• Journal of Practical Agriculture & Fisheries Research
• /
• v.17 no.1
• /
• pp.145-155
• /
• 2015

To investigate the practicality of a small scale softwood propagation plastic film tent and the rooting promoting effect of indole-3-butyric acid(IBA) for northern highbush blueberry, softwood cuttings of 3 varieties (Duke, Elizabeth, Elliot) were made after dipping in the IBA solutions of 100ppm, 300ppm, 500ppm, 1,000ppm for 2 hour, and 3,000ppm for 20 seconds, respectively. Two-way ANOVA confirmed the significant differences in the percentage of rooting of cutting, longest root length and rooting volume index (RVI) induced by IBA treatment, as well as the percentage of rooting of cutting and RVI among examined varieties. In particular, the highly significant difference was observed in th RVI for IBA treatment. However, there was no interactions between the auxin treatments and varieties. Spontaneous rooting ability (control) depends on the varieties, showing that the lowest rooting ability was observed in the 'Duke' (45%) followed by 'Elliot'(85%) and 'Elizabeth' (90%). In addition, the rooting of the examined 3 varieties were enhanced by both of short time (20sec) dipping treatment of low level solutions, and long time (2hr) dipping treatment of high level solution, with the remarkably promoted rooting of the 'Duke' cuttings.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.1
• /
• pp.30-37
• /
• 2001

The effects of enzymatic treatment of recycled fiber were investigated to obtain the basic informations which can be used to improve the papermaking properties of recycled fiber. The recycled fibers were prepared by the repeated handsheet making and disintegrating of hardwood of hardwood and softwood kraft pulp. Novozym 342, Dinimax and Pulpzyme HC were used for enzymatic treatment. The change of fiber length distribution, freeness, contact angle and crystallinity of pulp were measured. The brightness, opacity, breaking and tear index of paper were also measured. The enzymatic treatment decreased long fiber fraction of recycled hardwood fiber, but increased long fiber fraction of recycled softwood fiber. Freeness was decreased with 0.1% enzyme and then increased again with the increase of th enzyme dosage. The improvement of flexibility of recycled fiber was obtained through the decrease of contact angle that is resulted from the decrease of crystallinity of fiber. Brightness and opacity were affected by the type of pulp and enzyme, and dosage of enzyme. Breaking length of recycled hardwood fiber was improved with enzyme treatment, but breaking length of recycled softwood fiber was decreased except for 0.01% Pulpzyme treatment. Tear index was decreased with enzymatic treatment and the lowest decrease was observed with the treatment to Pulpzyme.

• Journal of Veterinary Clinics
• /
• v.16 no.2
• /
• pp.257-264
• /
• 1999

The objective of this study was to estimate the possibility of use as a crude feed about Korean pine foliage. Foliage was fermented aerobic and anaerobic state. And then, it was fed Korean native bull 5 to 6 month old. Bulls were fed control (n=4), aerobic fermented (n=4) and anaerobic fermented (n=4) feed 30 percent of total ration. Bulls were examined with blood sample and body weight on day 0, 60, 120 and 180. There were no differences on complete blood cell count serum chemistry and incidence of disease among groups for experiment period. Also, electrolytes (Ca, Mg, P) balance were good condition. Experimental feed did not induced toxicosis in kidney and liver, Fermented foliage and leaves of Korean softwood were efficient crude feed in carbohydrate, fat and protein metabolism. Experimental feed induced growth of Korean native bull body weight in growing stage without retard. In addition to anaerobic fermented feed has a more higher growth rate than control feed. Our conclusion is that fermented softwood substitute some part of ration, minimum 30 percent, in growing stage of a Korean native bull.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.43 no.3
• /
• pp.106-112
• /
• 2011

The effects of alkaline treatment on the WRV, crystalline structure and sheet structure of softwood and hardwood bleached kraft pulp were investigated. Sodium hydroxide and sodium carbonate were used as chemicals for alkaline treatment and two levels of alkali dosage (5%, 10%) were applied respectively. Alkali treated and untreated pulp were refined to three levels (550, 450 and 350 mL CSF). WRV of the alkali treated pulps depended on the alkaline type and concentration. It was found that the crystalline structures of softwood and hardwood pulp were not changed by refining. Sodium carbonate and lower concentration of sodium hydroxide treatment did not caused any modification of cellulose crystalline structure, while higher concentration of sodium hydroxide treatment caused the partial modification of cellulose crystalline structure. Alkaline treatment of hardwood bleached kraft pulp led to the shrinkage of fiber diameter and bulky structure of sheet. Alkaline treatment of softwood bleached kraft pulp did not cause the significant change in fiber shrinkage and bulk of sheet.

• Journal of the Korean Wood Science and Technology
• /
• v.21 no.3
• /
• pp.53-60
• /
• 1993

Substrates used were hardwood-Suwon poplar-(Populus alba${\times}$glandulosa L.) and softwood-pitch pine-(Pinus rigida M.). And these substrates were steam exploded then treated with sodium chlorite at 75$^{\circ}C$ with occasional stirring in order to obtain samples which had different lignin contents and crystallinity. And then this resulting samples incubated with a commercial cellulase derived from Trichoderma ressei. The contents of Klason lignin were decreased as the increasing of the ratio of sodium chlorite in the two species. The effect of hardwood was more effective than that of softwood in the same ratio of sodium chlorite. The minimum contents of Klason lignin were 0.8% and 5.1% respectively. And the crystallinities of cellulose were increased very little as increasing of the ratio of sodium clorite. The hydrolysis extent of the two species were increased as the increasing of delignification. Especially, the hydrolysis extent of hardwood was more higher than that of softwood. The maximum hydrolysis extent were 89.8% and 71.1%, respectively.

• Journal of the Korean Wood Science and Technology
• /
• v.30 no.3
• /
• pp.109-115
• /
• 2002

Mycelial growth of L. edodes by pretreatments of softwood was studied on a sawdust medium. The sawdust used was from the following softwood species : Larix leptolepis, Pinus densiflora and Pinus koraiensis. The pretreatment consisted of cold-water (48 h), hot-water (3 h) and steam extractions (3 h) at a ratio of 500 g : 3,000 mL (sawdust : distilled water). The sawdust medium was a mixture of 76% sawdust, 20% rice bran, 3% glucose, 0.4% potassium nitrate and 0.6% calcium carbonate. Following sawdust pretreatments proved most suitable : L. leptolepis (steam extraction), P. densiflora (hot-water extraction) and P. koraiensis (hot-water extraction). Mycelial growth on P. koraiensis sawdust increased in proportion to an increase in hot-water extraction time. Mycelial growth was optimum on the sawdust extracted for 12 hours, hot-water extraction beyond this period proved unsuitable. With the exception of P. densiflora at 100 ㎍/mL, antifungal activity occurred in every sample. Maximum inhibition of mycelial growth was obtained from following concentration of hot-water extractives : P. densiflora (10⁴ ㎍/mL) and P. koraiensis (10⁴ ㎍/mL). This study has provided useful preliminary information for the cultivation of L. edodes.

• Journal of Sericultural and Entomological Science
• /
• v.39 no.2
• /
• pp.101-105
• /
• 1997

Most of the mulberry saplings in Korea have been produced by grafting. But the production of mulberry sapling by this method is very complex process and requires high level of technique and two years to produce saplings. Therefore, to develop the mulberry sapling production system by softwood cutting method which is suitable for mass production, several conditions on rooting and growth of cuttings were investigated. The rooting ability of cuttings varied according to mulberry varieties, showing the highest rooting ratio of 93.3% in cultivar of Shingwangppong. Of different soil texture as for rooting media, the clay was found to be the best; other media decreased in order as follows; sand, sand loam and vermiculite. The shading ratio by 70% with polyethylene film showed the highest rooting ratio of the cuttings. Optimum day of cutting was around 50th day after sprouting, whereas the ratio of stem thicker than 7mm at the base of saplings in diameter was highest at 44th day.

• Journal of the Korean Wood Science and Technology
• /
• v.24 no.4
• /
• pp.40-46
• /
• 1996

It is well-known fact that dimensional stability of wood is greatly enhanced by acetylation of wood. This dimensional stability results from bulking of the reacted acetate within the cell wall, which reduces further swelling when the modified woods corne into contact with water or water vapor. The purpose of this research was to determine the water absorption and dimensional stability of the acetylated solid wood in liquid water and in humidity tests. Radiata pine, Siberian larch, and Japanese larch were acetylated. Antiswelling efficiency(ASE) and equilibrium moisture content(EMC) of acetylated wood, at 95% RH and $20^{\circ}C$ after 4weeks, was quite dependent on WPG, but was not dependent on species.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2011.11a
• /
• pp.27-28
• /
• 2011

This research aims to secure fundamental data for the development offire-retardant wood by soaking dried wood in fire-retardant liquid. To dry wood, optimal drying conditions for softwood usually used as structural material and hardwood usually used as finishing or furniture material were derived by varying the microwave outputs and heating times of microwave wood drying equipment. The research foundthat each specimen needs 8 to 15 minutes of heating time depending on water content and output. For softwood, fire-retardant liquid equivalent to about 10 percent of the total mass of the specimen infiltrated into the dried wood, of which the water content was reduced to 5~6 percent.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2006.06a
• /
• pp.37-42
• /
• 2006

The paper discusses the combined use of softwood and eucalyptus kraft pulps in the production of printing and writing papers. Looking for process and paper quality optimization, refining pilot plant trails were carried to identify the effects of refining type (mixed or separate) and intensities (specific edge load), and also furnish composition (amount of each pulp in mixture) on final paper quality and process costs. The basic effects on pulp fibers were evaluated against paper quality properties, such as physical strengths, bulk, vessel picking, opacity and porosity, as well as the interactions with papermaking process, such as estimates of paper machine runnability, paper breaks and industrial refining control. The results show that the furnish composition and the type of refining has a significant effect on properties related with both final paper quality and total costs. The best alternative for printing and writing papers was identified for mixed refining, under the lowest refining intensity, and with the highest dosage of eucalyptus pulp.