• Asian-Australasian Journal of Animal Sciences
• /
• v.17 no.12
• /
• pp.1647-1651
• /
• 2004

The follicles (1.8 to 7.8 mm in diameter) were recovered from the ovaries in marketed pigs and the number of granulosa cells, the diameter of oocytes obtained from different development stages of the follicles and follicular fluid levels were determined. Correlations between size measurements and cell counts as well as the diameter of antral follicles and oocytes were also investigated. The results indicated that, while expanding in size, follicle numbers decreased with a greater atretic proportion. Granulosa cells increased in numbers continuously and remained unchanged beyond the size of 200 ${mm}^3$ in non-atretic follicles, whereas a sudden drop of granulosa counts was observed in atretic follicles. Follicular fluid, on the other hand, linearly increased its volume with follicle size and differed little between those of non-atretic and atretic follicles. Diameters of oocytes in non-atretic follicles increased to its maximum when follicles expanded to 150 ${mm}^3$ and maintained its size during later follicular expansion. It is concluded that, for in vitro culture, the optimal size of porcine follicle should be between 150 to 180 ${mm}^3$if they are collected from pre-pubertal gilts of marketing size slaughtered in an abattoir.

• Journal of Korean Society for Atmospheric Environment
• /
• v.14 no.3
• /
• pp.229-236
• /
• 1998

Visibility is a good indicator of comprehensive alto quality. The prevailing visibility in Seoul is no better than the past although the average concentration of SO2 and TSP (total suspended particulate) has decreased quite significantly in the past decade, owing to the government efforts to reduce the emission. Then, a question arises why visibility has not been improved. In order to answer this question we have investigated which components of air pollutants are most responsible for the visibility degradation in Seoul. Analysis on the visibility vs the aerosol sixte distribution measured by an optical particle counter shows that the particles of the size interval between 0.5mm and 2.5mm are most responsible for the visibility degradation. Among the criteria air Pollutants, NOB concentration is found to be moot responsible, rather than PM10. ton analysis of the particulate collected by a high volume sampler shows that the nitrate component increases more significantly than other ions when visibility becomes very poor. Therefore, we conclude that the major causes of visibility degradation in Seoul are the increase of NOB, nitrates and the particles of the size range between 0.5mm and 2.5mm.

• Journal of Powder Materials
• /
• v.21 no.1
• /
• pp.50-54
• /
• 2014

A powder-in-sheath rolling method was applied to a fabrication of a carbon nano tube (CNT) reinforced aluminum composite. A STS304 tube with an outer diameter of 34 mm and a wall thickness of 2 mm was used as a sheath material. A mixture of pure aluminum powders and CNTs with the volume contents of 1, 3, 5 vol was filled in the tube by tap filling and then processed to 73.5% height reduction by a rolling mill. The relative density of the CNT/Al composite fabricated by the powder-in-sheath rolling decreased slightly with increasing of CNTs content, but exhibited high value more than 98. The grain size of the aluminum matrix was largely decreased with addition of CNTs; it decreased from $24{\mu}m$ to $0.9{\mu}m$ by the addition of only 1 volCNT. The average hardness of the composites increased by approximately 3 times with the addition of CNTs, comparing to that of unreinforced pure aluminum. It is concluded that the powder-in-sheath rolling method is an effective process for fabrication of CNT reinforced Al matrix composites.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2011.11a
• /
• pp.211-212
• /
• 2011

It was very important to evaluate concrete experimentally at elevated temperature because concrete was filled with aggregate of concrete volume about 70 percent. Concrete exposure to high temperatures produces changes in its internal structure, for instance loss of its strength and deformation capacity, in extreme cases risking the service life of the structure. The work of this paper is performed to evaluate the thermal behavior of ultra-high strength concrete having different water to cement ratio (strength), fine aggregate to aggregate ratio and maximum size of coarse aggregate. For exposure to 500℃ during 1 hour, residual mechanical properties of the ultra-high strength concrete decreased as the s/a ratio decreases and the maximum size of coarse aggregate increases.

• Korean Journal of Materials Research
• /
• v.27 no.4
• /
• pp.184-191
• /
• 2017

This present study deals with the effect of micro-alloying elements and transformation temperature on the correlation of microstructure and tensile properties of low-carbon steels with ferrite-pearlite microstructure. Six kinds of low-carbon steel specimens were fabricated by adding micro-alloying elements of Nb, Ti and V, and by varying isothermal transformation temperature. Ferrite grain size of the specimens containing mirco-alloying elements was smaller than that of the Base specimens because of pinning effect by the precipitates of carbonitrides at austenite grain boundaries. The pearlite interlamellar spacing and cementite thickness decreased with decreasing transformation temperature, while the pearlite volume fraction was hardly affected by micro-alloying elements and transformation temperature. The room-temperature tensile test results showed that the yield strength increased mostly with decreasing ferrite grain size and elongation was slightly improved as the ferrite grain size and pearlite interlamellar spacing decreased. All the specimens exhibited a discontinuous yielding behavior and the yield point elongation of the Nb4 and TiNbV specimens containing micro-alloying elements was larger than that of the Base specimens, presumably due to repetitive pinning and release of dislocation by the fine precipitates of carbonitrides.

• Journal of Physiology & Pathology in Korean Medicine
• /
• v.16 no.5
• /
• pp.893-898
• /
• 2002

Citri Reticulatae Viride Pericarpium extract(CRVP) have been used in oriental medicine for many centuries as a therapeutic agent for smoothing the liver and regulating the circulation of qi, and promoting digestion and removing stagnated food. The effects of CRVP on the inhibition of brain damage in cerebral ischemia is not known. Therefore, this Study was designed to investigate the cerebral protective effects of CRVP on the transient cerebral ischemia using modern techniques, and further to provide the possibility of scientification of oriental medicine. The size of cerebral infarct size was measured by morphometry, and brain edema was measured by morphometry and brain water content determination. The results were a$ follows ; 1. Water fraction of CRVP was reduced infect area of rats brain slices which were subjected to a transient cerebral ischemia in a dose-dependent manner. 2. Methylene chloride fraction and hexane fraction of CRVP was significantly reduced infarct area of rats brain slices which were subjected to a transient cerebral ischemia in a dose-dependent manner. 3. Methylene chloride fraction and hexane fraction of CRVP was significantly reduced infarct volume of rats brain which was subjected to a transient cerebral ischemia in a dose-dependent manner. 4. Methylene Chloride fraction and hexane fraction of CRVP was significantly decreased brain edema induced by a transient cerebral ischemia in a dose-dependent manner. 5. Methylene chloride fraction and hexane fraction of CRVP was significantly decreased brain water content of rats which were subjected to a transient cerebral ischemia. It is suggested that CRVP has an anti-ischemic effect through the inhibition of brain damage in a transient cerebral ischemia, and that in future further development of main effective constituent in CRVP can provide a novel therapeutic strategy for cerebral ischemia.

• Journal of Industrial Technology
• /
• v.23 no.A
• /
• pp.199-206
• /
• 2003

The charcoal-encapsulated methyl silica microcapsules were prepared by a O/W microemulsion sol-gel method, and the adsorption properties on aquatic humic acid were investigated. The capsules prepared were spherical, $100{\sim}1000{\mu}m$ in size. The size distribution was controllable by adjusting the size of charcoal powder, charcoal/methyl silica ratio, and agitating speed in O/W sol-gel process. Adsorption efficiency of charcoal for aquatic humic acid was decreased after encapsulation by methyl silica shell. The decreased adsorption efficiency can be dependent on the decrease of the BET surface area and pore volume after encapsulation. Diffusion properties of humic acid through the capsule shell also played an important role on adsorption efficiency. Therefore, the reasonable target pollutants for the capsules can be VOC or odor molecules which can overcome diffusion barrier through shell of capsules in air condition. Functionalization methods for the charcoal-encapsulated $CH_3(SiO)_n$ microcapsules by incorporation of $TiO_3$ as a phtocatalytic function and by incorporation of inorganic pigment as a color function were also investigated. $TiO_2$ coating properties were controllable by adjusting pH, temperature, and the concentration of $TiOSO_4$. In XRD measurement, the crystal form of the coated $TiO_2$ was anatase. For the colorization of the capsules, inorganic pigments were more efficient than organic dyes, and various color was introduced to the capsules using inorganic pigments.

• Journal of Korean Neurosurgical Society
• /
• v.65 no.5
• /
• pp.741-750
• /
• 2022

Objective : In March 2020, World Health Organization declared a global pandemic caused by a novel coronavirus (SARS-CoV-2). The disease caused by this virus is called COVID-19. Due to its high contagiousness, many changes have occurred in overall areas of our daily life including hospital use by patients. The aim of this study was to investigate the impact of COVID-19 on volume of spine surgery in South Korea using the National Health Insurance database and compare it with the volume of a homologous period before the pandemic. Methods : Data of related to spine surgery from January 2019 to April 2021 were obtained from the National Health Insurance and Health Insurance Review and Assessment Service database. Primary outcomes were total number of patients, rate of patients per 100000 population, and total number of procedures. The number of patients by hospital size was also analyzed. Results : COVID-19 outbreaks occurred in South Korea in March, August, and December of 2020. Compared to the previous year, the total number of patients who underwent spinal surgery showed a decrease for 2-3 months after the first and second outbreaks. However, it showed an increasing trend after the third outbreak. The same pattern was observed in terms of the ratio of the number of patients per 100000 population. Between 2019 and 2021, the mean number of spine surgeries per month tended to increase. Mean annual medical expenses increased over the years (p=0.001). When the number of spine surgeries was analyzed by hospital size, proportion of tertiary general hospital in 2021 increased compared to those in 2019 and 2020 (vs. 2019, p=0.012; vs. 2020, p=0.016). The proportion of general hospital was significantly decreased in 2020 compared to that in 2019 (p=0.037). Conclusion : After the COVID-19 outbreak, patients tended to postpone spinal surgery temporarily. The number of spinal surgeries decreased for 2-3 months after the first and second outbreaks. However, as the ability to respond to the COVID-19 pandemic at the hospital and society-wide level gradually increased, the number of spine surgeries did not decrease after the third outbreak in December 2020. In addition, the annual number of spine surgeries continued to increase. However, it should be noted that patients tend to be increasingly concentrated in tertiary hospitals for spinal surgery.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.3
• /
• pp.408-415
• /
• 2014

In order to prepare high-quality activated carbons (ACs), coal tar pitch (CTP), and mixtures of CTP and petroleum pitch (PP) were activated with KOH. The ACs prepared by activation of CTP in the range of $700{\sim}1000^{\circ}C$ for 1~5 h had very porous textures with large specific surface areas of $2470{\sim}3081m^2/g$. The optimal activation conditions of CTP were determined as CTP/KOH ratio of 1:4, activation temperature of $900^{\circ}C$, and activation time of 3 h. The obtained AC showed the highest micro-pore volume, and pretty high specific surface area and meso-pore volume. The micro-pore volumes and specific areas of activated mixtures of CTP and PP were similar to each other but the meso-pore volume could be increased. In order to change the degree of crystallinity of precursors before KOH activation process, the CTPs were carbonized in the range of $500{\sim}900^{\circ}C$. As the carbonization temperature increased, the specific surface area and pore volume of the activated ACs with the same activation conditions for CTP decreased dramatically. It was demonstrated that the increased pore size distribution of AC electrodes in the range of 1 to 2 nm plays an important role in the performance of electric double-layer capacitor.

• Archives of Plastic Surgery
• /
• v.34 no.6
• /
• pp.685-690
• /
• 2007

Purpose: Numerous materials, both autologous and nonautologous, have been used for augmentation of sunken areas and each has its own limitations. The ideal material for augmentation should not be absorbed in any manner. This study is designed to assess the survival of $SureDerm^{(R)}$, $Permacol^{(R)}$ graft according to the volume and histologic change. Methods: Twenty four mice, weighing about 50 grams and of 5 weeks of age were used. $SureDerm^{(R)}$ is an acellular dermal matix obtained from human cadeveric skin. $Permacol^{(R)}$ is a porcine derived acellular dermal matrix whose manufacture involves trypsinisation, solvent extraction. Graft pieces standardized to $1{\times}1cm$ size were used in each group. The implanted material were taken 1, 4, 8 and 12 weeks later, respectively. The changes of graft volume during the graft period were measured on initial, 1, 4, 8 and 12 weeks. Results: The initial shape of graft was maintained up to 12 weeks in $Permacol^{(R)}$ graft group and mean survival rate was $80.36{\pm}8.21%$ in $SureDerm^{(R)}$, $89.57{\pm}6.39%$ in $Permacol^{(R)}$(p=0.01). The volume of each graft decreased 29% from initial volume on 12 weeks in $SureDerm^{(R)}$, 18% in $Permacol^{(R)}$. The structure of $Permacol^{(R)}$ remained until 12 week after implantation. Conclusion: Our experimental study suggests that $Permacol^{(R)}$ could be a safe material as an implant for permanent augmentation. However, There are further study remained for antigenicity of these material, and the choice of graft for augmentation should be remained to the clinical situations.