• Journal of Life Science
• /
• v.17 no.12
• /
• pp.1616-1621
• /
• 2007

Off-flavors and odors in fermented cucumbers result from the growth of undesirable microorganisms during the secondary fermentation. Under laboratory conditions using a sterile fermented cucumber slurry medium, the spoilage fermentations were reproduced. Using this system the salt and pH conditions that allow the spoilage to occur were determined by varying the NaCl concentration and pH of the slurry medium. At pH 3, no spoilage was observed, regardless of the salt concentration, while at pH 3.5, pH 4, and pH 4.5, spoilage occurred in the 0 and 2% NaCl samples. For pH 5.0 samples, spoilage products were seen for all NaCl treatments. Based on these results the Preservation Prediction Chart was developed. The Chart may be used for selection of proper pH value and salt concentration for long term storage of fermented cucumber.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.24 no.4
• /
• pp.631-635
• /
• 1995

In order to develop effective manufacturing method and to improve quality of low-salt fermented squid(10% of table salt), we investigated the effects of temperature, salinity and pH on the growth of Staphylococcus xylosus, Micrococcus varians, Pseudomonas diminuta and Pseudomonas D2 isolated from of low-salt fermented squid and the growth characteristics of these bacteria during fermentation were elucidated. All bacteria showed good growth during the process of low-salt fermented squid(pH 6~7 ; concentration of NaCl, 7~10% ; temperature, 7~1$0^{\circ}C$) and their cell numbers increased as fermentation proceeded under the same fermentation condition.

• KSBB Journal
• /
• v.17 no.6
• /
• pp.509-514
• /
• 2002

Experiments were carried out to optimize the fermentation conditions for the production of erythritol by salt-tolerant mutant, Candida magnoliae M26. The optimum conditions of erythritol production showed a 1.0 vvm aeration and 500 rpm agitation at 28$\^{C}$ with an initial medium pH of 7.0. The pH control during the fermentation did not improve the erythritol yield and productivity. The maximum erythritol concentration of 143.3 g/L was obtained with 57% yield and 0.70 g/L-h productivity from 250 g/L of glucose and 5 g/L of yeast extract under an optimum fermentation conditions. The medium containing 0.5 M KCl or 0.5 M NaCl enhanced the production of erythritol and glycerol. However, glycerol production increased and erythrtiol production decreased by increasing the concentration of NaCl or KCl.

• The Korean Journal of Soil Zoology
• /
• v.3 no.1
• /
• pp.9-16
• /
• 1998

Effects of temperature, pH, and salt concentration on the preservation of the infective juvenile entolopathogenic nematodes, Steinernema carpocapsae, were analyzed. The effects of acclimation to sublethal low temperature and glycerol concentrations on rapid cold hardening of the nematodes were also evaluated to set up the conditions for their cryopreservation. All tested environmental factors could change the storage effectiveness of the nematodes. These analyses indicated that the optinal storage condition for the nematodes consisted of $15^{\circ}C$, pH 8.5, and 0.5-1.0% salt concentration. The nematodes showed a rapid could hardening in response to $5^{\circ}C$ for 2h. Glycerol induced the nematodes to increase the cold hardiness. Its high concentration over 10%, however, gave a harmful effect on the nematode survival.

• Korean Journal of Materials Research
• /
• v.13 no.4
• /
• pp.251-258
• /
• 2003

The effects of the salt and the precursor pH on the synthesizing behavior and the morphology of mullite have been studied. Two kinds of mullite precursor sols were prepared by the dissolution of two kinds of salt (aluminum nitrate enneahydrate, Al($NO_3$)$_3$ㆍ$9H_2$O; type I and aluminum sulfate 14∼18 water, (SO$Al_4$)$_3$$\cdot$$14∼18H_2$O; type II) into the mixture of colloidal silica sol, respectively. Precursor pH of the sols was controlled to the acidic (pH= 1.5∼2) and basic (pH= 8.5∼9) conditions. The co-products with nitrate and sulfate were completely eliminated at $500^{\circ}C$ and $850^{\circ}C$, respectively, which was confirmed by TG/DTA results. The synthesizing temperature of mullite phase was found to be above $1200^{\circ}C$ for pH= 1.5∼2 and above $1300^{\circ}C$ for pH= 8.5∼9 in type I. However, in type II, the synthesizing temperature of mullite was decreased to $850^{\circ}C$ for pH= 1.5∼2 and $1100^{\circ}C$ for pH= 8.5∼9. The grain size of the mullite synthesized at pH= 8.5∼9 was larger than that at pH= 1.5∼2 in overall heat-treated temperatures, showing smaller grain size in type II. Aspect ratio of the mullite grains was more increased at pH= 1.5∼2 than pH= 8.5∼9 in type I, showing similar aspect ratio at both pH conditions in type II. It was found that the synthesizing temperature and grain size were predominantly governed by the initial precursor pH and decomposition of the salt, with minor effect on the grain morphology.

• Membrane Journal
• /
• v.10 no.2
• /
• pp.92-101
• /
• 2000

For selective elimination of salt in the boiled extract of baby neck clam (Tapes variegata, BEBNC), electrodialyzer was used and the desalination conditions of BEBNC were determined at various concentrations, pH's and volumes of BEBNC. The ion-exchange membrane with a molecular weight cut off 100 Da was used for desalting of BEBNC. The desalination times on BEBNC concentrations of 0.5％ and 4％ were 100 min and 170 min and the final desalting ratio was above 90％. 1'he desalination of BEBNC at pH 4.0 was 12％ higher than that at pH 9.0 for 60 min. The electrodialysis process could remove above 90％ of the initial salt content in 2％ BEBNC of 1 L for 80 min. The results obtained prove that electrodialysis is a practical solution to the problem of selective elimination of salt from BEBNC.

• 한국생물공학회:학술대회논문집
• /
• 2000.04a
• /
• pp.157-160
• /
• 2000

Solubilization of bovine serum albumin(BSA) is performed using a reverse micellar system consisting of sodium bis(2-ethylhexyl) sulfosuccinate(AOT). Of particular, effects of pH, salt concentration and its type on the solubilization are investigated by means of the phase-transfer method. One of significant findings in our study is that the protein is to a large extent aggregated in the interface between organic and aqueous phases at lower pH and small salt concentration. In this presentation, the optimal extraction process conditions for BSA, which is bulky, are proposed.

• Polymer(Korea)
• /
• v.25 no.1
• /
• pp.108-114
• /
• 2001

Crosslinked poly(glycerol-co-malate)s were synthesized from L-malic acid in Krebs cycle and glycerol. The synthesized polymer was identified by FT-IR spectroscopy. Swelling degrees of the copolymer hydrogels were increased with an increase in pH of the aqueous solution. Hydrolytic behaviors of the crosslinked copolymers were investigated in various pH buffer solutions at 37${\circ}C$. The Hydrolysis of the copolymers proceeded faster with increasing pH of the aqueous solution. Releasing behaviors of the model drug such as diclofenac monosodium salt were also measured in various pH aqueous solutions at 37${\circ}C$. The release concentration of diclofenac monosodium salt from the hydrogel systems was increased with increasing pH. These facts indicate that the unreacted carboxyl and hydroxyl groups in the copolymers are greatly affected by pH in the conditions.

• Korean Chemical Engineering Research
• /
• v.51 no.6
• /
• pp.661-665
• /
• 2013

Effect of organic acid on the preparation of indium-oxalate salt from indium scraps generated from ITO glass manufacturing process was studied. Effects of parameters, such as type and concentration of organic acids, pH of reactant, temperature, reaction time on indium-oxalate salt preparation were examined. The impurity removal efficiency was similar for both oxalic acid and citric acid, but citric acid did not make organic acid salt with indium. The optimum conditions were 1.5 M oxalic acid, pH 7, $80^{\circ}C$, and 6 hours. On the other hand, the recoveries increased with pH, but the purity decreased. The indium-oxalate salt purity prepared by two cycles was 99.995% (4N5). The indium-oxalate salt could be converted to indium oxide and indium metal by substitution reaction and calcination.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.3 no.3
• /
• pp.159-167
• /
• 1999

This study performed experiments for measuring corrosion potential and current density variations in the polarzation curves of polyvinylchloride. The results were examined to identify particular influences affectingthe corrosion potential such as temperature, pH, enzyme, and salt. The lines representing active anodic dissolution were only slightly shifted in the potential direction by temperature, pH, enzyme and salt. The Tafel slope for the anodic dissolution was determined using the polarization effect with varying conditions. The slope of the polarization curves describing the active-to-passive transition region was noticeably shifted in the potential direction. In addition, using the variation in conditions, the best temperature and pH were determined for the corrosion rate, and resistance of corrosion. The second anodic current density peak and maximum passive current density were designated as degraded(IP/I0). The value of IP/I0 was used in measuring the extent of the degradation of the polyvinychloride. The potentiodynamic parameters of the corrosion were obtained using a Tafel plot.