• Proceedings of the Korean Society for Rock Mechanics Conference
• /
• 2008.03a
• /
• pp.203-216
• /
• 2008

• Proceedings of the Korean Society for Rock Mechanics Conference
• /
• 2008.03a
• /
• pp.51-68
• /
• 2008

When the train enters into a tunnel a high speed, pressure waves are generated inside the tunnel. The pressure waves at propagate in a form of compression wave toward the tunnel exit and a fraction of the compression waves that arrives at the exit of the tunnel are discharged to outside of the tunnel and the remainder is reflected into the tunnel as expansion waves. The compression waves emitted from the tunnel does not radiate in a specific direction but in all directions. If the amplitude of the compression wave is great, it causes noise and vibration, and it is called "Micro-Pressure Wave." "Micro-Pressure Wave" must be considered as a decision for the optimum tunnel cross-section as the amplitude of the compression wave depends on train speed, tunnel length, area of tunnel and train. Therefore, this paper introduces the case study of Micro-Pressure Wave characteristics for determination of tunnel cross section in Honam high speed railway, the pressure inside the tunnel and the micro-pressure waves at tunnel exit were measured at Hwashin 5 tunnel in Kyungbu HSR line. At the same time. a test of train operation model was performed and then the measurement results and test results were compared to verify that the various parameters used as input conditions for the numerical simulations, which were appropriate. Also a model test was performed, in order to analysis of the Micro-Pressure Wave Mitigation Performance by Type of Hood at Entrance Portal.

• Tunnel and Underground Space
• /
• v.15 no.2 s.55
• /
• pp.111-118
• /
• 2005

The area of investigation belongs to Okchon metamorphic zone and the fault fractured zone runs parallel to the tunnel direction. It causes the independent decline of tunnel face and the slackness of the tunnel surrounding base so, after all, the severe displacement has occurred within the tunnel. Accordingly, the TSP(Tunnel Seismic Prediction) survey has been performed to investigate the extent of fault fractured zone and to analize its characteristics. Also, we have analized the behavior causes by performing the tunnel face mapping and drilling investigation, and confirmed the position and scale of geological anomaly area and front fractured zone which influences tunnel excavation and supporting. Collected data analyzed ground layer condition through 3 dimensional modeling. Several variables included in the modeling were analyzed by geostastistics. The analysis of the modeling data shows that the belt of weathering by fault fractured zone is developing on the basis of the right side of tunnel and that is decreasing to the left side. The fault fractured zone was confirmed that it has strike, $N0\~5^{\circ}E$ dip NW, and it is consisted of large-scale fractured zone including several anomalies. The severe displacement in tunnel is probably caused by asymmetrical load that n generated by the crossing of discontinuity and the rock strength imbalance of tunnel's both side by fault fractured zone, and judge that need tunnel reinforcement method of grouting etc.

• Tunnel and Underground Space
• /
• v.11 no.3
• /
• pp.279-288
• /
• 2001

Jointed rock mass can be analyzed by either continuum model or discontinuum model. Finite element method or finite difference method is mainly used for continuum modelling. Although discontinuum model is very attractive in analyzing the behavior of each block in jointed blocky rock masses, it has shortcomings such that it is difficult to investigate each joint exactly with the present technology and the amount of calculation in computer becomes trio excessive. Moreover, in case of the jointed blocky rock mass which has more than 2 dominant joint sets, it is impossible to model the behavior of each block. Therefore, a model such as ubiquitous joint model theory which assumes the rock mass as a continuum, is required. In the case of tunnels, unlike slopes, it is not easy to obtain safety factor by utilizing analysis method based on limit equilibrium method because it is difficult to assume the shape of failure surface in advance. For this reason, numerical analyses for tunnels have been limited to analyzing stability rather than in calculating the safety factor. In this study, the behavior of a tunnel excavated in jointed rock mass is analyzed numerically by using ubiquitous joint model which can incorporate 2 joint sets and a method to calculate safety factor of the tunnel numerically is presented. To this end, stress reduction technique is adopted.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03b
• /
• pp.93-100
• /
• 2000

In this study, we used photoelastic coating method which is a kind of model test for examining the stress condition of rock masses around underground structures. Using this method, we could know adaptability and usefulness of photoelastic coating method for various shape of tunnel models. And, in spite of higher cross section efficiency, square shape model showed unstable status because of high stress concentration. So, we cut the slits at the each corner of tunnel, and we could make more stable stress condition by means of moving high stress concentration to rock mass.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.341-344
• /
• 2001

Fiber reinforced shotcrete(FRS) is widely used in tunnel linings, which strengthen the rock surface and reduce the loosening of the rock strata. The advantages of FRS in tunnel linings are the unsusceptibility to crack, the benefit of shotcrete strength, and the superiority of toughness. In this study, the several evaluation methods of FRS toughness were investgated experimentally, which included the ASTM beam test, EFNARC square panel test and RTA round panel test. Especially, it was examined that the round panel test could fulfill the toughness evaluation of FRS.

• Tunnel and Underground Space
• /
• v.14 no.3
• /
• pp.175-187
• /
• 2004

고준위방사성폐기물 처분의 경우 심부 암반에 만들어진 처분장에 영구 처분하는 것이 최선의 방안으로 여겨지고 있다. 하지만 지하 심부의 암반에 대한 물리적, 화학적, 역학적, 열적, 수리적 물성과 이들과 핵종 이동의 관계, 처분환경에서의 공학적 방벽 및 암반의 거동이 처분장 안정성 및 안전성에 미치는 영향 등을 파악해야하는 어려움이 따른다. 특히 고준위폐기물 처분의 경우 장기간의 안전성을 고려해야하기 때문에 자연방벽과 공학적 방벽의 시간에 따른 거동변화도 고려하여야 할 필요가 있다. (중략)

• Tunnel and Underground Space
• /
• v.4 no.2
• /
• pp.77-86
• /
• 1994

The vibration resulting from track-train interaction is transmitted through the tunnel structure and the surrounding ground to adjacent buildings. This paper provides a review of the ground vibration propagation mechanism and the theoretical isolation effectiveness of each transit systems. Moreover, predictive vibration values estimated from various models are compared with measured results performed in Seoul Metropolitan Subways and evaluate the applicability of those models.

• Tunnel and Underground Space
• /
• v.3 no.1
• /
• pp.11-23
• /
• 1993

• Tunnel and Underground Space
• /
• v.15 no.1 s.54
• /
• pp.9-21
• /
• 2005