• Journal of the Korean Society of Tobacco Science
• /
• v.36 no.1
• /
• pp.26-33
• /
• 2014

Simultaneous determination of crop protection agents(CPAs) in food are done with multi-residue methods, which are composed of sample clean-up, concentration, chromatographic separation and detection. Stir Bar Sorptive Extraction(SBSE) technique is used for sample preparation of various analytes in several fields. The aim of this study was to develop a sensitive and fast method based on SBSE followed by thermal desorption - gas chromatography - mass spectrometry(TD - GC/MS) to determine CPAs in tobacco sample. For the analysis of tobacco sample prior to the SBSE method, solvent extraction or ultrasound-assisted solvent extraction was performed. methanol was used as the extraction solvent. The extract was then diluted with water. Finally, the sample was subjected to SBSE. A method for fast screening of crop protection agents in tobacco using SBSE-TD - GC/MS has been developed. About 17 CPAs including organochlorine, organophosphorous and others were identified and quantified. This method showed good linearity and high sensitivity for most of the target CPAs. The method was applied to the determination of CPAs at ng/mL levels in tobacco sample. This method is simple, rapid and may be applied in detection of other components.

• Journal of Environmental Science International
• /
• v.23 no.7
• /
• pp.1289-1297
• /
• 2014

In this study, PVC-LMO beads were prepared by immobilizing lithium manganese oxide (LMO) with poly vinyl chloride (PVC) diluted in dioxane solvent. XRD and SEM analysis confirmed that LMO was immobilized well in PVC-LMO beads. The diameter of PVC-LMO beads prepared by dioxane solvent was about 2 mm. The adsorption experiments of lithium ions by PVC-LMO beads were conducted batchwise. The optimum pH was pH 10. The adsorption characteristics of lithium ions by PVC-LMO beads was well described by the pseudo-second-order kinetic model. The maximum adsorption capacity obtained from Langmuir model was 24.25 mg/g. The thermodynamic parameters such as ${\Delta}H^{\circ}$, ${\Delta}S^{\circ}$ and ${\Delta}G^{\circ}$ were evaluated. The calculated ${\Delta}G^{\circ}$ was between -6.16 and -4.14 kJ/mol (below zero), indicating the spontaneous nature of $Li^+$ adsorption on PVC-LMO beads. Also, the results showed that PVC-LMO beads prepared in this study could be used for the removal of lithium ions from seawater containing coexisting ions such as $Na^+$, $K^+$, $Mg^{2+}$ and $Ca^{2+}$.

• Applied Chemistry for Engineering
• /
• v.25 no.2
• /
• pp.147-151
• /
• 2014

In many polymer processing operations, the diffusion of small molecules in polymeric materials plays an important role. The fundamental physical property required to design and optimize processing operations is the mutual diffusion coefficient. To investigate the transport properties of polymer/solvent systems at infinite dilution, capillary column inverse gas chromatography (CCIGC) is often employed. In this study, diffusion and partition coefficients of cyclic solvents in styrene/butadiene/styrene (SBS) block copolymer were measured over a wide temperature range using the CCIGC technique.

• Restorative Dentistry and Endodontics
• /
• v.8 no.1
• /
• pp.115-121
• /
• 1982

Sodium hypochlorite solution has been widely used as endodontic irrigant due to its ability to dissolve pulp tissue debris and its antimicrobial action. This in vitro study was conducted to evaluate the solvent action of sodium hypochlorite solution on vital pulp tissue under various conditions include concentration, exposure time, and temperature. The percentage of weight loss due to pulp tissue dissolution was calculated with weight difference of lyophilized specimens before and after the exposure to test solutions. The results were as follows; Statistical analysis indicated that the ability of both 5.0% and 2.5% sodium hypochlorite solutions to dissolve pulp tissue was significantly greater than that of distilled water, but no significant difference was found between 5.0% and 2.5% sodium hypochlorite solutions. There was no significant increase in the pulp tissue dissolving ability of sodium hypochlorite solutions; as exposure time increased 2 minutes, 5 minutes, and 10 minutes. Of the given temperatures, no significant difference was found in the solvent aciton of sodium hypochlorite solution on pulp tissue between $20^{\circ}C$ (room temperature) and $37^{\circ}C$(body temperature).

• Journal of the Korean Chemical Society
• /
• v.36 no.1
• /
• pp.125-130
• /
• 1992

Stereoisomers of trifluoroethylmandelate(mandelic acid trifluoroethylester) were synthesized from each isomer of mandelic acid and trifluoroethanol with p-toluene sulfonic acid in order to study the enantioselectivity of lipase in organic solvent. The products were identified by $^1H$ NMR and elemental analysis and their physical properties such as melting point, densities and specific optical rotations($[{\alpha}]_{25}{^D}$) were also characterized. $[{\alpha}]_{25}{^D}$ of (+)- and (-)-trifluoroethylmandelate were +74° and -75.4°, respectively. The trifluoroethylmandelate was found out to be as a good substrate for the transesterfication stereoselectivity of lipases in organic solvent. Any significant difference of the lipase catalyzed transesterification activity between (+)- and (-)-methylchloropropionate was not found, and even lipase activity of transesterfication was not found with high optical polar (+)-and (-)-methylmandelate.

• Natural Product Sciences
• /
• v.16 no.1
• /
• pp.39-42
• /
• 2010

The content of hyperin in Acanthopanax species was determined by high performance liquid chromatography (HPLC). Hyperin was quantified by a reverse-phase column with elution program [initially gradient solvent (acetonitrile : water = 85 : 15 to 80 : 20 for 20 min), then isocratic solvent (acetonitrile : water = 80 : 20 for 20 min), and finally gradient solvent (acetonitrile : water = 80 : 20 to 65 : 35 for 20 min)]. UV detection was conducted at 210 nm. The content of hyperin in the fruits of Acanthopanax was measured in the species A. chiisanensis (2.04 mg/g), A. sessiliflorus (1.13 mg/g), A. divaricatus (0.98 mg/g), A. koreanum (0.75 mg/g) and A. senticosus (0.05 mg/g). The content of hyperin in A. chiisanensis was higher than that of other Acanthopanax species.

• Analytical Science and Technology
• /
• v.34 no.4
• /
• pp.153-159
• /
• 2021

In this study, we describe the development of a new high-performance liquid chromatography (HPLC) method for the simultaneous analysis of six bioactive compounds (including gallic acid, epicatechin 3-gallate, quercitrin, afzelin, quercetin, and kaempferol) from Orostachys japonicus. The extraction method was investigated and optimization of the extraction time (min), solvent composition (%), and solvent to material ratio were conducted. As a result, 30 min extraction with 50% methanol and 40:1 mL/g of solvent: material ratio achieved the highest extraction efficiency with a yield of 3.32 mg/g. Furthermore, the developed HPLC method was validated and the correlation coefficient (R) values were within the satisfactory range of 0.9995-0.9999 over the linearity range of 1.53-417 ㎍/mL. The limit of detection and limit of quantification for the six active components were between 0.03-0.08 ㎍/mL and 0.08-0.26 ㎍/mL, respectively. With these newly optimized and developed methods, four batches of O. japonicus were analyzed to confirm the high extraction efficiency of the method and the feasibility of an application.

• Korean Journal of Materials Research
• /
• v.22 no.2
• /
• pp.78-81
• /
• 2012

$Y_2O_3$ nanomaterials have been widely used in transparent ceramics and luminescent devices. Recently, many studies have focused on controlling the size and morphology of $Y_2O_3$ in order to obtain better material performance. $Y_2O_3$ powders were prepared under a modified solvothermal condition involving precipitation from metal nitrates with aqueous ammonium hydroxide. The powders were obtained at temperatures at $250^{\circ}C$ after a 6h process. The properties of the $Y_2O_3$ powders were studied as a function of the solvent ratio. The synthesis of $Y_2O_3$ crystalline particles is possible under a modified solvothermal condition in a water/ethylene glycol solution. Solvothermal processing condition parameters including the pH, reaction temperature and solvent ratio, have significant effects on the formation, phase component, morphology and particle size of yttria powders. Ethylene glycol is a versatile, widely used, inexpensive, and safe capping organic molecule for uniform nanoparticles besides as a solvent. The characterization of the synthesized Y2O3 powders were studied by XRD, SEM (FE-SEM) and TG/DSC. An X-ray diffraction analysis of the synthesized powders indicated the formation of the $Y_2O_3$ cubic structure upon calcination. The average crystalline sizes and distribution of the synthesized $Y_2O_3$ powders was less than 2 um and broad, respectively. The synthesized particles were spherical and hexagonal in shape. The morphology of the synthesized powders changed with the water and ethylene glycol ratio. The average size and shape of the synthesized particles could be controlled by adjusting the solvent ratio.

• International Journal of Highway Engineering
• /
• v.17 no.4
• /
• pp.53-61
• /
• 2015

PURPOSES : The objective of this study is to evaluate the SDAR (solvent deasphaltene residue), which is obtained from the solvent deasphalting (SDA) process, as a pavement material. METHODS : The physical properties of the SDAR were evaluated based on its chemical composition, and asphalt mixtures with the SDAR were fabricated and used for the evaluation of mechanical properties. Firstly, the chemical composition of SARA (saturate, aromatic, resin and asphaltene) was analyzed using the TLC-FID (thin-layer chromatography-flame ionization detector). Moreover, the basic material properties of the asphalt binder with the SDAR were evaluated by the penetration test, softening point test, ductility test, and PG (performance grade) grade test. The rheological properties of the asphalt binder with the SDAR were evaluated by the dynamic shear modulus ($G^*$) obtained using the time-temperature superposition (TTS) principle. Secondly, the mechanical properties of the asphalt mixtures with the SDAR were evaluated. The compactibility was evaluated using the gyratory compacter. Moreover, the tensile strength ratio (TSR) was used for evaluating the moisture susceptibility of the asphalt mixtures (i.e., susceptibility to pothole damage). The dynamic modulus $E^*$, which is a fundamental property of the asphalt mixture, obtained at different temperatures and loading cycles, was used to evaluate the mechanical properties of the asphalt mixtures. RESULTS AND CONCLUSION : The SDAR shows stiffer and more brittle behavior than the conventional asphalt binder. As the application of the SDAR directly in the field may cause early failures, such as cracks on pavements, it should be applied with modifiers that can favorably modify the brittleness property of the SDAR. Therefore, if appropriate additives are applied on the SDAR, it can be used as a pavement material because of its low cost and strong resistance to rutting.

• Journal of Preventive Medicine and Public Health
• /
• v.31 no.3 s.62
• /
• pp.404-413
• /
• 1998

This study was conducted in order to clarify the factors affecting the number of utilization to health center for the shipyard workers who have been work in exposed environment to solvent. At first the tendencies of the number of utilization to health conte. in accordance with cumulative exposure(CE), lifetime weighted average exposure(LWAE), one's place of duty, work contents, states of using safety apparatus, the degree of the knowledge on handling solvents, exposure year. 1). The increase in the cumulative exposure(CE) war significantly higher in the number of utilization to health center. The group with longer exposure year showed significantly higher number of utilization to health center(p<0.01). Considering the work contents such as power blasting, spray, mixing and touch-up, the group of touch-up showed higher number of utilization to health center and this difference was statistically significant(p<0.001). Those who were not using the safety apparatus, showed higher number of utilization to health center, which was statistically significant(p<0.05). The degree of the knowledge on handling the solvent had no relation with using health center. 2) The results conducted from this study by multiple regression analysis in clarifying the factors affecting the number of utilization to health center, CE, exposure year and using safety apparatus was significant factor in utilization of health center.