• Journal of Broadcast Engineering
• /
• v.13 no.3
• /
• pp.365-379
• /
• 2008

In this paper we consider technological requirements of the on-channel repeater to broadcast the terrestrial digital multimedia broadcasting (T-DMB) signals using single frequency networks (SFN) and propose the configuration and implementation method of the equalization on-channel repeater (OCR) that meet such requirements. The proposed equalization OCR not only has short time delay, but shows high output power and good quality of output signal by removing a feedback signal due to incomplete antenna isolation and multipath signal existing between the main transmitter and the OCR. In addition, computer simulations and laboratory tests results are provided to figure out performance of the proposed equalization OCR.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.4
• /
• pp.453-461
• /
• 2011

In order to use more efficiently limited frequency resources at the broadcasting band and to eliminate blanket area of the terrestrial broadcasting and to improve broadcasting quality. The importance of repeaters has increasing continuously. However, in case of T-DMB digital on channel repeater in OFDM systems, some of the signal radiated feedback again at the receiver antenna. So it generates feedback signal interference in repeater system. Also phase noise increases ICI(Inter Carrier Interference). It affects seriously the frequency domain equalizer. In this paper, we remove the feedback signal interference by LMS with correlation. Also we propose an effective equalizer algorithm that can remove ICI caused by phase noise and the power amplifier's back-off. In this simulation results, this system is satisfied the performance of BER=$10^{-4}$ at less than SNR=14 dB after compensation of phase noise.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.7 s.361
• /
• pp.35-40
• /
• 2007

As the mobile communication service is widely used and the demand for wireless repeaters is rapidly increasing because of the easiness of extending service areas. But a wireless repeater has a problem that the output of the transmit antenna is partially fed back to the receive antenna, which results in feedback interference. In this paper, we propose a new varable step-size LMS algorithm which utilizes correlation between reference and error signals to adjust the step sizes, for cancelling the feedback interference signals in the WCDMA repeater under time-varying multi-path channels. The proposed algorithm was evaluated through computer simualation by being applied to the feedback canceling filter of the WCDMA repeater. The simulation results demonstrated that the proposed one is superior to the conventional ones in terms of the cancelation perormance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.9
• /
• pp.1058-1064
• /
• 2012

In this paper, an absorber based on metamaterial is proposed to improve the isolation of conventional WCDMA indoor repeater antenna. The proposed absorber is composed of Double Split Ring Resonators(DSRRs) and Complementary Spiral(CS) structure. The proposed absorber based on metamaterial is $9.6mm{\times}9.6mm{\times}1.2mm$ and absorption is about 94 % at 2.2875 GHz. The proposed antenna, which proposed absorber is applied to conventional WCDMA indoor repeater antenna, has isolation over 85 dB. Isolation is improved more than 10 dB compared with the conventional antenna. The VSWR is lower than 2 at WCDMA band from 1.92 GHz to 2.17 GHz. The radiation patterns are $60^{\circ}{\pm}10^{\circ}$ E-plane and H-plane, respectively. And, the gain is more than 6 dBi. The volume of proposed antenna with absorber based on metamaterial is $90mm{\times}90mm{\times}44.8mm$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.75-76
• /
• 2016

Even if ICS(Interference Cancellation System) repeater is used in wireless communication system, it has the disadvantage that it must have enough distance between Donor and Service antenna to be isolated. In this paper, new ICS repeater integrated antenna with high insolation characteristics is designed. The proposed antenna is fabricated for 800MHz and measured. Bandwidth and gain are optimized by changing the stub lengths near main patch and power divider, and also by changing the size of parasitic patch. This antenna has a return loss less than -13 dB, a gain over 3 dBi, and an isolation between the donor and the server antennas less than -56 dB from 824~894 MHz for CDMA mobile communication. Therefore, the proposed antenna structure can be applied to eliminate the shadow area and to expand the coverage area for any other wireless communication bands.

• Journal of IKEEE
• /
• v.17 no.2
• /
• pp.145-150
• /
• 2013

In the paper, we propose a new CSS(Complex Signed-Signed) CMA(Constant Modulus Algorithm) algorithm for ICS(Interference Cancellation System). When the repeater get the feedback signal, the CSS CMA algorithm is proposed at the ICS repeater using DSP(Digital Signal Processing) for the removal of interfering signals from the feedback paths. The proposed CSS CMA algorithm improved performances and hardware complexity by adjusting step size values. the steady state MSE(Mean Square Error) performance of the proposed CSS CMA algorithm with step size of 0.00043 is about 4dB better than the conventional CMA algorithm. And the proposed Complex Signed Signed CMA algorithm requires 1950 ~ 2150 less iterations than the LMS(Least Mean Square) and Signed LMS(Normalized Least Mean Square) algorithms at MSE of -25dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11A
• /
• pp.909-917
• /
• 2009

In this paper, we proposed and implemented the method to efficiently generate TDD synchronization signal and the digital circuit for the RF repeater which can eliminate the shadow region in the wireless communication field using the time division duplex (TDD) method. After detecting the TDD signal from the transmitted or received RF signal, the detected TDD signal is fed to the RF repeater for the normal operation. The proposed technique detects the envelop of the downlink signal and amplifies the detected envelop, and then restores the degraded envelop with the proposed digital filtering method. Finally the restored envelop is manipulated to the TDD synchronization signal. Our focus on the proposed algorithm is to develop it with simple feature and low cost but robust performance. The proposed scheme was implemented to the integrated system which has both RF and digital circuit and tested under the same condition with the commercial WiBro service.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.4
• /
• pp.761-766
• /
• 2004

Rayleigh fading due to multi-path degrades the mobile service quality, especially high data rate mobile services such as 1xEVDO and W-CDMA. The field test showed that down load date rate of 1xEVDO is seriously affected by Rayleigh fading. To reduce the effect of Rayleigh fading, transmit diversity was implemented in RF repeater. In field test, transmit diversity function increased the data rate about twice comparing with no transmit diversity repeater. Recently high data rate service is getting more important, so transmit diverstiy function will be an important function in repeater.

• Journal of Broadcast Engineering
• /
• v.9 no.4 s.25
• /
• pp.371-383
• /
• 2004

In this paper we consider technological requirements to broadcast digital television signals using single frequency networks (SFN) in the Advanced Television Systems Committee (ATSC) transmission systems and propose equalization digital on-channel repeater (EDOCR) that overcomes the limitations of conventional digital on-channel repeaters (DOCRs). Since there are no forward error correction (FEC) decoder and encoder, the EDOCR does not have an ambiguity problem. In addition, since an adaptive equalizer in the EDOCR removes multi-path signals, additive white Gaussian noise (A WGN), and feedback signal due to low antenna isolation, the EDOCR may have good output signal quality with high power.

• Journal of Positioning, Navigation, and Timing
• /
• v.11 no.4
• /
• pp.369-379
• /
• 2022

In weighted k-nearest neighbor (WkNN)-based Fingerprinting positioning step, a process of comparing the requested positioning signal with signal information for each reference point stored in the fingerprint DB is performed. At this time, the higher the number of matched base station identifiers, the higher the possibility that the terminal exists in the corresponding location, and in fact, an additional weight is added to the location in proportion to the number of matching base stations. On the other hand, if the matching number of base stations is small, the selected candidate reference point has high dependence on the similarity value of the signal. But one problem arises here. The positioning signal can be compared with the repeater signal in the signal information stored on the DB, and the corresponding reference point can be selected as a candidate location. The selected reference point is likely to be an outlier, and if a certain weight is applied to the corresponding location, the error of the estimated location information increases. In order to solve this problem, this paper proposes a WkNN technique including an outlier removal function. To this end, it is first determined whether the repeater signal is included in the DB information of the matched base station. If the reference point for the repeater signal is selected as the candidate position, the reference position corresponding to the outlier is removed based on the clustering technique. The performance of the proposed technique is verified through data acquired in Seocho 1 and 2 dongs in Seoul.