• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.7
• /
• pp.1529-1536
• /
• 2010

In this paper, we propose a Axially displaced ellipse gregorian antenna with conical feed horn operating in Ku-band. For fast searching satellite position, it is designed the sub-reflector rotates about $1.5^{\circ}$ tilted by the central axis. the curvature and feed center of the main-reflector and sub-reflector are optimized to achieve maximum antenna efficiency. The designed reflector antenna shows the gain of 33dB and the cross polarization level of less than -21dB and the side-lobe level of less than －14 dB at 12.2 GHz. and C/N ratio of 19dB is proved by reception experiment of Koreasat with fabricated antenna.

• Journal of Biomedical Engineering Research
• /
• v.28 no.3
• /
• pp.429-440
• /
• 2007

A coded excitation has been studied to improve the performance for ultrasound imaging in term of SNR, imaging frame rate, contrast to tissue ratio, and so forth. However, it requires a complicated arbitrary waveform transmitter for each active channel that is typically composed of a multi-bit Digital-to-Analog Converter (DAC) and a linear power amplifier (LPA). Not only does the LPA increase the cost and size of a transmitter block, but it consumes much power, increasing the system complexity further and causing a heating-up problem. This paper proposes an optimized 1.5bit fourth order sigma-delta modulation technique applicable to design an efficient arbitrary waveform generator with greatly reduced power dissipation and hardware. The proposed SDM can provide a required SQNR with a low over-sampling ratio of 4. To this end, the loop coefficients are optimized to minimize the quantization noise power in signal band while maintaining system stability. In addition, the decision level for the 1.5 bit quantizer is optimized for a given input waveform, which results in the SQNR improvement of more than 5dB. Computer simulation results show that the SQNR of a FM(frequency modulated) signal generated by using the proposed method is about 26dB, and the peak side-lobe level (PSL) of its compressed waveform on receive is -48dB.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.758-761
• /
• 2007

Digital signal processing technique is applied in wide fields such as speech processing, image processing and spectrum analysis. Therefore, in order to do frequency selective operation digital filter is used in stead of analog filter and sharp filter characteristics can be implemented. Since finite impulse response (FIR) digital filter as nonrecursive type represents linear phase response characteristics and is always stable and is used in fields regarding wave information importantly such as data transmission. And due to frequency characteristics, in order to remove the Gibbs phenomenon generating around a discontinuous point, filter is designed through window function method. Therefore, in this paper to improve performance of FIR digital filter, a modified window function was applied. And the proposed method was compared with conventional methods using peak side-lobe and transition properties in simulations.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.1
• /
• pp.90-97
• /
• 2014

In this paper, we have designed the antenna for Korea SAT-5 Satellite Communication which can use Ka band in the earth station. The antenna structure consist of the the dual-offset gregorian reflector that has high gain and efficiency, the corrugated horn that has symmetric radiation patterns and low side lobe levels, the iris polarizer that make circular polarization and the OrthoMode Transducer that separate transmitting and receiving signals. The designed antenna gain is more than 45.7dBi in Tx-band which use LHCP and 42.0dBi in Rx-band which use RHCP. The co-polarized and cross-polarized radiation pattern comply with ITU-R S.580-6 and S.731-1 that are recommended by International Telecommunication Union in the geostationary satellite. The Axial ratio is less than 1.0dB in Tx-band and 1.5dB in Rx-band that meet MIL-STD-188-164A.

• Proceedings of the ESK Conference
• /
• 1997.04a
• /
• pp.17-25
• /
• 1997

The evoked potentials for concentrations of solutions of the four qualities of tastes(i.e., sweet, salty, sour, and bitter tastes) were measured. The solution was applied to the chorda tympani nerve located on the left side of the tongue at 20mm from the tip and 15mm left from the center line. The evoked potentials were detected from Cz referred to A1(left lobe) with the ground at the Fpz position. The Maximum potential level and its latency were evaluated. The individual threshold level of concentration of the solutions of four tastes were measured. Artificial saliva was used as a control solution. The evoked positive potentials for four qualities of tastes (i.e., gustatory evokde potentials) were found to be around 150ms by averaging eight responses. The arbitrary concentration of the solutions were presented by the relative concentration, which was the ratio of the arbitrary concentration to the individual threshold level. The characteristic relations between the latency and the relative concentration ;and those between the potential level and the relative concentration were evaluated. These evalutions showed that (1) the latencies for salty and bitter tastes denoted the minimum values due to for the change of relative concentration, and that (2) the latency for sour taste decreased as the relative concentrations increased, while the latency for sweet taste denoted the inverse tendency, Sinificant differences between any two maximum potential levels were not recognized. A response latencies to sucrose were abolished after treatment of tongue by a sweet-suppressing agent.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.3 s.357
• /
• pp.105-110
• /
• 2007

We have built the millimeter-wave passive imaging system with a lens and mechanical scan antenna. The lens was designed based on optical theory in order to focus millimeter-wane. A full image was taken from image points scanned by Placing antenna at the representative focal plane selectively. An integrated antenna array device for low-loss and low-noise with the array of 4 by 1, where components such as antenna, balun, MMIC, and detector were assembled on a sin91e substrate, and a fermi tapered slot antenna with high-gain and low-side lobe were used for elements of this millimeter-wave passive imaging system. Two dimensional antenna arrangement on focal plane was achieved in this imaging system.

• Journal of Chest Surgery
• /
• v.29 no.3
• /
• pp.346-349
• /
• 1996

This 32 year old female patient underwent left radical mastectomy due to ductal carcinoma on May 1990, and treated with FAM (5-fluorouracil, Adriamycin and Mitomycin C) regimen postoperatively. However, right cervical Iymph node enlargement and facial edema progressively developed since December 199). On April 1994, operation was performed, and findings were as followes; x4$\times$5$\times$7 to 1 : 1 $\times$ 1 cm sized multiple enlarged and hyperemic Iymph nodes were scatterred throughout submandibular area to the junction of superior vents cave and pericardium, and partially invaded both anterior segmental lobe, sternum and both distal tip of clavicles. After radical dissection of the nodes of neck and mediastinal nodes, and wedge resection of both anterior segments of lung, and partial resection of both clavicle tips and total sternum. The both innominate veins and superior vena cava were partially obstructed by invaded cancer SVC reconstruction was done with preclotted 10$\times$ 10$\times$ 18mm Y shap d woven Dacron graft, which was anastomosed to the point of the junction of subclavian vein and jugular vein after cross clamping both veins and 2cm above the pericardial junction with one arm clamp. After maintaining blood drainage to the SVC from the right side, left innominate vein was anastomosed with 4-0 Prolene continuous running suture. Bone cement was used for resected sternal portion and clavicular ends were fixed to postal portion with 18 Gauge wires. The patient was treated with radiation and chemotherapy after discharge, and there were no evidence of regrowing of the mass nor obstruction of the graft inspite of no antithrombotic therapy.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.5 no.2
• /
• pp.46-54
• /
• 1994

In this paper, an analysis and design method is proposed, which is to improve the directivity of microstrip array antennas conformed to a cylindrical surface. In the case of forming an arc-array in the circumferential direction on a circula-cylinder surface, the circular-cylinder can be approximated to a polygonal-pillar and on each pillar-planes the sub-arrays, Dolph-Tschebyscheff array and uniform array with a beam steered in the desired direction, would make a sharp directivity for the total cylin- drical array antenna. And the radiation pattern according to the type of its sub arrays is analyzed and compared using the cylindrical-cavity codel. A cylindrical microstrip array antenna, with 12 elements and uniform arra as a sub-array which have an equal distance$\lambda_0$/2between the elements, is manufactured and conformed to a cylinder with radius of 6 The measured data of side lobe level, HPBW and FNBW are - 13dB, $9^{\circ}$, and $15{\circ}$, ,respectively. This result shows a good improvement on the directivity comparing with a linear array.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.8
• /
• pp.684-692
• /
• 2016

In this paper, a non-offset longitudinal shunt slot excited by an asymmetry compound iris on the broad wall of a rectangular waveguide is presented as an element for a waveguide slot-array antenna(WSAA). By properly adjusting the iris dimension, a resonance of the slot at a desired frequency can be achieved. The proposed resonant slot has some advantageous properties, such as a wide range of normalized resonant conductance, and minimum change of phase in the waveguide at the resonance. In addition, when the slots are arrayed for a waveguide slot antenna, the unwanted cross-polarization level can be reduced because each slot is placed in a straight line. A $8{\times}1$ WSAA with -20 dB side-lobe level(SLL) is designed, fabricated, and tested experimentally. The measured results are well agreed with the simulated ones and have an SLL of -18.13 dB and a cross-polarization level of -48.85 dB at 9.41 GHz, which was improved by about 15 dB of that of the conventional longitudinal slot array antenna.

• Journal of IKEEE
• /
• v.6 no.1 s.10
• /
• pp.40-46
• /
• 2002

In this paper, a microstrip array antenna is designed, fabricated and measured for ETCS(Electronic Toll Collection System). To reduce effect of external propagation environment, we use edge-cuffed element and to obtain wider axial ratio and increased bandwidth, we use the sequential rotation array method. Also to fulfill ETCS, roadside equipment are designed to be provide a radiation pattern which can accurately pinpoint the designated communication area without interference of another lanes. And we make and apply an absorber to the array antenna to reduce SLL(Side Lobe Level). From the measurement, we get that return-loss at center frequency is -20.675dB, axial ratio is 0.35dB and the gain is 20.26dBi. And we found that SLL is reduced.