• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.6
• /
• pp.833-842
• /
• 2009

A series of laboratory experiments has been performed to investigate the behaviour of interfacial layer of saltwater wedge in estuary. Experimental conditions have been established according to densimetric Froude number, which is a dimensionless number comparing inertia force with buoyancy due to the density difference. To observe the behaviour of saltwater wedge, conductivity meter has been used to detect salinity. Time averaged and temporal variation of observed properties have been analyzed to determine and investigate the interfacial layer. The location and profile of interfacial layers have shown the dependency on densimetric Froude number. The thickness of interfacial layer has been also dependent on the variation of densimetric Froude number.

• Journal of Korea Water Resources Association
• /
• v.42 no.11
• /
• pp.1005-1015
• /
• 2009

Saltwater intrusion in coastal aquifer was investigated using a laboratory model. Salt-wedge profiles were reproduced in a porous media tank 140 cm long, 70 cm high, and 10 cm wide. The experiments were performed with various conditions of porous media hydraulic conductivity, salinity, and ground surface slope to assess relationships on salt wedge location and inclination. Salt-wedge profiles induced by saltwater intrusion were observed in porous media equilibrium state, and compared with previously derived formulas of the Glover (1959), Henry (1959) and Strack (1976). It was found that salt-wedge shape and formations were affected by the water level ratio ($H_F/H_S$) due to high hydraulic conductivity, saltwater salinity and ground surface slope. High $H_F/H_S$ of porous media having high hydraulic conductivity shifted the saltwater interface toward the saltwater reservoir. Increasing surface slope of the porous media caused the salt-wedge profile inclination to decrease. Saltwater salinity also contributed to the location of saltwater interface, yet the impact was not more significant than hydraulic conductivity.

• Journal of Fisheries and Marine Sciences Education
• /
• v.27 no.6
• /
• pp.1842-1853
• /
• 2015

The behavior characteristics of the saltwater intrusion in the Seomjin River Estuary by the inflow of fresh water were analysed by the field observation using CTD in the neap tide in January, June, and August 2013 as well as a numerical model, EFDC (Environmental Fluid Dynamics Code). As a result, Seomjin River Estuary is found that the saltwater intrusion is sensitive to the tide and tidal and freshwater flow. The results of field observation and numerical model were similar in the range of salt, but the results of salt wedge distribution were quite different. The observation of tide and tidal current as well as hydrographic surveying the Seomjin River Estuary will be jointly conducted for the accurate analysis.

• Journal of the Korean Society of Groundwater Environment
• /
• v.4 no.1
• /
• pp.5-13
• /
• 1997

The Island of Cheju plans massive ground water development to meet predicted water demand. Effective management of ground water resources requires impact assessment study. Due to the nature of the island, effects of sea water must be considered. In this work, salt water intrusion, due to hypothetical ground water development in Eastern and Central Cheju Watersheds, is predicted using a sharp-interface model. The model considers simultaneously hydrodynamics of both freshwater and saltwater. The hypothetical ground water development was designed such that it follows closely the regional ground water development plan. The numerical model predicted that the saltwater wedge may intude over 1km depending on the location. This observation leaves doubt on impact assement studies based on freshwater-flow only modeling.

• Journal of Ocean Engineering and Technology
• /
• v.32 no.4
• /
• pp.261-271
• /
• 2018

In this study, a hydraulic model test, to which Particle Image Velocimetry (PIV) system applied, was used to determine the hydrodynamic characteristics of the advection-diffusion of saltwater according to bottom conditions (impermeable/permeability, diameter, and inclination) and the difference of the initial salt. Considering quantitative and qualitative results from the experiment, the characteristics of the density current were discussed. As an experimental result, the advection-diffusion mechanism of salinity was examined by the shape of saltwater wedge and the flow structure of density currents with various bottom conditions. The vertical salt concentration obtained from the experiment was used as quantitative data to calculate the diffusion coefficient that was used in the numerical model of the advection-diffusion of saltwater.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.10 no.5
• /
• pp.159-168
• /
• 2010

This study investigates the relationships between the maximum freshwater pumping discharge and hydraulic properties of coastal aquifer using a laboratory model. The experiment performed the fresh pumping test in various locations near the saltwedge induced by saltwater intrusion to freshwater over aquifer characteristics of hydraulic conductivity, salinity, and ground surface slope. Saltwater pumping also tested to protest saltwater intrusion to the excessively discharging freshwater well. The maximum freshwater discharges were achieved, and then the optimum saltwater discharges were measured. It is found that greater hydraulic conductivity and ground surface slope produced greater the maximum freshwater pumping discharge. Salinity gave less impact on the pumping discharge relatively. Higher freshwater discharge was found at higher hydraulic conductivity and steeper ground surface slope. The optimum saltwater discharge required 14% more pumping rate than the maximum freshwater discharge to keep saltwater intrusion to the freshwater pumping well. Pumping well located closer to salt-wedge profile promoted less freshwater pumping discharge. Therefore, pumping well location, hydraulic conductivity, ground surface slope, and salinity should be taken into account in freshwater pumping in coastal aquifer.

• The Journal of Engineering Geology
• /
• v.19 no.2
• /
• pp.131-138
• /
• 2009

A simulation-optimization model is developed for development of groundwater and control of a saltwater wedge for protecting over-exploiting freshwater pumping wells. To achieve the goal an objective function is developed for three types of wells: freshwater pumping, freshwater injection and saltwater pumping. Integrity of groundwater environment is accounted for by including three indices. Illustrative cross-sectional examples show that both types of barriers can protect freshwater pumping wells from saltwater intrusion. A barrier well operating at the same rate located anywhere within a certain reach can protect a pumping well. However, the location of the reach appears to contradict the common practice of barrier placements. Consideration of the groundwater environment yields a unique optimal location for barrier wells.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2008.05a
• /
• pp.1838-1842
• /
• 2008

본 연구에서는 하구 유입 하천에서 발생하는 염수쐐기의 형상 및 거동특성을 구명하기 위하여 정상상태 염수쐐기 실험을 수행하였다. 길이에 비해 상대적으로 폭이 좁은 개수로의 상류부분에는 담수를 지속적으로 공급할 수 있는 담수공급장치를 설치하였고, 정상상태의 염수쐐기를 발생시키기 위하여 염수수조 측면에 지속적으로 염수를 공급할 수 있는 염수공급수조를 설치하였다. 실험조건은 담수 방류량과 이층류의 밀도차의 영향을 고려한 밀도프루드수(densimetric Froude number)를 기준으로 선정하였다. 실험결과 각 케이스별 염수쐐기의 형상은 중앙부에서 약간의 산포된 양상을 제외하고는 거의 선형을 이루는 것으로 관찰되었다. 경계층의 형상과 두께는 이층류의 농도장을 측정하고 밀도변동성분을 고려한 표준편차를 통하여 산정하였다. 그리고 염수쐐기의 선단부에 해당하는 리차드슨수와 경계층 두께와의 비교 등을 통해서 경계층의 양상을 파악하였다.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2005.05a
• /
• pp.59-64
• /
• 2005

Although experimental analysis for groundwater sample at wells located systematically are very effective to delineate seawater intrusion region at coastal area, this method is restricted in few wells and time. We have conducted electrical resistivity sounding at 30 points in the study areas to analyze the region of seawater intrusion and found the boundary between salt wedge and fresh water lens from the analysis results of geostatistical method using variogram for one-dimensional inversion results. The methodology adopted in this study would be useful for finding the seawater intrusion region and evaluating quantitatively.

• Journal of Korea Water Resources Association
• /
• v.49 no.5
• /
• pp.431-438
• /
• 2016

Large energy consumption is one of the main weaknesses of RO desalination. A new method is proposed to reduce the energy consumption of RO desalination which depends on the salinity of the feedwater. Low salinity feedwater can be obtained using groundwater wells which extracts both fresh groundwater and subsurface sea water. Subsurface feedwater is advantageous in overcoming other problems associated with surface seawater intakes. Salinities of groundwater depend on a number of factors. In this work a new simulation-optimization model is proposed to identify well locations and pumping rates with would provide the required design flow rate with the minimum salinity. When groundwater is developed in a coastal area, the saltwater wedge advances inland and may contaminate existing groundwater wells, which must be prevented. The model can protect existing wells while developing minimum salinity feedwater. Examples are provided to demonstrate the usage of the model.