• Nuclear Engineering and Technology
• /
• v.50 no.6
• /
• pp.849-853
• /
• 2018

Mechanistic calculations for wet scrubbing of aerosol/vapor from gas bubble rising in liquid pool are essential to safety of sodium-cooled fast reactor. Hence, scrubbing of volatile fission product from mixed gas bubble rising in sodium pool is presented in this study. To understand this phenomenon, a theoretical model has been setup based on classical theories of aerosol/vapor removal from bubble rising through liquid pools. The model simulates pool scrubbing of sodium iodide aerosol and cesium vapor from a rising mixed gas bubble containing xenon as the inert species. The scrubbing of aerosol and vapor are modeled based on deposition mechanisms and Fick's law of diffusion, respectively. Studies were performed to determine the effect of various key parameters on wet scrubbing. It is observed that for higher vapor diffusion coefficient in gas bubble, the scrubbing efficiency is higher. For aerosols, the cut-off size above which the scrubbing efficiency becomes significant was also determined. The study evaluates the retention capability of liquid sodium used in sodium-cooled fast reactor for its safe operation.

• Journal of Institute of Control, Robotics and Systems
• /
• v.13 no.6
• /
• pp.519-524
• /
• 2007

The OBC(on-board computer) of a satellite which plays a role of the controller for the satellite should be equipped with preventive measures against transient errors caused by SEU(single event upset). Since memory devices are pretty much susceptible to these transient errors, it is essential to protect memory devices against SFU. A common method exploits an error detection and correction code and additional memory devices, combined with periodic memory scrubbing. This paper proposes an effective memory scrubbing scheme for the OBC of STSAT-2. The memory system of the OBC is briefly mentioned and the reliability of the information stored in the memory system is analyzed. The result of the reliability analysis shows that there exist optimal scrubbing periods achieving the maximum reliability for allowed overall scrubbing overhead and they are dependent on the significance of the information stored. These optimal scrubbing periods from a reliability point of view are derived analytically.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.11
• /
• pp.1101-1105
• /
• 2011

Radiation particles can introduce temporary errors in memory systems. To protect against these errors, so-called soft errors, error detection and correcting codes are used. In addition, scrubbing is applied which is a fundamental technique to avoid the accumulation of soft errors. This paper introduces an optimal scrubbing scheme, which is suitable for a system with auto error detection and correction logic. An auto error detection and correction logic can correct soft errors without CPU's writing operation. The proposed scrubbing scheme leads to maximum reliability by considering both allowable scrubbing load and the periodic accesses to memory by the tasks running in the system.

• Journal of Korean Academy of Fundamentals of Nursing
• /
• v.13 no.2
• /
• pp.208-216
• /
• 2006

Purpose: This study was done to identify the differences in effectiveness of disinfections for surgical hand scrubbing according to the duration of scrubbing and the type of disinfectant. Method: From June 30 to August 14, 2003, the data were collected from 30 surgical nurses and surgeons in one general hospital in P city, Korea. All participants washed their hands with two different disinfectants and four different scrubbing times, they placed both finger tips on a blood agar plate and using sterile cotton tips microbes were collected from their palms, nails and forearms. Results: The first hypothesis of this study(with same disinfectant, there will be no difference in effect of disinfection in surgical hand scrub among four time groups) was supported. The second hypothesis of this study(with same duration of surgical hand scrub, there will be no difference in effect between two disinfectants) was also supported. Conclusion: There are no differences in effectiveness of disinfection for surgical hand scrubbing according to duration of the scrubbing and the type of disinfectant. So it is concluded that the effectiveness of disinfection depends more on the exactly how the scrubbing is done rather than the duration of scrubbing or the type of disinfectant.

• Journal of Korean Society of Water and Wastewater
• /
• v.9 no.3
• /
• pp.78-87
• /
• 1995

A study on the fouling control by periodical ozone-scrubbing was conducted in a membrane filtration process for drinking water treatment. Hydrophilic hollow fiber polyethylene membrane with pore size of $0.1{\mu}m$ and its surface area of $0.42m^2$ was used. Dead-End filtration method was selected to obtain high efficiency of energy. Laboratory prepared synthetic raw water with kaolin was used and the membranes were scrubbed by ozone once in an hour and once in two hours. When the duration of ozone scrubbing was increased from 10 seconds to 20 seconds, the rate of membrane fouling was significantly decreased. Although the frequency of ozone-scrubbing was reduced from once in an hour to once in two hours. the effect of fouling control was unchanged. However, ozone-scrubbing was not effective after a membrane was fouled and washed with detergent for reuse. Among several possible working effects of ozone, bactericidal effect was confirmed to be the primary reason of fouling control.

• Journal of Institute of Control, Robotics and Systems
• /
• v.20 no.4
• /
• pp.443-448
• /
• 2014

Soft errors in memory devices that caused by radiation are the main threat from a reliability point of view. This threat can be commonly overcome with the combination of SEC (Single-Error Correction) codes and scrubbing technique. The interleaving architecture can give memory devices the ability of tolerating these soft errors, especially against multiple-bit soft errors. And the interleaving distance plays a key role in building the tolerance against multiple-bit soft errors. This paper proposes a reliability model of an interleaved memory device which suffers from multiple-bit soft errors and are protected by a combination of SEC code and scrubbing. The proposed model shows how the interleaving distance works to improve the reliability and can be used to make a decision in determining optimal scrubbing technique to meet the demands in reliability.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.677-680
• /
• 2011

Error detection and correcting codes are typically used to protect against soft errors. In addition, scrubbing is applied which is a fundamental technique to avoid the accumulation of soft errors. This paper introduces an optimal scrubbing scheme, which is suitable for a system with auto error detection and correction logic. An auto error detection and correction logic can correct soft errors without CPU's writing operation. The proposed scrubbing scheme leads to maximum reliability by considering both allowable scrubbing load and the periodic accesses to memory by the tasks running in the system.

• Nuclear Engineering and Technology
• /
• v.53 no.2
• /
• pp.509-521
• /
• 2021

In this paper, from a review of the size distribution of the bubbles during pool scrubbing obtained from experiments by EPRI, we apply the bubble size distributions to analyses on the decontamination factors of pool scrubbing via I-COSTA (In-Containment Source Term Analysis). We perform sensitivity studies of the bubble size on the various mechanisms of deposition of aerosol particles in pool scrubbing. We also perform sensitivity studies on the size distributions of the bubbles depending on the diameters at the nozzle exit, the molecular weights of non-condensable gases in the carrier gases, and the steam fractions of the carrier gases. We then perform analyses of LACE-ESPANA experiments and compare the numerical ~ results to those from SPARC-90 and experimental results in order to show the effect of the bubble size distributions.

• Aerospace Engineering and Technology
• /
• v.2 no.1
• /
• pp.73-79
• /
• 2003

Usual satellite design adopts hardware Error Detection and Correction (EDAC) circuitary for memory elements to endure proper operation in space radiation environment and periodic read-back(scrubbing) scheme to remove errors occurred and to prevent further accumulation of errors, in parallel, But lack of detail radiation test data upset rates of KOMPSAT-2 mass storage was estimated very worse compared to that of KOMPSAT-1, which was evaluated from very precise radiation test. Although upset rates were evaluated enough low to accommodate by KOMPSAT-2 Flight Software, hardware scrubbing scheme is studied to shorten scrubbing time as well. This paper describes hardware scrubbing architecture having minimum 1.88 minutes scrubbing interval over 1 Gbits memory.

• Nuclear Engineering and Technology
• /
• v.46 no.6
• /
• pp.797-802
• /
• 2014

This study investigated the thermal hydraulic issues in the Containment Filtered Venting System (CFVS) for a long operating time using the MELCOR computer code. The modeling of the CFVS, including the models for pool scrubbing and the filter, was added to the input file for the OPR-1000, and a Station Blackout (SBO) was chosen as an accident scenario. Although depressurization in the containment building as a primary objective of the CFVS was successful, the decontamination feature by scrubbing and filtering in the CFVS for a long operating time could fail by the continuous evaporation of the scrubbing solution. After the operation of the CFVS, the atmosphere temperature in the CFVS became slightly above the water saturation temperature owing to the release of an amount of steam with high temperature from the containment building to the scrubbing solution. Reduced pipe diameters at the inlet and outlet of the CFVS vessel mitigated the evaporation of scrubbing water by controlling the amount of high-temperature steam and the water saturation temperature.