• Industrial Engineering and Management Systems
• /
• v.15 no.3
• /
• pp.268-277
• /
• 2016

Load balancing is a significant technique to prolong a network's lifetime in sensor network. This paper introduces a hybrid approach named as Load Distributing Hybrid Routing Protocol (LDHRP) composed with a border node routing protocol (BDRP) and greedy forwarding (GF) strategy which will make the routing effective, especially in mobility scenarios. In an existing solution, because of the high network complexity, the data delivery latency increases. To overcome this limitation, a new approach is proposed in which the source node transmits the data to its respective destination via border nodes or greedily until the complete data is transmitted. In this way, the whole load of a network is evenly distributed among the participating nodes. However, border node is mainly responsible in aggregating data from the source and further forwards it to mobile sink; so there will be fewer chances of energy expenditure in the network. In addition to this, number of hop counts while transmitting the data will be reduced as compared to the existing solutions HRLBP and ZRP. From the simulation results, we conclude that proposed approach outperforms well than existing solutions in terms including end-to-end delay, packet loss rate and so on and thus guarantees enhancement in lifetime.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.6
• /
• pp.550-559
• /
• 2005

The matrix converter provides sinusoidal input and output wave forms, bidirectional power flow, controllable input power factor and a long life, compared to the VSI(Voltage Source Inverter) with diode rectification stage at the input. However it has tasks, such as complexity of the control method, ride-through problem and low voltage-ratio limitation, to overcome for commercializing, This paper describes the design, construction and implementation of matrix converter based on space vector modulation technique. The implemented prototype of matrix converter is built using the exclusive IGBT module and control circuit constituted with DSP and CPLD and it has an input filter, overvoltage protection circuit and commutation means for overcoming practical issues. The good results tested using an induction motor are also presented.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.12
• /
• pp.1792-1798
• /
• 2017

Event Data Recorder(Car Black-Box) with WiFi dongle have been released, and the platform of the majority is the Linux platform. This is because the platform development is possible in little investment cost by reducing the source licensing costs by taking advantage of the open source. But utilizing Linux platform has the limitations of boot-up time and consuming processing power due to the limitation of battery capacity, to be cost-competitive to minimize the use of memory. In this paper, the real-time operating system(RTOS) is utilized to optimize these portions. MP4 encoder and Muxer are developed to be about ten seconds boot up and minimized memory. It has the advantages of operating at lower power consumption than the Linux utilizing WiFi dongle. Utilizing a WiFi dongle is to provide a progressive download feature on smart phones to lower product prices. But RTOS has the weakness in WiFi. Porting TCP /IP, Web and DHCP server and combination with the USB OTG Host interface by implementing the protocol stack are developed for WiFi. And also SPI NOR flash memory is utilized for faster boot time and cost reductions, low processing power to be consume. As the results, the developed proved the 10 seconds booting time, 24 frame rate/sec. and 10% lower power consumption.

• The Journal of Asian Finance, Economics and Business
• /
• v.8 no.3
• /
• pp.1241-1248
• /
• 2021

This study employs data from CRSP/Compustat files for the period from 2003 to 2017 and applies a panel data analysis. The results of this study show a positive relationship between trade credit and the firm's market value, however, the results show a negative relationship if we test the impact of financial credit on the firm's market value. The results have direct policy implications for investors, the firm's management, and financial strategy. An implication of our study is that using trade credit as a source of financing may give a positive signal of the firm's creditworthiness and increase the firm's market value. Also, the results of our study indicate that the benefits of using trade credit may outperform the cost of using it as a source of finance. Prior studies examine the impact of financial leverage on the firm's value, however, this study contributes to the existing studies that examine the factors that affect the firm's market value by examining the impact of using trade credit finance on the firm's market value. The main limitation of this study is that the results are based on listed firms, using data from unlisted firms is not available.

• Journal of the Korean Society of Food Culture
• /
• v.21 no.2
• /
• pp.116-123
• /
• 2006

This study was carried out to examine Korean housewives' preference in mushrooms, their nutritional knowledge of mushrooms as a source of Vitamin D, and five characteristics of four mushroom dishes. The data were collected from 713 subjects in various age ranges. The housewives ate mushrooms because of their healthfulness. Frequency of eating mushroom was related to preference of mushrooms. Frequency of eating mushroom was also influenced by intake of balanced diet, healthfulness of current diet, and application of nutritional knowledge. Mushroom dishes were considered nutritious (72.4%), easy to purchase (55.7%), easy to cook (63.7%) and expensive (36.3%). Mushroom was also considered superior to other vegetable in nutrition and taste but evaluated inferior to other vegetable in aspects of high price and limitation of variety. Intake of balanced diet, healthfulness of current diet and application of nutritional knowledge were influenced by the level of nutritional knowledge. Korean housewives liked mushroom but they didn't recognized the value of mushroom as a source of Vitamin D well. Introducing various cooking methods and nutritional informations are suggested to use mushroom diversely.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.40 no.2
• /
• pp.255-259
• /
• 1995

Improvement in potential Crop yield could be achieved through either the improve-ment of source potential or sink capacity, but preferably both simultaneously. The field experiment was performed to evaluate the genotypic difference in partitioning of dry matter into each plant part in response to photosynthetic manipulation as well as to assess whether the soybean yield is source or sink-limited. Four soybean genotypes, which were 'Baekunkong', 'Suwon 168', and two local soy-beans with black seed coat(hereafter referred to as the 'black soybean', 'Kangleungjarae' and 'Keumleungjarae', were grown in four different environments in which one or two layers of shading net during grain filling and two different planting densities(55,000 and 110,000 plants $ha^{-1}$) were applied to manipulate photosynthesis. Significant effects of genotype (G), photosynthetic manipulation(P), and$G^p$P were shown in top and grain dry weight. Relative grain to top dry weight was the lowest in soybean plants grown at 110,000 plants$ha^{-1}$and covered with two layers of shading net during grain filling, Evaluation of dynamic changes in shoot harvest index in response to photosynthetic manipulation treatments revealed that sink was more limited in local black soybeans than Suwon 168 and Baekunkong, indicating that the availability of photosynthate during grain filling did not limit the grain yield in local black soybeans when compared to Baekunkong and Suwon 168.oybeans when compared to Baekunkong and Suwon 168.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.2
• /
• pp.104-115
• /
• 2013

In a shallow water waveguide, reverberation signals and their Doppler effects form the primary limitation on sonar system performance. Therefore, in the reverberation-limited environment, it is necessary to estimate the reverberation level to be encountered under the conditions in which the sonar system is operated. In this paper, high-frequency reverberation model capable of simulating the reverberation signals received by a high-speed moving source in a range independent waveguide is suggested. In this model, eigenray information from the source to each boundary is calculated using the ray-based approach and the optimizing method for the launch angles. And the source receiving position changed by the moving source is found by a scattering path-finding algorithm, which considers the speed and direction of source and sound speed to find the path of source movement. The scattering effects from sea surface and bottom boundaries are considered by APL-UW scattering models. The model suggested in this paper is verified by a comparison to the measurements made in August 2010. Lastly, this model reflects well statistical properties of the reverberation signals.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.39 no.8
• /
• pp.702-710
• /
• 2011

This paper aims to verify the applicability of OpenFOAM, the widely recognized open source CFD code, to external flows commonly found in aeronautical problems. To this end, several representative flow cases are selected first from subsonic to supersonic flow fields. Then, the computational results obtained from OpenFOAM are systematically compared against available data from experiments and other numerical codes. It was found that the strength and location of shock are well predicted and the effects of boundary conditions on the computed results are reviewed. Subsonic flow with massive separation is selected to validate the prediction capability of OpenFOAM. Based on the current results, the limitation and possibility of OpenFOAM was confirmed and for future study using OpenFOAM was suggested.

• Nuclear Engineering and Technology
• /
• v.46 no.6
• /
• pp.837-846
• /
• 2014

A lead slowing down spectrometer (LSDS) is under development for analysis of isotopic fissile material contents in pyro-processed material, or spent fuel. Many current commercial fissile assay technologies have a limitation in accurate and direct assay of fissile content. However, LSDS is very sensitive in distinguishing fissile fission signals from each isotope. A neutron spectrum analysis was conducted in the spectrometer and the energy resolution was investigated from 0.1eV to 100keV. The spectrum was well shaped in the slowing down energy. The resolution was enough to obtain each fissile from 0.2eV to 1keV. The detector existence in the lead will disturb the source neutron spectrum. It causes a change in resolution and peak amplitude. The intense source neutron production was designed for ~E12 n's/sec to overcome spent fuel background. The detection sensitivity of U238 and Th232 fission chamber was investigated. The first and second layer detectors increase detection efficiency. Thorium also has a threshold property to detect the fast fission neutrons from fissile fission. However, the detection of Th232 is about 76% of that of U238. A linear detection model was set up over the slowing down neutron energy to obtain each fissile material content. The isotopic fissile assay using LSDS is applicable for the optimum design of spent fuel storage to maximize burnup credit and quality assurance of the recycled nuclear material for safety and economics. LSDS technology will contribute to the transparency and credibility of pyro-process using spent fuel, as internationally demanded.

• 보존과학연구
• /
• s.17
• /
• pp.123-160
• /
• 1996

There have been many studies and experiments regarding exhibition lighting. Many experiments on photochemical damaging effect and visibility resulted in a practice limited to assigning light levels and adjusting annual exposure time. The three damaging factors to the artifacts are intrinsicsusceptibility to absorb radiant energy, spectral distribution of light source and intensity of illumination and time of exposure. Dividing all the artfacts into three categories to suggest a recommended illuminance level causes some problems. Blue wool, for example, used as the reference material for susceptibility, is not a standard material representing museum artifacts. In the most light sensitive category, ISO class I or anything below have been excluded. The exposure time of one soure can be three times more than another sourece. The spectral distribution of the light source and the relative spectral responsibility of the artifact are not considered in the practice. So in case of very light sensitive material, the recommended illuminance is only the referring value and it is indispensable to check the characteristic of susceptibility of each artifacts. Daylighting is prevailing method to solve the psychological need of the visitors. However, it sould transparent, and should not diffused, and the green-house effect must be considered. llluminance uniformity should based on the maximum illuminance to handle the limitation of exposure for the conservation of a large sensitive object such as a painting. Damage index is not absolute reference for selecting the lighting source because it is experimented from the paper of low grade then calculated. Visibility should be increased by reducing the visual noiseand by planning of appropriate luminance contrast. This paper reviews the problems with the previous studies and experiment sand the current exhibition lighting design practice. The plan for museum showcase lighting is to check the susceptibility and to raise the visibility simultaneously.