• The Korean Journal of Pesticide Science
• /
• v.4 no.2
• /
• pp.44-49
• /
• 2000

Objective of this study was to determine the Si distribution and extent of control of powdery mildew diseases of cucumber(Cucumis sativus L.). The distribution of silicon in the leaf epidermis of cucumber plants grown in hydroponic nutrient solutions supplemented with soluble silicates was examined using scanning electron microscopy and energy dispersive X-ray analysis. The silicate absorbed from nutrient solution was translocated into cucumber leaves, and accumulated mainly in the cells surrounding the base of trichome hairs. Base cells surrounding the trichomes also had high levels of Si, Ca, and K. Si levels in the epidermal cells for low Si treatment were not detectable except in the trichome bases. Hyphal lengths of powdery mildew occurring on cucumber leaves cultivated in medium with high concentration of silicate were remarkably shorter than those of cucumber leaves cultivated with low concentration of silicate. There was a negative correlation between hyphal length of S. fuliginea and silicate concentrations.

• Journal of the Korean Ceramic Society
• /
• v.18 no.1
• /
• pp.41-47
• /
• 1981

The sintering characteristics of the SiC-Clay-Kaolin chamotte system were studied by addition of $Al_2O_3$ for the manufacture of silicate-bonded silicon carbide refractories at $1350^{\circ}C$. The sinterbilit of SiC-Binder mixture was measured by apparent porosity and compressive strength. And its mineral compositions were identified with X-ray diffractometer. The following results were obtained; 1) Optimum amount of mixed clay ($\textrm{Al}_2\textrm{O}_3$ 40 wt% mixed) as a binder was about 25wt% 2) Appropriate mixing ratio of mixed Kaolin chamotte ($\textrm{Al}_2\textrm{O}_3$ 40wt% mixed) was about 30wt% in the clay Kaolin chamotte binder. 3) Variation of apparent porosity and compressive strength of sintered SiC-binder mixture fired at $1350^{\circ}C$ were due to the sinterbility of clay.

• Journal of the Korean institute of surface engineering
• /
• v.47 no.4
• /
• pp.147-154
• /
• 2014

Formation behavior of PEO (Plasma Electrolytic Oxidation) films on AZ31 Mg alloy was studied in aqueous solutions containing various concentrations of hydroxide ion ($OH^-$) and silicate ion ($SiO_3{^{2-}}$) by voltage-time curves, and corrosion resistance of the PEO film-covered specimen was investigated by immersion test in 0.5 M NaCl solution. From the analyses of the voltage-time curves, it is suggested that two different types of anions are essentially needed for the formation of PEO films on AZ31 Mg alloy: film formation agent and local film breakdown agent. $SiO_3{^{2-}}$ ion acts only as a film formation agent but $OH^-$ ion acts not only as a film formation agent but also film breakdown agent. The PEO films prepared on AZ31 Mg alloy in alkaline silicate solution showed very good corrosion resistance without any pitting or filiform corrosions up to 480 h of immersion in 0.5 M NaCl.

• Journal of the Mineralogical Society of Korea
• /
• v.1 no.2
• /
• pp.94-103
• /
• 1988

Diamond anvil cell (DAC) interfaced with a YAG laser heating system has been used to study the phase transformations on perovskite structured titanates ($BaTiO_3$, and $PbTiO_3$) and to synthesize the silicate perovskite phase from the orthopyroxenes of $MgSiO_3$ and $(Mg_{0.87},\;Fe_{0.13})SiO_3$. $BaTiO_3$ and $PbTiO_3$ transform from tetragonal phase to cubic at the pressures of approximately 2.6 GPa and 4.0 GPa at room temperature, respectively. Cubic phases of the both show wide range of stability in the extended in-situ high pressures and high temperature regions. Starting orthoenstatite of $MgSiO_3$ has yielded the perovskite phase as the major structure with ilmenite, gamma-spinel, betta-spinel and stishovite phases at ~38 GPa and ${\sim}1,000^{\circ}C$. $(Mg_{0.87},\;Fe_{0.13})SiO_3$ has shown the perovskite as the major phase with betta-spinel, stishovite and enstatite phases at ~35 GPa and ${\sim}1,000^{\circ}C$. The ilmenite phase does not occur at this condition.

• Journal of the Korean Ceramic Society
• /
• v.32 no.2
• /
• pp.171-182
• /
• 1995

Five eucryptite and ten spodumene compositional powders were syntehsized from three sillimanite group, two kaolin group, and five pyrophyllite group silicate minerals. Those powders were isotatically pressed and fired at 1200~135$0^{\circ}C$ for 2 hrs, and then the sintered bodies were characterized. Silicate minerals with molar ratio of Al2O3 to SiO2 correspond to those of eucryptite and spodumene are kaolin and pyrophyllite group silicate minerals, respectively. Sintering characteristics of eucryptite from kaolin group and spodumene from pyrophyllite group mineral were superior to those from other silicate minerals. Eucryptite sintered bodies with 95~97% relative densities and densified microstructures can be obtained using Hadong pink kaolin as starting materials by sintering over broad temperature zone(1250~135$0^{\circ}C$). The eucryptite sintered bodies which were fired at 130$0^{\circ}C$ for 2hrs, from Hadong pink kaolin had within 3.0wt% microstructural compositional variations compaired with stoichiometric compound, and had good negative thermal expansiion property with -3.55$\times$10-6/$^{\circ}C$ thermal expansion coefficient. Spodumene sintered bodies which were prepared from pyrophyllite group silicate minerals, had dense microstructures and high densities by densification through liquid phase sintering with enlarged temperature range. The specimens which were fired at 130$0^{\circ}C$ for 2 hrs from Gusipyrophillite, had dense microstructure with crystallines mainly, and low thermal expansion property with 0.62$\times$10-6/$^{\circ}C$ thermal expansion coefficient. The porous texture and residual glass phase in LAS system ceramics which were prepared from silicate minerals, tend to increase the thermal expansion properties of sintered bodies to positive direction.

• Journal of the Korean Ceramic Society
• /
• v.17 no.4
• /
• pp.213-216
• /
• 1980

A glass-ceramics material of composition %SiO_2$: 38.50, $Al_2O_3$: 26.00, $Na_2O$: 18.00, CaO: 6.00, MgO: 4.00, $TiO_2$: 7.50 was strengthened by coating a series of glazes$(SiO_2-B_2O_3-Al_2O_3-CaO-PbO-Na_2O-)$, which has lower thermal expansion coefficient than that of the glass-ceramics. The thermal expansion coefficient of the glazes ranges $80~90{\times}10^{-7}$cm/cm/$^{\circ}C$, whereas that of the glass-ceramics is $115{\times}10^{-7}$cm/cm/$^{\circ}C$. The glass-ceramics was identified to be composed of nepheline, carnegieite low form, and meta sodium silicate crystal by X-ray diffraction phase analysis. The glaze, having lower melting point and appropriate thermal expansion coefficient, was tried to be stable and good at secondary heat treatment.

• Journal of the Korean Ceramic Society
• /
• v.11 no.1
• /
• pp.29-35
• /
• 1974

Effect of calcium sulfate and barium sulfate on the formation of portland cement clinker was studied by means of chemical analysis. DTA and X-ray diffraction analysis. In the presence of liquid phase, effect of the additives on the formation of tricalcium silicate was examined according to the reaction, 2CaO.$SiO_3$＋CaO$\longrightarrow$3CaO.$SiO_3$, which is the principal reaction in portland cement clinkerization, and optimum conditions in firing clinker concerning amount of additive, firing time and temperature were determined, and its kinetics was referred to. The experimental results are summerized as follow: (1) Appropriate burning temperature range of cement clinker is more limited as the content of calcium sulfate in clinker is increased. Amount of calcium sulfate, firing time and temperature in proper condition of clinkerization is related to each others. Being added suitable quantity of calcium sulfate, firing temperature of clinker can be lowered about $100^{\circ}C$. (2) When 3-5 mole% of calcium sulfate is added, firing time of 15-30 minutes at about $1380^{\circ}C$ is reasonable, and if the content is over7 mole %, firing for 1 hr. or more at $1350^{\circ}C$ is anticipated to be optimum condition. (3) In the reaction of tricalcium silicate formation, the role of barium sulfate as a mineralizer is similar to that of calcium sulfate, but the optimum firing temperature of cement clinker containing barium sulfate tends to be 20-$30^{\circ}C$ higher than that of clinker containing calcium sulfate. (4) When barium sulfate is used as mineralizer, 2-3 mole % of it to tricalcium silicate is recommended and if it is added more than this amount, free CaO is increased rapidly in clinker and alite formation is inhibited.

• Korean Journal of Soil Science and Fertilizer
• /
• v.12 no.3
• /
• pp.153-167
• /
• 1979

Proposal on the ways to determine the optimum levels of nutrients application on rice to maximize the yield was made paying attention on the desirable ratios among the major nutrients including N (organic matter) K, $SiO_2$, Ca, Mg. Following are the summary of the discussion. 1. For the higher yields, the balanced nutrients absorption is important. 2. Silica plays an important role in leading the applied N to increased yield. 3. Level of N application should be determined taking account of soil organic matter and abailable silicate contents. The higher the ratio of $SiO_2$/O.M. the more N can be applied for higher yield. 4. Different rice cultivars responds to the ratio of $SiO_2$/O.M. in soils, in different manner, in translating the applied N into yield. 5. By altering the ratio of $SiO_2$/O.M. through the application of silicate fertilizer or organic matter, the requirement of N in accordance with varietal characteristics can be determined. 6. When amount of N determined by above mentioned approaches, level of K application can be determined upon the basis of the ratio of $K/\sqrt{Ca+Mg}$ in soils.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.4
• /
• pp.103-111
• /
• 2012

One of the basic physical properties of the hardened cement paste, the rigidity, is deteriorated during concrete matrix forming, depending on the replacement rate of the crushed stone powder, and due to drying shrinkage. Therefore, the concrete containing crushed stone powder has been limitedly used as non-structural construction material. To improve these disadvantages, a hydrothermal reaction employing method can be considered. High-temperature and high-pressure water is involved in the hydrothermal reaction in the mixing with specific materials. The rigidity improving mechanism is related to the synthesis of calcium silicate. The calcium silicate is produced through reaction between calcium compounds and the silicic acid. Various kinds of calcium silicate can be produced depending on the CaO/$SiO_2$ mole ratio, the temperature of the hydrothermal synthesis, the pressure, and the reaction time. The product of the synthesis mechanism, tobermorite crystal, plays a pivotal role for the rigidity reinforcement. The crushed stone powder, analyzed in this study, contains 50 to 60% of $SiO_2$ and 10 to 20% $Al_2O_3$. The composite rate is appropriate to create the tobermorite crystal through formation of hardened cement matrix under the hydrothermal synthetic conditions and with the CaO in the cement. Moreover, further reinforcement was promoted using the property of material under the identical density through promoting the formation of tobermorite crystal.

• Korean Journal of Soil Science and Fertilizer
• /
• v.3 no.1
• /
• pp.17-21
• /
• 1970

To determine the effects of the silicate and the phosphate on the rice seedlings, 200 grams dry soil of the paddy field taken in the petri dish of 15cm diameter were treated with three levels of silicate(wollastonite) and phosphate. And the same amounts of nitrogen and potash were added constantly to each treated petridish. 100 grains of rice of which variety is Nongrim 25 were sown on each treated petridish simultaneously. After five times continuous culture, the rice plants and the soil were analyzed chemically and the results obtained are summarized as follows: 1. Dry matter weight of the rice seedlings was significantly increased to the increased phosphate absorption, on the other hand that was decreased when the silica absorption was increased. 2. The higher the available phosphate content in the soil after the experiments, the lower the silica content as well as absorption by the plant, and the $SiO_2/P_2O_5$ ratio in the plant was significantly decreased. 3. By the wollastonite application, the available silica, the exchangeable calcium in the soil after the experiment, and the silica content as well as silica absorption and $SiO_2/P_2O_5$ ratio in the rice plant was significantly increased. 4. Higher correlation coefficient was obtained between the exchangeable calcium amount and the silica content or silica/phosphate ratio in the rice plant than the available silica content in soil itself. 5. It is possible to control the silica/phosphate ratio in plant by the control of the silica/phosphate ratio in soil. 6. The relation between the silica/phosphate ratio in plant (y) and the available silica/phosphate ratio in soil (x) was $y=0.665+1.420x-0.0825x^2$ and the goodness of fit(r) was 82%.