• Wind and Structures
• /
• v.19 no.2
• /
• pp.199-217
• /
• 2014

Reported experimental and computational fluid dynamic (CFD) studies have demonstrated significant power augmentation of diffuser shrouded horizontal axis micro wind turbine compared to bare turbine. These studies also found the degree of augmentation is strongly dependent on the shape and geometry of the diffuser such as length and expansion angle. However study flow field over the rotor blades in shrouded turbine has not received much attention. In this paper, CFD simulations of an experimental diffuser shrouded micro wind turbine have been carried out with the aim to understand the mechanisms underpinning the power augmentation phenomenon. The simulations provide insight of the flow field over the blades of bare wind turbine and of shrouded one elucidating the augmentation mechanisms. From the analysis, sub-atmospheric back pressure leading to velocity augmentation at the inlet of diffuser and lowering the static pressure on blade suction sides have been identified as th dominant mechanisms driving the power augmentation. And effective augmentation was achieved for ${\lambda}$ above certain value. For the case turbine it is ${\lambda}$ greater than ${\approx}2$.

• KIEE International Transactions on Power Engineering
• /
• v.5A no.2
• /
• pp.132-137
• /
• 2005

In Korea, the protection systems against the instability of the nation's power system are insufficient in contrast with many other countries. In addition, there have just been studies carried out on detecting power system instability, while only a few studies pertaining to protection plans against instability exist. This paper focuses on systems to protect against the instability phenomena in the Korean power system. In this paper, we survey possible contingencies in the Korean power system and suggest outline and specs of the SPS (System Protection Scheme) against faults on the 765 kV line, based on simulations. It is concluded that event-based SPS for transient stability is appropriate for the Korean power system. In the simulations, the most severe contingency on the Korean power system is the fault on 765 kV transmission lines. If one of these lines is tripped by a fault, synchronism may be lost on the power plants near this line because of heavy power flow carried by them. In addition, undervoltage in the Metropolitan region is a serious problem in this case since this region receives about half its total power flow through these lines. In order to prevent a synchronism loss, some power plants have to be rejected according to the situations in the simulations.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.3
• /
• pp.309-315
• /
• 1991

The thermal transport coefficients-the self-diffusion coefficient, shear viscosity, and thermal conductivity-of liquid argon at 94.4 K and 1 atm are calculated by non-equilibrium molecular dynamics (NEMD) simulations of a Lennard-Jones potential and compared with those obtained from Green-Kubo relations using equilibrium molecular dynamics (EMD) simulations and with experimental data. The time-correlation functions-the velocity, pressure, and heat flux auto-correlation functions-of liquid argon obtained from the EMD simulations show well-behaved smooth curves which are not oscillating and decaying fast around 1.5 ps. The calculated self-diffusion coefficient from our NEMD simulation is found to be approximately 40% higher than the experimental result. The Lagrange extrapolated shear viscosity is in good agreement with the experimental result and the asymptotic formula of the calculated shear viscosities seems to be an exponential form rather than the square-root form predicted by other NEMD studies of shear viscosity. The agreement for thermal conductivity between the simulation results (NEMD and EMD) and the experimental result is within statistical error. In conclusion, through our NEMD and EMD simulations, the overall agreement is quite good, which means that the Green-Kubo relations and the NEMD algorithms of thermal transport coefficients for simple liquids are valid.

• Journal of Mechanical Science and Technology
• /
• v.14 no.1
• /
• pp.103-112
• /
• 2000

Numerical simulations of unsteady opposed-flow flames are performed using an adaptive time integration method designed for differential-algebraic systems. The compressibility effect is considered in deriving the system of equations, such that the numerical difficulties associated with a high-index system are alleviated. The numerical method is implemented for systems with detailed chemical mechanisms and transport properties by utilizing the Chemkin software. Two test simulations are performeds hydrogen/air diffusion flames with an oscillatory strain rate and transient ignition of methane against heated air. Both results show that the rapid transient behavior is successfully captured by the numerical method.

• Smart Structures and Systems
• /
• v.4 no.2
• /
• pp.123-135
• /
• 2008

Damping capacity of SMA damping devices is simulated numerically under distinct geometry and loading conditions. Two-dimensional numerical simulations are performed on the basis of a phenomenological model of dynamics of martensite-austenite phase boundaries. Results of the simulations predict the time delay and the value of the stress transferred to other parts of a construction by a damper device.

• 한국전산유체공학회:학술대회논문집
• /
• 1997.10a
• /
• pp.10-15
• /
• 1997

Unsteady natural convection of an enclosed fluid has been one of the fundamental thermo-fluid problems, of which dynamic relevance is found in many engineering applications. Together with the inherent coupling between the boundary layers and the interior core, and strong interaction between flow and temperature fields, the unsteadiness poses serious hurdles for analytical and experimental approaches. With the recent development of computers and solution algorithms, computational fluid dynamics has become the prevailing tool to tackle the underlying problems. In this presentation, a few examples of numerical studies are introduced. The usefulness and potential of numerical simulations in investigating unsteady natural convection are elaborated.

• Proceedings of the IEEK Conference
• /
• 2000.11a
• /
• pp.279-282
• /
• 2000

As digital systems continue to use components with faster edge rates and clock speeds, transmission of the digital information in these systems approaches the microwave realm. At these speeds digital signal fidelity becomes both a critical success factor and design challenge. The noise sources in digital systems include the noise in power supply, ground and packaging media due to simultaneous switching of drivers, signal reflections and distortions on single and multiple transmission lines. This paper presents theory, case studies and design considerations of gigabit interconnection for network and communication systems. The case studies show HSPICE and Ampredictor simulations of alternate approaches. Various subjects including skin effect and dielectric losses, interconnect simulations and crosstalks of connector, affected signal discontinuity, are addressed.

• Journal of Ocean Engineering and Technology
• /
• v.24 no.3
• /
• pp.31-37
• /
• 2010

During typhoon periods, coastal regions are often directly flooded by typhoon-surges. There are also many cases where coastal regions are inundated by river inundations or dam breaks. However, most studies on coastal flooding by typhoons have been restricted to cases involving the sea. Flooding by river inundation has been excluded in those studies. Usually ocean numerical models are not applied to river flow because the governing equations for ocean flow and river flow are not the same. For a coastal flooding simulation with river inundation, POM, the three-dimensional numerical ocean model, was applied to the popular river flow problems, dam-break problem, and flows over a spillway. The simulated results showed good agreement with other numerical simulations and measured data, suggesting the possibility of using POM in coastal flooding simulations involving direct coastal surges and river inundations.

• Journal of Preventive Medicine and Public Health
• /
• v.55 no.1
• /
• pp.28-36
• /
• 2022

The current multimorbidity correction method in the Global Burden of Disease studies assumes the independent occurrence of diseases. Those studies use Monte-Carlo simulations to adjust for the presence of multiple disease conditions for all diseases. The present study investigated whether the above-mentioned assumption is reasonable based on the prevalence confirmed from actual data. This study compared multimorbidity-adjusted years of lived with disability (YLD) obtained by Monte-Carlo simulations and multimorbidity-adjusted YLD using multimorbidity prevalence derived from National Health Insurance Service data. The 5 most common diseases by sex and age groups were selected as diseases of interest. No significant differences were found between YLD estimations made using actual data and Monte-Carlo simulations, even though assumptions about the independent occurrence of diseases should be carefully applied. The prevalence was not well reflected according to disease characteristics in those under the age of 30, among whom there was a difference in YLD between the 2 methods. Therefore, when calculating the burden of diseases for Koreans over the age of 30, it is possible to calculate the YLD with correction for multimorbidity through Monte-Carlo simulation, but care should be taken with under-30s. It is useful to apply the efficiency and suitability of calibration for multiplicative methods using Monte-Carlo simulations in research on the domestic disease burden, especially in adults in their 30s and older. Further research should be carried out on multimorbidity correction methodology according to the characteristics of multiple diseases by sex and age.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2021.06a
• /
• pp.60-60
• /
• 2021

Investigating Backward-Facing Step(BFS) flow is important in that it is a representative case for separation flows in various engineering flow systems. There have been a wide range of experimental, theoretical, and numerical studies to investigate the flow characteristics over BFS, such as flow separation, reattachment length and recirculation zone. However, most of such previous studies were concentrated only on the perpendicular step angle. In this study, several numerical investigations on the flow pattern over BFS with various step angles (10° ~ 90°) and expansion ratios (1.48, 2 and 3.27) under different Reynolds numbers (5000 ~ 64000) were carried out, mainly focused on the reattachment length. The numerical simulations were performed using an open source 3D CFD software, OpenFOAM, in which the velocity profiles and turbulence intensities are calculated by RANS (Reynolds Averaged Navier-Stokes equation) and 3D LES (Large Eddy Simulation) turbulence models. Overall, it shows a good agreement between simulations and the experimental data by Ruck and Makiola (1993). In comparison with the results obtained from RANS and 3D LES, it was shown that 3D LES model can capture much better and more details on the velocity profiles, turbulence intensities, and reattachment length behind the step for relatively low Reynolds number(Re < 11000) cases. However, the simulation results by both of RANS and 3D LES showed very good agreement with the experimental data for the high Reynolds number cases(Re > 11000). For Re > 11000, the reattachment length is no longer dependent on the Reynolds number, and it tends to be nearly constant for the step angles larger than 30°.) Based on the calibrated and validated numerical simulations, several additional numerical simulations were also conducted with higher Reynolds number and another expansion ratio which were not considered in the experiments by Ruck and Makiola (1993).