• Journal of the Korean Society for Marine Environment & Energy
• /
• v.4 no.1
• /
• pp.38-46
• /
• 2001

To assess the oil-containment effectiveness of tandem oil fences placed in currents, the movement of oil droplets in the fore and aft region of the fences is investigated by experimental and numerical methods. The effect of the flexibility of the fence skirt of single fence on the fence effectiveness is also investigated. Laboratory experiment is conducted to trace the path of a spherical solid particle of equivalent density to an oil droplet which was released in a uniform stream ahead of a model oil fence. Depending upon the releasing position and the flow condition there, it was observed that the particle floated up to the free surface, collided with the fence, or escaped below the fence. By analyzing the droplet trajectories, a numerical method is developed to predict the region ahead of the fore fence where an oil droplet initiating its motion eventually escapes beneath the fence. The effect of the relative sizes of the drafts of the fore and aft fences, the fence separation, and the bottom depth of the sea bed on the effectiveness of tandem fences is investigated using the numerically obtained trajectories of oil droplets.

• Journal of the Korean earth science society
• /
• v.26 no.8
• /
• pp.800-808
• /
• 2005

Elemental mobility during the weathering of granite in the Gwangju Hyangdeung area was investigated using ICP-MS analysis. It appeared that Al, Fe, Ti, K were lost from the profile, whereas Si, Ca, Na Mg, P and Mn were immobile during chemical weathering. In less weathered soil, large enrichment of K and Ti were found relative to Al, whereas other elements such as Si, Ca, Na, Mg and P are deplete. Fe content is constant throughout the weathered profiles. Amounts of Rb, Sr, Y, Cs, Pb, Th and U increased toward the surface. Nb, and Co have accumulated in the deepest parts of the weathered soil profile. These results agree with similar published studies. In addition, the analytical data shows that Ba and Ga increased, while Cu, Zn, Cr and Ni were relatively constant in this area. REE tend to increase in most samples, while LREEs, relative to Al, were enriched in the lower and upper saprolite. HREEs were enriched in the lower and upper saprolite.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.32 no.4
• /
• pp.28-38
• /
• 2004

Korean goral (Nemorhaedus caudatus raddeanus) is one of the endangered species in Korea, and the rugged terrain of the Soraksan National Park (373㎢) is a critical habitat for the species. But the goral population is threatened by habitat fragmentation caused by roads and hiking trails. The objective of this study was to develop a potential habitat suitability model for Korean goral in the park, and the model was based on the concepts of fuzzy set theory and multi-criteria evaluation. The process of the suitability modeling could be divided into three steps. First, data for the modeling was collected by using field work and a literature survey. Collected data included 204 points of GPS data obtained through a goral trace survey and through the number of daily visitors to each hiking trail during the peak season of the park. Second, fuzzy set theory was employed for building a GIS data base related to environmental factors affecting the suitability of the goral habitat. Finally, a multiple-criteria evaluation was performed as the final step towards a goral habitat suitability model. The results of the study were as follows. First, characteristics of suitable habitats were the proximity to rock cliffs, scattered pine (Pinus densiflora) patches, ridges, the elevation of 700∼800m, and the aspect of south and southeast. Second, the habitat suitability model had a high classification accuracy of 93.9％ for the analysis site, and 95.7％ for the validation site at a cut off value of 0.5. Finally, 11.7％ of habitatwith more than 0.5 of habitat suitability index was affected by roads and hiking trails in the park.

• Journal of the Korean Society of Costume
• /
• v.60 no.10
• /
• pp.100-117
• /
• 2010

This thesis has three main purposes: first, will show kinds, patterns, types, expression techniques of modern korean women's trimmings by every ten years. Second, it is to trace the effect of each decade on women's Hanbok trimming designs. Third, it will point out factors. that caused the change of modern Korean women's Hanbok trimming design patterns. Henceforth, there comes the result of the research and analysis. Trimming design patterns of modern women's Hanbok can be divided into three categories temporally: The first period of from 1910s to the first half of 1950s saw that design patterns did not changed much from traditional ones. It is because there were many catastrophes such as the invasion of Japanese Empire and Korean War. The compound design had expressed people's wish to earn many sons and babies at the end of Joseon Dynasty. But it turned to wishing luck for individuals affected by individualism and liberalism imported from the west. Realistic designs are the most frequently used and the least lines made up patterns. The second period of from the latter half of 1950s to 1970s saw that women wore their Jeogories and Chimas as suits. Screen printing technique enabled for various design patterns to come out. And the development of textile industry introduced various expression techniques such as making lace, meshing, flocking, burn-out etc cetera. The third period of 1980s saw that Hanbok became a kind of luxurious clothe as people's living standard rose. Hanbok again came into the spotlight, Hanbok designers came forward and their individualities are respected. The characteristic expression technique of grey-dying and geometric design patterns are more frequently used for the simple and modern beauty.

• Geophysics and Geophysical Exploration
• /
• v.10 no.2
• /
• pp.131-137
• /
• 2007

With consideration of the first arrival picking methodology and inherent errors in picking process, I propose, from the computerization point of view, a practical algorithm for picking and error computation. The proposed picking procedure consists of 2-step; 1) picking the first coherent peak or trough events, 2) derive a line which approximates the record in the interval prior to the pick, and set the intercept time of the line as the first break. The length of fitting interval used in experiment, is few samples less than 1/4 width of the arriving wavelet. A quantitative measure of the error involved in first arrival picking is defined as the time length that needed to determine if an event is the first arrival or not. The time length is expressed as a function of frequency bandwidth of the signal and the S/N ratio. For 3 sets of cross-well seismic data, first breaks are picked twice, by manually, and by the proposed method. And at the same time, the error bound for each trace is computed. Experiment results show that good performance of the proposed picking method, and the usefulness of the quantitative error measure in pick-quality evaluation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.14 no.2
• /
• pp.171-181
• /
• 2002

Among various numerical methods of wave transformations including wave breaking by structure, models using VOF(Volume Of Fluid) method to trace free surface are getting into the spotlight recently. In order to analyze wave transformations and velocity of the wave fields due to the permeable submerged breakwater(PSB), This study applied VOF method to the two-dimensional wave channel installed line-source to generate waves and added dissipation zone to offer a non-reflective boundary. Hydraulic experiments was performed to obtain the application of two-dimensional numerical wave channel. The results of numerical experiments using the two-dimensional wave channel agree well with the experimental data. It was shown that vortices are formed behind the PSB, and in case of the 2-rowed PSB they also are occurred in between PSBs, strongly non-linear waves are developed on the crown of the PSB, and the direction of velocities in porous media is determined by the shape of free surface.

• Journal of Hydrogen and New Energy
• /
• v.21 no.5
• /
• pp.425-434
• /
• 2010

Integrated gasification combined cycle (IGCC) is an efficient and environment-friendly power generation system which is capable of burning low-ranked coals and other renewable resources such as biofuels, petcokes and residues. In this study some process modeling on a conceptual entrained flow gasifier was conducted using the ASPEN Plus process simulator. This model is composed of three major steps; initial coal pyrolysis, combustion of volatile components, and gasification of char particles. One of the purposes of this study is to develop an effective and versatile simulation model applicable to numerous configurations of coal gasification systems. Our model does not depend on the hypothesis of chemical equilibrium as it can trace the exact reaction kinetics and incorporate the residence time calculation of solid particles in the reactors. Comparisons with previously reported models and experimental results also showed that the predictions by our model were pretty reasonable in estimating the products and the conditions of gasification processes. Verification of the accuracy of our model was mainly based upon how closely it predicts the syngas composition in the gasifier outlet. Lastly the effects of change oxygen are studied by sensitivity analysis using the developed model.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.22 no.3
• /
• pp.341-346
• /
• 2012

In rehabilitation where ultrasonographic diagnosis is not popular, it could be subjective by medical expert's experience. Thus, it is necessary to develop an objective automative procedure in ultrasonic image analysis. A disadvantage of existing automative analytic procedure in musculoskeletal system is to designate an incorrect muscle area when the figure of fascia is vague. In this study, we propose a new procedure to extract more accurate muscle area in abdomen ultrasonic image for that purpose. After removing unnecessary noise from input image, we apply End-in Search algorithm to enhance the contrast between fascia and muscle area. Then after extracting initial muscle area by Up-Down search, we trace the fascia area with a mask based on morphological and directional information. By this tracing of mask movements, we can emphasize the fascia area to extract more accurate muscle area in result. This new procedure is proven to be more effective than existing methods in experiment using convex ultrasound images that are used in real world rehabilitation diagnosis.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.3
• /
• pp.609-616
• /
• 2014

Large linear span makes difficult to predict, so this study is important to the security and code system. It has been studied about the non-linear binary sequences having low correlation values and large linear span. In this paper we analyze the linear span of $S^r_a(t)=Tr^m_1\{[Tr^n_m(a{\alpha}^t+{\alpha}^{dt})]^r\}$ ($a{\in}GF(2^m)$, $0{\leq}t{\leq}2^m-2$) where n=2m and $d=2^{m-2}(2^m+3)$.

• Journal of the Korean Professional Engineers Association
• /
• v.28 no.5
• /
• pp.12-19
• /
• 1995

Korean fresh elephant -foot (Amorphophalus Konjak K. Koch) and its powder were analyzed and compared with foreign samples for the purpose of investigating the physico -chemical characteristics of Korean konjak. The Korean fresh konjak contains 80.64% of moisture and most of the solid component comprises sugar, protein and trace of fat and fibre. The mannan content of Korean konjak powder is far smaller than those of Japanese and Chinese konjak powder. The analysis of the korean konjak protein tells that 45% of glutamic acid, aspartic acid and argi-nine is included other remaining amino acid is larger with the order of valine, serine, leucine, and gly-cine. The Korean konjak contains a moderate amount of K component and other inorganic component increases with the order of P Na and Ca. The yield of konjak refined powder from dried chip was 61% and 51.5% of korean and chinese re-spectively. The whiteness degree of chinese konjak powder was slightly higher than that of korean product but the difference could not be recognized by the naked eye.