• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2006년도 추계학술대회 논문집
• /
• pp.1364-1368
• /
• 2006

By the countermeasure which is caused by with railroad station ground settlement it applied a CGS in each independent foundation. The effectiveness of the ground improvement and the bearing capacity of the compaction pile has been verified by the Cone Penetration Test(CPT) and Load Test. Test result show that penetration resistance and the cone friction force increased a lot and settlement 13.475mm as the standard settlement 40.0mm appeared at below. Also uniaxial compression test result $278kg/cm^2$ as the standard $150kg/cm^2$ appeared far a lot.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2006년도 춘계학술대회 논문집
• /
• pp.360-364
• /
• 2006

Recently KS documents related to lightning protection were revised complying with the requirements of IEC standards. Lightning protection parts are divided three in IEC, those are arrestor(60099), SPD(61643), and protection facilities(62305). According as international standard is applicable in Korea, type tests, routine tests, and acceptance tests shall be made to demonstrate compliance with the relevant standards. KESRI have installed test equipment which is funded by Ministry of Commerce, Industry and Energy fit for lightning surge test form 2002, and we introduce the test equipments in detail.

• 품질경영학회지
• /
• 제25권2호
• /
• pp.15-27
• /
• 1997

This paper describes a highly accelerated life test (HALT, USPCBT) method for rapid qualification testing of STH PWB(Silver Through Hole Printed Wiring Boards). This method was carried out to be an alternative to the present time-consuming standard 1344 hours life testing(THB). The accelerated life test conditions were $121^{\circ}C$/95%R.H. at 50V bias and without bias. Their results are compared with those observed in the standard 1344 hours life test at $40^{\circ}C$/95%R.H. at 50V bias and without bias. The studies were focused on the samples time-to-failure as well as the associated conduction and failure mechanisms. The abrupt drop of insulation resistance is due to the absorption of water vapour. And the continuous drop of insulation resistance is due to the Ag migration. The ratios of time-to-failure of HALT(USPCBT) to THB were 25 and 11 at 50V bias and without bias respectively.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 A
• /
• pp.430-432
• /
• 2004

The standard power system model is needed to test a transmission line protective relay There are two methods to develop a power system model for transmission line protection. First method is based on characteristic power system model, and second method is based on functional power system model. This paper presents a standard power system model for performance test of transmission line protective relay, where the power system model is based on the two methods. And this model is simulated by using RTDS to test a protective relay.

• 대한환경공학회지
• /
• 제27권2호
• /
• pp.191-197
• /
• 2005

Ceriodaphnia dubia를 이용한 새로운 독성시험법인 온도증가 단기독성평가법(ToxTemp, ToxCity test based on TEMPerature control)을 이용하여 농약성분에 대한 민감도를 조사하였다. BPMC, Diazinon, Fenitrothion등 하수의 생물학적 처리에 독성을 나타낼 수 있는 물질들에 대하여 기존의 실험방법인 표준 48시간 독성시험법과 비교했을 때 온도증가법은 $1{\sim}1.5$시간의 짧은 접촉시간에도 농약의 독성을 잘 감지할 수 있음을 알 수 있었다. 또한 중금속, 독성 유기화합물 그리고 농약성분을 비교, 평가했을 때 온도증가법은 1.25시간의 짱은 접촉시간 내에 48시간독성법의 결과와 높은 상관관계를 유지하며 독성을 감지하였다. 염색공단 폐수와 하수 등 실폐수에서의 독성평가능을 검토하기 위하여 활성슬러지를 이용한 질산화율, 산소이용율(OUR)과 C. dubia를 이용한 표준 48시간 독성시험법, 온도증가법을 비교하였다. 그 결과 OUR을 이용한 평가에서는 비교적 높은 질산화율 저해도를 보인 원수에 대해서도 독성민감도가 낮아 현장적용에 한계를 나타낸 반면 C. dubia를 이용한 표준 48시간 독성시험법과 온도증가법은 각기 다른 수준의 독성에 대해 민감하게 차이를 보였으며, 이 두 방법은 질산화율 저해도와 좋은 상관관계를 보였다. 온도증가법은 표준 48시간 독성시험법에 비해 1.5% 정도 민감도가 떨어지지만 현장에서의 신속한 감지가 가능하다는 점에서 현장에서의 질산화 독성진단에 대한 적용가능성이 높음을 보여주었다.

• 말소리와 음성과학
• /
• 제1권2호
• /
• pp.151-162
• /
• 2009

This paper aims to investigate how tensification preference has changed over time and discuss how appropriately tensification preference is reflected in Principles of Standard Pronunciation and Standard Korean Language Dictionary. For this research, a questionnaire survey of tensification preference was conducted. 173 test words were used and 156 native Seoul speakers participated in this survey. The results have shown that tensification preference has gradually increased from older to younger generations. In addition, Principles of Standard Pronunciation and Standard Korean Language Dictionary do not reflect real pronunciation appropriately. Therefore, some ways of incorporating the actual pronunciation of Seoul speakers in the Principles of Standard Pronunciation and the Standard Korean Language Dictionary are suggested.

• 한국CDE학회논문집
• /
• 제9권1호
• /
• pp.19-26
• /
• 2004

It is not possible to exchange parametric information of CAD models based on the current version of STEP (Standard for the Exchange of Product model data). The designer intents are lost during the transfer of CAD models. To resolve this problem, the macro-parametric approach had been proposed. To enable this approach, a set of standard modeling commands has been defined. Errors or missing elements of the standard modeling commands can be discovered by implementing macro-parametric translators. But there is a limit to discover problems only by using translators. This paper proposes a method to verify the standard modeling commands by implementing a geometric modeler. First, each argument of a modeling command is verified. Second, the set of the standard modeling commands is applied to geometric modeling of commercially available product parts. For the geometric modeling, nine test models have been selected.

• 대한음성학회지:말소리
• /
• 제21_24호
• /
• pp.43-89
• /
• 1992

In this thesis, the prominent aspect of word accent in standard Korean is studied by auditory test and acoustic analysis experiment. The definition of 'accent' is, following Hoyoung Lee's discussion(1990), to be described as 'the means whereby a focused part of an utterance is made to stand out in order to concentrate the hearer's attention on it.' That is to say, the ten of 'accent' may be described in terms of phonological phenomenon and the accented syllable can be phonetically prominent as the result of those phonological process. Prosodic features may have different characteristics in different languages whether they contain linguistically important functions or not. Thus the characteristics of word accent in standard Korean will be determined as the content and trait of prosodic features. Following this viewpoint, present study looked over prosodic features which may effect the characteristics of word accent in standard Korean, through systematic experimental procedure. And the result of this experiment has been verified by statistical method, the T-test, for the purpose of identifying the relatedness among prosodic features(parameters). This thesis, therefore, aimed to investigate the intrinsic acoustic and physical qualities of the word accent in standard Korean. Nonsense words composed by 'mal' and 'ma' which can be divided into 'heavy syllable' and 'light syllable' quoted from Hyman(1975) have been classified into 28 types with respect to syllable numbers(2 syl., 3 sy1., 4 syl.) and these words have become the target of auditory test and acoustic experiment. As the result of those experimental Procedures, the word accent in standard Korean may be said that it has a tendency of fixing first two syllables regardless of syllable numbers. The syllable types of HH, HL, LL in the first two syllables may be prominent at first syllable and the type of H may be at second syllable. Various prosodic features(parameters) including duration, intensity, and Fo(purely phonetic terms) were also strengthened in those positions. The result of this experiment can be cleared up like these : 1. The most important feature is proved as 'duration', the feature of intensity resulted in more subsidiary one than the feature of duration. 2. Fo( fundamental frequency) could be observed as having some coherent contour through almost all syllable types(99 ％), that is, in 2 syllable types, it had rising contour, in 2 syllable types, rising-falling contour, and in 4 syllable types, it contained rising-falling-rising contour. The result of auditory test was different with those contour forms of all Fo surveyed. With respect to these results, the discuss for Fo is determined' to be excluded comparing other features. 3. Finally, this thesis resulted in a decision that the word accent in standard Korean may has fixed(somewhat weaker) accent, especially fixed at first two syllables in almost all words. 4. Various kinds of syllable types related with 2,3,4 syllables, therefore, can be reclassified into 4 types of HH, HL, LH, LL following the concept of accent fixing placement(i.e. first two syllables). In these 4 types, the types of HH, HL, LL were prominent at the position of the first syllable , and the type of LH was prominent at the second syllable otherwise.

• 한국산업보건학회지
• /
• 제20권4호
• /
• pp.217-224
• /
• 2010

The purity methods to determine LOD/LOQ using standard deviation of the residual, intercept and blank by IUPAC and ACS describe many of the pitfalls and pose significant challenges to analytical chemists. Therefore, the aim of this study is the development of the simple, easy, convenient and statistically significant method to determine LOD in quantitative analysis of organic solvents by GC. The new approaching method by linearization in the given concentration range used coefficient of variation ; ${\sigma}_{n-1}$/S(standard deviation, ${\sigma}_{n-1}$ and average, S) of sensitivity(Response/concentration). The comparison of results among the purity methods(IUPAC and ACS) and the linearization have been fulfilled the F-test for standard deviations and t-test for LOD range values. The results of F-test and t-test are satisfied within 95 % confidence level, respectably. The LOD values determined by the new procedure are n-Hexane 0.0116 mg/$m^3$, Toluene 0.0807 mg/$m^3$, and o-Xylene 0.0494 mg/$m^3$. Because the standard deviation of the residual, intercept and blank and the slope of calibration curve are not calculated and the new approaching method use the coefficient of variation of sensitivity by linearization, this new method is simple, easy, convenient and statistically significant. In future, many chemical analysts will expect to applicate and routinely use this method in the all quantitative analysis.

• Environmental Analysis Health and Toxicology
• /
• 제21권2호
• /
• pp.173-184
• /
• 2006

From the harmfulness expectation test conducted through a toxicity anticipation program, methylcyclohexane turned out to be harmful and simulative, but no carcinogenicity was anticipated. In a four-hour acute inhalation toxicity test, the result showed that lethal concentration ($LC_{50}$) was 3,750 ppm (15,054 mg/L), which was identified as a harmful substance on the basis of the harmful substance classification standard $2 of the Industrial safety and health law. methylcyclohexane fell under the category $4(2,500 substance from the GHS standard acute toxicity harmfulness classification. Also, from subchronic inhalation toxicity test that included 6 hours a day, five days a week, and for 13 weeks, we could observe weight, activity, long term weight, blood and blood biochemical influence from the exposure of test substance. No-observed effect level (NOEL) was determined below $100{\sim}400ppm$ inboth male and female. This material falls under the Category 2 ($50{\sim}250ppm/6hours/90days$) in the GHS (Globally Harmonized System) standard trace long-term whole body toxicity repeated exposure, and can be classified as a harmful substance in accordance with the Industrial Safety and Health Law harmful substance standard $NOEL{\leq}0.5mg/L/6hr/90day$ (rat).