navigation data from the abstract log. And then it was proposed that the ship's economic speed was 14~15kts and the optimum rpm was 140~150 in specific sea conditions.

• Journal of Navigation and Port Research
• /
• v.38 no.5
• /
• pp.463-470
• /
• 2014

In this paper, calculation of towing force required to tow the ship and experiments to verify its appropriacy are discussed. Friction, wind and wave-making resistance of vessel are considered to calculate towing force of specified vessel. Propeller resistance is also reflected and it is assumed that the propellers are locked. Node analysis to estimate additional resistance on towline is applied. Total towing force could be obtained by adding the ship's resistance and towline resistance. Experiments with training ship SAE YU DAL was executed to check the effectiveness of calculation methods and some comparison between experiments and calculation results was also done. From the comparative analysis, we confirmed that towing speed is primary terms in the calculation of towing force and propeller resistance is a major elements of ship's resistance with the increasing of towing speed. We can see that additional resistance induced by yawing of ship during towing have to be considered for total tow resistance.

• Journal of Korea Multimedia Society
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2022

Ship detection in synthetic aperture radar (SAR) images is an important application in marine monitoring for the military and civilian domains. Over the past decade, object detection has achieved significant progress with the development of convolutional neural networks (CNNs) and lot of labeled databases. However, due to difficulty in collecting and labeling SAR images, it is still a challenging task to solve SAR ship detection CNNs. To overcome the problem, some methods have employed conventional data augmentation techniques such as flipping, cropping, and affine transformation, but it is insufficient to achieve robust performance to handle a wide variety of types of ships. In this paper, we present a novel and effective approach for deep SAR ship detection, that exploits label-rich Electro-Optical (EO) images. The proposed method consists of two components: a data augmentation network and a ship detection network. First, we train the data augmentation network based on conditional generative adversarial network (cGAN), which aims to generate additional SAR images from EO images. Since it is trained using unpaired EO and SAR images, we impose the cycle-consistency loss to preserve the structural information while translating the characteristics of the images. After training the data augmentation network, we leverage the augmented dataset constituted with real and translated SAR images to train the ship detection network. The experimental results include qualitative evaluation of the translated SAR images and the comparison of detection performance of the networks, trained with non-augmented and augmented dataset, which demonstrates the effectiveness of the proposed framework.

• Journal of Fisheries and Marine Sciences Education
• /
• v.28 no.5
• /
• pp.1308-1318
• /
• 2016

In order to prevent the maritime accident, all seafarers who work on fishing vessels over G/T 20 tons are required to undergo the basic safety training by the Seafarer's Act. 45% of domestic crews have boarded on the fishing vessels. However, the fishermen have been trained in accordance with the STCW(International convention on standards of training certification and watch-keeping for seafarers) Convention. But safety training courses for seaman do not reflect on the safety equipment and the limitation of the fishing vessel in the training contents which is organized in accordance with the merchant ship by STCW convention and code. Most of the fishing vessels are small fishing boat of less than G/T 80 tons. Small fishing vessels are operating with only a minimum of safety equipment that has been defined by the fishing vessel safety equipment standard. Due to the safety training that does not fit the situation of the fishing boat, the level of satisfaction by the crews onboard is low for the training. Furthermore, there is a difficulty in achieving the goal of safety education. In order to carry out the safety training that is suitable for fishermen, it is required to provide appropriate standards for the safety education of workers of small fishing boat, by understanding the current state of the domestic fishing vessels. The purpose of this study is to define the aforementioned problems and to provide the standard for the safety education of fishermen. In order to complete the purpose, the research team has conducted a analyzation for registered domestic fishing vessel and safety equipment standard.

• Journal of Fisheries and Marine Sciences Education
• /
• v.29 no.1
• /
• pp.137-147
• /
• 2017

An accident during pilotage may cause several problems such as crippling the harbour function, environmental disruption, loss of life. Since the pilot plays an important role in the safe operation of the port, securing their safety is directly connected to the vessel's safety coming into port in Korea. Pilotage service is offered on request without distinction of day and night. And traveling by helicopter and boarding/disembarking using a pilot ladder from and to a pilot boat have a high risk of falling into the sea. So, pilots can fall into the sea while boarding/disembarking from ship which can lead to serious injury by cardiac arrest. A number of pilots have died or severely injured due to fall from the pilot ladder during embarkation and disembarkation up to now. Current safety measures at embarkation and disembarkation required by pilotage act and IMO resolutions could not prevent all the pilot related accidents. Therefore, to prevent pilot accident during boarding/disembarking from ship, it is necessary to include safety training requirement for new pilots under the requirements for licensing of pilotage act. It is also necessary to compel pilots to take necessary personal protective equipment when they use a pilot ladder. In addition, the placement of emergency kit on pilot boats and first-aid training are required in order to deal with emergency situation promptly.