• Journal of Wetlands Research
• /
• v.9 no.2
• /
• pp.57-69
• /
• 2007

This study focused on coastal water quality response to land-based and sediment pollution loads and estimation of the carrying capacity in Masan Bay using an ecological model with the data in summer of 2002. A residual current was simulated to have a slightly complicated pattern with ranging from 0.1 to 1.5 cm/s. In Masan Bay, pollutant materials cannot flow from the inner to the outer bay easily because of residual currents flow southward at surface and northward at the bottom. The simulation results of COD distribution showed high concentrations over 3 mg/L in the inner part of Masan Bay related pollutant discharge. For improvement seawater quality grade I in Masan Bay, it is necessary to reduce the organic and inorganic loads from point sources by more than 80%. For improvement seawater quality grade II, it is necessary to reduce the organic and inorganic loads from point sources by more than 50% and ameliorate severe polluted sediment. The carrying capacity for COD is 2.32 ton/day and 7.16 ton/day for each grade.

• Korean Journal of Materials Research
• /
• v.21 no.9
• /
• pp.486-490
• /
• 2011

Nano-indium-coated ZnO:In thick films were prepared by a hydrothermal method. ZnO:In gas sensors were fabricated by a screen printing method on alumina substrates. The gas sensing properties of the gas sensors were investigated for hydrocarbon gas. The effects of the indium concentration of the ZnO:In gas sensors on the structural and morphological properties were investigated by X-ray diffraction and scanning electron microscopy. XRD patterns revealed that the ZnO:In with wurtzite structure was grown with (1 0 0), (0 0 2), and (1 0 1) peaks. The quantity of In coating on the ZnO surface increased with increasing In concentration. The sensitivity of the ZnO:In sensors was measured for 5 ppm $CH_4$ gas and $CH_3CH_2CH_3$ gas at room temperature by comparing the resistance in air with that in target gases. The highest sensitivity to $CH_4$ gas and $CH_3CH_2CH_3$ gas of the ZnO:In sensors was observed at the In 6 wt%. The response and recovery times of the 6 wt% indiumcoated ZnO:In gas sensors were 19 s and 12 s, respectively.

• Korean Journal of Materials Research
• /
• v.20 no.5
• /
• pp.235-240
• /
• 2010

We investigated the carbon monoxide (CO) gas-sensing properties of nanostructured Al-doped zinc oxide thin films deposited on self-assembled Au nanodots (ZnO/Au thin films). The Al-doped ZnO thin film was deposited onto the structure by rf sputtering, resulting in a gas-sensing element comprising a ZnO-based active layer with an embedded Pt/Ti electrode covered by the self-assembled Au nanodots. Prior to the growth of the active ZnO layer, the Au nanodots were formed via annealing a thin Au layer with a thickness of 2 nm at a moderate temperature of $500^{\circ}C$. It was found that the ZnO/Au nanostructured thin film gas sensors showed a high maximum sensitivity to CO gas at $250^{\circ}C$ and a low CO detection limit of 5 ppm in dry air. Furthermore, the ZnO/Au thin film CO gas sensors exhibited fast response and recovery behaviors. The observed excellent CO gas-sensing properties of the nanostructured ZnO/Au thin films can be ascribed to the Au nanodots, acting as both a nucleation layer for the formation of the ZnO nanostructure and a catalyst in the CO surface reaction. These results suggest that the ZnO thin films deposited on self-assembled Au nanodots are promising for practical high-performance CO gas sensors.

• Korean Journal of Materials Research
• /
• v.28 no.1
• /
• pp.12-17
• /
• 2018

$In_2O_3$ doped $WO_3$ powders were prepared by a polymer solution route and their $NO_2$ gas sensing properties were analyzed. The synthesized powders showed nano-sized particles with specific surface areas of $6.01{\sim}21.5m^2/g$ and the particle size and shape changed according to the content of $In_2O_3$. The gas sensors fabricated with the synthesized powders were tested at operating temperatures of $400{\sim}500^{\circ}C$ and 100~500 ppm concentrations of $NO_2$ atmosphere. The particle size and $In_2O_3$ content affected on the initial sensor resistance in an air atmosphere. The highest sensitivity (8.57 at $500^{\circ}C$), which was 1.77 higher than the sensor consisting of the pure $WO_3$ sample, was measured in the 0.5 mol% $In_2O_3$ doping sample. In addition, the response time and recovery time were improved by the addition of $In_2O_3$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.726-728
• /
• 2013

Optoelectronic arc discharge sensor was used to detect arc discharge inside power distribution panel. Arc discharge is fatal to power system once it begins, thus preventive detection is necessary before power failure occurs. Optoelectronic detection method was used to avoid direct electrical contact to power apparatus inside power distribution panel. 180 degree detection angle and detection range far exceeding 6m, which was sufficient for monitoring purpose, was achieved using the photodiode having $7.5mm^2$ of active surface area and flash source with $0.4cal/cm^2$ energy density, which is equivalent to 1.9J with $2.16cm^2$ emitting area. The response speed of arc discharge sensor was measured to be below 1 msec. The above optoelectronic arc discharge sensor was measured to be sensitive enough to detect 0.94 pC charge.

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.381-384
• /
• 2002

Response surface methodology (RSM) was successfully applied to optimize for the production of Ganoderma lucidum in batch fermentations using the whey (40,000 mg latose/L) as substrate. This study was performed according to the central composite design (CCD) with respect to pH and temperature, where the designed intervals were 3.3$22.9^{\circ}C$$37.1^{\circ}C$, respectively. A second-order factorial design of the experiments was used to build empirical models providing a quantitative interpretation of the relationships between the two variables. The optimum conditions to maximize the production of G. lucidum were pH 4.2 and $28.3^{\circ}C$. At optimum conditions, the mycelial dry weight (MDW) and residual soluble COD (SCOD) were simultaneously used to evaluate the biokinetic coefficients assocoated with substrate inhibition model by nonlinear least squares method with 95% confidence interval. The. maximum microbial growth rates (${\mu}m$), half saturation coefficient ($K_s$), and the inhibition substrate concentration ($K_{is}$) were determined to be 0.095 l/hr, 128,000 mg SCOD/L and 49,000 mg SCOD/L, respectively. And the microbial yield coefficient (Y), biomass decay rate coefficient ($K_d$), and the maintenance energy coefficient ($m_s$) were determined to be 0.37 mg MDW/mg SCOD, 0.001 1/hr, and 0.0015 1/hr, respectively.

• Korean Chemical Engineering Research
• /
• v.58 no.2
• /
• pp.266-272
• /
• 2020

In this study, the production of ethyl levulinate from chitosan using successive acid-catalyzed hydrolysis and esterification was investigated. To optimize and analysis the reaction factors and heir reciprocal interaction, response surface methodology was introduced. In the effect of water content in ethanol solvent, the production yield of ethyl levulinate was high at 5% water content (or 95% ethanol). As a result of optimization of reaction factors, 30.1% ethyl levulinate yield was obtained under the condition of 200 ℃, 3.19% chitosan, 0.49M sulfuric acid, 5% water content, and 58 min. Finally, the formation yield of ethyl levulinate was tended to enhance by increase of combined severity factor. This result indicated that the potential of chitosan as feedstock for production of chemicals and fuels.

• International Journal of Fluid Machinery and Systems
• /
• v.10 no.3
• /
• pp.240-253
• /
• 2017

Latin hypercube sampling is widely used design-of-experiment technique to select design points for simulation which are then used to construct a surrogate model. The exploration/exploitation properties of surrogate models depend on the size and distribution of design points in the chosen design space. The present study aimed at evaluating the performance characteristics of various surrogate models depending on the Latin hypercube sampling (LHS) procedure (sample size and spatial distribution) for a diverse set of optimization problems. The analysis was carried out for two types of problems: (1) thermal-fluid design problems (optimizations of convergent-divergent micromixer coupled with pulsatile flow and boot-shaped ribs), and (2) analytical test functions (six-hump camel back, Branin-Hoo, Hartman 3, and Hartman 6 functions). The three surrogate models, namely, response surface approximation, Kriging, and radial basis neural networks were tested. The important findings are illustrated using Box-plots. The surrogate models were analyzed in terms of global exploration (accuracy over the domain space) and local exploitation (ease of finding the global optimum point). Radial basis neural networks showed the best overall performance in global exploration characteristics as well as tendency to find the approximate optimal solution for the majority of tested problems. To build a surrogate model, it is recommended to use an initial sample size equal to 15 times the number of design variables. The study will provide useful guidelines on the effect of initial sample size and distribution on surrogate construction and subsequent optimization using LHS sampling plan.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.29 no.4
• /
• pp.647-654
• /
• 2000

Response surface methodology (RSM) was used for monitoring the changes in browning reaction and organoleptic quality of roasted Polygonatum roots under various of roasting conditions. Total free sugar decreased up to 13$0^{\circ}C$, but increased above 13 $0^{\circ}C$. The amounts of total free amino acids decreased in proportional to the roasting temperature and time. Theronine, glycine and serine decreased by about 91~94% under the roasting conditions. Browning color intensity of water extracts increased with the roasting time up to around 18 min, but decreased over 18 min. The optimum conditions based on overall palatability of the roasted Polygonatum roots were 13$0^{\circ}C$ and 15 to 25 min. Organoleptic qualities of the roasted samples showed higher correlations with the changes in free amino acids.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.44 no.1
• /
• pp.32-37
• /
• 1999

The experiment was conducted to investigate emergence response of lowland weeds at different soil moisture contents, burying depths and upon changes in soil moisture. Rice germination was over 50% at all burying depths under aerobic condition, but the emergence rate of the soil surface placed seeds in saturated and flooded conditions decreased by 19% and 29%, respectively, as compared with that of aerobic condition. Rice seeds at burying depth of over 3 cm did not emerge at all. The emergence rate of Echinochloa crus­galli (L.) Beauv. in aerobic condition was lower than 30%, but the emergence pattern of E. crus galli (L.) Beauv. at different soil moisture contents and seeding depths was similar to that of rice. Emergence behavior of lschaemum rugosum Salisb., Ludwigia octovalvis (Jacq.) Raven and Sphenoclea zeylanica Gaertn. which are dominant lowland weed species in the Philippines also differed depending on soil moisture conditions and burying depths. lschaemum rugosum Salisb. emerged at all burying depths under aerobic condition, whereasLudwigia octovalvis (Jacq.) Raven emerged only at 0 cm deep under saturated and aerobic condition and Sphenoclea zeylanica Gaertn. at 0 cm deep under flooding condition. Weed seeds planted at 1, 3, and 5 cm deep in continuous flooded and saturated condition did not emerge at all, but upon a change of soil moisture condition from saturated to drainage (S$\rightarrow$D) and flooded to drainage (F$\rightarrow$D), grass weeds began to germinate again and the average emergence rate in S$\rightarrow$D and F$\rightarrow$D were 26% and 5% forE. crus­galIi (L.) Beauv., 9% and 8% forI. rugosum SaIisb., respectively. Weed seeds buried in soil in the pot showed great emergence at S$\rightarrow$D but did not emerge under continuous flooded condition. The diversity index accounting for dominance degree and occurrence aspect of weed, was the lowest at F$\rightarrow$D.