• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 추계학술대회 논문집 Vol.15
• /
• pp.175-177
• /
• 2002

Electrical characteristics of the Si-O superlattice diode as a function of annealing conditions have been studied. The nanocrystalline silicon/adsorbed oxygen superlattice formed by molecular beam epitaxy (MBE) system. Consequently, the experimental results of superlattice diode with multilayer Si-O structure showed the stable and good insulating behavior with high breakdown voltage. This is very useful promise for Si-based optoelectronic and quantum device as well as for the replacement of silicon-on-insulator (SOI) in ultra high speed and lower power CMOS devices in the future, and it can be readily integrated with silicon ULSI processing.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 추계학술대회 논문집 학회본부 A
• /
• pp.250-255
• /
• 2000

본 "수소 플라즈마를 이용한 SOI 기판 제작 및 SOI 전력용 반도체 소자 제작에 관한 연구"를 통해 수소플라즈마 전처리 공정에 의한 실리콘 기판 표면의 활성화를 통해 실리콘 직접 접합 공정을 수행하여 접합된 기판쌍을 제작할 수 있었으며, 접합된 기판쌍에 대한 CMP(Chemical Mechanical Polishing) 공정을 통해 SOI(Silicon on Insulator) 기판을 제작할 수 있었다. 아울러, 소자의 동작 시뮬레이션을 통해 기존 SOI LIGBT(Lateral Insulated Gate Bipolar Transistor) 소자에 비해 동작 특성이 향상된 이중 채널 SOI LIGBT 소자의 설계 파라미터를 도출하였으며, 공정 시뮬레이션을 통해 소자 제작 공정 조건을 확립하였고, 마스크 설계 및 소자 제작을 통해 본 연구 수행으로 개발된 SOI 기판의 전력용 반도체 소자 제작에 대한 가능성을 확인할 수 있었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 하계학술대회 논문집
• /
• pp.99-100
• /
• 2009

SGOI 1T-DRAM cells with various Ge mole fractions were fabricated and compared to the SOI 1T-DRAM cell. SGOI 1T-DRAM cells have a higher leakage current than SOI 1T-DRAM cell at subthreshold region. The leakage current due to crystalline defects and interface states at Si/SiGe increased with Ge mole. This phenomenon causes sensing margin and the retention time of SGOI 1T-DRAMs decreased with increase of Ge mole fraction.

• 반도체디스플레이기술학회지
• /
• 제3권4호
• /
• pp.29-32
• /
• 2004

Fully depleted Silicon-on-Insulator (FD-SOI) devices lead to better electrical characteristics than bulk CMOS devices. However, the presence of a thin top silicon layer and a buried SiO2 layer causes self-heating due to the low thermal conductivity of the buried oxide. The electrical characteristics of FDSOI devices strongly depend on the path of heat dissipation. In this paper, we present a new three-dimensional (3-D) analysis technique for the self-heating effect of the finger-type and bar-type transistors. The 3-D analysis results show that the drain current of the finger-type transistor is 14.7% smaller than that of the bar-type transistor due to the 3-D self-heating effect. We have learned that the rate of current degradation increases significantly when the width of a transistor is smaller that a critical value in a finger-type layout. The current degradation fro the 3-D structures of the finger-type and bar-type transistors is investigated and the design issues are also discussed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 하계학술대회 논문집 Vol.6
• /
• pp.21-22
• /
• 2005

Partially-depleted Silicon on insulator metal-oxide-semiconductor field- effect transistors (PD-SOI MOSFETs) with Silicon-germanium (SiGe) layer is investigated. This structure uses SiGe layer to reduce the kink effect in the floating body region near the bottom channel/buried oxide interface. Among many design parameters influencing the performance of the device, Ge composition is presented most predominant effects, simulation results show that kink effect is reduced with increase the Ge composition. Because the bandgap of SiGe layer is reduced at higher Ge composition, the hole current between body and SiGe layer is enhanced.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.565-568
• /
• 2000

This paper describes on the temperature characteristics of a SDB(silicon-wafer direct bonding) SOI(silicon-on-insulator) Hall sensor. Using the buried oxide $SiO_2$ as a dielectrical isolation layer, a SDB SOI Hall sensor without pn junction isolation has been fabricated on the Si/$SiO_2$/Si structure. The Hall voltage and the sensitivity of the implemented SOI Hall sensor show good linearity with respect to the applied magnetic flux density and supplied current. In the temperature range of 25 to $300^{\circ}C$, the shifts of TCO(temperature coefficient of the offset voltage) and TCS(temperature coefficient of the product sensitivity) are less than $\pm 6.7$$\times$$10^{-3}$/$^{\circ}C$ and $\pm 8.2$$\times$$10^{-4}$/$^{\circ}C$respectively. These results indicate that the SDB SOI structure has potential for the development of a silicon Hall sensor with a high-sensitivity and hip high-temperature operation.

• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2000년도 춘계총회,특별강연,심포지움,연구발표회
• /
• pp.127.1-127.1
• /
• 2000

• 대한전자공학회논문지
• /
• 제25권8호
• /
• pp.950-958
• /
• 1988

We have implemented a RTA system using W-halogen lamps and tried to recrystallize the phosphorus ion implanted amorphous silicon on insultor (SOI) taking advantages of seeding window. The purpose of this study is to investigate the possibility of a typical crystalline orientation occurred during the solidifying process of molten amorphous silicon layer. Experimental results show that several twin boundaries are found on the seeding window region after annealing for 15 sec at 1040\ulcorner. These twin boundaries represent that the recrystallization is partialy possible and when the annealing is done at 1150\ulcorner, (100) etch pits with <110> facets are found on the solidified amorphous silicon layer. Consequently, Hall mobility of recrystallized silicon film is measured and the thermal behavior of grain boundary is also observed by SEM.

• 센서학회지
• /
• 제19권2호
• /
• pp.137-141
• /
• 2010

In this paper, we fabricated silicon piezoresistive pressure sensor with dry etching technology which used Deep-RIE and etching delay technology which used SOI(silicon-on-insulator) wafer. We improved pressure sensor offset and its temperature dependence by removing oxidation layer of SOI wafer which was used for dry etching delay layer. Sensitivity of the fabricated pressure sensor was about 0.56 mV/V${\cdot}$kPa at 10 kPa full-scale, and nonlinearity of the fabricated pressure sensor was less than 2 %F.S. The zero off-set change rate was less than 0.6 %F.S.

• 대한전자공학회논문지SD
• /
• 제45권7호
• /
• pp.9-16
• /
• 2008

본 논문에서는 short-gate SOI MESFET의 문턱전압 도출을 위한 간단한 해석적 모델을 제시하였다. 완전 공핍된 실리콘 채널 영역에서는 2차원 Poisson 방정식을, buried oxide 영역에서는 2차원 Laplace 방정식을 반복법(iteration method)을 이용해 풀어 각 영역 내에서의 전위 분포를 채널에 수직한 방향의 좌표에 대해 5차 다항식으로 표현하였으며 채널 바닥 전위를 구하였다. 채널 바닥 전위의 최소치가 0이 되는 게이트 전압을 문턱 전압으로 제안하여 closed-form의 문턱 전압 식을 도출하였다. 도출된 문턱 전압 표현 식을 모의 실험한 결과, 소자의 구조 parameter와 가해진 bias 전압에 대한 정확한 의존성을 확인할 수 있었다.