• Journal of Electrical Engineering and Technology
• /
• 제3권1호
• /
• pp.29-35
• /
• 2008

With long time setting, zone 3 impedance relays are considered insensitive to power swings, and their operation condition during power swings is seldom analyzed. Instead of ti me-consuming simulation to the swing loci, their operation condition is directly quantified by polynominal functions in this paper to find the critical swing angle and frequency for relay operation under different relay settings and system parameters. It is found: (1) the swing loci are more densely populated inside than outside of the protection region, which corresponds to long residence time and possible relay operations; (2) the relays may be sensitive to load encroac hments and stable power swings with different relay settings and system parameters; (3) the critical swing frequency may be in the range of low-frequency power swings.

• Tribology and Lubricants
• /
• 제14권1호
• /
• pp.45-53
• /
• 1998

Friction and wear test for two kinds of Cu-based sintered metallic friction material against cast iron disk was carried out by plate-on-disk type friction and wear tester to investigate the friction and wear characteristics of brake system in severe condition. In this experimental study, the counter specimen was cast iron which is being used generally in brakes of heavy duty equipments. Test friction materials were A type which was manufactured by foreign company and B type by domestic company. Friction coefficient and wear volume were measured and compared with each other. The experiment was performed under room temperature. The worn surface of cast iron disk and friction material were observed by scanning electron microscope. The temperature of surface of disk was measured continuously by the non-contacting thermometer. It was found that A type friction material had stable friction coefficient over the wide range of sliding condition, but B type friction material had unstable friction coefficient and lower value of 0.2 under the severe sliding condition.

• 한국전기전자재료학회논문지
• /
• 제17권5호
• /
• pp.476-480
• /
• 2004

The characteristics of antimony implants are relatively well-known. Antimony has lower diffusion coefficient, shorter implantation range, and smaller scattering as compared with conventional dopants such as phosphorous and arsenic. It has been commonly used in the doping of buried layer in Bi-CMOS process. In this paper, characteristics and appropriate condition of monitoring in antimony implant beam tuning using Sb$_2$O$_3$were investigated to get a reliable process. TW(Thema Wave) and R$_{s}$(Sheet Resistance) test were carried out to set up condition of monitoring for stable operation through the periodic inspection of instruction condition. The monitoring was progressed at the point that the slant of R$_{s}$ varied significantly to Investigate the variation of instruction accurately.

• 한국수소및신에너지학회논문집
• /
• 제30권2호
• /
• pp.103-110
• /
• 2019

Cu-Zn-Al catalysts were prepared via co-precipitation method for low-temperature water-gas shift (LT-WGS) reaction under practical reaction condition. Aging time was systematically changed to find optimum point for LT-WGS under practical condition. The Cu-Zn-Al catalyst aged for 72 hours showed the highest CO conversion within low-temperature range as well as very stable catalytic activity for 200 hours despite the practical reaction condition.

• 대한수학회지
• /
• 제45권3호
• /
• pp.741-756
• /
• 2008

In this paper, we introduce a new class of rings, SB-rings. We establish various properties of this concept. These shows that, in several respects, SB-rings behave like rings satisfying unit 1-stable range. We will give necessary and sufficient conditions under which a semilocal ring is a SB-ring. Furthermore, we extend these results to exchange rings with all primitive factors artinian. For such rings, we observe that the concept of the SB-ring coincides with Goodearl-Menal condition. These also generalize the results of Huh et al., Yu and the author on rings generated by their units.

• 한국식품영양학회지
• /
• 제5권2호
• /
• pp.132-136
• /
• 1992

Streptomyces sp. YB-88-20 was Isolated from soil and the properties of chitobiase were investigated. The optimal reaction condition for the enzyme was pH 5.5 and 4$0^{\circ}C$ , and was stable in the range of pH 4. 0 to 5.5 and temperature at 4$0^{\circ}C$, and 40 min, respectively The enzyme was inactivated by heating at 45$^{\circ}C$ for 1 hr. The enzyme was slightly activated by Mna+. Mg2+, but inhibited by Fea+. Km and activation energy was 1.5072 M and 8.314 kcal/mol.

• 한국수소및신에너지학회논문집
• /
• 제22권6호
• /
• pp.772-779
• /
• 2011

New type of syngas generator based on the partial oxidation of biogas in volumetric permeable matrix reformers was suggested as an effective, adaptable and relatively simple way of syngas and hydrogen production for various low-scale applications. The use of biogas as an energy source reduces the chance of possible emission of two greenhouse gases, $CH_4$ and $CO_2$, into the atmosphere at the same time. Its nature of being a reproducible energy source makes its use even more attractive. Parametric screening studies were achieved as air ratio, biogas component ratio, input gas temperature, Steam/Carbon ratio. As the air ratio was low, the production of the hydrogen and carbon monoxide increased in the condition that 3D matrix reformer maintains the stable driving. As it was the simulation biogas in which the carbon dioxide content is high, the flammable range became narrow. And the flammable range was extended if the injected gas was preheated. The stable driving was possible in the low air ratio. The amount of hydrogen production was increased as S/C ratio increased.

• 대한금속재료학회지
• /
• 제46권1호
• /
• pp.1-5
• /
• 2008

This study has been investigated the deformation behavior of a hot-extruded Mg-Zn-RE (RE: rare earth elements) alloy containing $Mg_{12}$(RE) particles at the elevated temperatures. The particles are intrinsically produced by breaking the eutectic structure of the alloy during the hot-extrusion process. The grain size of the extruded Mg-Zn-RE alloy developed via dynamic recrystallization is around $10{\mu}m$. Under the heat treatment at 200o C up to 48 hr, no change has been observed on the microstructure and mechanical properties due to the pinning effect of the thermally stable particles. Under the tensile test condition in the initial strain-rate range of $1\times10^{-3}s^{-1}$ and the temperature range up to $200^{\circ}C$, the alloy shows yield strength of 270 MPa and elongation to failure around 9% at room temperature and yield strength of 135 MPa at $200^{\circ}C$. Furthermore, although the alloy contains large amount of the second phase particles around 15%, it shows excellent hot-workability possibly due to the presence of the thermally stable interface between the particles and the matrix.

• 한국식품영양과학회지
• /
• 제23권1호
• /
• pp.125-129
• /
• 1994

The acetone extracted pigment from the cell mass of Rhodophila globiformis DSM 161 was generally red. In a pH 5-6 condition, the color of pigment was red, while in p/h 7-9 condition it was yellowish red. The pigment was stable at pH range between 6.0-11.0 and below 4$0^{\circ}C$. In the presence of light and oxygen , the pigment was rapidly degraded and became unstable in the presence of metal ions such as Fe3++(1.0$\times$ 10-2M, 1.0$\times$10-3 M), Al3+ (1.0$\times$10-2 M, 1.0$\times$10-3 M) and Zn2+(1.0$\times$10-2 M). But in the presence of Zn2+ (1.0$\times$10-2M). But in the presence of Zn2+ (1.0$\times$10-3 M) it was very stable. Through visible absorption scanning ,it showed five sharp absorption peaks at 358 , 385, 494, 680 ad 748 nm with three shoulder peaks at 410, 466 and 522nm. On the results of TLC analysis , it was shown to be composed of seven color fractions.

• 한국세라믹학회지
• /
• 제12권2호
• /
• pp.26-30
• /
• 1975

The experiment has been carried out to clarify the condition of acid treatment for preventing the crack formation caused by swelling and shrinking during acid leaching process. The borosilicate glass contained phosphorous pentoxide was chosen as the sample, which is recognized to be more homogeneous in phase separation. The various effects, such as kind, cocentration and acid temperature, were investigated. The experimental results are summerized as follows. (1) Sulfuric acid is more stable than hydrochrolic acid for preventing the crack. (2) The optimum concentration of acid lies in the range of 0.1~0.3N. (3) Higher temperature of the acid to treat the separated glass was more stable than lower temperature. (4) The rate of crack decreased with the longer period and the higher temperature of the heat treatment.