• Transactions of Materials Processing
• /
• v.15 no.2 s.83
• /
• pp.132-137
• /
• 2006

This paper is concerned with the thermo-mechanical behavior including temperature dependent strain-rate sensitivity of steel sheet for an auto-body. In order to identify the temperature dependent strain-rate sensitivity of SPRC35R and SPRC45E, uniaxial tension tests are performed with the variation of the strain-rates from 0.001 /sec to 200 /sec at environmental temperatures varied from $-40^{\circ}C\;to\;200^{\circ}C$. The thermo-mechanical response at the quasi-static state is obtained with the static tensile test and at the intermediate strain-rate is from the high speed tensile test. Experimental results show that the strain-rate sensitivity increases at low temperature. It represents that as the strain-rate increases, the variation of flow stress becomes sensitive on the temperature. The results indicate that the flow stress of SPRC35R is more dependent on the changes of strain-rate and temperature than those of SPRC45E.

• Journal of Environmental Health Sciences
• /
• v.30 no.2
• /
• pp.133-139
• /
• 2004

The objective of this study was to investigate the destruction efficiency and to determine the fundamental parameters of oxidation kinetics under the supercritical water(SCW) condition. Target material was cephradine, toxic and antibiotic material, in the pharmaceutical wastewater. For this purpose, the effect of reaction temperature and oxidant were investigated on the destruction efficiency of cephradine. And the oxidation kinetics of cephradine was derived by using a empirical power-law model. The experiment was carried out in a cylindrical batch reactor made of Hastelloy C-276 which was endurable high temperature and pressure. The destruction efficiency of cephradine increased with increment of the temperature and reaction time. Also the type of oxidants was effected and oxidants(Air and $H_2O$$_2$) were enhanced the destruction efficiency. The global oxidation kinetics for cephradine has led to two rate expressions according to type of oxidant. - In the presence of air oxidant: Rate=k. $e^{-Ea}$RT/(Ceph.)$^{1.0}$ ( $O_2$)$^{0.51}$$\pm$0.05(k=3.27${\times}$$10^{5}$ sec. Ea=63.25 kJ/mole) - In the presence of $H_2O$$_2$ oxidant : Rate=kㆍ $e^{-Ea}$RT/(Ceph.)$^{1.0}$ ($H_2O$$_2$)$^{0.62}$$\pm$0.02(k=2.76${\times}$$10^4$/sec. Ea=47.65 kJ/mole)ole))

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.1
• /
• pp.37-42
• /
• 2011

In this study, it is analyzed that mechanical properties and required strength of porous concrete according to the mixing ratio of cement, fine aggregate, and water/cement ratio in order to evaluate mechanical properties of porous concrete using recycled asphalt aggregate. Recycled asphalt aggregates of 13 mm were used without modification of aggregate grading to extend porous concrete application. The water/concrete ratio was poor mix and the range of compressive strength was 18.2 to 19.5 MPa. The average value of permeability showed 8.0E-02 cm/sec.

• Journal of the Korean Chemical Society
• /
• v.40 no.12
• /
• pp.719-723
• /
• 1996

An inverse photoemission spectrometer has been built and tested to study the unoccupied electron energy states of solid surfaces. It consists of a low energy electron gun and a band pass photon detector in an ultra-high vacuum chamber. The electron ray tracing simulation and current measurement of the electron gun show a good focus and a high flux of electron current. The overall resolution of the spectrometer is 0.74 eV and the sensitivity of the photon detector is about 10 counts/$sec{\cdot}{\mu}A.$ As a test experiment, the inverse photoemission spectra of a Ge(111) sample is in good agreement with the theoretical result.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.31 no.2 s.257
• /
• pp.174-181
• /
• 2007

This paper is concerned with the thermo-mechanical behavior of steel sheet for an auto-body including temperature dependent strain rate sensitivity. In order to identify the temperature-dependent strain rate sensitivity of SPRC35R, SPRC45E and TRIP60, uniaxial tensile tests are performed with the variation of the strain rates from 0.001/sec to 200/sec and the variation of environmental temperatures from $-40^{\circ}C$ to $200^{\circ}C$. The thermo-mechanical response at the quasi-static state is obtained from the static tensile test and that at the intermediate strain rate is obtained from the high speed tensile test. Experimental results show that the variation of the flow stress and fracture elongation becomes sensitive to the temperature as the strain rate increases. It is observed that the dynamic strain aging occurs with TRIP60 at the temperature above $150^{\circ}C$. Results also indicate that the flow stress and tincture elongation of SPRC35R are more dependent on the changes of strain rates and temperature than those of SPRC45E and TRIP60.

• Journal of Sensor Science and Technology
• /
• v.5 no.6
• /
• pp.60-67
• /
• 1996

The interfacial electrical properties of InSb MIS structure with low temperature remote PECVD $SiO_{2}$ have been characterized. The interlace-state density at mid-bandgap of the MIS structure was about $1{\sim}2{\times}10^{11}\;cm^{-2}eV^{-1}$, when the $SiO_{2}$ film was deposited at $105^{\circ}C$. However, large amount of interlace states and trap states were observed in the MIS structure fabricated at temperatures above $105^{\circ}C$. The time constant of $10^{-4}{\sim}10^{-5}\;sec$ of interface states was extracted from G- V measurement. As the deposition temperature increased, the hysteresis of C- V curves were increased due to the high trap density.

• Journal of the Korean Vacuum Society
• /
• v.7 no.2
• /
• pp.112-117
• /
• 1998

TiN has been investigated as a good candidate for a diffusion barrier of Cu. Therefore, in this study, the grain boundary diffusion of Cu in TiN film was investigated by X-ray photoelectron spectroscopy(XPS). In general, TiN has a columnar grain structure. In the relatively lower temperature, less than 1/3 of the melting point, it was observed that Cu diffused into TiN mainly along the grain boundaries of TiN. The grain size of TiN was measured by atomic force microscope (AFM). In order to estimate the grain boundary diffusion constants, we used the modified surface accumulation method. The activation energy, $Q_b$ was 0.23 eV, and the diffusivity, $D_{bo}$ was $5.5\times10^{-12{\textrm{cm}^2$/sec.

• Journal of International Academy of Physical Therapy Research
• /
• v.9 no.4
• /
• pp.1596-1601
• /
• 2018

Smoking can be a significant cause of lung diseases and reduced respiratory functions. Among soldiers, smoking may have a negative impact on their health (physical strength) and well being. Information on differences in the respiratory functions of smokers and nonsmokers in the military services and the effects of the smoking duration and amount (i.e., the number of cigarettes smoked per day) would be useful. This study investigated smoking durations and smoking amounts among young male soldiers (N = 61). The forced vital capacity (FVC), forced expiratory volume in 1 sec (FEV1), and forced expiratory volume in 1 sec/forced vital capacities (FEV1/FEC) were measured FVC, FEV1, or FEV1/FEC of smokers and nonsmokers were not significantly different, and FVC and FEV1 were inversely proportional to smoking duration. Besides, the number of cigarettes smoked per day was not correlated with respiratory functions. These findings may be attributed to the effect of the strenuous physical activity (e.g., military drills) undertaken by soldiers on their respiratory functions. Despite the lack of evidence for a difference in the respiratory functions of smokers and nonsmokers, this study recommends ongoing respiratory function management through smoking cessation programs and respiratory physiotherapy to manage the respiratory functions of Korean smoking soldiers.

• Journal of Advanced Navigation Technology
• /
• v.13 no.4
• /
• pp.509-514
• /
• 2009

In this paper, we designed and analyzed 256GB DRAM-based SSD storage using DDR1 memory and PCI-e interface. SSD is a storage system that uses DRAM or NAND Flash as primary storage media. Since the SSD read and write data directly to memory chips, which results in storage speeds far greater than conventional magnetic storage devices, HDD. Architecture of the proposed SSD system has performance of high speed data processing duo to use multiple RAM disks as primary storage and PCI-e interface bus as communication path of RAM disks. We constructed experimental system with UNIX, Windows/Linux server, SAN Switch, and Ethernet Switch and measured IOPS and bandwidth of proposed SSD using IOmeter. In experimental results, it has been shown that IOPS, 470,000 and bandwidth,800MB/sec of the DDR-1 SSD is better than those of the HDD and Flash-based SSD.

• Journal of Astronomy and Space Sciences
• /
• v.27 no.4
• /
• pp.401-406
• /
• 2010

We have measured and analyzed the dark data of two PICNIC IR arrays (P574 and P560) obtained through the Cosmic Infrared Background ExpeRiment (CIBER). First, we identified three types of bad pixels: the cold, the hot, and the transient, which are figured in total as 0.06% for P574 and 0.19% for P560. Then, after the bad pixels were masked, we determined the dark noise to be 20.5 ${\pm}$ 0.05 $e^-$ and 16.1 ${\pm}$ 0.05 $e^-$, and the dark current to be 0.6 ${\pm}$ 0.05 $e^-$/sec and 0.7 ${\pm}$ 0.05 $e^-$/sec for P574 and P560, respectively. Finally, we discussed glitches and readout modes for a future mission.