• Geomechanics and Engineering
• /
• 제12권6호
• /
• pp.935-948
• /
• 2017

An experimental program was conducted to investigate the effects of the static compaction pressure, cement content, water/cement ratio, and curing time on unconfined compressive strength (UCS) of the cement treated sand. UCS were conducted on samples prepared with 4 different cement/sand ratios and were compacted under the lowest and highest static pressures (8 MPa and 40 MPa). Each sample was cured for 7 and 28 days to observe the impact of curing time on UCS of cement treated samples. Results of the study showed the unconfined compressive strength of sand increased as the cement content (5% to 10%) of the cement-sand mixture and compaction pressure (8 MPa to 40 MPa) increased. UCS of sand soil increased 30% to 800% when cement content was increased from 2.5% to 10%. Impact of compaction pressure on UCS decreased with a reduction in cement contents. On the other hand, it was observed that as the water content the cement-sand mixture increased, the unconfined compressive strength showed tendency to decrease regardless of compaction pressure and cement content. When the curing time was extended from 7 days to 28 days, the unconfined compressive strengths of almost all the samples increased approximately by 2 or 3 times.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.705-712
• /
• 2005

Among soft ground treatment methods with granular soil used in domestic, the sand compaction pile method has been utilized greatly, but, as a result of exhaustion of sand and increase of unit cost, a necessity of an alternative method is suggested. In this study, the static load tests for group crushed-stone compaction piles which were constructed at in-situ site were performed. Pile diameter was 700mm and area of loading plates were changed. The static load tests of single and group piles were performed for area replacement ratio of 20, 30 and 40%. Based on test results, bearing capacity of group crushed-stone compaction pile were estimated. The more both single pile and group pile increase, the more yield bearing capacity tended to increase. Also, the yield bearing capacity of a group pile is about 50% less than the yield bearing capacity of a single pile. If the ground reinforced with the crushed-stone compaction pile is replacement ratio of $20{\sim}40%$, RIYB of both single pile and group pile increases qualitative tendency of linear more than original ground

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2004년도 춘계학술발표회
• /
• pp.66-73
• /
• 2004

Prototype crushed-stone compaction pile(${\Phi}=700mm$) were constructed on specific test site. Static loading tests for crushed-stone compaction piles were performed. Based on the static loading test results, finite element analysis was performed using software PENTAGON 3D. Numerical analysis were done for the area replacement ratio($a_s$) of $20{\sim}70%$ and $a_s$ was varied as a step of 10%. In the single crushed-stone compaction pile, settlement was decreased as $a_s$ was increased. In the group pile, this tendency was similar. In the in-sit test and numerical analysis, as $a_s$ increased, the stress concentration ratio was increased. But $a_s$ in the numerical analysis were more than that of in-situ test, greatly.

• 한국지반공학회논문집
• /
• 제23권12호
• /
• pp.5-11
• /
• 2007

국내에서는 조립토를 이용한 연약지반 처리공법 중 모래다짐말뚝공법이 많이 활용되고 있으나, 모래자원의 고갈과 단가상승으로 인해 적용이 제한되고 있어 대체공법이 필요한 실정이다. 본 연구에서는 육상부 현장에 시험시공된 단일쇄석다짐말뚝에 대한 정재하시험을 수행하였다. 시험시 말뚝의 직경을 700mm로 고정하구 재하판의 면적을 변화시켰으며, 치환율 20, 30, 40%에 대하여 정재하시험을 실시하였다. 그 결과를 토대로 하여 단일쇄석다짐말뚝의 지지력 증가효과를 평가하였다. 치환율이 증가할수록 침하량이 작아지는 경향을 보였다. 또한, 치환율이 고려된 단일쇄석다짐말뚝의 항복지지력 공식을 제안하였다.

• 한국지반환경공학회 논문집
• /
• 제3권2호
• /
• pp.61-70
• /
• 2002

본 논문은 폐 Styrofoam과 현장발생토를 활용하여 경량 성토재로서의 특성을 파악하고자 하는데 목적이 있다. 폐 Styrofoam 입자는 가볍고 단열성이 좋으며 진동차단효과도 우수하기 때문에 경량 성토재로서의 활용이 가능하다. 특히 Styrofoam은 1996년 재활용 품목으로 선정되어 토공재료로서의 적합성만 확인된다면 체계적인 공급이 가능하다. 따라서 본 논문에서는 폐 Styrofoam 혼합토의 동적 다짐시험, 정적 다짐시험, pH 및 용출실험을 하였으며, 그 결과 효율적인 다짐관리를 위해서는 정적 다짐방식으로 다짐관리가 이루어져야 하며, 경량 성토재의 환경적 위해성 평가결과 pH는 지정폐기물 판정기준을 만족하는 것으로 나타났다.

• 한국지반공학회논문집
• /
• 제21권5호
• /
• pp.143-151
• /
• 2005

본 연구는 불포화토의 역학적 특성, 특히 메트릭 흡인력(matric suction)을 이용하여 다짐토의 압밀 항복응력을 산정하는 방법에 대해 검토되었다. 이를 위해, 두 종류의 시험을 실시하였다. 하나는 흡인력을 측정하기 위하여 정적 다짐시험이 실시하였으며, 다른 하나는 수침시키지 않은 다짐토의 압밀시험을 실시하였다. 그 시험 결과, 다짐곡선 상에 흡인력의 분포를 나타낼 수 있었으며, 압밀시험에서 간극비의 변화는 흡인력에 의존하는 것을 알 수 있었다. 이상의 시험결과를 기초로 하여, 다짐 곡선을 포함하는 다짐토의 압밀 항복 응력을 산정하는 새로운 방법을 제안하였다.

• Geomechanics and Engineering
• /
• 제13권6호
• /
• pp.929-946
• /
• 2017

Composite foundation treated with compaction piles can eliminate collapsibility and improve the bearing capacity of foundation in loess area. However, the large number of piles in the composite foundation leads to difficulties in the analysis of such type of engineering works. This paper proposes two simplified methods to quantify the stability of composite foundation treated with a large number of compaction piles. The first method is based on the principle of making the area replacement ratios of the simplified model as the same time as the practical engineering situation. Then, discrete piles arranged in a triangular shape can be simplified in the model where the annular piles and compacted soil are arranged alternately. The second method implements equivalent continuous treatment in the pile-soil area and makes the whole treated region equivalent to a type of composite material. Both methods have been verified using treated foundation of an oil storage tank. The results have shown that the differences in the settlement values obtained from the water filled test in the field and those calculated by the two simplified methods are negligible. Using stability analysis, the difference ratios of the static and dynamic safety factors of the composite foundation treated with compaction piles calculated by these two simplified methods are found to be 3.56% and 5.32%, respectively. At the same time, both static and dynamic safety factors are larger than the general safety factor, which should be greater than or equal to 2.0 according to the provisions in civil engineering. This indicates that after being treated with compaction piles, the bearing capacity of the composite foundation is effectively improved and the foundation has enough safety reserve.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2004년도 춘계학술발표회
• /
• pp.525-532
• /
• 2004

Among soft ground treatment methods with granular soil used in domestic, the sand compaction pile method has been utilized greatly, but, as a result of exhaustion of sand and increase of unit cost, a necessity of an alternative method is suggested. In this study, the static load tests for crushed-stone compaction piles which were constructed on test field were performed. Based on test results, stress concentration ratios between the crushed-stone compaction pile and the soft ground were investigated and estimated. The stress concentration ratio was the range of 1.7 to 3.0 and the higher it was the more replacement rate was increased.

• 한국분말재료학회지
• /
• 제9권2호
• /
• pp.124-132
• /
• 2002

Nano Cu powders, synthesized by Pulsed Wire Evaporation (PWE) method, have been compacted by Magnetic Pulsed Cojpaction(MPC) method. The microstructure and mechanical properties were analyzed. The optimal condition for proper mechanical properties with nanostructure was found. Both pure nano Cu powders and passivated nano Cu powders were compacted, and the effect of passivated layer on the mechanical properties was investigated. The compacts by MPC, which had ultra-fine and uniform nanostructure, showed higher density of 95% of theoretical density than that of static compaction. The pur and passivated Cu compacted at $300^{\circ}C$ exhibited maximum hardnesses of 248 and 260 Hv, respectively. The wear resistance of those compacts corresponded to the hardness.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2009년도 세계 도시지반공학 심포지엄
• /
• pp.967-975
• /
• 2009

In order to control differential settlement and to secure the safety of super structure on a high rock embankment the designed static compaction is changed with dynamic compaction and piled raft method. The parameters for dynamic compaction design are obtained from a pilot test. In addition, numerical analyses are also carried out to figure out the length and quantity of piled raft that can restraint the differential settlement within allowance range.