• Korean Journal of Applied Biomechanics
• /
• v.23 no.3
• /
• pp.225-233
• /
• 2013

The purpose of this study was to estimate the potential injury via analyzing ground reaction force components that were resulted from a prolonged-run-induced fatigue. For the present study, passive and active components of the vertical ground reaction force were determined from time and frequency domain. Shear components of GRF also were calculated from time and frequency domain. Twenty subjects with rear foot contact aged 20 to 30, no experience in injuries of the extremities, were requested to run on the instrumented tread-mill for 160 minutes at their preference running speed. GRF signals for 10 strides were collected at 5, 35, 65, 95, 125, and 155 minute during running. In conclusions, there were no significant difference in the magnitude of passive force, impact load rate, frequency of the passive and active components in vertical GRF between running times except the magnitude of active force (p<.05). The magnitude of active force was significantly decreased after 125 minute run. The magnitude of maximum peak and maximum frequency of the mediolateral GRF at heel strike and toe-off have not been changed with increasing running time. The time up to the maximum peak of the anteroposterior at heel-strike moment tend to decrease (p<.05), but the maximum peak and frequency of that at heel and toe-off moment didn't depend significantly on running time.

• Structural Monitoring and Maintenance
• /
• v.2 no.1
• /
• pp.49-64
• /
• 2015

This paper presents a method for assessing the risk of wave run-up and overtopping of existing coastal defences and for analysing the probability of failure of the structures under future hydraulic conditions. The recent UK climate projections are employed in the investigations of the influence of changing environments on the long-term performance of sea defences. In order to reduce the risk of wave run-up and overtopping caused by rising sea level and to maintain the present-day allowances for wave run-up height and overtopping discharge, the future necessary increase in crest level of existing structures is investigated. Various critical failure mechanisms are considered for reliability analysis, i.e., erosion of crest by wave overtopping, failure of seaside revetment, and internal erosions within earth sea dykes. The time-dependent reliability of sea dykes is analysed to give probability of failure with time. The results for an example earth dyke section show that the necessary increase in crest level is approximately double of sea level rise to maintain the current allowances. The probability of failure for various failure modes of the earth dyke has a significant increase with time under future hydraulic conditions.

• Kyungpook Mathematical Journal
• /
• v.64 no.2
• /
• pp.287-301
• /
• 2024

From the mathematical and statistical point of view, a segment of a DNA strand can be viewed as a sequence of four-state (A, C, G, T) trials. Herein, we consider the distributions of runs and patterns related to the run lengths of multi-state sequences, especially for four states (A, B, C, D). Let X₁, X₂, . . . be a sequence of four state independent and identically distributed trials taking values in the set 𝒢 = {A, B, C, D}. In this study, we obtain exact formulas for the probability distribution function for the discrete distribution of runs of B's of order k. We obtain longest run statistics, shortest run statistics, and determine the distributions of waiting times and run lengths.

• Journal of Ocean Engineering and Technology
• /
• v.34 no.4
• /
• pp.245-252
• /
• 2020

Wave run-up is an important phenomenon that should be considered in ocean structure design. In this study, the wave run-up of a surface-piercing circular cylinder was calculated in the time domain using the three-dimensional linear and fully nonlinear numerical wave tank (NWT) techniques. The NWT was based on the boundary element method and the mixed Eulerian and Lagrangian method. Stokes second-order waves were applied to evaluate the effect of the nonlinear waves on wave run-up, and an artificial damping zone was adopted to reduce the amount of reflected and re-reflected waves from the sidewall of the NWT. Parametric studies were conducted to determine the effect of wavelength, wave steepness, and the draft of the cylinder on the wave run-up of the cylinder. The maximum wave run-up value occurred at 0°, which was in front of the cylinder, and the minimum value occurred near the circumferential angle of 135°. As the diffraction parameter increased, the wave run-up increased up to 1.7 times the wave height. Furthermore, the wave run-up was 4% higher than the linear wave when the wave steepness was 1/35. In particular, the crest height of the wave run-up increased by 8%.

• Journal of Technology Innovation
• /
• v.11 no.2
• /
• pp.27-39
• /
• 2003

This study empirically examines the relationship between technology licensing and licetnsee firms' profitability. A significant positive effect of licensing on profitability is generally demonstrated in both the short run and the long run. Further, the magnitude of positive effect is bigger in the long run than that in the short run. The paper suggest that, for firms, aggressive management strategy of collaborating with technology holders through licensing agreements is beneficial. It also argues that transferred technology requires time to be implemented, modified and mastered better by companies.

• Journal of the Korean GEO-environmental Society
• /
• v.2 no.1
• /
• pp.31-35
• /
• 2001

The effects of the ratio of effective size of filter media and diatom size on filter run time were evaluated by using both reported data and experimental results from several water treatment plants. For single media at several WTPs, the range of probability of the filter run time less than 15hr was 10~60%, and for dual media, that of the filter run time less than 30hr was 10~20%. The major filter clogging algae was Synedra acus of which dominant ratio was in the range of 64~92%. The effective size(ES) of filter medium for dual media filter was 0.71~1.40mm and uniformity coefficient of the filter was 1.25~1.67. The effective size(ES) of filter medium for single medium filter was 0.52~0.65mm and uniformity coefficient of the filter was 0.25~1.40. The range of calculated penetration depth was 2.58~15.4cm for dual media and 1.29~2.17cm for single media, and average filter run time was 40.1~83.3hr and 13.9~34.9hr, respectively. When Synedra counts were over 400cells/ml for single media, filter run time was below 5hr, while filter run time for dual media filter, remained as high as 70hr.

• Journal of Environmental Science International
• /
• v.1 no.2
• /
• pp.49-57
• /
• 1992

First, We classified man-made lakes in Korea as 4-type lakes, that is, there were River-run lakes, Dendritic lakes, Reservoir-lakes, River-mouth lakes, We studied on the environmental factors of 3-type lakes except River-mouth lakes, compared these lakes with natural lakes in foreign country. Environmental factors were watershed area, lake storage, mean depth, hydraulic retention time. As a results, 3-type lakes in Korea had remarkable differences one another according to above-mentioned environmental factors. First, We recognized that River-run lakes had higher nutrient loading according to having wider watershed area than natural lakes, and had lower algal growth rate according to shorter hydraulic retention time than natural lakes. Dendritic lake had higher nutrient loading than natural lakes, longer retention time than River-run lake. Reservoir-lakes had environmental factors between Dentritic lakes and River-run lakes. Therefore, If this studies had no quantitative results about various factors, We recognized that man-made lakes in korea had different environmental factors as compared with natural lakes, and had clear classification among 3-type lakes.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.7
• /
• pp.1941-1954
• /
• 1999

This paper presents a design and implementation of CRs(CHILL Run-time support System) to adapt the concurrent processing facilities of CHILL(CCITT High Level Language) which had recommended by ITU-T(International Telecommunication Union Telecommunication Standardization Sector). Because the CHILL provides more various concurrent processing facilities that other concurrent programming language, a design and implementation on CRS can give us real effects to gain the major functionalities and the techniques of the concurrent processing. In this paper, we design the interface rules of concurrent functions to conform with the CHILL compiler. We use the concurrent processing primitives as the library style to be invoked by procedure calls, and implement the start-up routine of the CHILL program, the context switching routine, and the CHILL process control parts to control be execution of the CHILL processes concurrently.

• Journal of Korean Society for Quality Management
• /
• v.24 no.4
• /
• pp.14-28
• /
• 1996

We consider optimal designs of partially accelerated life testing which is deviced for parallel systems with the considerably long life time. In partially step-stress life testing, test items are first run simultaneously at use condition for a specified time, and the surviving items are then run at accelerated condition until a predetermined censoring time. In partially constant-stress life testing, test items are run at either use or accelerated condition only until a specified censoring time. The optimal criterion for each test is to minimize either the generalized asymptotic variance of maximum likelihood(ML) estimators of the hazard rates at use condition and the acceleration factors or the asymptotic variance of the ML estimators of the acceleration factors.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.5
• /
• pp.786-791
• /
• 2017

In this paper, the run time of Li-polymer secondary cell with and without Active Balancing BMS is analyzed. The Active Balancing System using Flyback Converter with two-way power control facility, his designed for optimal characteristics of balancing. The run time of Li-polymer secondary cell is drastically increased employing the Flyback Convert Active Balancing BMS. The run time performance of Li-polymer secondary cell with or without Flyback Converter Active Balancing BMS is analyzed with the discharging and charging experiment of Li-polymer secondary cell.