• 한국조명전기설비학회지:조명전기설비
• /
• 제8권3호
• /
• pp.54-63
• /
• 1994

본 연구에서는 판상스페이서 위에 침전극을 고정하고 gap간격 40[mm]에 평판전극을 설치한 gap 간에 10[mm]간격으로 나누어 각 구간내에 스페이서와 같은 재질의 Barrier를 설치하고 파티클을 두었을 때 AC 및 정극성 DC 전압에서의 방전로와 FOV에 대해 연구한 결과 다음과 같은 결론을 얻엇다. 1) Barrier가 고전위측에 위치한 경우와 파티클이 Barrier뒤에 은폐된 경우가 FOV가 높다. 2) 침전극 선단에 파티클 위치할 때 심한 FOV의 감소가 있다. 3) 파티클이 전극간에 게재되면 방전로는 파티클을 경유하므로 FOV는 감소한다.

• 한국제4기학회지
• /
• 제21권2호
• /
• pp.77-79
• /
• 2007

The source regions of Asian Dusts (Yellow Sands) in the western part of China are investigated, and the soil samples are collected samples for approximately 15 days during the spring of 2005. Particle sizes of sediments are analyzed and compared with each other. These grain-size analyses from the source areas can be compared Particle sizes between loess deposits and desert sands in western part of China and desert areas show distinctive differences. Loess deposits are predominantly composed of fine sands and silts. The distinction between the final characteristics of Asian Dust particles arrived in Korea and characteristics during transportation can be recognized comparison with the Asian Dust particles collected where the dust particles settled down. The characteristics of Asian Dust particle sizes can provide the basic information regarding the transportation history from the source region.

• 환경위생공학
• /
• 제11권1호
• /
• pp.39-44
• /
• 1996

The pressure fluctuations in a gas-solid fluidized bed has been analysed using s statistical method interpreting fluidized 냥d behavior. The performing statistical a analysis of the pressure fluctuations in a fluidized bed of 6.7cm-ID. using uniform p particle size of 115 to $1015{\mu}m$ in diameter. The fluidized gas used air(velocity 0.1~1.2m/sec) at settled bed height to diameter ratios which is LlD=l.O. Then, the pressure fluctuations measured by DPT(differantial pressure transducer). The measuring characteristic values of pressure fluctuation were the mean value and standard value, and also, it has been found that the standard deviation of the pressure fluctuations can be effectively used to predict minimum fluidizing velocity and to explain the fluidized phenomena.

• 한국조경학회지
• /
• 제25권2호
• /
• pp.94-103
• /
• 1997

The purpose of this study is to find out the effects of brick paved under-surface soil physical properties which are changed by fixed trampling. Thus, a sandy loam which is known as a profitable soil for plants is used an experimental soil to study the changes of the soil physical properties. It is related to sand bed's thickness & particle size which are settled by experimental variable factors. According to the variation of sand bed's particle size, bulk density and soil hardness at natural dryed soilcondition result in 0.075~2.00mm>2.00~5.00mm>2.00~8.00mm>5.00~8.00mm, and water content at natural dryed soil condition are observed being insensible change rate from the point that sand thickness is 30~40mm and more sand bed's thickness constructed by the variation of sand bed's thickness.

• 미생물학회지
• /
• 제48권2호
• /
• pp.134-140
• /
• 2012

황사는 중국과 몽골의 사막지역과 중국 황하 중 상류의 황토지대에서 바람에 의해 대기 중에 부유한 미세먼지가 상층 바람을 타고 멀리까지 날아가는 기상 현상을 말한다. 황사 먼지는 bioaerosol을 포함하며 미생물의 운반체로 작용할 수 있다. 따라서 본 연구에서는 황사 발생 기간과 황사가 없는 기간 동안 각각 포집한 낙하먼지에서 미생물의 농도와 종 조성을 비교하고자 하였다. 2008년 2월부터 4월까지 울산 지역의 한 지점에서 직경 200 mm의 강수량계를 사용하여 낙하먼지를 포집하였으며, 조사 기간 동안 울산 지역에서 황사 현상은 3월 2일과 3일에 걸쳐 한번 발생하였다. 낙하먼지에 포함된 세균의 농도는, 황사 기간 동안 포집한 시료에서 황사가 없는 기간의 시료에 비해 크게 높았다. 하지만, 낙하먼지의 진균 농도는 비 황사 기간에 비해 황사 기간 동안 유의성 있게 증가하지 않았으며, 조사 기간 동안 세균에 비해 상대적으로 일정한 수준을 유지하였다. 낙하먼지 시료로부터 분리한 45개 세균의 16S rRNA 유전자 염기 서열을 분석하였으며, 이들 세균은 Bacillus 속의 B. amyloliquefaciens, B. aryabhattai, B. atrophaeus, B. licheniformis, B. megaterium, B. methylotrophicus, B. pumilus, B. sonorensis, B. subtlis, B. vallismortis와 Staphylococcus 속의 S. epidermidis, S. succinus로 확인되었다. 진균의 경우 Mucor 속, Alternaria 속, Cladosporium 속, Aspergillus 속 등을 황사 기간 및 비 황사 기간의 시료에서 모두 확인할 수 있었다. Bacillus 속과 같은 내생포자를 형성하는 세균이 진균(포자)에 비해 황사 먼지에의 부착 및 이동과 더 연관이 있는 것으로 보인다.

• Nuclear Engineering and Technology
• /
• 제48권2호
• /
• pp.457-469
• /
• 2016

During the late phase of severe accidents of light water reactors, a porous debris bed is expected to develop on the bottom of the flooded reactor cavity after breakup of the melt in water. The geometrical configuration, i.e., internal and external characteristics, of the debris bed is significant for the adequate assessment of the coolability of the relocated corium. The internal structure of a debris bed was investigated experimentally using the DAVINCI (Debris bed research Apparatus for Validation of the bubble-Induced Natural Convection effect Issue) test facility. Particle sedimentation under the influence of a two-phase natural convection flow due to the decay heat in the debris bed was simulated by dropping various sizes of particles into a water vessel with air bubble injection from the bottom. Settled particles were collected and sieved to obtain the particle mass, size distribution in the radial and axial positions, and the bed porosity and permeability. The experimental results showed that the center part of the particle bed tended to have larger particles than the peripheral area. For the axial distribution, the lower layer had a higher fraction of larger particles. As the sedimentation progressed, the size distribution in the upper layers can shift to larger sizes because of the higher vapor generation rate and stronger flow intensity.

• Ocean Systems Engineering
• /
• 제2권1호
• /
• pp.33-47
• /
• 2012

This study revealed the behavior of droplets formed through leak process in deep water. There was a threshold depth named the universal attraction depth (UAD). Droplets rose upward in the zone below the UAD called the rising zone, and settled down in the zone above the UAD called the settling zone. Three mass loss modes were identified and formulated: dissolution induced by mass transfer, condensation by heat transfer and phase separation by pressure decrease. The first two were active for the settling zone, and all the three were effective for the rising zone. In consequence, the life time of the droplets in the rising zone was far shorter than that of the droplets in the settling zone.

• KIEAE Journal
• /
• 제7권4호
• /
• pp.135-140
• /
• 2007

In this study we settled the trouble of the MgO board of existence by this research. We changed the wooden one of the main ingredient of a board to a perlite and a mineral particle in the aluminum hydroxide group and proceeded with a study to physical character and fire resistance efficiency improvement. The result yellowing phenomenon could be improved and it was possible to reduce size decrease of pin hole and the frequency of occurrence. We found out that the in case of absorbed amount added 5~8% corresponding to the weight decreases the acrylic group emulsion suddenly. So this product is improved with the bending strength and water-resistance. After behavior stop time measurement of a mouse for experiments was measured at the time of a gas harmful effect test, an improved MgO board appeared more highly for an average of 138 seconds compared with a board of existence.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 The 6th International Symposium of East Asian Resources Recycling Technology
• /
• pp.715-718
• /
• 2001

This study uses traditional alum coagulation and sedimentation process to treat CMP wastewater from cleaning after polishing. The primary goal is to successfully recycle both solid fines and water for semiconductor manufacturing. Results indicated that CMP wastewater may be successfully treated to recover clean water and fine particles by alum coagulation. The optimum operating conditions for coagulation are as fellowing: alum dosage of 10 ppm, pH at 5, rapid mixing speed at 800 rpm, 5 min rapid mixing time, and long slow mixing time. The treated water with low turbidity and an average residual aluminum ion concentration of 0.23 ppm may be considered for reuse. The settled sludge after alum coagulation contains mainly SiO$_2$particle with a minor content of aluminum (1.7 wt%) may be considered as raw materials for glass and ceramic industry.

• 상하수도학회지
• /
• 제27권2호
• /
• pp.207-214
• /
• 2013

To evaluate characteristics of water quality in Jeju, a study was implemented for Han stream and retention ponds. Inflow water quality of retention ponds was heavily dependent on precedent rainfall, and no pesticide was detected due to the little artificial pollution sources. A smooth settling efficiency curve was noticed because heavy particles were already settled down in front of the retention pond. There were weak relationships between retention time and water quality, and this can be attributable to high concentration of pollutants influx at peak inflow. In addition, as Han stream retention pond has a role of groundwater recharge, inflow control based on water quality as well as quantity is needed to maximize pollutant removal at the retention ponds.