• Journal of Sensor Science and Technology
• /
• v.19 no.1
• /
• pp.58-61
• /
• 2010

This paper describes the fabrication and characteristics of NO sensor using ZnO thin film by RF magnetron sputter system. The sensitivity, working temperature, and response time of sputtered pure ZnO thin film and added catalysts such as Pt, Pd, Al, Ti on those films were measured and analyzed. The sensitivity of pure ZnO thin film at working temperature of $300^{\circ}C$ is 0.875 in NO gas concentration of 0.046 ppm. At same volume of the gas in chamber, measuring sensitivity of 1.87 at $250^{\circ}C$ was the case of Pt/ZnO thin film. The ZnO thin films added with catalyst materials were showed higher sensitivity, lower working temperature and faster adsorption characteristics to NO gas than pure ZnO thin film.

• 한국신재생에너지학회:학술대회논문집
• /
• 2008.05a
• /
• pp.419-421
• /
• 2008

Sputter deposition on a Pt counter electrode was studied using RF plasma as the improvement of conversion efficiency for dye-sensitized solar cells (DSC). The effects of the sputtering thickness and incident angle on a Pt counter electrode for DSC was scrutinized. We conducted the experiment to get the optimal sputtering time for the performance of the DSC. Under the sputtering time condition of 120 seconds, we varied the incident angles of substrate from $0^{\circ}$ to $60^{\circ}$. Under standard test condition (AM 1.5, 100mW/$cm^2$), we obtained the maximum efficiency of 4.61% at the incident angle of $40^{\circ}$ with an active cell area of $1cm^2$.

• Korean Journal of Materials Research
• /
• v.6 no.10
• /
• pp.1043.2-1048
• /
• 1996

자기기록의 고밀도화로 인해 보자력(Hc)이 큰 자기기록매체가 필요하게 되었다. 고보자력매체에 신호를 충분히 기록하기 위해서는 보다 강한 자장이 필요하다. 이 때문에 포화자화(Ms)가 큰 재료가 필요하며 고주파 영역에서 실효투자율($\mu$eff)이 높아야 한다. Fe계 합금박막은 이에 적합한 재료이다. 본 연구에서는 Fe의 결정자기이방성에 영향을 미치는 Si과 Fe의 격자 변형을 유도할 수 있는 B를 첨가하였다. Fe-B-Si 계 박막을 질소분위기 중에서 RF Matnetron Sputter로 제작하여 연자기적 특성에 관하여 고찰하였다. Fe91.49B4.01Si4.50at% 박막은 35$0^{\circ}C$에서 1시간 열처리를 행함으로써 약 900(10MHz) 정도의 투자율과 7.6Oe의 보자력을 나타냈으며 포화자화는 1300emu/㎤를 얻었다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.4
• /
• pp.321-324
• /
• 2013

In this study, The RF magnetron sputter and evaporator was on glass substrates 30 mm ${\times}$ 30 mm OMO multilayer thin film structure is applied to the low-e. Structural and optical properties, a thin film was produced, the variable was placed into a variable deposition time of the oxide layer. According to the XRD measurement results there is no peak that satisfies the Bragg's law ($2dsin{\theta}=n{\lambda}$) which confirmed that it is an amorphous structure. RMS value of the results of the AFM measurement, has a roughness of less than 2 nm. transmittance measurements results, visible light region an average 80%, IR region 40% showed.

• Journal of Electrical Engineering and Technology
• /
• v.2 no.4
• /
• pp.532-536
• /
• 2007

Carbon nanotube (CNT) properties, produced using a magnetic null discharge (MND) plasma production technology, were investigated. We firstly deposited the Fe layer 200 nm in thickness on Si substrate by the magnetic null discharge sputter method at the substrate temperature of $300도C$, and then prepared CNTs on the catalyst layer by using the magnetic null discharge (MND) based CVD method. CNTs were deposited in a gas mixture of CH4 and N2 at a total pressure of 1 Torr by the MND-CVD method. The substrate temperature and the RF power were $650^{\circ}C$ and 600W, respectively. The characterization data indicated that the proposed source could synthesize CNTs even under relatively severe conditions for the magnetic null discharge formation.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1622-1624
• /
• 2007

In order to realize effective p-type doping in ZnO thin films, ZnO films were deposited on P-doped Silayers by RF-magnetron sputter deposition technique and annealed at various temperatures. The result indicated that ZnO film annealed at $700^{\circ}C$ showed p-type conduction with a high carrier concentration in the order of $10^{19}\;cm^{-3}$.

• Transactions on Electrical and Electronic Materials
• /
• v.6 no.4
• /
• pp.149-153
• /
• 2005

In this paper, we investigated the island density-dependent stress distribution of indium-tin-oxide (ITO) film on polycarbonate substrate by external bending force. We used e-beam and RF­sputter for SiON, ITO sputtering. It was found that there are influence of island density on the substrate and decreasing crack density as goes to the minimum density. From the result that crack density was increasing at maximum island density, it is evident that more stress is imposed on same island position as island density.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.895-897
• /
• 2008

ZnO films were fabricated using rf-magnetron sputter deposition process with different $N_2$ ambient. N-content in N-doped ZnO films was less than 1%. The wavelength of the highest intensity PL peak of N-doped ZnO was shifted to higher wavelength with increasing $N_2$ flow rate in the deposition ambient. These results indicated that the optical property of ZnO was significantly affected by the defect level created by doping with a very small amount of N.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.119-119
• /
• 2008

The electrical characteristics of Metal-Ferroelectric-Nitride-Oxide-Silicon (MFNOS) structure is studied and compared to the conventional Silicon-Oixde-Nitride-Oxide-Silicon (SONOS) capacitor. The ferroelectric blocking layer is SrBiNbO (SBN with Sr/Bi ratio 1-x/2+x) with the thickness of 200 nm and is fabricated by the RF sputter. The memory windows of MFNOS and SONOS capacitors with sweep voltage from +10 V to -10 V are 6.9 V and 5.9 V, respectively. The effect of ferroelectric blocking layer and charge trapping on the memory window was discussed. The retention of MFNOS capacitor also shows the 10-years and longer retention time than that of the SONOS capacitor. The better retention properties of the MFNOS capacitor may be attributed to the charge holding effect by the polarization of ferroelectric layer.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.11a
• /
• pp.7-10
• /
• 1992

CoNiCr/Cr and CoCrTa/Cr for longitudinal magnetic recording media were. prepared on Coming 7059 glass by RF magnetron sputtering. The thickness of Cr underlayer was varied from 500 to $3000{\AA}$ and. that of magnetic layer was $700{\AA}$. Coercivity and squareness were measured using V.S.M.(vibrating sample magnetometer). The coercivity of films increased with increasing Cr thickness when the films were unannealed. The coercivity of the films annealed in a 10 mtorr vacuum increased initially with annealing time and then saturated with further increase in annealing time. The coercivity value difference between the unannealed and annealed films increased with increasing the thickness of Cr underlayer No significant change was found in squareness after anneal, regardless of Cr underlayer thickness.