• 토지주택연구
• /
• 제8권1호
• /
• pp.13-22
• /
• 2017

In this study, triggering mechanism of ground sinking was analyzed through groundwater flow analysis on the basis of a case of the ground sinking occurred in Yongsan in 2015. The results of geotechnical investigation performed before and after the ground sinking were analyzed for the accurate understanding of geological features in the study area. The numerical groundwater flow analysis was performed to evaluate the influence of the flow behavior from the surrounding area toward the excavated site using software of Visual MODFLOW. As a result, it was found from the geotechnical analysis that the strata of sedimentary layer along the sunken area in the vertical direction was mixed significantly after the ground sinking compared with the status of the soil condition before the ground sinking. Piping was occurred at the toe of cut-off wall in the sandy gravel layer, and this phenomenon was predicted by the numerical flow analysis. Sequential ground displacement scenario of the ground sinking was derived from the geotechnical in situ test and numerical flow analysis performed in this study.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.434-437
• /
• 2006

Though numerous drilling has been performed in Jeju Island for development of ground water, the wells are mostly located along the coast lines or at low altitude area, and can hardly be found on the mid-mountain area. Two-dimensional magnetotelluric (MT) surveys have been carried out to cover the lack of geological Informal ion on the mid-mountain area and to figure out any possible structures or evidences for deep geothermal energy remained. Two-dimensional (2-D) inversion of MT data for four survey lines surrounding the Halla mountain show a thick layer having around 10 ohm-m in the depth of a few hundred meters throughout the survey area, which can be considered as the unconsol idated sedimentary layer. And they also show a conductive anomaly extending to more than 2km depth at the central part of each survey lines, which can possibly be related with old volcanic activities during the formation of Halla Mt.. Further seological/geophysical investigations should be followed.

• 지구물리
• /
• 제9권4호
• /
• pp.343-349
• /
• 2006

소양댐 상류의 미고결 퇴적물 분포를 파악하기 위하여, 길이 94 m의 5개 측선을 따라 2 m 간격으로 204 ms동안 탄성파 자료를 기록하였다. 기록된 자료를 초동주시 토모그래피 역산법과 지연시간법으로 처리하여 조사지의 퇴적물 분포를 종합적으로 구명하였다. 기반암은 평균 14 m 깊이로 비교적 평탄하게 분포하며, 산사면이 있는 남동쪽으로 상승한 형태를 보인다. 이 기반암을 댐 건설 이전에 형성된 기존 퇴적물이 덮고 있으며, 주로 호수 생성 이전에 형성된 토양이나 사질 퇴적물로 구성되어 있다. 최상부층인 최신 퇴적물은 호수 생성 이후 유입된 부유 퇴적물 기원의 이질 퇴적층으로, 하류지역보다 두꺼운 평균 1.6 m 두께로 쌓여 있다.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2007년도 공동학술대회 논문집
• /
• pp.267-272
• /
• 2007

Uiseong subbasin belonging to Kyungsang basin resulted from volcanic activity in the late Cretaceous. In this study, we carry out MT and gravity survey at the Hwasan caldera, which was formed of volcanic and abyssal rocks complex, then analyze and identify geological substructure. Potential survey such as gravity and magnetic survey has been mainly carried out in former studies, so depth information for understanding substructure was not enough. To complement a potential survey, we use MT method, which has high vertical resolution. Moreover we make a simple 2D model comparing with former study. The result of MT and gravity 2D modeling shows that this area is roughly composed of 3 layers; The bottom layer is a basement. In the second layer, intrusive rocks having high resistivity is placed along the ring faults and the sedimentary layer of low resistivity is inside caldera. The highest layer is alluvium. To comprehend the 3D structure of the Hwasan caldera, we perform 3D gravity inversion, and construct the 3D model from the result of 3D gravity inversion. MT responses are calculated by using the constructed 3D model and the 3D model of the Hwasan caldera's structure is suggested after comparing the calculated values with the observed values at MT line.

• 한국지반환경공학회 논문집
• /
• 제25권4호
• /
• pp.5-12
• /
• 2024

간석지(공유수면) 내 단지를 조성하는 경우, 해안 퇴적지반 특성상 대규모 성토재가 필요하고, 단지공사 시 불가피하게 발생되는 연약점성토를 성토재료로 활용하는 것이 자원재활용 및 경제적 측면(소요토량감소)에서 필요한 실정이다. 본 연구에서는 연약점성토의 성토재활용에 따른 절취교란된 점성토의 압밀특성변화를 파악하고, 압밀침하량 설계방안에 대하여 제안하였다. 연구 대상지의 압밀시험결과를 통해 교란(절취)에 따른 압밀특성치 변화(압축지수감소, 선행하중산정불가)를 확인하였고, 점성토 성토층을 복합대상층(압밀대상 및 상재하중층)으로 산정(압밀침하량)하는 방안이 실제거동과 부합한 결과로 분석되었다.

• 한국환경과학회지
• /
• 제4권5호
• /
• pp.103-103
• /
• 1995

In the Chinhae Bay, Korea, sedimentation rates and sedimentary record of anthropogenic metal loads were determined by $^{210}Pb$ dating and heavy metal analysis of four sediment cores . The sedimentation rates varied from 0.16g/$cm^2$/yr(3.1mm/yr) at Sta. Ct, located within narrow waterway to 0.24g/$cm^2$/yr(4.8mm/yr) at Sta. Cl, located in Haengam Bay. Maximum contents of Mn, Zn, Cu and Cr were observed at Sta. C2 located near the mouth of Masan Bay, while minimum contents were observed at Sta. CB. Mn/Fe ratios at Sta. C2 and Sta. C4 showed gradually increasing and decreasing downward, respectively, in the upper layer of sediment cores. This suggests that Mn may be diagenetically redistributed in highly reduced environment. At Sta. C2, the concentrations of Zn and Cu began to increase from 1920s by anthropogenic input and have been remarkablely increasing since mid 1960s. At Sta. C3, located near Sungpo, anthropogenic input of these two elements has also slightly increased after 1970s. However, pollution of these two elements was not significant in Haengam Bay(Sta. Cl) and Chiljun watenway(Sta. C4). The pollution of Co, Ni and Cr was not remarkable in all core samples except surface sediment of Sta. C2. The total input of anthropogenic Zn and Cu since 1920s was estimated to be 28∼792 ㎍/cm2 and 0∼168㎍/cm2, respectively. Sta. C2 showed remarkablely higher values relative to other stations: anthropogenic loads of Zn and Cu constituted 27% and 29% of the total sedimentary inventories at the present day, respectively. Fe, Ni, Cr and Co contents showed good correlation(r>0.8) with each other. Anthropogenic Zn and Cu also showed a very good positive correlation(>0.9). However, correlation between these two group of element was quite scattered, indicating different sources and geochemical behaviors.

• 한국환경과학회지
• /
• 제4권5호
• /
• pp.489-500
• /
• 1995

In the Chinhae Bay, Korea, sedimentation rates and sedimentary record of anthropogenic metal loads were determined by $^{210}Pb$ dating and heavy metal analysis of four sediment cores . The sedimentation rates varied from 0.16g/$cm^2$/yr(3.1mm/yr) at Sta. Ct, located within narrow waterway to 0.24g/$cm^2$/yr(4.8mm/yr) at Sta. Cl, located in Haengam Bay. Maximum contents of Mn, Zn, Cu and Cr were observed at Sta. C2 located near the mouth of Masan Bay, while minimum contents were observed at Sta. CB. Mn/Fe ratios at Sta. C2 and Sta. C4 showed gradually increasing and decreasing downward, respectively, in the upper layer of sediment cores. This suggests that Mn may be diagenetically redistributed in highly reduced environment. At Sta. C2, the concentrations of Zn and Cu began to increase from 1920s by anthropogenic input and have been remarkablely increasing since mid 1960s. At Sta. C3, located near Sungpo, anthropogenic input of these two elements has also slightly increased after 1970s. However, pollution of these two elements was not significant in Haengam Bay(Sta. Cl) and Chiljun watenway(Sta. C4). The pollution of Co, Ni and Cr was not remarkable in all core samples except surface sediment of Sta. C2. The total input of anthropogenic Zn and Cu since 1920s was estimated to be 28~792 $\mu\textrm{g}$/cm2 and 0~168$\mu\textrm{g}$/cm2, respectively. Sta. C2 showed remarkablely higher values relative to other stations: anthropogenic loads of Zn and Cu constituted 27% and 29% of the total sedimentary inventories at the present day, respectively. Fe, Ni, Cr and Co contents showed good correlation(r>0.8) with each other. Anthropogenic Zn and Cu also showed a very good positive correlation(>0.9). However, correlation between these two group of element was quite scattered, indicating different sources and geochemical behaviors.

• 한국방재학회:학술대회논문집
• /
• 한국방재학회 2008년도 정기총회 및 학술발표대회
• /
• pp.249-252
• /
• 2008

본 연구에서 북한의 지진자료에 대해 지진파의 이론적인 파형이 파수(wavenumber)와 주파수(frequency)에 대한 적분의 형태로 계산된다. 이 방법은 매질에 대해 많은 층의 입력값을 적용할 수 있기 때문에 실제지진 자료와 비슷한 이론적인 파형을 계산할 수 있다. 반복 작업에 의해 각 층의 두께와 속도, 감쇄상수 등을 고려한 한반도 지각에 가장 잘 적용할 수 있는 모델을 사용해서 북한의 폭파와 지진자료와 비슷한 이론적인 파형을 계산하였다. 본 연구의 결과는 지표의 퇴적층의 두께, 속도, 감쇄 상수가 이론적인 파형 계산에 매우 중요하다는 사실을 말한다. 실제 지진자료와 이론 파형을 비교 시, 초기 주시와 파형의 모양이 아주 잘 맞는 것을 볼 때 결과 모델이 한반도의 실제 지각구조와 매우 비슷하고 북한의 지진자료의 이론 파형 계산이 잘 되었다는 것을 알 수 있다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 봄 학술발표회 논문집
• /
• pp.747-752
• /
• 2003

This study was carried out to understand the stratigraphy and depositional environment of clayey soils that distributed in the Gadeok-do area, Kimhae plain (Nakdong estuary). For the study, SPT core sampling and magnetic susceptibility analysis were conducted. Soils in study area is classified into five sedimentary facies ascending order; sand/gravel. clay, sand/gravel, clay, interbedded sand and silty clay. Analysis of magnetic susceptibility for Gadeok-do clayey soil reveals that depositional process and environment can be divided into upper, middle and lower layer, and they are closely related to the sea level change since late Quaternary.

• 지질공학
• /
• 제19권2호
• /
• pp.145-152
• /
• 2009

절리는 전파할 때 상대적인 이동이 절리 벽에 수직으로 일어난 평탄한 신장 열림 모드 단열이다. 층상 퇴적암에 발달하는 절리는 일반적으로 층리면에 수직이고 인접한 절리와 평행한 배향과 규칙적인 간격을 가지며 절리 조를 이룬다. 본문은 층상 퇴적암의 절리에 대한 최근 연구 결과들을 토대로 절리 전파의 역학적 규제, 층두께-절리간격의 관계, 절리 간격의 빈도 분포, 절리 포화, 절리 밀도, 교차 절리, 절리 발달 기구 등을 고찰 한다.