• ETRI Journal
• /
• 제43권5호
• /
• pp.923-931
• /
• 2021

We studied the influence of GaAs top-layer thickness on the small-signal modulation response and 56 Gb/s four-level pulse-amplitude modulation eye quality of 850 nm vertical-cavity surface-emitting lasers (VCSELs). We considered the proportionality of the gain-saturation coefficient to the photon lifetime. The simulation results that employed the transfer-matrix method and laser rate equations led to the conclusion that the proportionality should be considered for proper explanation of the experimental results. From the obtained optical eyes, we could determine an optimum thickness of the GaAs top layer that rendered the best eye quality of VCSEL. We also compared two results: one result with a fixed gain-saturation coefficient and the other that considered the proportionality. The former result with the constant gain-saturation coefficient demonstrated a better eye quality and a wider optimum range of the GaAs top-layer thickness because the resultant higher damping reduced the relaxation oscillation.

• 센서학회지
• /
• 제29권5호
• /
• pp.324-327
• /
• 2020

The impact of output conductance (g_o) on the short-circuit current-gain cut-off frequency (f_T) in In_0.8Ga_0.2As high-electron-mobility transistors (HEMTs) on an InP substrate was investigated. An attempted was made to extract the values of f_T in a simplified small-signal model (SSM) of the HEMTs, derive an analytical formula for f_T in terms of the extrinsic model parameters of the simplified SSM, which are related to the intrinsic model parameters of a general SSM, and verify its validity for devices with L_g from 260 to 25 nm. In long-channel devices, the effect of the intrinsic output conductance (g_oi) on f_T was negligible. This was because, from the simplified SSM perspective, three model parameters, such as g_{m_ext}, C_{gs_ext} and C_{gd_ext}, were weakly dependent on g_oi. However, in short-channel devices, g_oi was found to play a significant role in degrading f_T as L_g was scaled down. The increase in g_oi in short-channel devices caused a considerable reduction in g_{m_ext} and an overall increase in the total extrinsic gate capacitance, yielding a decrease in f_T with g_oi. Finally, the results were used to infer how f_T is influenced by g_oi in HEMTs, emphasizing that improving electrostatic integrity is also critical importance to benefit fully from scaling down L_g.

• Journal of the Optical Society of Korea
• /
• 제16권1호
• /
• pp.53-56
• /
• 2012

We have developed a slab-type Nd:YAG gain module based on the techniques of conduction cooling and end pumping. The Nd:YAG slab is end-capped on both ends by undoped pure YAG and is pumped through the end-caps by stacked arrays of laser diode bars. The slab's surfaces of total internal reflection are in contact on both sides with microchannel cooling blocks which are cooled by water circulation. The power oscillator based on the gain module generates more than 400 W at 1-kW pumping with a slope efficiency of 55%. The small-signal gain of the gain module is 10 in a single zig-zag pass, and the amplified beam shows a near diffraction-limited beam quality.

• 한국통신학회논문지
• /
• 제27권5C호
• /
• pp.522-529
• /
• 2002

GaAs pHEMT 기술로 V-band 수신단 각 MMIC 회로들을 설계 제작하였다. 또한 이를 집적하여 V-band downconverter module을 제작하였다. 제작된 downconverter는 24 dBm의 출력을 내는 LO 구동 전력 증폭기, 20dB의 소신호 이득을 가지는 저잡음증폭기, -1.6dBm의 출력을 내는 active parallel type의 발진기, 6 dB 이상의 변환이득 특성을 나타내는 cascode type의 혼합기로 구성되어 있다. 이처럼 혼합기의 우수한 변환이득 특성은 밀리미터파 대역에서 변환 이득 특성을 키우기 위해 반드시 필요한 거대한 IF buffer amplifier의 필요를 없애 주었다. 완성된 downconverter module의 측정결과 별도의 IF buffer amplifier없이 57.5 GHz와 61.7 GHz 사이에서 20 dB 이상의 높은 변환이득을 얻을 수 있었다.

• Transactions on Electrical and Electronic Materials
• /
• 제2권4호
• /
• pp.1-6
• /
• 2001

In this paper, a 1.5 V high-gain high-frequency CMOS complementary operational amplifier is presented. The input stage of op-amp is designed for supporting the constant transconductance on the Input stage by consisting of the parallel-connected rail-to-rail complementary differential pairs. And consisting of the class-AB rail-to-rail output stage using the concept of elementary shunt stage and the grounded-gate cascode compensation technique for improving the low PSRR which was a disadvantage in the general CMOS complementary input stage, the load dependence of open loop gain and the stability of op- amp on the output load are improved, and the high-gain high-frequency operation can be achieved. The designed op-amp operates perfectly on the complementary mode with the 180° phase conversion for a 1.5 V supply voltage, and shows the DC open loop gain of 84 dB, the phase margin of 65°, and the unity gain frequency of 20 MHz. In addition, the amplifier shows the 0.1 % settling time of .179 ㎲ for the positive step and 0.154 ㎲ for the negative step on the 100 mV small-signal step, respectively, and shows the total power dissipation of 8.93 mW.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.183-184
• /
• 2007

A 40 Gb/s transimpedance amplifier IC was designed and fabricated with a InP/InGaAs HBTs technology. In this study, we interconnect 40Gbps trans impedance amplifier IC to a duroid substrate by a flip chip bonding instead of conventional wire bonding for interconnection. For flip chip bonding, we developed fine pitch bump with the $70{\mu}m$ diameter and $150{\mu}m$ pitch using WLP process. To study the effect of WLP, electrical performance was measured and analyzed in wafer and package module using WLP. The Small signal gains in wafer and package module were 7.24 dB and 6.93dB respectively. The difference of small signal gain in wafer and package module was 0.3dB. This small difference of gain is due to the short interconnection length by bump. The characteristics of return loss was under -10dB in both wafer and module. So, WLP process can be used for millimeter wave GaAs MMIC with the fine pitch pad and duroid substrate can be used in flip chip bonding process.

• 한국컴퓨터산업교육학회:학술대회논문집
• /
• 한국컴퓨터산업교육학회 2003년도 제4회 종합학술대회 논문집
• /
• pp.99-102
• /
• 2003

Data acquisition of biomedical signal is important that can convert health of human body to measurable datas. In this paper, we developed system that can send multiple ECG data, ECG signal in biomedical signals, using Bluetooth wireless transmission. Developed system has several features, total gain of 1000, filtering data for noise reduction in hardware / software parts, portable to carry cause it has small size and battery operation. And system was designed which can measures data in several OS(Windows 2000, Windows CE).

• 한국통신학회논문지
• /
• 제40권5호
• /
• pp.924-930
• /
• 2015

본 논문에서는 잡음 환경에서 적은 연산량으로 소형 음향기기의 음질 향상을 위한 새로운 저연산 이득 제어 알고리즘을 제안한다. 대표적인 소형 음향기기인 보청기의 이득 제어 알고리즘은 입력 신호를 잡음 제거 한 후 이 신호의 파워를 기준으로 광역동범위압축 (wide dynamic range compression, WDRC)을 하기 때문에 불필요한 신호까지 증폭된다. 제안된 이득 제어 알고리즘은 음성 검출기 (voice activity detection, VAD)의 결과를 이용하여 음성의 존재 유/무에 따라 적응적으로 이득을 제어한다. 성능 평가를 위해 제안된 알고리즘은 VAD를 적용하지 않은 알고리즘과 정상 및 비정상 잡음환경에서 다양한 조건을 부과하여 비교하였으며, 실험결과 제안된 알고리즘이 전체 성능 및 잡음 구간에서 향상된 결과를 보였다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 ITC-CSCC -1
• /
• pp.654-657
• /
• 2002

This paper introduces the design and implementation of 40-㎓-band low noise amplifier (LNA) with ultra low gain flatness for wide-band wireless multimedia and satellite communication systems. The 40-㎓-band 4-stage LNA MMIC (Monolithic Microwave Integrated Circuit) demonstrates a small signal gain of more than 20 ㏈, an input return loss of 10.3 ㏈, and an output return loss of 16.3 ㏈ for 37$\square$42 ㎓. The gain flatness of the 40-㎓-band 4-stage LNA MMIC was 0.1 ㏈ for 37$\square$42 ㎓. The noise figure of the 40 ㎓-band LNA was simulated to be less than 2.7 dB for 37~42 ㎓. The chip size of the 4-stage LNA MMIC was 3.7${\times}$1.7 $\textrm{mm}^2$.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제16권5호
• /
• pp.687-694
• /
• 2016

A differential power amplifier operating at millimeter-wave frequencies is demonstrated using a 65-nm CMOS technology. All of the input, output, and inter-stage network are implemented by transformers only, enabling impedance matching with low loss and a wide bandwidth. The millimeter-wave power amplifier exhibits measured small-signal gain exceeding 12.6 dB over a 3-dB bandwidth from 45 to 56 GHz. The output power and PAE are 13 dBm and 11.7%, respectively at 50 GHz.