• Journal of information and communication convergence engineering
• /
• v.14 no.1
• /
• pp.21-25
• /
• 2016

N-screen is a promising technology to improve support for multimedia multicasting, content sharing, content mobility, media scalability, and seamless mobility. In this paper, the WiMedia distributed-MAC (D-MAC) protocol is adopted for development of a seamless N-screen wireless service. Furthermore, to provide a multi-hop, one source multi-use N-screen service through point to point streaming in a seamless D-MAC protocol, a dynamic multi-frame transmission technology is proposed. In this technology, a dynamic time slot allocation scheme and a multi-hop resource reservation scheme are combined. In the proposed dynamic time slot allocation scheme, two thresholds, a hard threshold and a soft threshold, are included to satisfy the power consumption and delay requirements. A multi-frame DRP reservation scheme is proposed to minimize end-to-end delay during the multi-hop transmissions between N-screen devices. The proposed dynamic multi-frame transmission scheme enhances N-screen performance in terms of the multi-hop link establishment success rate and link establishment time compared to the conventional WiMedia D-MAC system.

• Proceedings of the KIEE Conference
• /
• 2004.11c
• /
• pp.243-245
• /
• 2004

This paper proposes design and implementation for Seamless Handoff method between adapters in a system environment where both wired and wireless adapters are present First of all, by settingLayer 2 address of wired adapter to Layer 2address of wireless adapter, then generate virtual adapter on the above layer to make these two adapters operate on an IP address. Under the condition, when wired communication via the wired adapter gets disconnected while in service, wireless handoff occurs by mapping information on the wireless adapter to the virtual adapter. According to the method proposed in this paper, continuous session can be obtained even when handoff between wired and wireless adapters occurs at lower level in an application where both IP address and Port address are used to maintain session since If address does not change.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2003.05b
• /
• pp.1301-1304
• /
• 2003

Mobile IP는 현재의 인터넷에서 노드가 링크를 변화시킬 때 통신이 지속 될 수 있도록 Mobility를 제공하기 위한 방안이다. Mobile IP는 MN(Mobile Node)가 HA(Home Agent) 와 FA(Foreign Agent) 사이에서 링크가 변화할 매 CN(Correspondent Node)와 지속적인 통신을 할 수 있도록 한다. 그러나 FA에서 FA로 MN이 노드의 위치를 바꿀 때에는 핸드 오프가 발생하여 패킷이 손실 될 수도 있다. 본 논문은 MN이 여러 FA를 이동할 때 발생하는 패킷 손실에 대한 경우를 살펴 이를 해결하기 위한 Seamless 핸드오프(Handoff) 알고리즘을 기술한다.

• Proceedings of the KSR Conference
• /
• 2009.05a
• /
• pp.396-405
• /
• 2009

An interlocking equipment of railway signalling systems should have very high functional safety and reliability properties because of its vital railway protection functionality. In order to achieve the required safety and reliability level, an engineer, in general, designs and implements the interlocking equipment to operate under RTOS(Realtime Operating System) environment, and the control hardware architecture redundant to cope with the random failures of system or subsystem. In such an architecture, it's very difficult to implement the interlocking equipment to communicate with various interface systems including the signal operator's terminal. In this paper, we propose a dual ethernet network topology and dual packet seamless transfer protocol algorithm for railway signaling system such as the interlocking equipment. We verify in this paper that the proposed DPST protocol algorithm has the evidence of its robust properties against the random hardware faults and communication errors. The proposed communication structure and algorithm is implemented in the electronic interlocking equipment for the private railway system of Hyundai Steel Company and its performance and properties are validated on the guideline of European Railway Standard EN50159.

• Journal of information and communication convergence engineering
• /
• v.2 no.4
• /
• pp.219-223
• /
• 2004

MMS has been seen as the key application in its entry into the 3G mobile markets. Furthermore, the combination of WLAN and 3G wireless technologies will make MMS service more popular, bringing benefits to both service providers and their customers. To realize seamless MMS service over WLAN and CDMA2000 networks, we design and implement new platform architecture by reusing the existing standards and network elements at the same time. We employ loose coupling approach and Mobile IP approach to propose new platform architecture, interfacing MMSC with many existing components. Based on our platform architecture, we also present seamless MMS delivery implementations that can't be possible within the current MMS reference architecture. This paper will make a contribution for service providers to offer their customers with seamless MMS service over WLAN and CDMA2000 networks.

• Journal of Communications and Networks
• /
• v.15 no.2
• /
• pp.207-216
• /
• 2013

Vehicular ad-hoc networks (VANETs) are self-organizing, self-healing networks which provide wireless communication among vehicular and roadside devices. Applications in such networks can take advantage of the use of simultaneous connections, thereby maximizing the throughput and lowering latency. In order to take advantage of all radio interfaces of the vehicle and to provide good quality of service for vehicular applications, we developed a seamless flow mobility management architecture based on vehicular network application classes with network-based mobility management. Our goal is to minimize the time of flow connection exchange in order to comply with the minimum requirements of vehicular application classes, as well as to maximize their throughput. Network simulator (NS-3) simulations were performed to analyse the behaviour of our architecture by comparing it with other three scenarios. As a result of this work, we observed that the proposed architecture presented a low handover time, with lower packet loss and lower delay.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.27 no.1
• /
• pp.139-142
• /
• 2023

In this paper, we propose a GNSS-UWB hybrid positioning system for indoor and outdoor seamless positioning. Fusion of GNSS and inertial sensors has been widely used as a method for estimating positions in places where GNSS reception sensitivity is low, and UWB technology, which started as a short-range wireless communication technology, is widely used indoors where GNSS is completely blocked. This paper proposes a method of mutual correction and fusion of the location information collected through GNSS and the location information collected from the UWB indoor positioning system when indoor and outdoor work occurs continuously and repeatedly, such as in an industrial site.

• Journal of Advanced Information Technology and Convergence
• /
• v.9 no.2
• /
• pp.55-63
• /
• 2019

Vehicle communication networks have some deficient network resources to support a vast multimedia service including safety driving information, video, news and some broadcast relayed from the playgrounds such as professional baseball games for autonomous vehicles. This paper deals with the framework for providing seamless multimedia service including safety driving information using multicast in cooperated-connected vehicle communication network (CVCN). It adopts smart-switch (SS) and smart intelligent multicast agent(SIMA) to support the seamless multimedia service. The SS manages and switches multimedia streams through SIMA in CVCN network. The SIMA to operate as an access point, is composed of multicast supporting part and control part of mobile devices/autonomous vehicles in CVCN network. Therefore this proposed technique using SS and SIMA within CVCN network is a new framework for multimedia service that can disperse the load of server.

• Journal of Information Technology Services
• /
• v.8 no.1
• /
• pp.193-202
• /
• 2009

Cloud computing emerges as a new computing paradigm which targets reliable and customizable services. The term builds on decades of research in virtual machine, distributed and parallel computing, utility computing, and more recently networking, web service, and software as a service. In this paper, we provide a seamless connection migration of web services. This is useful for cloud computing environment in which many client terminals have mobility. With the wireless internet facility, those mobile users can move place to place during internet communication. Therefore, we provide solutions to the two major problems in current virtualization based migration: communication failure problems and connection re-establishment. Communication channel flushing by zero window notification helps to resolve the communication failure problems and TCP port inheritance prevents connection re-establishment errors during socket reconstruction. Thus, our web service migration facility is now able to preserve open network connections, and even for server sockets. This is a highly transparent approach, in that we did not Introduce additional messages for channel flushing and did not make any modification to the TCP protocol stack. Experimental results show that the overhead due to connection migration of web services is almost negligible when compared with time to take the conventional web service migration.

• Journal of Information Processing Systems
• /
• v.14 no.3
• /
• pp.771-789
• /
• 2018

In heterogeneous wireless networks supporting multi-access services, selecting the best network from among the possible heterogeneous connections and providing seamless service during handover for a higher Quality of Services (QoSs) is a big challenge. Thus, we need an intelligent vertical handover (VHO) decision using suitable network parameters. In the conventional VHOs, various network parameters (i.e., signal strength, bandwidth, dropping probability, monetary cost of service, and power consumption) have been used to measure network status and select the preferred network. Because of various parameter features defined in each wireless/mobile network, the parameter conversion between different networks is required for a handover decision. Therefore, the handover process is highly complex and the selection of parameters is always an issue. In this paper, we present how to maximize network utilization as more than one target network exists during VHO. Also, we show how network parameters can be imbedded into IEEE 802.21-based signaling procedures to provide seamless connectivity during a handover. The network simulation showed that QoS-effective target network selection could be achieved by choosing the suitable parameters from Layers 1 and 2 in each candidate network.