• Korean Journal of Food Science and Technology
• /
• v.34 no.5
• /
• pp.919-923
• /
• 2002

'Manita', a red pepper cultivar, and 'HL', a cultivar bred for single-harvest by National Horticultural Research Institute, were cultivated using direct sowing method, and all fruits were harvested five times at on interval of one week, and were grouped into five grades by color and appearance (drying degree). The amount of red fruits increased gradually with increasing harvest time, and at the fifth harvest time, the ratios of red fruits were 80.9 and 79.1% for Manita and HL, respectively. Among red fruits, the portion of ROO grade (red pepper dried considerably on the plant) was 42.9%, RO (red pepper dried partially on the plant) 31.9%, and RF (fresh red pepper) 6.1% for Manita. For HL, the portions of RO and RF were 56.7 and 22.4%, respectively. As fruits aged, the redness intensified. ROO, RO, and RF fruits had ASTA color values of 150.4, 140.1, and 107.4 for Manita, and for HL, those of RO and RF were 100.0 and 77.1, respectively. The contents of capsaicinoids, organic acid, and sugar were not significantly different with the harvest time.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.9
• /
• pp.848-852
• /
• 2008

Characteristics of microcrystalline-silicon thin-films deposited by plasma-enhanced chemical-vapor deposition (PECVD) method were studied. There were optimum values of RF power density and $H_2$ dilution ratio $(H_2/(SiH_4+H_2))$; maximum grain size of about 35 nm was obtained at substrate temperature of 250 $^{\circ}C$ with RF power density of 1.1 W/$cm^2$ and $H_2$ dilution ratio of 0.91. Larger grain was obtained with higher substrate temperature up to 350 $^{\circ}C$. Grain size dependence on RF power density and $H_2$ dilution ratio could be explained by etching effects of hydrogen ions and changes of species of reactive precursors on growing surface. Surface-mobility activation of reactive precursors by temperature could be a reason of grain-size dependence on the substrate temperature. Microcrystalline-silicon thin-films that could be used for flat-panel electronics such as active-matrix organic-light-emitting-diodes are expected to be fabricated successfully using these results.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.173-180
• /
• 2015

In this study, an algorithm that detects a spoofing signal for a GPS L1 signal was proposed, and the performance was verified through RF spoofing signal simulation. The proposed algorithm determines the reception of a spoofing signal by detecting a correlation distortion of GPS L1 C/A code caused by the spoofing signal. To detect the correlation distortion, a detection criterion of a spoofing signal was derived from the relationship among the Early, Prompt, and Late tap correlation values of a receiver correlator; and a detection threshold was calculated from the false alarm probability of spoofing signal detection. In this study, an RF spoofing environment was built using the GSS 8000 simulator (Spirent). For the RF spoofing signal generated from the simulator, the RF spoofing environment was verified using the commercial receiver DL-V3 (Novatel Inc.). To verify the performance of the proposed algorithm, the RF signal was stored as IF band data using a USRP signal collector (NI) so that the data could be processed by a CNU software receiver (software defined radio). For the performance of the proposed algorithm, results were obtained using the correlation value of the software receiver, and the performance was verified through the detection of a spoofing signal and the detection time of a spoofing signal.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.4
• /
• pp.602-607
• /
• 2006

In this paper, the distributed network synthesis, which is useful to the design of wireless power amplifiers, is proposed, and a RF power amplifier is designed using the technique. The transfer function of distributed matching circuits is derived by Chebyshev approximation, and network element values for a specified topology are given as a function of minimum insertion losses and ripples. As an example, after a power transistor is modeled by load-pull data, the synthesis for distributed matching networks is applied to a power amplifier design, which has the electrical performance of 17dB gain and less IM3 than -43dBc at the 20W output power between 800 to 900MHz frequency range. Experimental results from a fabricated amplifier are shown to approach the design performance in the operating frequency range. The design of impedance matching networks by the transfer function synthesis is a useful method for the design of RF power amplifiers.

• Korean Journal of Materials Research
• /
• v.4 no.7
• /
• pp.783-791
• /
• 1994

Piezoelectric ZnO thin films were deposited on 7059 glass substrate by rf magnetron sputtering. The effects of deposition parameter, such as rf power, gas pressure and $O_{2}$/Ar gas ratio, on the crystallinity and electrical properties of the deposited ZnO thin films were studied. It was found that the deposition rate was higher than the previously reported values. ZnO films were suitable for SAW filter since a standard deviation of XRD (002) peak rocking curve was less than $6^{\circ}$. ZnO thin films, which were deposited at $O_{2}$/Ar ratio larger than 25%, showed high resistance. SAW filter was fabricated using ZnO film, of which thickness was 0.25 of the wavelength of the propatating surface acoustic wave. The measured frequency response was consistent with the calculated one. The SAW filter had center frequency 39.08 MHz, phase velocity 2501 m/sec and insertion loss 29 dB.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.51 no.4
• /
• pp.282-286
• /
• 2006

The effect of biofertilizer (compound of microbial inoculants or groups of micro-organisms) on growth and yield of rice was investigated. The experiment was carried out in a randomized complete block design with 3 replications and 7 treatments namely: $RF=N-P_2O_{5-}K_2O$ (11-5.5-4.8 kg $10a^{-1}$); half of the recommended fertilizer rate, $HRF=N-P_2O_5-K_2O$ (5.5-2.75-2.4 kg $10a^{-1}$); HRF+Bio 250=HRF combined with 250 kg biofertilizer $10a^{-1}$; HRF+Bio 500=HRF combined with 500 kg biofertilizer $10a^{-1}$; Bio 250=250 kg biofertilizer $10a^{-1}$; Bio 500=500 kg biofertilizer $10a^{-1}$; and NF = No Fertilizer. Results showed that the recorded values of plant height, tiller number and chlorophyll content at 40 to 60 days after transplanting (DAT) in HRF+Bio 500 were significantly higher than those recorded in the RF treatment. Similar observations between these two treatments were only recorded from 60 DAT onwards. Yield components were also superior in HRF+Bio 500 treatment and comparable to that of RF. The highest grain yield obtained in HRF+Bio 500 treatment (785.8 kg $10a^{-1}$) was statistically similar to that of RF (739.8 kg $10a^{-1}$) but significantly higher than that of NF (506.7 kg $10a^{-1}$). Finally, head grain recovery (90.9) was low while chalkiness (0.03) was high at HRF+Bio 500 treatment as compared with RF, which were (96.1) and (0.3), respectively. Results showed that combined treatment of HRF and 500 kg biofertilizer $10a^{-1}$ has similar effects on the growth and yield of rice with that of RF.

• Korean Journal of Environmental Agriculture
• /
• v.21 no.1
• /
• pp.7-16
• /
• 2002

Contamination of groundwater by agrochemicals used in the regional-scale Is now a major environmental problem, and this is especially true for Cheju island where virtually all potable water is from groundwater. The objective of this study was to assess leaching potential of eight pesticides in soils of citrus orchards using groundwater ubiquity score (GUS), retardation factor (RF) and attenuation factor (AF). Considering GUS estimated in 30 citrus orchard soils, metribuzin and metolachlor were classified as leacher, alachlor in volcanic ash soils and linuron in non-volcanic soils were classified as leacher, but chlorothalonil and chlorpyrifos were classified as non-leacher. For RF values, metribuzin was classified to be mobile in soils of low organic carbon, metolachlor and alachlor were classified to be moderately immobile in most soils, but linuron, diuron, diniconazole, chlorothalonil and chlorpyrifos were all classified to be very immobile. For AF values, diniconazole, chlorothalonil, and chlorpyrifos were classified to be very unlikely leachable in all of the soils, metribuzin was classified to be likely leachable, and metolahclor, alachlor, linuron and diuron were classified to be leachable only in non-volcanic soils. Although there were some variations in the relative potential of teachability of pesticides estimated with the three different indices, the ranking was essentially determined on the base of the intrinsic properties of the chemicals and environmental properties. Among the eight pesticides, metribuzin, metolachlor, and alachlor, which have high water solubility and low $K_{oc}$ values, have a significant leaching potential especially in non-volcanic ash soils of low organic carbon. But diniconazole, chlorothalonil, and chlorpyrifos, which have low water solubility and high $K_{oc}$ values, were classified to be very immobile in all of the soils. Therefore, to lower the possibility of pesticide contamination of the groundwater in Cheju island, those pesticides which have high water solubility and low $K_{oc}$ values should be used with care in soils of low organic carbon including non-volcanic ash soils.

• Journal of Satellite, Information and Communications
• /
• v.11 no.2
• /
• pp.55-59
• /
• 2016

Conventional RF energy harvesting systems can harvest energy and decode information from same source as an Hybirid-AP (H-AP). However, harvesting efficiency is seriously dependent on distance between users and H-AP. Therefore, in this paper, we proposed a transmission model for RF harvesting consisting of information and power source separately called Decoupled RF Energy harvesting networks. Main purpose of this paper is to maximize energy efficiency under various constraints of transmit power from H-AP and power beacon (PB), minimum quality of service and quality of harvested power of each users. To measure proposed model's performance, we proposed optimal time scheduling algorithms for energy efficiency (EE) maximization using Lagrangian dual decomposition theory that locally maximizes the EE by obtaining suboptimal values of three arguments : transmit power of H-AP, transmit power of PB, frame splitting factor. Experiment results show that the proposed energy-efficient algorithms converge within a few iterations with its optimality and greatly improve the EE compared to that of baseline schemes.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.3
• /
• pp.443-450
• /
• 2021

After selecting a PES substrate with excellent thermal stability and optical properties among plastic substrates, a SiO₂ thin film was deposited as a buffer layer to a thickness of 20nm by plasma-enhanced chemical vapor deposition to compensate for the high moisture absorption. Then, the ITZO thin film was deposited by a RF magnetron sputtering method to investigate electrical and optical properties according to RF power. The ITZO thin film deposited at 50W showed the best electrical properties such as a resistivity of 8.02×10^-4 Ω-cm and a sheet resistance of 50.13Ω/sq.. The average transmittance of the ITZO thin film in the visible light region(400-800nm) was relatively high as 80% or more when the RF power was 40 and 50W. Figure of Merits (Φ_TC and FOM) showed the largest values of 23.90×10^-4 Ω^-1 and 5883 Ω^-1cm^-1, respectively, in the ITZO thin film deposited at 50W.

• PNF and Movement
• /
• v.16 no.1
• /
• pp.125-132
• /
• 2018

Purpose: The aim of this study was to investigate the isolated activation ratio of the quadriceps femoris muscle on different support surfaces during squat exercise. Methods: Twenty participants (10 males and 10 females) voluntarily agreed to participate in the research after receiving an explanation about the purpose and process of the study. Each participant performed squat exercises on three different support surfaces (a flat surface, a form roller, and an unstable surface). Muscle activities of the rectus femoris (RF), vastus medialis (VM), and vastus lateralis (VL) were measured by electromyography. The isolated activation ratio of the quadriceps femoris muscle was calculated using the %isolation formula. Results: For the squat exercise, the %isolation value of the VM was significantly higher on the unstable surface than on the flat surface and form roller. In contrast, the %isolation values for the RF for the squat exercise were significantly higher on the flat surface and form roller than on the unstable surface. There was no significant differences in the %isolation values of the VL on the three different surfaces. Conclusion: The findings indicate that squat exercise on different surfaces results in differential activation of the quadriceps femoris muscle, which suggests that squat exercise on a multi-directional unstable surface could increase the isolated activation ratio of the VM.