• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2011년도 추계학술대회
• /
• pp.389-391
• /
• 2011

본 논문에서는 VDR(VHF Data Radio)용 선형 25Watt 고출력 증폭기 회로를 설계하고 제작하여 특성을 측정하였다. VDR의 주파수 대역은 117.975~137MHz이고, CSMA(Carrier Sense Multiple Access) 다중 접속방식, D8PSK(Differential Eight Phase Shift Keyed), 25kHz 채널 대역폭을 사용한다. 또한 DO-281A MOPS에 규정된 출력 전력 및 심볼 배열 에러, 불요파 방사, 인접채널 전력을 만족해야 한다. 설계한 고출력증폭기는 DO-281A 표준을 만족한다.

• Structural Engineering and Mechanics
• /
• 제10권2호
• /
• pp.157-164
• /
• 2000

This paper discusses the error propagation characteristics of the Newmark explicit method, modified Newmark explicit method and ${\alpha}$-function dissipative explicit method in pseudodynamic tests. The Newmark explicit method is non-dissipative while the ${\alpha}$-function dissipative explicit method and the modified Newmark explicit method are dissipative and can eliminate the spurious participation of high frequency responses. In addition, error propagation analysis shows that the modified Newmark explicit method and the ${\alpha}$-function dissipative explicit method possess much better error propagation properties when compared to the Newmark explicit method. The major disadvantages of the modified Newmark explicit method are the positive lower stability limit and undesired numerical dissipation. Thus, the ${\alpha}$-function dissipative explicit method might be the most appropriate explicit pseudodynamic algorithm.

• Journal of electromagnetic engineering and science
• /
• 제4권4호
• /
• pp.143-149
• /
• 2004

This paper describes characteristics of the single-balanced low IF resistive FET mixer for the digital beam forming(DBF) receiver. This DBF receiver based on the direct conversion method is designed with Low IF I and Q channel. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(IF) considered in this research are 1950 MHz, 1940 MHz and 10 MHz, respectively. Super low noise HJ FET of NE3210S01 is considered in design. The measured results of the proposed mixer are observed IF output power of -22.8 dBm without spurious signal at 10 MHz, conversion loss of -12.8 dB, isolation characteristics of -20 dB below, 1 dB gain compression point(PldB) of -3.9 dBm, input third order intercept point(IIP3) of 20 dBm, output third order intercept point(OIP3) of 4 dBm and dynamic range of 30 dBm. The proposed mixer has 1.0 dB higher IIP3 than previously published single-balanced resistive and GaAs FET mixers, and has 3.0 dB higher IIP3 and 4.3 dB higher PldB than CMOS mixers. This mixer was fabricated on 0.7874 mm thick microstrip $substrate(\varepsilon_r=2.5)$ and the total size is $123.1\;mm\times107.6\;mm$.

• 한국정보통신학회논문지
• /
• 제3권4호
• /
• pp.805-817
• /
• 1999

In this paper, the needs for introduction and adoption of MㆍHF DSC/NBDP system and for developments of its circuits and call sequences for use in the maritime mobile services for small-ships, leisure-ships and fishing ships are analyzed, discussed. Also design and implement for MㆍHF(1.6-4MHz) DSC/NBDP system is discussed. Most of casualties have been arisen from small-ships and fishing ships during last 5 years. So, the SAR schematic plans should been prepared to prevent casualties and facilitate the activities of SAR for those ships. DSC/NBDP for MㆍHF system is able to fulfill the roles of efficient SAR communication functions, and to advance the SAR system to small ships and fishing ships. This study is focused on the techniques of processing the DSC call sequences and the ARQ sequences of NBDP system. Especially ARQ sequences are expanded into processing of Korean letters, designed the call sequences and code conversion algorithm for Korean-code. It will be evaluated the availability of Korean-NBDP system. In designing the Transmitting circuits and Receiving circuits, for the carrier generation, DDS(Direct Digital Synthesizer) is used in stead of the Phase Locked Loop and frequency conversion by the mixer, BPF. And PSK modulation signals are directly generated by the controls of DDS, which show the characteristics of Spurious Free Dynamic Range are below -62dBc. Also, the monolithic U subsystem IC which provides various functional components, AD608 is used for designing the receiving circuitsㆍAnd the algorithm of Phasing methode for FSK demodulation are devised to process IF frequency 455kHz in the IF circuits.

• 한국통신학회논문지
• /
• 제1권1호
• /
• pp.23-31
• /
• 1976

VHF 및 UHF 챠넬의 TV 信號는 映像 및 音聲을 포함한 6MHz의 대역폭으로 챠넬變換 된후 直線增幅器를 통해 재 送信될 때 搬送波付近의 兩側波帶傳送領域에서 出力振幅周波數特性에 不自然스러운 變化가 생겨 화질에 影響을 주는수가 있다. 이러한 現像은 發振器로 부터의 不要信號로 因한 不要下側帶波의 發生등 問題가 되는 要因인 트랜지스터 直線增幅器의 非直線性, MIXER 회로에서의 상호변조 歪 AM-PM 變換 및 envelope delay 特性 등을 고려하여 出力特性을 구한 결과 主原因은 非直線性에 의한 것이였으며 實驗結果로서는 非直線性의 主因으로 Bias 조건의 불합리 및 發振器로 부터의 不要周波數의 發生이 가장 큰 原因으로 나타났다. 특히 인접信號에 對한 相互變調歪 및 不要信號發生은 Up conversion의 경우가 Down Conversion의 경우보다 현저히 감소됨을 확인하였고 發振器로부터의 spurious가 system에 영향을 주지 않는 方案을 모색하였다.

• Smart Structures and Systems
• /
• 제6권2호
• /
• pp.115-133
• /
• 2010

A modal filter is a tool used to extract the modal coordinates of each individual mode from a system's output. This is achieved by mapping the response vector from the physical space to the modal space. It decomposes the system's responses into modal coordinates, and thus, on the output of the filter, the frequency response with only one peak corresponding to the natural frequency to which the filter was tuned can be obtained. As was shown in the paper (Deraemecker and Preumont 2006), structural modification (e.g. a drop in stiffness or mass due to damage) causes the appearance of spurious peaks on the output of the modal filter. A modal filter is, therefore, a great indicator of damage detection, with such advantages as low computational effort due to data reduction, ease of automation and lack of sensitivity to environmental changes. This paper presents the application of modal filters for the detection of stiffness changes. Two experiments were conducted: the first one using the simulation data obtained from the numerical 7DOF model, and the second one on the experimental data from a laboratory stand in 4 states of damage.

• ETRI Journal
• /
• 제31권3호
• /
• pp.254-262
• /
• 2009

This paper presents a novel simple filter design method based on a parallel short-ended coupled-line structure with capacitive loading for size reduction and ultra-broad rejection of spurious passbands. In addition, the introduction of a cross-coupling capacitor into the miniaturized coupled-line can create a transmission zero at the second harmonic frequency for better frequency selectivity and attenuation level. The aperture compensation technique is also applied to achieve a strong coupling in the coupled-line section. The influence of using the connecting transmission line to cascade two identical one-stage filters is studied for the first time. Specifically, such a two-stage bandpass filter operating at 2.3 GHz with a fractional bandwidth of 10% was designed and realized with low-temperature co-fired ceramic technology for application in base stations that need high power handling capability. It achieved attenuation in excess of -40 dB up to $4f_0$ and low insertion loss of -1.2 dB with the size of 10 mm ${\times}$ 7 mm ${\times}$ 2.2 mm. The measured and simulated results showed good agreement.

• 한국군사과학기술학회지
• /
• 제15권1호
• /
• pp.66-74
• /
• 2012

The virtual target signal generator was developed to verify the shipborne tracking radar performance. It was used to DRFM(Digital RF Memory) method to generate the virtual moving targets. The target signal includes Doppler shift and RCS according to the target motion. And the signal generator can make jamming signal and clutter to test shipborne radar performance at real environmental condition. This paper described the functional diagram and the hardware configuration items to meet the test requirements for the tracking radar. And it showed the critical design points for the sub-systems. The signal generator which was developed in this paper shared the operational information of the radar with the radar command and control part. To test the frequency agility of the radar, it had the local oscillator which could do high speed frequency switching according to radar information. By communicating between the signal generator and the radar command and control part, the local oscillator of signal generator could be controlled every pulse. It reduced the instantaneous bandwidth of signal generator and minimized the spurious. So it lowered the probability of generating wrong targets.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.226-229
• /
• 2005

In this study, a step-down piezoelectric transformer was fabricated to utilize as an adapter for charging batteries of mobile electronic appliances. The ceramic part of the transformer is $Pb[(Mn_{1/3}Sb_{2/3})_{0.05}Zr_{0.475}Ti_{0.475}]O_3$ with mechanical quality factor of 1600, electromechanical coupling coefficient 59 %, and piezoelectric constant d33 1300, which can be utilized as a piezoelectric transformer. A simply fabricated disk-typed test pattern of diameter 28 mm and thickness 2 mm was used to characterize resonant frequency, Qm, kp according to the different input/output electrode area. efficiency and power as a function of load resistance was also investigated. The sample APT showed some spurious mode and BPT showed better frequency property. Taking all properties which are admittance, effective electromechanical coupling coefficient and mechanical quality factor most suitable for piezoelectric transformer is BPT which has 12 mm diameter electrode and the condition of 15 Vrms, 30 $\Omega$ made the maximum efficiency of 93.7 % and maximum power is 6W with 50 Vrms.

• 한국전자파학회논문지
• /
• 제10권5호
• /
• pp.653-662
• /
• 1999

본 논문에서는 부고조파를 이용한 주입 동기 발진기를 설계, 제작하였다. 발진기는 Two Signal Method ( (TSM)의 방법을 사용하여 직렬 궤환회로로 설계하였다. 발진기의 발진주파수 9.4 GHz에서 출력전력 6dBm으 로 free-running하고 었고, 입력선호가 들어가연 주파수가 체배되어 locking되었다. 이때 원하는 출력 파형의 크 기는 다른 부고조파 신호에 비해 최소 40dB 이상이며, 2차 부고조파를 이용한 경우 locking range는 최대 220 MHz 정도이고,4차 부고조파를 이용한 경우 10 MHz이었다 이때의 위상잡음은 각각 100 KHz offset에서 -111dBe/Hz, - 104 dBelHz 정도의 특성을 나타내었다.