• E2M - 전기 전자와 첨단 소재
• /
• 제9권3호
• /
• pp.277-283
• /
• 1996

The temperature dependent characteristics of hydrogenerated amorphous silcon thin film transistor (a-Si:H TFT) with a bottom gate of N-Type <100> Si wafer were investigated. Drain current on the hysteresis characteristic curve showed an exponential variation. Hysteresis area of TFT increased with the gate voltage increased and decreased with the small gate voltage. According to the variation of gate voltages, drain current of TFT increased by temperature increase, and hysteresis characteristics mainly depended on the temperature increase. The hysteresis current showed negative characteristics curve over 383K. The hysteresis occurance area and the differences of forward and reverse sweep were increased at the higher temperature. Hysteresis current of I$_{d}$(on/off) ratio decreased at the lower temperature and increased at the higher temperature.e.

• 한국식품영양과학회지
• /
• 제20권3호
• /
• pp.281-283
• /
• 1991

The effect of temperature on hysteresis of rough rice grown in Korea was investigated. The maximum hysteresis effect of Chucheongbyeo paddy rice at 5$^{\circ}C$ amounted to an average 1.7% moisure content. However, their values at $25^{\circ}C$ and 4$0^{\circ}C$ averaged 1.2% and 0.7% moisture, respectively. It may be suggested that the exteents of hysteresis are affected by the temperature of hysteresis are affected by the temperature of adsorption and desorption.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권2호
• /
• pp.156-165
• /
• 1997

D-E hysteresis loops have been measured for the 65/35 mole % copolymer of vinylidene fluoride and trifluoroethylene over wide temperature range. The remanent polarization and the coercive field at room temperature were estimated to be 75 mC/m$^{2}$ and 55 MV/m respectively. D-E hysteresis loops were observed even below the glass transition temperature(-20.deg. C) and the remanent polarization and the coercive field were larger, as the temperature lower. It seems that the remanent polarization and the coercive field depend on the amorphous region as well as crystalline region in this copolymer. And the ferroelectric-to-paraelectric phase transition was observed at 90.deg. C on heating and 80'C on cooling. Double hysteresis loops were observed at the temperature(85.deg. C) of paraelectric phase.

• 설비공학논문집
• /
• 제15권4호
• /
• pp.254-260
• /
• 2003

The boiling characteristics for R134a are studied to clarify the hysteresis at low temperature on enhanced tubes of a flooded evaporator. Initial boiling conditions, refrigerant temperature, and inlet temperature of the chilled water are considered as the key parameters of the experiments. Unlike previous studies of the boiling heat transfer with uniform heat flux and uniform wall temperature, the wall temperature was varied along the tube. In, this study, it was found that the hysteresis of the temperature overshoot (705) at the onset of nucleate boiling initially at the inlet section of the tube. It is also concluded that the abnormal operation can be avoided during the low temperature boiling if the refrigeration system is started with LMTD larger than $3.4^{\circ}C$ at initial stage and larger than $1.0^{\circ}C$ at normal stage.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2002년도 춘계학술대회논문집
• /
• pp.316-322
• /
• 2002

This paper presents the temperature-dependent hysteresis identification of an electro-rheological (ER) fluid under various operating temperatures using the Preisach model. As a first step, polymethylaniline (PMA) particles are prepared and mixed with silicone oil to make an ER fluid. A couette type electroviscometer is then employed to obtain the field-dependent shear stress. In order to show the suitability of the Preisach model to predict a physical hysteresis phenomenon of the ER fluid, two significant properties; the minor loop property and the wiping-out property are experimentally examined under three dominant temperature conditions. Subsequently, the Preisach model fur the PMA-based ER fluid is identified using experimental first order descending (FOD) curves. The effectiveness of the identified hysteresis model is verified in the time domain by comparing the predicted field-dependent shear stress with the measured one under the both specified and unspecified temperatures. In addition, the hysteresis model proposed in this work is compared to Bingham model.

• 한국소음진동공학회논문집
• /
• 제12권8호
• /
• pp.648-656
• /
• 2002

This paper presents the identification of temperature-dependent hysteresis of an electro-rheological (ER) fluid under various operating temperatures using the Preisach model. As a first step, polymethylaniline (PMA) particles are prepared and mixed with silicone oil to make an ER fluid. A couette type electroviscometer is then employed to obtain the field-dependent shear stress. In order to show the suitability of the Preisach model to predict a physical hysteresis phenomenon of the ER fluid, two significant properties; the minor loop property and the wiping-out property are experimentally examined under three dominant temperature conditions. Subsequently, the Preisach model for the PMA-based ER fluid is identified using experimental multiple first order descending (FOD) curves. The effectiveness of the identified hysteresis model is verified in the time domain by comparing the predicted field-dependent shear stress with the measured one under the both specified and unspecified temperatures. In addition, the hysteresis model proposed in this work is compared to Bingham model.

• 환경정책연구
• /
• 제12권2호
• /
• pp.17-32
• /
• 2013

최근 인류가 초래한 지구의 온난화로 인하여 기온이 상승하고 이의 직접적인 반응으로 수온 증가가 감지되고 있다. 기온변화가 하천의 수질과 생태 환경에 미치는 영향을 추정하기 위해서는 수온 상승의 시기와 하천 어종에 대한 이해가 필요한데 이를 위하여 미래의 수온을 예측할 필요가 있다. 이에 하나의 사전연구로서 기온-수온 관계에 대하여 분석해 보았다. 2009년에서 2011년까지 3년 동안 환경부의 수질자동관측소에서 관측한 최소 873개에서 최대 1083개의 일 관측 자료를 바탕으로 자기상관관계와 교차상관관계를 조사해 본 결과 0.9 이상의 높은 상관관계를 보였다. 또 지체시간이 10일 미만에서는 기온의 자기 상관 계수가 수온의 가기 상관 계수보다 더 높은 것으로 나타났다. 관측자료의 이력현상을 분석하기 위하여 상승기와 하강기로 나누었는데, 관측지점에 따라서는 강한 이력현상을 보이는 지점도 발견되었다. 결국 기온-수온 관계를 구축함에 계절적인 이력현상이 고려되어야 정확도를 높일 수 있음을 유추할 수 있다.

• Journal of Information Display
• /
• 제6권4호
• /
• pp.6-10
• /
• 2005

The dependence of hysteresis characteristics in low temperature poly-Si (LTPS) thin film transistors (TFTs) on the gate-source voltage (Vgs) or the drain-source voltage (Vds) bias is investigated and discussed. The hysteresis levels in both p-type and n-type LTPS TFTs are independent of Vds bias but increase as the sweep range of Vgs increases. It has been found that the hysteresis in both p-type and n-type LTPS TFTs originated from charge trapping and de-trapping in the channel region rather than at the source/drain edges.

• 한국초전도ㆍ저온공학회논문지
• /
• 제15권1호
• /
• pp.1-5
• /
• 2013

We transformed the shape of a YBCO sample with striation to reduce hysteresis and ac losses. And we chose several points to analyze in detail and visualized superconducting properties like critical transition temperature, distribution of the magnetic field, distribution of the current density and hysteresis in a non-destructive manner based on Low Temperature Scanning Laser Hall Probe Microscopy (LTSLHPM) to examine the homogeneity of the sample.

• 동력기계공학회지
• /
• 제5권3호
• /
• pp.48-55
• /
• 2001

In many applications. rubber components undergo dynamic stresses or deformations of fairly large magnitude. Since rubbers are not fully elastic, a part of the mechanical energy is converted into heat due to the hysteresis loss. Heat generation without adequate heat dissipation leads to heat build up. i. e. internal temperature rise. The purpose of this paper is to predict temperature rise caused by the hysteresis loss, in a rubber pad subjected to complex dynamic deformation. In this unsteady thermal analysis, the temperature distributions of track components are displayed in contour shapes and the temperature variations of some important nodes are represented graphically with respect to the running time of the tank.