• Journal of Korean Society on Water Environment
• /
• v.22 no.6
• /
• pp.1119-1122
• /
• 2006

Aeration by using diffusers usually requires approximately 50~90% of the total electricity needed to operate WWTP (WasteWater Treatment Plant)s. Accurate evaluation of the oxygen transfer efficiency for an aeration system, and recommendation of a better alternative may help saving WWTP operational costs. Appropriate techniques and methods to achieve this purpose have not been introduced in Korea. In this study, in-process analysis was performed for a coarse bubble aeration system by the off-gas method to evaluate its applicability in Korea. To accomplish this analysis, an off-gas test, unsteady-state clean water test and steady-state off-gas column test was conducted and comparisons to other aeration systems were made. The ${\alpha}$ and the F estimated from the results of the unsteady-state clean water test and the steady-state off-gas column test were 0.61 and 0.90 respectively in a coarse bubble aeration system. The comparison of P.E tube diffusers laid out single spiral roll and ceramic dome diffusers laid out full floor coverage showed that the oxygen transfer efficiency of the coarse bubble aeration system was less than or similar to other aeration systems. But, airflow rates per unit area were 4~5 times greater than other aeration systems. In regards to the oxygen transfer efficiency for airflow rates per unit area, a retrofit to higher efficiency diffusers was urgently needed. This study showed proved that off-gas methods can apply to evaluate diffuser performances to estimate operating factors and to compare other aeration systems in Korea.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.10
• /
• pp.2246-2255
• /
• 1997

Gardner proposed an algorithm for timing recovery of BPSK/QPSK signals based on zero-crossing detection technique. When Gardner's method is applied to multi-level PAM signals, it suffers from increased timing jitter due to self noise. To alleviate this problem, an improved algoritjm is proposed in this paper. The timing function is modified so that it zero point at the transition of PAM signals, that results in remarkable reduced timing jitter. The performance of the proposed algorithm is analyzed and compared to that of Garner's one. Finally, analytical results are verified by computer simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.1A
• /
• pp.27-33
• /
• 2000

Gardner’s algorithm is one of the useful algorithm for NDD(Non-Decision Directed) symbol synchronization in PAM communications. But the algorithm has a weak point such as pattern noises increasing in multi-level PAM. To insert a pre-filter in the algorithm is able to reduce timing jitter and pattern noise. In this paper, we analyze statistical properties of NDD algorithm to find an optimal parameter of the pre-filter for improving timing jitter and PLL locking. As a simulation result, optimum value of pre-filter parameter, $\beta$, is 0.3 and 0.5 at the roll off factor of the channel, $\alpha$, is 0.5 and 1.0, respectively. Optimum parameters of the pre-filter for clock synchronization of all-digital 256-QAM demodulator is shown in the results.

• Journal of Navigation and Port Research
• /
• v.32 no.5
• /
• pp.333-339
• /
• 2008

When a vessel is underway in a heavy weather, passengers and crew suffer from seasickness caused by ship motions such as pitch, heave or roll, or all combined Sickness induces drowsiness, dizziness, headache, stomachache etc, in extreme conditions, they are met with a serious trouble which is physiologically unrecoverable. It results in weakening of spiritual activities or making errors from decrease of motivation, dropping off skills, poor recognition and poor judgement. In this paper, it was examined the international standards concerning the occurrence of sickness and the execution of works, also evaluated the boarding comfort by conducting several times of questionnaire on cadets boarding on the training ship HANBADA As a result, it was confirmed that the main factor of occurring the sickness was the vertical acceleration and the level was more than 0.2g. Also, it was presented the way how to reduce the sickness by changing the speed and/or course in relation to the encounter period.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.1
• /
• pp.76-87
• /
• 2000

Multicarrier DS-CDAM is an effective approach to realize wideband CDMA system in a multipath fading channeal. In this paper, we propose a cinvolutionally-coded overlapped multicarrier DS-CDMA system, and show the performance improvement by comparing with conventional multicarrier DS-CDMA system. We consider the case of 50% overlapping with the adjacent subband to utilize the transmission bandwidth more efficiently. In the proposed multicarrier system, each of the rate 1/M convolutionally-encoded symbols is also 1/R repetition coded and transmitted using overlapped multicarriers and we may obtain the coding gain and frequency diversity effect, simultaneously. We also analyze the possibility of reduction in total MUI by considering a raised-cosine wave-shaping filter having a roll-off factor (0< ${\beta}{\le}1$). It will be shown that the proposed system outperforms the multicarrier DS-CDMA system in $^{[3]}$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11C
• /
• pp.1106-1112
• /
• 2009

The SC-FDMA(single carrier-frequency division multiple access) was recently adopted as the uplink multiple access scheme from 3GPP LTE(3rd Generation Partnership Project Long Tenn Evolution) due to its low PAPR (Peak-to-averaged power ratio). The bandwidth of IFDMA(interleaved FDMA), one of the sub-carrier mapping methods of SC-FDMA, gets narrower as the roll-off factor of RRC(root raised cosine) filter decreases from 1 to 0, whereas its PAPR can increase significantly. In practice, to increase the power efficiency of an amplifier, signals with high PAPR undergo the process of clipping. Clipping of signals may cause regeneration of high-frequency components as well as distortion of signals. The current paper deals with the effect of clipping on the spectrum and BER of IFDMA signals with RRC filters.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.272-273
• /
• 2013

Some living thingsuse micro- or nano- structures for living in nature. Scientists and engineers made efforts to mimic them, and they succeeded in making new types of applications. They used 'Namib desert beetle' to self-filling device by moisture harvesting and 'lotus leaf' to self-cleaning device by water repelling. 'Namib desert beetle' and lotus leaf have micro-patterns on their surface, which consists of hydrophobic or hydrophilic materials [1]. Moreover, micro-patterns on the surface make self-filling or self-cleaning property enhanced because of the surface roughness. Surface roughness enhances wettability [2]. Micro-pattern is a significant factor to make the surface be functional, so we want to make new types of functional surface by micro-patterning. In this work,we make several functional micro-patterns (radial, line, and dot arrays) using maskless lithography and analyze the characteristics of each micro-pattern. In order to analyze and understand surface characteristics, micro-patterns with varying sizes are investigated. All experiments are proceeded on mr-DWL5 photo resists coated on silicon wafers in same condition. All the experiments have demonstrated good performances about hydrophobic or hydrophilic property corresponding to their material and structural combinations. In radial micro-pattern, although the surface is flat, water drops on hydrophilic radial pattern can be convergent to a middle point and water drops on hydrophobic radial pattern can be divergent from the middle point. In line array micro-pattern, water drops can roll off along only one direction in parallel with the line arrays. Such phenomena might be mainly caused by the local change of surface roughness. From these results, controlling the movement and direction of water drops is made feasible without introducing a slope, which can potentially be used for new types of applications.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.6
• /
• pp.8-12
• /
• 2008

A ring resonator based band-pass filter enabling enhanced sideband suppression was proposed and demonstrated. It is composed of a single-ring based band-pass section combined with a band-rejection section based on two different coupled rings. The sideband region of the transfer characteristics of the first band-pass filter section was selectively suppressed by means of the band-rejection section without causing any excessive insertion loss. As a result, the overall transfer characteristics of the proposed filter was unproved so that its sideband suppression was elevated to allow for sharper roll-off and narrower bandwidth. In this work, a conventional single-ring band-pass filter and a proposed filter including the band-rejection section were designed and fabricated. As for the achieved device performance, with the center frequency at about 4 GHz, the sideband suppression ratio was increased as much as 8 dB and the 3-dB bandwidth was reduced from 98 MHz to 48 MHz by about 51% with no remarkable excessive insertion loss as expected. And the quality factor of the device was increased by about 105%.

• Korean Journal of Optics and Photonics
• /
• v.16 no.5
• /
• pp.469-475
• /
• 2005

An integrated photonic microwave bandpass filter has been proposed and demonstrated incorporating a coherently coupled microring resonator in low-loss polymers. The proposed device may feature compact site, simple structure, tuning via the thermooptic and electrooptic effect, and flexible integration with other electrical and optical devices. The resonator was designed to have an extremely small bandwidth so that it could be used to selectively pass the optical signal carrying the microwave signal to attain efficient bandpass filtering. We made and tested two resonators with a single ring and double rings, and performed a theoretical fitting of their measured transfer curves to predict the performance of the microwave filters based on them precisely. It was found that as the number of the rings used for the resonator increases, the bandwidth gets smaller, the rolloff sharper, and the band rejection higher. Finally our filter exhibited the center frequency of 10GHz, the 3-dB bandwidth of 1.0GHz, the corresponding quality (Q) factor of 10, and the rejection outside of the passband of more than 25dB.