• Korean Journal of Food Science and Technology
• /
• v.28 no.4
• /
• pp.790-795
• /
• 1996

Citrus juice was treated with supercritical carbon dioxide $(SC-CO_{2})$ as an alternative to heat for pectinesterase (PE) inactivation to minimize undesirable changes in flavor, color and ascorbic acid loss caused by the current heat treatment, and the effect of temperature $(40,\;50,\;60^{\circ}C)$, pressure (138, 276 bar) and process time $(5{\sim}130\;min) $ on PE activity was determined. PE in temperature control samples was inactivated by 54% at $40^{\circ}C$ after 130 min, 84% at 50% after 60 min and 83% at $60^{\circ}C$ after 30 min treatment compared to the original juice. PE inactivation in $(SC-CO_{2})$ treated samples at 138 bar was 83% at $40^{\circ}C$ after 130 min, 88% at $50^{\circ}C$ after 20 min and 87% at $60^{\circ}C$ after 10 min. %PE inactivation due to pressure was higher at low temperature and lower at high temperature. Higher temperature, Pressure and longer process time resulted in higher %PE inactivation. Nonlinearity in the curves of PE inactivation at different temperatures and pressures indicated that at least two forms of PE existed in citrus juice with different stabilities.

• Clean Technology
• /
• v.16 no.3
• /
• pp.191-197
• /
• 2010

Repair reaction of plasma damaged porous methyl doped SiOCH films was carried out with silylation agents dissolved in supercritical carbon dioxide ($scCO_2$) at various reaction time, pressure, and temperature. While a decrease in the characteristic bands at $3150{\sim}3560cm^{-1}$ was detectable, the difference of methyl peaks was not identified apparently in the FT-IR spectra. The surface hydrophobicity was rapidly recovered by the silylation. In order to induce effective repair in bulk phase, the wafer was heat treated before reaction under vacuum or ambient condition. The contact angle was slightly increased after the treatment and completely recovered after the subsequent silylation. Methyl groups were decreased after the plasma damage, but their recovery was not identified apparently from the FT-IR, spectroscopic ellipsometry, and secondary ion mass spectroscopy analyses. Furthermore, Ti evaporator was performed in a vacuum chamber to evaluate the pore sealing effect. The GDS analysis revealed that the open pores in the plasma damaged films were efficiently sealed with the silylation in $scCO_2$.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.19 no.1
• /
• pp.52-61
• /
• 2016

To inject huge amount of $CO_2$ for CCS application, high pressure pipeline transport is accompanied. Rapid depressurization of $CO_2$ pipeline is required in case of transient processes such as accident and maintenance. In this study, numerical analysis on the depressurization of high pressure $CO_2$ pipeline was carried out. The prediction capability of the numerical model was evaluated by comparing the benchmark experiments. The numerical models well predicted the liquid-vapor two-phase depressurization. On the other hands, there were some limitations in predicting the temperature behavior during the supercritical, liquid phase and gaseous phase expansions.

• Journal of the Korean institute of surface engineering
• /
• v.34 no.1
• /
• pp.62-67
• /
• 2001

Green technology is being developed up to a point that is feasible not only in an environmental sense, but also in an economical viewpoint. This paper introduces two case studies that applied $CO_2$ technology into nuclear industry. 1) Nuclear laundry : A laundry machine that uses liquid and supercritical $CO_2$ as a solvent for decontamination of contaminated working dresses in nuclear power plants was developed. The machine consists of a 16 liter reactor, a recovery system with compressors, and storage tanks. All $CO_2$ used in cleaning is fully recovered and reused in next cleaning, resulting in no production of secondary nuclear waste. Decontamination factor is still lower than that in the methods currently used in the plant. Nuclear laundry using $CO_2$ looks promising with technical improvements-surfactants and mechanical agitation. 2) $CO_2$ nozzle decontamination : An adjustable nozzle for controlling the size of dry ice snow was developed. Using the developed nozzle, a surface decontamination device was made. Human oils like fingerprints on glass were easy to remove. Decontamination ability was tested using a contaminated pump-housing surface. About 40 to 80% of radioactivity was removed. This device is effective in surface-decontamination of any electrical devices like detector, controllers which cannot be cleaned in aqueous solution.

• Journal of the Korean Chemical Society
• /
• v.45 no.2
• /
• pp.149-155
• /
• 2001

A new analytical method of cyanobacterial toxins, i, e, microcysins was deveeloped using supercritical fluid extraction(SFE). The microcystins mcluded in the study are sparsely soluble in neat supercritical fluid CO$_2$ However, the microcystins were successfully extracted with a temary mixture(90% CO$_2$,9.0% methanol 1.0% water) at 40$^{\circ}$C and 250 atm. The SFE method developed in this study has several advantages over solid-phase extraction(SPE) sample preparation for the analysis of microcystins. Sample handling steps are minimized thus reducing possible losses of analytes and saving analysis time. No clean-up steps are employed in this SFE method. Althouhgh many methods have been described for microcystim RR and LR, the method using solid-phase extraction with ODS cartridges is the most commonly used. However, the adsorbing power of ODS caridges for microcystins is weak, so we have attempted to use a more polar CN cartridge, to increase the adsorbing power for microcystins. Lyophilized cells(100mg) were wxtracted with 5% (v/v) acetic acid. The extract was centrifuged and then the supernatant was applied to a CN cartridge. The cartridge which contained microcystins was rinsed with 5 ml of water and 5 ml of 0.5 M acetic acid. followed by 5 ml of 5% acetonitrile in water , and were determined by HPLC. Better recoveries and chromatogram were observed than with ODS cartridge.

• Journal of the Korean Institute of Gas
• /
• v.18 no.5
• /
• pp.26-32
• /
• 2014

CCS(Carbon Capture and Storage) which is technic to capture and storage the carbon-dioxide is the method that reduces the carbon-dioxide from the industries to prevent earth from the global warming. In order to apply to the practical site, it is inevitable to investigate the possibility of damage in the pipe or components by carbon-dioxide. In this paper, the immersion test is performed to estimate the suitability of the rubber which is used to seal or connect the pipelines because the rubber has not been validated. Also, the immersion test is carried out in a certain condition(pre- and supercritical state).

• Applied Chemistry for Engineering
• /
• v.9 no.5
• /
• pp.624-628
• /
• 1998

The aromatic organic solvents(BTX) were decomposed in the fixed bed reactor packed with a 0.5% $Pt/{\gamma}-Al_2O_3$ catalyst, then, supercritical carbon dioxide(SC-$CO_2$) was used as the reaction media. And the conversion was dependent on the inlet concentration of BTX and the molar density of SC-$CO_2$. The conversion of BTX was decreased with increasing of inlet concentration, and was increased with temperature and pressure. The maximum conversion of benzene was 98.5% at $300^{\circ}C$ and 204.1 atm, and that of toluene and xylene were 82.0 and 76.5%, respectively, at $350^{\circ}C$ and 204.1 atm. The intermediate products of partial oxidation were identified as benzaldehyde, phenol, benzenemethanol, and so on. The BTX can be effectively converted into harmless $CO_2$ and $H_2O$ at appropriate operating condition. Thus, the nontoxic recovery process was suggested as the removal method of BTX.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.2
• /
• pp.285-295
• /
• 2014

Citrus essential oil were extracted from citron peel of cultivated in Gohong (CCP) using environmentally friendly supercritical carbon dioxide method. Antioxidant activity and aroma composition of the essential oils extracted by the SC-$CO_2$ method were evaluated by comparing with those extracted by organic solvent method. Fatty acid composition, DPPH scavenging, and antioxidant activity of the oils obtained by different extraction condition of SC-$CO_2$ method were investigated and their antioxidant activities were compared with commercially available lavender, eucalyptus and tea tree oils. As the results, linoleic acid was most abundantly found from CCP oil extracted by the SC-$CO_2$ method and cis-11,144-eicosadienoic acids was second abundantly found. Radical scavenging ability of DPPH was 98% when the concentration of CCP oil was 50 mg/mL. This scavenging ability increased with the increase of oil concentration. On the other hand, flavonoids content (84 mg/100g) of the CCP oil extracted by the SC-$CO_2$ method was slightly higher than that (75 mg/100g) by hexane extraction. The results, obtained from CCP oil by GC-MS, indicated that, among 66 components, the content of terpenes was 55.8% and limonene was 27.3%.

• Journal of the Korean Institute of Gas
• /
• v.25 no.4
• /
• pp.10-18
• /
• 2021

CO₂ storage technology in an aquifer is one of the most effective way to decrease global warming due to a high storage capacity and economics. A demonstration-scale offshore CO₂ storage project was performed in a geological deep aquifer in the Pohang Basin, Korea for a technological development of large-scale CO₂ storage. A challenging issue in the early design stage of the project was to establish the proper injectivity during CO₂ injection. To solve this issue, injection conditions were calculated by calculating injection rate, pressure, temperature, CO₂ phase change, and thermodynamic properties. For this study, we simulated and numerically analyzed CO₂ phase change from gas to supercritical phase and flow behavior in transport piping and injection tubing using OLGA program. Our results provide the injectivity conditions of CO₂ injection system combined with a bottomhole pressure of an aquifer.

• Tribology and Lubricants
• /
• v.34 no.2
• /
• pp.43-48
• /
• 2018

This paper presents the thermohydrodynamic analysis of tilting journal pad bearings supporting a power turbine rotor applied to a 250 kW super-critical $CO_2$ cycle. In the analysis, the generalized Reynolds equation and 3D energy equation are solved to predict oil film temperature and the 3D heat conduction equation is solved for pad temperature. The power turbine rotor is supported by two tilting pad bearings consisting of five pads with an oil supply block between the pads. Copper backing pads with higher thermal conductivity compared to steel backing pads are adopted to improve thermal management. The predicted maximum pad temperature is around $55^{\circ}C$ which is approximately $15^{\circ}C$ higher than oil supply temperature. In addition, the predicted minimum film thickness is 50 mm at a rotating speed of 5,000 rpm. These results indicate that there is no issue in the thermal behavior of the bearing. An operation test is performed with a power turbine module consisting of a power turbine, a reduction gear and a generator. Thermocouples are installed at the 75% position from the leading edge of the pad to monitor pad temperature. The power turbine uses compressed air at a temperature of $250^{\circ}C$ in its operation. The steady state pad temperatures measured in the test show good agreement with the predicted temperatures.