• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.10
• /
• pp.2397-2402
• /
• 2014

Recently, heterogeneous mobile communication network is attracting plenty of interest to serve explosively increasing mobile data traffic. Although the heterogeneous mobile communication network can enhance spatial reuse ratio by using both conventional macro cells and small cells simultaneously, it causes the unbalance in performance of downlink and uplink. In this paper, we propose a new cell selection scheme for heterogeneous mobile communication network. In the proposed cell selection scheme, mobiles select their home cells by considering both uplink and downlink performance, contrary to conventional schemes. We analyze the performance of the proposed scheme in terms of average cell transmission rate through system level simulations and compare it with those of conventional schemes.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.9
• /
• pp.3016-3033
• /
• 2014

The downlink performance of distributed antenna systems (DAS) with antennas selection is investigated in Rayleigh fading multicell environment, and the corresponding system capacity and bit error rate (BER) analysis are presented. Based on the moment generating function, the probability density function (PDF) and cumulative distribution function (CDF) of the effective signal to interference plus noise ratio (SINR) of the system are first derived, respectively. Then, with the available CDF and PDF, the accurate closed-form expressions of average channel capacity and average BER are further derived for exact performance evaluation. To simplify the expression, a simple closed-form approximate expression of average channel capacity is obtained by means of Taylor series expansion, with the performance results close to the accurate expression. Besides, the system outage capacity is analyzed, and an accurate closed-form expression of outage capacity probability is derived. These theoretical expressions can provide good performance evaluation for DAS downlink. It can be shown by simulation that the theoretical analysis and simulation are consistent, and DAS with antenna selection outperforms that with conventional blanket transmission. Moreover, the system performance can be effectively improved as the number of receive antennas increases.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.6
• /
• pp.211-223
• /
• 2018

Mobile relay systems have been adopted by $4^{th}$ generation mobile systems as an alternative method to extend cell coverage as well as to enhance the system throughput at cell-edges. In order to achieve such performance gains, the mobile relay systems require path selection and resource allocation schemes that are specifically designed for these systems which make use of additional radio resources not needed in single-hop systems. This paper proposes an integrated path selection and resource allocation scheme for LTE-Advanced relay systems using collaborative communication. We first define the problem of maximizing the downlink throughput of LTE-Advanced relay systems using collaborative communication and transform it into a multi-dimensional multi-choice backpacking problem. The proposed Lagrange multiplier-based heuristic algorithm is then applied to derive the approximate solution to the maximization problem. It is shown through simulations that the approximate solution obtained by the proposed scheme can achieve a near-optimal performance.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.12
• /
• pp.5723-5743
• /
• 2018

The evolving internet-based services demand high-speed data transmission in conjunction with scalability. The next generation optical network has to exploit artificial intelligence and cognitive techniques to cope with the emerging requirements. This work proposes a novel way to solve the dynamic provisioning problem in optical network. The provisioning in optical network involves the computation of routes and the reservation of wavelenghs (Routing and Wavelength assignment-RWA). This is an extensively studied multi-objective optimization problem and its complexity is known to be NP-Complete. As the exact algorithms incurs more running time, the heuristic based approaches have been widely preferred to solve this problem. Recently the software-defined networking has impacted the way the optical pipes are configured and monitored. This work proposes the dynamic selection of path computation algorithms in response to the changing service requirements and network scenarios. A software-defined controller mechanism with a novel packet matching feature was proposed to dynamically match the traffic demands with the appropriate algorithm. A software-defined controller with Path Computation Element-PCE was created in the ONOS tool. A simulation study was performed with the case study of dynamic path establishment in ONOS-Open Network Operating System based software defined controller environment. A java based NOX controller was configured with a parent path computation element. The child path computation elements were configured with different path computation algorithms under the control of the parent path computation element. The use case of dynamic bulk path creation was considered. The algorithm selection method is compared with the existing single algorithm based method and the results are analyzed.

• Journal of Biosystems Engineering
• /
• v.36 no.2
• /
• pp.130-139
• /
• 2011

Three modes of VIS/NIR spectroscopic measurement (interactance and two modes of transmission) were compared for their ability to estimate soluble solids content (SSC) of 'Shingo' pear non-destructively. The two transmission modes are named as full- and semi-transmission, where full-transmission stands for passing of light through abdomen of pear and semi-transmission is for transit of light mainly through flesh of pear. For comparison of the modes, prediction models developed from the collected spectroscopic data by the three modes were developed and tested for comparison of their performance. Partial least square regression (PSLR) was used to develop the models and various pre-processing methods were applied to develop models of high accuracy. The experiment was repeated three times with pears produced in different regions. The experiments resulted that selection of pre-processing is very important to attain accurate models, and multiplicative scatter correction (MSC) was selected as a pre-processor of high accuracy for the three modes of spectroscopic measurement in every experiment. Except for MSC, different group of pre-processing methods were selected for the three modes of measurement in every experiment without any tendency to the tested modes of measurement and pears of different produced region. Root-mean-square error of prediction (RMSEP) of prediction models of the three modes of measurement using prepreocessor of MSC were compared for their ability to estimate SSC. The models resulted in ranges of $0.37{\sim}0.57^{\circ}Brix$, $0.65{\sim}0.72^{\circ}Brix$, $0.39{\sim}0.51^{\circ}Brix$ for interactance, full- and semi-transmission, respectively. As shown, modes of semi-transmission and interactance resulted about the same level of prediction accuracy and were noted as modes of high performance to predict SSC.

• Journal of Digital Convergence
• /
• v.12 no.1
• /
• pp.339-345
• /
• 2014

This study has a purpose that improves efficiency of energy management and adaptation followed by movement of node better than the various early studied routing techniques. The purpose of this paper is the technique that uses RSSI value and location of sensor that is received by each sensor node to routing. This sduty does not save node information of 1-hop distance. And it solves energy-inefficient traffic problem that happens during data exchange process for middle node selection in close range multi hop transmission technique. The routing protocol technique that is proposed in this study selects a node relevant to the range of transmission which is set for RSSI value that is received by each node and selects the closest node as a middle node followed by location data. Therefore, it is for not exhaustion of node's energy by managing energy efficiently and cutting data transmission consuming until the destination node.

• Journal of KIISE
• /
• v.42 no.6
• /
• pp.791-800
• /
• 2015

In this paper, we propose the contribution-level-based opportunistic flooding in a wireless multihop network which achieves outstanding transmission efficiency and reliability. While the potential of the the predetermined relay node to fail in its receipt of broadcast packets is due to the inherent instability in wireless networks, our proposed flooding actually increases network reliability by applying the concept of opportunistic routing, whereby relay-node selection is dependent on the transmission result. Additionally, depending on the contribution level for the entire network, the proposed technique enhances transmission efficiency through priority adjustment and the removal of needless relay nodes. We use the NS-3 simulator to compare the proposed scheme with dominant pruning. The analysis results show the improved performance in both cases: by 35% compared with blind flooding from the perspective of the transmission efficiency, and by 20~70% compared to dominant pruning from the perspective of the reliability.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.5A
• /
• pp.333-340
• /
• 2003

In this paper, we propose a new turbo-coded orthogonal frequency division multiplexing (OFDM) transmission scheme that can improve greatly the performance by making all the turbo-coded symbols have the same reliability for OFDM transmission over a frequency selective fading channel. The same reliability, that is, the same fading can be accomplished through multiplexing of turbo-coded symbols using distinct orthogonal codes and spreading over the whole effective subcarriers (hereafter, called as the orthogonal code multiplexing (OCM)). As for the orthogonal code selection, we choose the set of the discrete Fourier transform (DFT) basis sequences, since the code set holds the orthogonality irrespective of the length and also has the equal energy property. We perform computer simulations using the Log-maximum-a-posteriori (Log-MAP) algorithm for iterative decoding in order to assess the performance of the proposed transmission scheme.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.40 no.6
• /
• pp.132-140
• /
• 2003

In this paper, we propose a new scheme for view-dependent transmission of three-dimensional (3-D) polygonal mesh models with hierarchial partitioning. In order to make a view-dependent representation of 3-D mesh models, we combine sequential and progressive mesh transmission techniques. By setting higher priorities to visible parts than invisible parts, we can obtain good qualify of 3-D models in a limited transmission bandwidth. In this paper, we use a multi -layer representation of 3-D mesh models based on hierarchical partitioning. After representing the 3-D mesh model in a hierarchical tree, we determine resolutions of partitioned submeshes in the last level. Then, we send 3-D model data by view-dependent selection using mesh merging and mesh splitting operations. By the partitioned mesh merging operation, we can reduce the joint boundary information coded redundantly in the partitioned submeshes. We may transmit additional mesh information adaptively through the mesh spritting operation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1542-1550
• /
• 2000

Fiber optic link systems based on SCM scheme are widely used as efficient and economic RF signal links between base station and a central station in mobile communication networks. However, its performance can be seriously limited depending on the operational conditions of not only the optical transmission system but also the wireless link in various environments. In this paper, we propose an analytic model for performance analyses of the SCM fiber optic link for CDMA RF signal transmission in various link environments. We present optimal operational conditions taking account of the nonlinear effects of the optical transmission system, and the multiple access interference produced at the wireless link. It has been shown through the BER analyses in this paper that the selection of optical modulation index of the SCM fiber optic links can be found optimally to minimize the fiber optic link noises and intermodulation distortion due to LD.