• Journal of the Korean Ceramic Society
• /
• v.41 no.4
• /
• pp.277-283
• /
• 2004

To fabricate green sheet of transparent dielectric for PDP front panel, dispersion of transparent dielectric slurry, density, and mechanical properties of green sheets have been investigated as a function of amount and composition of organic additives. Measurements of sedimentation and viscosity were employed to determine a proper dispersant and its amount for a well dispersed transparent dielectric powders in non-aqueous system. Green sheets, having various ratios of transparent dielectric powders to transparent dielectric powders＋ binder＋plasticizer and binder to binder＋plasticizer, were fabricated. All the tape casting slurries showed shear thinning effect, that is, the apparent viscosity decreased with the increase of shear rate. It was found that the amount and composition of organic additives were main variables to affect densities and mechanical properties of transparent dielectric green sheets for PDP.

• Journal of Animal Environmental Science
• /
• v.19 no.1
• /
• pp.39-46
• /
• 2013

This study was carried out to compare the filtration effect of anaerobic digestion waste water by compost filtration bed. Three types of filtration systems were set for filtration test following to composition of bedding materials. Two filtration systems were filled with sawdust, rice-hull and wood-chip. And the other was filled with sawdust and rice-hull. Anaerobic digestion waste water was applied evenly on the surface of the filtration bed with spraying nozzle. The concentration of nitrogen, biochemical oxygen demand (BOD), suspended solids (SS) of anaerobic digestion waste water was decreased by filtration treatment. The total nitrogen content was decreased from 1,313 mg/L to 1,090~1,293 mg/L and BOD concentration was decreased from 529.7 mg/L to 125~162.3 mg/L, respectively. The SS content was decreased from 69~79% by filtration process. In addition, the electrical conductivity (EC) was decreased from 10.22 ds/m to 7.91~8.31 ds/m.

• Journal of the Korean Ceramic Society
• /
• v.41 no.7
• /
• pp.548-554
• /
• 2004

A sol-gel method was applied to coat TiO$_2$ on porous silica prepared using slurry foaming method from silica. from the results of XRD, SEM, and BET, the anatase phase was firstly observed at the coated supports with the heated of 50$0^{\circ}C$. The coated supports with the heated of $700^{\circ}C$ had the maximum anatase peak, and the particle size of coated TiO$_2$ was about 1 ${\mu}{\textrm}{m}$. Bending strength and gas permeability of the porous silica were measured for the feasibility as a catalytic supports. In case of the uncoated porous materials with the strength of 2.4 MPa, the strength increased to 3.9∼4.3 MPa after the coating process regardless of the heating temperature. On the other hand, the permeability of the uncoated porous materials decreased from 770${\times}$10$^{-13}$ $m^2$ to 363${\times}$10$^{-13}$ $m^2$ after the coating process, and it decreased with the increasing heating temperature.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2001.10a
• /
• pp.29-62
• /
• 2001

Based on the results from investigation of behaviour of pulverized fly ashes (PFA) at laboratory and field, the way how to reduce the environmental impacts to geotechnical practices Is considered and described. In order to reduce discharged industrial by-products, it should primarily be emphasized that an effort are made as much as possible not to put into homing. Secondarily, an effort must be made to increase amount of utilization to geotechnical engineering practices. In addition, from an environmental point of view, we should challenge to create innovative materials which are eligible for controlling other wastes and remedying contamination m soils by using industrial byproducts which belong to wastes This Is a new concept in which the polluting materials can be eliminated by making use of wastes. Based on the above-stated concept, the previous and possible utilization of PFA is classified into: (1 ) reclamation, embankment or backfill material, (2) light weight geo-material, (8) soil stabilization/improvement, and (4) environmental material. The reason why PFA, in particular, slurry PFA has been used and will possibly be used more widely is due to the fact that PFA has the advantages : (i) low specific gravity leading to a light weight geomaterial, (ii) high pozzolanic activity enhancing strength, especially due to cement addition, and (iii) spherical shape of particles producing isotropy and then pumpability. As well as the concept of reducing geo-environmental impacts, the present text mainly describes the successful results at laboratory and field which have been obtained by the authors. The most important issue hi application of byproducts including PFA for geotechnical practices is to prevent leakage of polluted substances from sedimentary deposits, ground and earth structures. As one of possible techniques far achieving this purpose, a method of washing off the polluted substances by hot water is described.

• 한국지구물리탐사학회:학술대회논문집
• /
• 1999.08a
• /
• pp.202-216
• /
• 1999

The deep foundation is frequently used for the infrastructures. Since the quality control of the cast-in-place concrete foundations such as CIP piles and slurry walls is not so easy as that of the ready made PC(prestressed concrete) piles, it is necessary to get the information on the integrity of the concrete of the foundation. The depth estimation of foundations whose depths are unknown is also very important in repair and reinforcement works or in safety inspection and assessment to the big structures. The cross-hole sonic logging(CSL) system and the single channel reflection seismic measurement system were developed to test the integrity of pile. The former is well applied to CIP structures, while the later to all kinds of piles with less accurate result compared to that of CSL. To estimate the depth of the deep foundations, parallel seismics, borehole RADAR, and borehole magnetics can be used.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.392-395
• /
• 2003

For the purpose of digital x-ray imaging, many materials such as $PbI_2$, $HgI_2$, TlBr, CdTe and CdZnTe have been under development for servaral years as direct converter layer. $Hgl_2$ film detector have recently been shown as one of the most promising semiconductor materials to be used as direct converters in x-ray digital radiography. This paper, the $HgI_2$ films are deposited on conductive-coated glass by screen printing, in which $HgI_2$ powder is embedded in a binder and solvent, and the slurry is used to coat the conductive-coated glass. We investigated electrical characteristic of the fabricated $HgI_2$ films. The x-ray response to radiological x-ray generator of 70Kvp using the current integration mode will be reported for screen printing films. These results indicate that $HgI_2$ detectors have high potential as new digital x-ray imaging devices for radiography.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.2
• /
• pp.53-62
• /
• 2011

During the construction of vertical cutoff walls, filtration of bentonite slurry into the adjacent soil formation fabricates a layer of bentonite filter cake on the wall surface. The bentonite filter cake possesses much lower hydraulic conductivity compared to that of backfill materials in the cutoff wall. Hydraulic conductivity of bentonite filter cakes formed with three different types of bentonites has been measured by performing the modified fluid loss test under various pressure levels. Three different mixture ratios, 4, 6, and 8%, were selected for fabricating bentonite filter cakes to represent common field conditions. Two analysis methods for interpreting the experimental data from the modified fluid loss tests were employed to estimate hydraulic conductivity of the bentonite cakes. The range of hydraulic conductivities of the three bentonite cakes is between $2.15{\times}10^{-11}\;m/s$ and $2.88{\times}10^{-10}\;m/s$ which is 1 to 2.7 orders of magnitude lower than that of the design cutoff wall backfill. The stress distribution and thickness of the bentonite cakes were also evaluated in this paper.

• Journal of the Korea Concrete Institute
• /
• v.21 no.1
• /
• pp.3-11
• /
• 2009

The increased demand and consumption of coal has intensified problems associated with disposal of solid waste generated in utilization of coal. Major utilization of coal by-products has been in construction-related applications. Since fly ash accounts for the part of the production of utility waste, the majority of scientific investigations have focused on its utilization in a multitude of use, while little attention has been directed to the use of bottom ash. As a consequence of this neglect, a large amount of bottom ash has been stockpiled. However, the need to obtain safe and economical solution for its proper utilization has been more urgent. The study presented herein is designed to ascertain the performance characteristics of bottom ash, as autoclaved lightweight foamed concrete product. The laboratory test results indicated that tobermorite was generated when bottom ash was used as materials for hydro-thermal reaction. According to the analysis of variance, at the fresh state, water ratio affects on flow and slurry density of autoclaved lightweight foamed concrete, but foam ratio influences on slurry density, while, at the hardened state, foam ratio affects on the density of dry and the compressive strength but doesn't affect on flexural and tensile strength. In the results of response surface analysis, to obtain target performance, the most suitable mix condition for lightweight foamed concrete using bottom ash was water ratio of 70$\sim$80% and foaming ratio of 90$\sim$100%.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.5
• /
• pp.235-242
• /
• 2017

In order to prepare porous scaffolds capable of pore control, PMMA powder serving as a pore-forming agent was added to HA powder to synthesize a slurry containing TBA as a solvent. And then, porous HA scaffolds where pillarshaped pore channels interconnected with each other were fabricated by freeze-casting and sintering. The crystal structure of the HA scaffolds according to the addition amount of PMMA powder was measured by XRD and the surface and inner cross section of the scaffolds were analyzed through SEM. It was found that removal of PMMA during sintering affects the internal structure of the scaffolds and the crystallinity of the HA powder. Furthermore, through evaluating the physical and mechanical properties of the scaffolds, it was confirmed that the porosity, pore size and compressive strength can be controlled by controlling the addition amount of the pore-forming agent. It was also found that the HA scaffolds produced in this study were similar in structure and properties to the natural cancellous bone. This suggests that porous HA scaffolds with PMMA can be used as an alternative to autogenous bone for tissue engineering as an artificial bone scaffold.

• Journal of Animal Environmental Science
• /
• v.8 no.3
• /
• pp.183-190
• /
• 2002

A study was conducted to determine the effect of dietary probiotics or antibiotics on growth and pathological status in growing-finishing pigs. Ninety male pigs weaned at 24 days of age were divided into three groups of 30 pigs each on the basis of body weight and litter. Three groups of ten pigs(one pen) each were assigned to one of the following diets; a control diet or diets containing 0.1% probiotics or 0.1% antibiotics (1:1 mixture of kitasamycin and sulfamethazine). Average daily gain (ADG), feed efficiency(G/F) and the pathological status were monitored. ADG, feed efficiency and carcass quality were not different (P>0.05) among the three treatments. But pork quality in pigs fed probiotics tended to be improved, compared to other treatments. The pigs fed probiotics had lower pathological lesion in intestinal monitoring than that of other treatments pigs. The chemical composition of slurry(BOD, COD, SS, T-N, T-P and ammonia) in the probiotics treatments tended to be decreased, compared to other treatments. Results of this study suggest that dietary probiotics improve pigs' housing environment, and decrease the contents of polluting materials in slurry.