• International Journal of High-Rise Buildings
• /
• v.3 no.2
• /
• pp.99-106
• /
• 2014

This paper presents the determination of the structural system of the Changsha IFC T1 tower with 452 m in architectural height and 440.45 m in structural height. Sensitivity analyses are carried out by varying the location of belt trusses and outriggers. The enhancement of seismic capacity of the outer frame by reasonably adjusting the column size is confirmed based on parametric studies. The results from construction simulation including the non-load effect of structures demonstrate that the deformation of vertical members has little effect on the load-bearing capacity of belt trusses and outriggers. The elastoplastic time-history analysis shows that the overall structure under rare earthquake load remains in an elastic state. The influence of the frame shear ratio and frame overturning moment ratio on the proposed model and equivalent mega column model is investigated. It is found that the frame overturning moment ratio is more applicable for judging the resistance of the outer frame against lateral loads. Comparison is made on the variation of these two effects between a classical frame-core tube-outrigger structure and a structure with diagonal braces between super columns under rare earthquakes. The results indicate that plasticity development of the top core cube of the braced structure may be significantly improved.

• Journal of Magnetics
• /
• v.18 no.3
• /
• pp.245-249
• /
• 2013

A finite element model was built for MnBi/${\alpha}$-Fe nanocomposite permanent magnets, and the demagnetization curves of the magnets were simulated by micro-magnetic calculation. The microstructure of the cubic model is composed of 64 irregular grains with an average grain size of 20 nm. With the volume fraction of soft magnetic phase (t vol. %) ranged from 5 to 20 vol. %, both isotropic and anisotropic nanocomposite magnets show typical single-phase permanent magnets behavior in their demagnetization curves, illustrating good intergranular exchange coupling effect between soft and hard magnetic phases. With the increase of volume fraction of soft magnetic phase in both isotropic and anisotropic magnets, the coercive force of the magnets decreases monotonically, while the remanence rises at first to a peak value, then decreases. The optimal values of maximum energy products of isotropic and anisotropic magnets are 84 and $200kJ/m^3$, respectively. Our simulation shows that the MnBi/${\alpha}$-Fe nanocomposite permanent magnets own excellent magnetic properties and therefore good potential for practical applications.

• International Area Studies Review
• /
• v.18 no.3
• /
• pp.293-316
• /
• 2014

This paper examined a comparative study on the domestic violence of general families and multicultural families using meta analysis. Based on the analysis of one twenty studies of domestic violence as seven studies of social welfare, seven studies of education, and six studies of counseling and psychology, the following results were found. First, domestic violence, effective sample size, have a significantly difference on domestic families and multicultural families. Second, fixed effect model, compared to random effect model, have a significantly difference on the domestic violence of domestic families and multicultural families. Third, domestic violence, relative and cumulative effects, have a significantly difference on domestic families and multicultural families.

• Composites Research
• /
• v.34 no.2
• /
• pp.129-135
• /
• 2021

In this paper, in order to examine the effect of fiber volume fraction non-uniformity in thickness direction on the buckling load of cylindrical composite lattice structures, we modified the equation of buckling load of the cylindrical composite lattice structures proposed by Vasiliev. The thickness of each layer of the rib was varied by fiber volume fraction, and material properties were applied differently by using the rule of mixture. Also, we performed linear buckling analysis by varying the structure size, thickness, and average value of the fiber volume fraction of finite element model. Finally, by comparing the calculation results of the buckling load of the equivalent model using the modified buckling load equation and the results of the finite element analysis, we found that the fiber volume fraction non-uniformity in thickness direction can reduce the buckling load of the cylindrical composite lattice structure.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.44 no.5
• /
• pp.1004-1018
• /
• 2020

Advances in e-commerce enable consumers to shop efficiently for fashion products in global markets in addition, the market size of purchasing directly from foreign websites are also increasing. This study investigates the effects of hedonic and utilitarian shopping values on the continuous use intention of online cross-border shopping. Curiosity and self-efficacy were introduced as mediating variables between shopping values and user intentions. A web-based survey is conducted on female consumers, who have experiences to buy fashion products by online cross-border shopping. A total of 472 responses were collected from a panel of online survey firms. Data are analyzed using confirmatory factor analysis, structural equation modeling, and multi-group SEM by AMOS 21.0. According to the results of the structural equation model test, hedonic value affected continuous use intention of online cross-border shopping as mediated by curiosity and self-efficacy; in addition, utilitarian value influenced self-efficacy, which mediated relations between the utilitarian value and the continuous use intention. The research model was also tested to compare heavy users and light users of online cross-border shopping. For heavy users, the effect of hedonic value on curiosity was significantly stronger than for light users. Several implications are suggested based on the results.

• Nuclear Engineering and Technology
• /
• v.54 no.1
• /
• pp.61-71
• /
• 2022

Pool boiling heat transfer is widely applied in nuclear engineering fields. The influence of heating surface orientation on the pool boiling heat transfer has received extensive attention. In this study, the heating surface with different roughness was adopted to conduct pool boiling experiments at different inclination angles. Based on the boiling curves and bubble images, the effects of inclination angle on the pool boiling heat transfer and critical heat flux were analyzed. When the inclination angle was bigger than 90°, the bubble size increased with the increase of inclination angle. Both the bubble departure frequency and critical heat flux decreased as the inclination angle increased. The existing theoretical models about pool boiling heat transfer and critical heat flux were compared. From the perspective of bubble agitation model and Hot/Dry spot model, the experimental phenomena could be explained reasonably. The enlargement of bubble not only could enhance the agitation of nearby liquid but also would cause the bubble to stay longer on the heating surface. Consequently, the effect of inclination angle on the pool boiling heat transfer was not conspicuous. With the increase of inclination angle, the rewetting of heating surface became much more difficult. It has negative effect on the critical heat flux. This work provides experimental data basis for heat transfer and CHF performance of pool boiling.

• The Korea Journal of Herbology
• /
• v.30 no.2
• /
• pp.11-18
• /
• 2015

Objectives : Polygoni Multiflori Radix (Jeokhasuo in Korean) is a Oriental traditional herbs widely used in East Asian countries. Overconsumption of fructose results in hypertension, dyslipidemia, obesity and impaired glucose tolerance which have documented as a risk of cardiovascular diseases. This experimental study was designed to investigate the beneficial effects of an ethanol extract from Polygoni Multiflori Radix (PMR) in high-fructose (HF) diet-induced metabolic syndrome rat model. Methods : Sprague-Dawley (SD) rats were divided into three groups; Control group, receiving regular diet and tap water, HF group, and HF + PMR group both receiving supplemented with 65% fructose (n=10), respectively. The HF + PMR group initially received HF diet with PMR (100 mg/kg/day) for 8 weeks. Results : PMR significantly prevented the metabolic disturbances such as hyperlipidemia, hypertension and impaired glucose tolerance. Chronic treatment with PMR significantly decreased body weight, fat weight and adipocyte size, suggesting a role of anti-obesity effect. PMR led to improve the hyperlipidemia through the increase in HDL cholesterol level as well as the decrease in triglyceride and LDL cholesterol level. In addition, PMR suppressed adhesion molecules and endothelin-1 (ET-1) expression in aorta resulting in the decrease of hypertension. In muscle tissue, PMR significantly recovered the HF-induced insulin resistance through increase of insulin receptor substrate-1 (IRS-1), p-$AMPK{\alpha}1/2$, and p-Akt expression. PMR improved HF-induced metabolic disorders and its action was caused by energy metabolism-mediated insulin signaling activation. Conclusions : These results demonstrate that PMR may be a beneficial therapeutic for metabolic syndrome through the improvement of hyperlipidemia, obesity, insulin resistance and hypertension.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.12
• /
• pp.4420-4438
• /
• 2021

Image dehazing is an ill-posed problem which is far from being solved. Traditional image dehazing methods often yield mediocre effects and possess substandard processing speed, while modern deep learning methods perform best only in certain datasets. The haze removal effect when processed by said methods is unsatisfactory, meaning the generalization performance fails to meet the requirements. Concurrently, due to the limited processing speed, most dehazing algorithms cannot be employed in the industry. To alleviate said problems, a lightweight fast dehazing network based on a multiple scale-patch framework (MSP) is proposed in the present paper. Firstly, the multi-scale structure is employed as the backbone network and the multi-patch structure as the supplementary network. Dehazing through a single network causes problems, such as loss of object details and color in some image areas, the multi-patch structure was employed for MSP as an information supplement. In the algorithm image processing module, the image is segmented up and down for processed separately. Secondly, MSP generates a clear dehazing effect and significant robustness when targeting real-world homogeneous and nonhomogeneous hazy maps and different datasets. Compared with existing dehazing methods, MSP demonstrated a fast inference speed and the feasibility of real-time processing. The overall size and model parameters of the entire dehazing model are 20.75M and 6.8M, and the processing time for the single image is 0.026s. Experiments on NTIRE 2018 and NTIRE 2020 demonstrate that MSP can achieve superior performance among the state-of-the-art methods, such as PSNR, SSIM, LPIPS, and individual subjective evaluation.

• Journal of the Korean Society for Heat Treatment
• /
• v.36 no.6
• /
• pp.402-411
• /
• 2023

In order to examine the effect of cementite precipitated on the steel surface on the carburizing rate, the carburizing process was carried out at various boost times to measure the mass gain and carbon flux, phase analysis and carbon concentration analysis were performed on the surface of the carburized specimen. In the case of the only boost type, the longer the boost time, the more the mass gain by the diffused carbon follows the parabolic law and tends to increase. In particular, as the boost time increased, the depth of cementite precipitation and the average size of cementite on the steel surface increased. At a boost time of 7 min, the fraction of cementite precipitated on the surface is 7.32 vol.%, and the carburizing rate of carbon into the surface (surface-carbon flux) is about 17.4% compared to the calculated value because the area of the chemical (catalyst) where the carburization reaction takes place is reduced. The measured carbon concentration profile of the carburized specimen tended to be generally lower than the carbon concentration calculated by the model without considering precipitated cementite. On the other hand, in the pulse type, the mass gain by the diffused carbon increased according to the boost time following a linear law. At a boost time of 7 min, the fraction of cementite precipitated on the surface was 3.62 vol.%, and the surface-carbon flux decreased by about 4.1% compared to the calculated value. As a result, a model for predicting the actual carbon flux was presented by applying the carburization resistace coefficient derived from the surface cementite fraction as a variable.

• Journal of Biomedical Engineering Research
• /
• v.21 no.4
• /
• pp.403-409
• /
• 2000

This paper is about to simulate the defibrillation situations using 3D FE(finite element) thorax model and describes the effects of three clinical electrodes' positions and size and organ's resistivity used in simulation on the characteristics of current density distribution over myocardium. The model was constructed with a eillipsoidal cylinder for the thorax and the 2D Visible Human images for remains. And, the distributions of current density were computed by a commercial program ANSYS 5.4. The electrical shock of the AP(anterior-posterior ) electrode provided more current flows with heart than the others and that of the LL(lateral-lateral) electrode showed the most uniform current density distribution. However, the electrode size had little effect on the current density distribution. In the evaluation of model's sensitivity to tissue resistivity variation, the variation of the myocardium's resistivity most affected the minimum, average and maximum current densities.