• Fibers and Polymers
• /
• v.5 no.1
• /
• pp.19-24
• /
• 2004

PET yarns textured at different texturing conditions were treated with superheated steam or dry heat at different temperatures for different times. The effects of the treatment conditions on the thermomechanical and structural changes of the yarn were examined by shrinkage, X-ray diffraction and birefringence measurements. With increase in superheated steam temperature, the crystalline orientation factor and birefringence decreased, whereas crystal size increased. Dry heat treatment had a smaller effect on shrinkage and structural properties in comparison with superheated steam treatment. The additional shrinkage after texturing process was investigated. The effect of heat-setting in both media was more significant at $200^{\circ}C$. The time dependence of the properties was not linear.

• Journal of the Korean Wood Science and Technology
• /
• v.46 no.5
• /
• pp.497-510
• /
• 2018

In this study, the decay resistance of larch wood, which was heat treated by superheated steam, was evaluated by the field decay test. During the field decay test of 12 months, non-treated wood has been severely damaged by termite, however, no visible damage has occurred in the preservative-treated wood and superheated steam heat-treated wood. Results of field decay test showed approximately 5% mass loss of the non-treated wood and the preservative-treated wood, and approximately 1% mass loss of the superheated steam heat-treated wood. After the field decay test for 12 months, the residual amount of preservatives remaining in the preservative-treated wood was lower than that before the field decay test. It was considered that the preservative was partially eluted during the field decay test, and the mass loss of the preservative-treated wood was thought to be similar to that of the non-treated wood. Through this study and additional long-term monitoring test, superheated steam heat treatment can be considered to be an environmental-friendly method to enhance the decay resistance of wood against rot fungi and/or insect without chemical treatment such as preservative injection.

• Food Science of Animal Resources
• /
• v.33 no.1
• /
• pp.103-108
• /
• 2013

This study was carried out to observe the effect of superheated steam combined with oven heating on the physico-chemical and sensory properties of chicken meat. Specially, chicken breasts and thighs were heated for 40 min in various heating formulations such as oven heating, superheated steam heating or a combination of two kinds of heating. In the physical properties measurement, the shear force was increased as superheated steam heating time and chicken thighs were higher than chicken breasts in all treatments (p<0.05). The highest level of water holding capacity was solely superheated steam treated chicken for 40 min (p<0.05). The $L^*$ value was decreased but $a^*$ value or $b^*$ value were increased after cooking. Chicken breast exhibited a higher colour value than chicken thigh. Superheated heating was effective to reduce heating loss as 22.64% (p<0.05). However, pH was not different depending on the heating formulation or part of the chicken meat (p>0.05). In the sensory test, the combination of 10 min oven heating and 30 min superheated steam heating was effective to create a good flavour of chicken meat. In this study, an optimum formulation was developed which was a combination of 10 min oven heating and 30 min superheated steam heating. It was more effective to improve the quality of chicken meat than the single heat treatment of chicken meat.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.5
• /
• pp.776-784
• /
• 2016

In this study, green Larix kaempferi lumber was heat-treated by using superheated steam (SHS) at a pilot scale and then various physico-mechanical properties of the heat-treated wood were evaluated and compared with the properties of conventional hot air (HA) heat-treated wood. Decay resistance of brown rot fungi and compressive strength parallel to the grain of the SHS heat-treated wood without occurrence of drying check from green lumber were increased. On the other hand, density, equilibrium moisture content, shrinkage, and bending strength of the SHS heat-treated wood were lower than those of the conventional HA heat-treated wood. Because heat transfer and thermal hydrolysis of SHS heat treatment was accelerated by a large amount of water, the effect of SHS heat treatment on the physico-mechanical properties was higher than that of HA heat treatment at the similar conditions of temperature and time. From the results of this study, because green lumber can be heat-treated without occurrence of cracks or checks by using SHS and similar heat treatment effect on the physico-mechanical properties of wood can be produced despite a low temperature or short time of heat treatment, it is expected that heat time and energy consumption could be reduced by using SHS.

• Korean Journal of Food Science and Technology
• /
• v.47 no.3
• /
• pp.350-358
• /
• 2015

Freezing is one of the main processes to extend the shelf life of foods. Before freezing, a thermal treatment is normally required to control the food quality. In this study, shiitake mushrooms were heated with boiling water and with superheated steam. After the thermal treatments, the samples were continuously frozen by an individual quick freezing (IQF) process, and put them into air-containing or vacuum packaging. Samples were stored at -12, -18 and $-24^{\circ}C$ for 24 weeks, and their physicochemical properties were determined. The lightness of the samples treated with boiling water and superheated steam was decreased by 12 and 15%, respectively, than that of the control. The hardness of all the samples rapidly increased after heat treatment. The contents of organic acids in the superheated steam treated samples were higher than those in the boiling water treated samples. Therefore, superheated steam treatment of samples may be a candidate thermal treatment to preserve frozen shiitake mushrooms.

• Journal of the Korean Wood Science and Technology
• /
• v.40 no.4
• /
• pp.257-267
• /
• 2012

In this study, the method for heat treating wood using superheated steam (SHS) was designed and applied. The physical and mechanical properties of Korean Pine (Pinus koraiensis Siebold & Zucc.) lumber heat-treated by SHS at $170^{\circ}C$ and 0.4 MPa for 10 hours were compared with those of non-treated and normal heat-treated wood. The amount of adsorbed water and equilibrium moisture content of the SHS treated wood were lower than non-treated wood. On the other hand the compressive strength parallel to grain and the bending strength of SHS treated wood were higher than those of non-treated wood. The hygroscopicity of SHS treated wood was similar to normal heat treated wood at $220^{\circ}C$. Internal checks that often occur during normal heat treatment were not developed at SHS treatment. Also, SHS treatment are effective in control of internal checks occurrence and resin exudation.