• KEPCO Journal on Electric Power and Energy
• /
• v.1 no.1
• /
• pp.79-84
• /
• 2015

Transformer is widely used element on power system and industrial area. Especially the transformers installed at power system are exposed to an environment of arbitrary changed. Thus the prediction of degradation and the analysis of response to impulse are important. To conduct those works, the electrical characteristics of system should be analyzed, effectively. But the analysis of electrical characteristic in electric machine level such as pole and pad-mounted transformer is almost no, thus commercial VNA (Vector Network Analyzer) is used to getting the response in wide frequency range. However, the output power of VNA is usually under 10mW, so verification for effectiveness of measuring electrically large component should be conducted, firstly. Next, after getting total S-parameter of transformer, predicting impulse response can be performed in time-domain with circuit simulator. In this paper, it is introduced that verification effectiveness of VNA using transfer function from SFRA (Sweep Frequency Response Analyzer), firstly. Next, total S-parameter, six by six matix form, was built using measured 2 port S-parameter from vector network analyzer. To get the response to impulse which is defined by IEC 60060-1, time-domain simulation is conducted to ADS (Advenced Design System) circuit simulator.

• Journal of the Korean Society of Safety
• /
• v.28 no.3
• /
• pp.63-68
• /
• 2013

This paper is aimed to make an analysis on characteristics of the parallel arc waveform and RMS of current at the electrical tracking state by conductive powder. In order to achieve the goal in this paper, field state investigation at metal processing companies in Chung-Nam province area was conducted. With the field state investigation, conductive powder were collected from metal processing companies. By experiment on electrical connector(breaker, connector) over which the conductive powder were scattered, arc waveform and RMS of current were measured. The measured waveform and RMS(root-mean-square) of current were analyzed to describe characteristics and patterns of electrical arc by the conductive powder. It was proved that conductive powder on electrical connector can flow electrical current enough to make electrical fire with high thermal energy. Also the change of sine waveform and RMS of current can be used to find out relationship between electrical fire and fault signal by conductive powder. The results obtained in this paper will be very helpful for the prevention of electrical fires occurred at the metal processing companies.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.8
• /
• pp.1684-1690
• /
• 2003

In this paper, we proposed a fuzzy controller for the evaluation of the quantization Parameters in the H.263 coder to optimize the subjective quality of each coded frame, keeping the transmission rate constant. We adopted the Mamdani method for fuzzification and the centroid method for defuzzification. The energy and entropy are correlated to features of the HVS in spatial domain, while motion vectors are used to estimate the temporal characteristics of the signal. And then, the fuzzy inputs adapted the variance and the entropy in spatial domain, and the motion vector in temporal domain. We induced the fuzzy membership function and decided the fuzzy relevance to be compatible in visual characteristics. And then, we designed FAM banks. The fuzzy technology has been applied to a practical video compression. This results is obtained an effective rate control technique, an optimum bit allocation and a high subjective quality using fuzzy quantization.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9A
• /
• pp.874-881
• /
• 2010

Acoustic signal, which is a main carrier of underwater communication, attenuates along the traveled path heavily depending on the frequency as well as inter-node distance. In addition, since it has a long propagation delay, the conventional medium access control (MAC) schemes requiring complex signaling procedures and accordingly heavy overhead messages would not be appropriate in underwater communications. In this paper, we propose a code division multiple access (CDMA) scheme as a solution for MAC of underwater communication and evaluate the performance. A hierarchical data-gathering tree topology is considered and a staggered wake-up pattern is employed for the purpose of energy saving. As a performance measure, the data rate at each level of hierarchical topology is derived.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.1870-1872
• /
• 2005

In this study, an ultrasonic level limit sensor with a new structure utilizing the acoustic impedance matching is proposed to be able to check it out a change of water-level. 2 PZT resonators with the same property are bonded directly on the polyethylene plate. One resonator is for transmitter as an ultrasonic transducer, the other one is for receiver. In this case, a polyethylene plate will operate as an acoustic guider to transmit a transverse wave between 2 PZT resonators in air. While in the water, a polyethylene plate having a similar acoustic impedance with the water will be emitted an acoustic energy into the water as a longitudinal wave. According to this mechanism, there was a wide difference of acoustic signal output between underwater and in air. As a summary, this proposed level limit sensor could be used as a strong candidate with low cost and more stable one.

• Proceedings of the KOSOMBE Conference
• /
• v.1996 no.11
• /
• pp.243-246
• /
• 1996

This study was peformed to characterize the physiological signal prior to develop an algorithm which quantifies EEGs evoked by tactile stimulation. The experiment was devised with four experimental conditions, which were control and two levels of pressures in tactile sensation. Twenty subjects were used to obtain EEGs while applying tactile stimulation using two types of textiles, soft towel and sand paper, to the right hand of each subject. EEGs were acquired for 20 seconds, and each trial was repeated five times randomly at the different levels of stimulus intensities. The index, $S_{n}$, was obtained by calculating the ratio of energy distribution in the time-frequency plot for each scored psychological state of the subject. The results showed that dominant aspects of the EEG signals have their maximal frequencies concentrated at a lower ranges for the resting and pleasant state, while the spectral energies were distributed to higher frequency ranges when subjects experience an unpleasant emotion.

• Journal of Satellite, Information and Communications
• /
• v.5 no.1
• /
• pp.6-16
• /
• 2010

Since OFDM system suffers from high peak-to average power ratio(PAPR) drawbacks, more energy has been converted to seek for a new substitutable system which can maintain OFDM system's inherent virtues while avoid its defects. Consequently, a new multicarrier system called as CI/OFDM system has been proposed which applied carrier interferometry(CI) code to OFDM system. Due to its low PAPR advantage and orthogonal property, it has received more and more attention. Simultaneously, an old technique called single carrier(SC) system has retaken its attractions for the same purposes. This paper analyzes two cyclic prefixed transmission schemes variants of OFDM system: 1.carrier interferometry-Orthogonal Frequency-Division Multiplexing (CI/OFDM); 2. Cyclic prefixed single carrie(CP-SC) with frequency domain equalization. We compare the achievable bit rate transmission of the two systems in terms of signal to noise ratio(SNR) by mathematical derivation. We demonstrated that CI/OFDM achieves a bit higher transmission bit rate to that of the CP-SC with frequency domain equalizer.

• Journal of Satellite, Information and Communications
• /
• v.9 no.4
• /
• pp.20-25
• /
• 2014

In this paper, we provide efficient spectrum sensing technology for smooth use of frequency and energy charge of multi-copter. The proposed structures focus on improving performance of spectrum sensing that is based on Ad-hoc network. First, we explain basic principles and disadvantages of cooperative spectrum sensing and ad-hoc based spectrum sensing. To solve these problems, in this paper, we employ the beamforming technology that guarantees higher transmit primary users' signal power to secondary users in ad-hoc network. The performance of proposed algorithm is analyzed in terms of detection probabilities, and the results of this paper can be applied to the various ad-hoc based Cognitive Radio system.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.4
• /
• pp.528-533
• /
• 2010

This paper describes a calculation method of source level of a ship transient noise, which is one of the important elements for the ship detection. Aim of transient noise measurements is to evaluate of acoustic energy due to singular occurrence, which is therefore defined as non-periodic and short termed events like an attack periscope, a rudder and a torpedo door. In generally, in the case of randomly spaced impulse, the spectrum becomes a broadband random noise with no distinctive pattern. Therefore, frequency analysis is not particularly revealing for type of signal. In the paper, it is performed in time domain to analyze a transient noise. However, a source level of transient noise is required an investigation for multiple frequency band. So, in order to calculate a source level of transient noise, a design of exponential weighting function, convolution, band pass filtering, peak detection, root mean square, and parameter compensation are applied. The effectiveness of this calculation scheme is studied through computer simulations and a sea test. Furthermore, an application of the method is applied in a real case.

• Journal of Power Electronics
• /
• v.7 no.2
• /
• pp.159-173
• /
• 2007

In this paper, an intelligent sliding-mode position controller (ISMC) for achieving favorable decoupling control and high precision position tracking performance of permanent-magnet synchronous motor (PMSM) servo drives is proposed. The intelligent position controller consists of a sliding-mode position controller (SMC) in the position feed-back loop in addition to an on-line trained fuzzy-neural-network model-following controller (FNNMFC) in the feedforward loop. The intelligent position controller combines the merits of the SMC with robust characteristics and the FNNMFC with on-line learning ability for periodic command tracking of a PMSM servo drive. The theoretical analyses of the sliding-mode position controller are described with a second order switching surface (PID) which is insensitive to parameter uncertainties and external load disturbances. To realize high dynamic performance in disturbance rejection and tracking characteristics, an on-line trained FNNMFC is proposed. The connective weights and membership functions of the FNNMFC are trained on-line according to the model-following error between the outputs of the reference model and the PMSM servo drive system. The FNNMFC generates an adaptive control signal which is added to the SMC output to attain robust model-following characteristics under different operating conditions regardless of parameter uncertainties and load disturbances. A computer simulation is developed to demonstrate the effectiveness of the proposed intelligent sliding mode position controller. The results confirm that the proposed ISMC grants robust performance and precise response to the reference model regardless of load disturbances and PMSM parameter uncertainties.