• 한국광학회지
• /
• 제8권5호
• /
• pp.362-365
• /
• 1997

Mach-Zehnder형 외부 광 변조기나 Homodyne 검출기 같은 간섭계 원리를 이용한 장치에서 최대 또는 최소의 광 출력을 유지하도록 두 입력 광 사이의 위상 차를 제어하는 새로운 방법을 제시하였다. 이 방법은 Steepest Descent 알고리즘의 변형된 형태로 Delta Modulation 이론으로 성능을 해석할 수 있다. 이 방법은 기존의 흔들림(dithering) 방법을 적용하기 어려운 저속 펄스가 사용되는 간섭계 장치에도 사용할 수 있다.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2004년도 Proceedings of ISRS 2004
• /
• pp.577-580
• /
• 2004

To overcome with large size noise source distribution network design difficulty in interferometric radiometer system, especially for sub-Y-type array, a new on-board calibration technique using noise re-radiation is proposed in this paper. The suggested calibration technique is using noise re-radiation effect of center antenna after noise source injection from matched load. This approach is especially proper to sub-Y-type array interferometric synthetic aperture radiometer in mm-wave frequency band. Compared with noise injection network of a conventional synthetic aperture radiometer, the system mass, volume, and hardware complexity is reduced and cost-effective. Only one internal noise source, matched load, is used for injection using noise re-radiation technique a small set of sub-Y receiver channels is calibrated. Detailed calibration scenario is discussed and simulation results about noise re­radiation effect are presented.

• 대한원격탐사학회지
• /
• 제16권4호
• /
• pp.355-365
• /
• 2000

The interferometric correlation, or coherence, is calculated to measure the variance of the interferometric phase and amplitude within the neighbourhood of any location within the image at a result of SAR (Synthetic Aperture Radar) interferometric process which utilizes the phase information of the images. The coherence contains additional information that is useful for detecting point targets which change their location in an area of interest (AOI). In this research, a RGB colour composite image was generated with a intensity image (master image), a intensity change image as a difference between master image and slave image, and a coherence image generated as a part of SAR interferometric processing. We developed a technique performing detection of a point target movement using SAR interferometry and applied it to suitable tandem pair images of ERS-1 and ERS-2 as test data. The possibility of change detection of a point target in the AOI could be identified with the technique proposed in this research.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제8권2호
• /
• pp.11-22
• /
• 2000

Holographic interferometric tomography can provide reconstruction of instantaneous three-dimensional gross flow fields. The technique however confronts ill-posed reconstruction problems in practical applications. Experimental data are usually limited in projection and angular scanning when a field is captured instantaneously or under the obstruction of test models and test section enclosures. An algorithm, based on a series expansion method, has been developed to improve the reconstruction under the ill-posed conditions. A three-dimensional natural convection flow around two interacting isothermal cubes is experimentally investigated. The flow can provide a challenging reconstruction problem and lend itself to accurate numerical solution for comparison. The refractive index fields at two horizontal sections of the thermal plume with and without an opaque object are reconstructed at a limited view angle of 80$\circ$. The experimental reconstructions are then compared with those from numerical calculation and thermocouple thermometry. It confirms that the technique is applicable to reconstruction of reasonably complex, three-dimensional flow fields.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집D
• /
• pp.497-502
• /
• 2001

Three-dimensional natural convection from a discrete flush-mounted circular heat source on the bottom of a cubic enclosure was studied by using a holographic interferometric tomography. The heat source was located at the off-center of the bottom plate so that three-dimensional temperature field can be achieved. A set of multidirectional holographic interferogram was recorded by employing a double-reference beam, double-exposure holographic technique in order to eventually reconstruct the temperature fields. The recorded interferometric data appear good enough to be further processed to extract optical pathlength data from them and finally reconstruct the temperature fields. A complete analysis of the temperature fields including the field reconstructions and comparison with thermocouple measurements is underway and will be reported shortly.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 춘계학술대회
• /
• pp.1609-1614
• /
• 2003

In this study, a practical holographic interferometric tomography system, which is instantaneous and non-contact for measuring three dimensional flow field, was developed. The system consists of holographic recording/reconstruction system, fringe analysis code and computational tomography code and it is developed with Gill environment for general users. The developed system was applied to three-dimensional natural convection from a discrete flush-mounted circular heat source on the bottom of a cubic enclosure. The heat source was located at the off-center of the bottom plate so that three-dimensional temperature field can be achieved. A set of multi-directional holographic interferograms was recorded by employing a double-reference beam, double-exposure holographic technique. Optical pathlength data were extracted from the recorded interferometric data and finally three dimensional temperature field inside the cube was reconstructed.

• 한국광학회지
• /
• 제6권4호
• /
• pp.365-372
• /
• 1995

취상변조기나 3*3 광결합기와 같은 특수 광부품을 사용하지 않고도 간섭형 센서의 고감도를 유지할 수 있고, 주변환경의 변화에도 영향을 받지 않는 간섭형 광섬유 센서를 위한 신호처리 기술을 소개하였다. 이 기법은 간섭형 센서의 넓은 다이나믹 레인지와 고감도를 유지한 신호처리를 위해 레이저 다이오드의 주파수 처핑을 이용하며 주변환경의 변화에 의한 측정에러를 보상하기 위해 별도의 간섭계를 기준 간섭계로 사용하였다. 새로운 신호처리 기법을 거울 내장형 Fabry-Perot(FT) 간섭계 온도센서에 적용한 결과 1cm 광섬유 FP 간섭계 센서소자로 부터 $4\times10^{-3\circ}C$(광위상 4.5mrad)의 분해능을 얻었으며 광위상 변화량의 크기가 $\pi$ 이내로 제한되지 않으므로 다이나믹 레인지가 넓은 온도센서의 구현이 가능하였다.

• 대한원격탐사학회지
• /
• 제26권3호
• /
• pp.335-346
• /
• 2010

Recently, ESA (European Space Agency) has launched CryoSAT-2 for polar ice observations. CryoSAT-2 is equipped with a SIRAL (SAR/interferometric radar altimeter), which is a high spatial resolution radar altimeter. Conventional altimeters cannot measure a precise three-dimensional ground position because of the large footprint diameter, while SIRAL altimeter system accomplishes a precise three-dimensional ground positioning by means of interferometric synthetic aperture radar technique. In this study, we developed an efficient SIRAL SARIn mode processing technique to measure a precise three-dimensional ground position. We first simulated SIRAL SARIn RAW data for the ideal target by assuming the flat Earth and linear flight track, and second accessed the precision of three-dimensional geopositioning achieved by the proposed algorithm. The proposed algorithm consists of 1) azimuth processing that determines the squint angle from Doppler centroid, and 2) range processing that estimates the look angle from interferometric phase. In the ideal case, the precisions of look and squint angles achieved by the proposed algorithm were about -2.0 ${\mu}deg$ and 98.0 ${\mu}deg$, respectively, and the three-dimensional geopositioning accuracy was about 1.23 m, -0.02 m, and -0.30 m in X, Y and Z directions, respectively. This means that the SIRAL SARIn mode processing technique enables to measure the three-dimensional ground position with the precision of several meters.

• 한국진공학회지
• /
• 제7권s1호
• /
• pp.149-155
• /
• 1998

The linear electro-optic (EO) effect is one of the second-order nonlinear optical effects existing in a noncentrosymmetric macroscopic system. In a polymer thin film, the noncentrosymmetry is achieved by electric field poling. The magnitude of the linear EO response is determined through the orientational distribution function of hyperpolarizable molecular dipoles. The relation between the linear EO coefficient and the second-order nonlinear optical susceptibility is explained. Three different methods of measuring the linear EO coefficient of a poled nonliner optical polymer thin film are introduced and discussed. All of them make use of the interferometric technique, the difference being in the optical parameters which are interfering.

• 한국광학회:학술대회논문집
• /
• 한국광학회 1991년도 제6회 파동 및 레이저 학술발표회 Prodeedings of 6th Conference on Waves and Lasers
• /
• pp.110-114
• /
• 1991

A guided-wave electrooptic Mach-Zehnder interferometric modulator was fabricated on Y-cut acoustic grade LiNbO3 process. In order to reduce the electrode capacitance, serial capacitance electrode(SCE) structure was adopted. Extinction ratio more than 30dB was obtained with V$\pi$ of 4.69 volt at λ= 0.6328${\mu}{\textrm}{m}$. Frequency response was measured by using the swept frequency technique, and the bandwidth of the modulator was about 1GHz.