• Journal of the Korean Society of Safety
• /
• v.20 no.4 s.72
• /
• pp.46-53
• /
• 2005

Existing study far fire-resistant concrete has been done already. but it is not found out how the waste tyre mixing concrete will be acted against fire. This waste tyre concrete molds under the condition of $0^{\circ}C,\;200^{\circ}C,\;400^{\circ}C,\;600^{\circ}C$ were heated in gas oven. It was worried about that they might be fractured down at about $800^{\circ}C$ so that they can not be tested. compressive strength for the test molds are made with commercially used $180kg/cm^2,\;210kg/cm^2,\;240kg/cm^2,\;270kg/cm^2$ mixing saw dust with proportion such as 0.05%, 0.1%, 0.2%, 0.4%, 0.6%, 0.8%, 1.0%, 1.2%, 1.4%, 1.6%, 1.8%, 2.0% compressive strength at $200^{\circ}C$ was approximately 20% from the original, while approximately 30% deoreased at $400^{\circ}C$. their results are not quite different from the normal concrete condition even though they contains saw dust in it. The higher strength the concrete has, the less strength was decreased. There are almost no difference in strength under the condition of less than $400^{\circ}C$, but damage of concrete structure could be considerable large with more than $400^{\circ}C$.

• Journal of the Korean Applied Science and Technology
• /
• v.15 no.1
• /
• pp.79-90
• /
• 1998

One of the objectives of this study were to develop a process for manufacturing activated carbons from agricultural by-products(rice shells and saw dust) and another is to measure the iodine number, ash content and removal ratio of COD. The other is to compare those values with those of commercialized activated carbons. Agricultural by-products based activated carbons were manufactured through the steam-reaction method. A rotary kiln type furnace was used for both carbonization and activation. The optimum operating temperatures for carbonization and activation were $650^{\circ}C$ and $900^{\circ}C$, respectively. For the activated carbons produced under these conditions, the iodine number was 1,127mg/g. Especially, removal efficiency of COD was 61.5% for 40mg/L of wastewater and 30% for 150mg/L of SLS(Sodium Lauryl Sulfate).

• Applied Chemistry for Engineering
• /
• v.22 no.1
• /
• pp.77-80
• /
• 2011

In this study, we measured changes in the lignin content of acidified lignocellulosic biomass such as rice straw, saw dust, chestnut shell and peanut hull and analyzed the conversion property to cellulosic ethanol. It turns out that the lignin content increases in chestnut shell, rice straw, saw dust, peanut hull order and the conversion property to cellulosic ethanol is superior in the reverse order. Thus, the removal of lignin by acidification is necessary. In addition, as the concentration of sulfuric acid increases, the lignin content decreases and the yield of cellulosic ethanol increased. The optimum concentration of sulfuric acid is 20 wt%.

• Journal of Mushroom
• /
• v.13 no.3
• /
• pp.228-232
• /
• 2015

'Nongjin-go' is a new breed strain of Lentinula edodes, saw-dust bag variety. It is a cross combination of dikaryon Lentinula edodes ASI 3305mut and monokaryon L5-16 of L. edodes ASI 3305(Sanjo701ho). We crossbred them by 2011 and verified productive capacity from 2012 to 2013 in Rural Development Administration. Optimum temperature of mycelial growth is $30^{\circ}C$ and it of fruit-body primodium formation is range from 15 to $23^{\circ}C$. Nongjigo is agricultured at mid-high temperature well. Fruiting body is platy-hemisphere, light brown and centralizing. And bast is formed around edge of pileus. Yield productions per period is regular than 'Sanjo701'. Plastic bag culture medium is 1.5 kilogram and culture periods are 90~100 days. As its browning of pileus in culture is a little slow, Light and ventilation is needed a lot in light-culturing. Humidity is controlled properly for its color in fruit-body growing. Tested culture medium is consisted of 80% Oak-Tree saw-dust and 20% rice-bran.

• Horticultural Science & Technology
• /
• v.19 no.4
• /
• pp.585-590
• /
• 2001

Bulbs of Lilium Oriental hybrids cv. 'Casablanca' and 'Marco Polo' were grown in a plastic house in alpine area of Pyongchang Kangwondo. Saw-dust, black film, reflective film, transparent film, and white/black double film were used as mulching materials to ascertain the growth of foliage, the quality of flower, and the size of bulbs. Foliage weights of both lilies were higher when lilies were grown with mulching materials than control. There were no differences of bulb weight among the control and mulching treatments, except delayed bulb growth in black film and white/black double film. Mulching cultivation with saw-dust and reflective film stimulated foliage growth, root growth and bulb production, but black film delayed the growth and development. Transparent and white/black double films showed no effects on foliage growth and bulb development than the control. As mulching materials tended to delay lily growth, including foliage and bulb, an extension of growing term might be better to produce high quality lilies than common cultivation in alpine area.

• Asian Journal of Atmospheric Environment
• /
• v.8 no.1
• /
• pp.15-24
• /
• 2014

The capital city of Himalayan Country Nepal, Kathmandu Valley is surrounded by consecutive high mountains, which limits the air distribution and mixing effects significantly. It in turn generates steady air flow pattern over a year except in monsoon season. The air shed in the Valley is easily trapped by the surrounded mountains and the inversion layer formulated as the cap. The $PM_{10}$ concentration was noticeably higher than the standard level (120 ${\mu}g/m^3$) in urban and suburban area of Kathmandu valley for all seasons except monsoon period. The Valley area experiences similar wind patterns (W, WWS, and S) for a year but the Easterly wind prevails only during the monsoon period. There was low and calm wind blows during the winter season. Because of this air flow structure, the air emission from various sources is accumulated within the valley air, high level of air pollution is frequently recorded with other air polluted cities over the world. In this Valley area, brick kilns are recognized as the major air pollution source followed by vehicles. Mostly Bull Trench Kiln (BKT), Hoffman Kiln and Vertical Shaft Brick Kiln (VSBK) are in operation for brick firing in Kathmandu valley where the fuels such as crushed coal, saw dust, and natural gas are used for processing bricks in this study. Tool for the Reduction and Assessment of Chemical and Other Environmental Impacts (TRACI) was used for screening and quantifying the potential impacts of air emission from firing fuels. The total Environmental Performance Score (EPS) was estimated and the EPS of coal was approximately 2.5 times higher than those of natural gas and saw dust. It is concluded that the crushed coal has more negative impact to the environment and human health than other fuel sources. Concerning the human health and environment point of view, alternative environment friendly firing fuel need to be used for brick industry in the kiln and the air pollution control devices also need to be applied for minimizing the air emissions from the kilns.

• The Korean Journal of Mycology
• /
• v.25 no.4 s.83
• /
• pp.268-275
• /
• 1997

High prices of raw materials used as media for the mushroom cultivation increased the cost of commercial production of oyster mushroom (Pleurotus ostreatus). In this study, garlic peels (Allium sativum f. pekinese) as an agricultural by-product were investigated to replace the saw dust for the bottle cultivation of oyster mushroom. Mycelial growth of oyster mushroom were examined by the extracts made from the sawdust, rice bran and garlic peels. The mycelial growth was very poor in the agar media containing the extracts of sawdust or garlic peels, but was good when those of the rice bran were added. In the polypropylene bottle experiment, the sawdust medium which ammended with minerals vitamin was essential for the production of the mushroom fruitbodies. The rice bran was considered to stimulate the mycelial growth, but not the development of basidiocarps. The garlic peel was not a factor to stimulate the production of mushroom fruitbodies, but a raw material ammended with the rice bran produced much amounts of mushroom. In this work, garlic peels ($10{\sim}70%$ v/v) added to the mixture of sawdust and rice bran (4 : 1, v/v) was considered to help the productions of mushroom fruitbodies. Based on the result, the replacement of expensive saw dust with inexpensive garlic peels was a good example to reduce production cost of the bottle cultivation of mushroom.

• Journal of Environmental Health Sciences
• /
• v.24 no.1
• /
• pp.112-119
• /
• 1998

The objective of this study was to investigate the effect of bulking agents including cow manure, saw dust and rice straw in the ripening of leather sludge for vermistabilization. The changes of the waste properties for ripening time for 50 days were observed according to the various mixture ratios of leather sludge and bulking agents. The pH values of the mixture wastes were decreased from 7.5-8.0 to 6.4-7.3 with the ripening time for 50 days, and it was indifferent of the mixture ratio and type of the bulking agent. The initial value of oxidation-reduction potential(Eh) of the mixture waste was a negative(-)value indicating an unfavorable condition for earthworm life, but the values of Eh were increased with the ripening time. The increase rate of Eh value was proportional to the mixture ratio of bulking agents, but the increase rate for saw dust was higher than that of the cow manure and the rice straw. The value of alkalinity was also changed into the favorable range for earthworm after 50 days except for 10% of the mixture ratio of the bulking agents. When the mixture ratios of the bulking agents were increased from 10% to 40%, the growth characteristics of earthworms were increased from 31.7% to 95% for the survival rate, 103% to 225% for the liveweight increase rate and 32% to 91% for hatching rate of the cocoons. It can be concluded that the proper content of the bulking agents in the leather sludge to ensure effective vermistabilization was over 30%, when the mixture was ripened during 50 days. The contents of heavy metals in the ripened sludge were lower than the other regulatory standards for compost.

• The Korean Journal of Mycology
• /
• v.24 no.4 s.79
• /
• pp.322-328
• /
• 1996

It is possible to cultivate Pleurotus ostreatus on the crush medium of Reynoutria sachalinensis. The crush of leaves and stems of Reynoutria sachalinensis with water (1:8 W/V) enhanced mycelial growth of P. ostreatus. That mycelial growth of P. ostreatus on the crush medium was accelerated three times as fast as that on malt extract agar (MEA), and mycelial compactness was denser than that of on MEA. The same result was obtained on mixture of saw dust and the crush of leaves and stems in test tube and bottle. The addition of rice bran and the crush to saw dust was best for mycelial growth. Regardless of pH (4.5, 6.5 and 8.5), P. ostreatus could suppress the growth.

• Korean Chemical Engineering Research
• /
• v.50 no.1
• /
• pp.76-82
• /
• 2012

Biomass and coal are great potential energy sources for gasification process. These solids can be gasified to produce syngas and bio-oil which can be upgraded further to transportation fuel. Two biomass and three coals have been gasified with steam in a thermobalance reactor under atmospheric pressure in order to evaluate their kinetic rate information The effects of gasification temperature ($600{\sim}850^{\circ}C$) and partial pressure of steam (30~90 kPa) on the gasification rate have been investigated. The three different types of gas-solids reaction models have been applied to the experimental data to compare their predictions of reaction behavior. The modified volumetric reaction model predicts the conversion data well, thus that model was used to evaluate kinetic parameters in this study. The gasification reactivity of five solids has been compared. The obtained activation energy of coal and biomass gasification were well in the reasonable range. The expression of apparent reaction rates for steam gasification of five solids have been proposed as basic information for the design of coal gasification processes.