• 제목/요약/키워드: recycling coefficient

검색결과 95건 처리시간 0.025초

Neutron Spectrum Effects on TRU Recycling in Pb-Bi Cooled Fast Reactor Core

  • Kim Yong Nam;Kim Jong Kyung;Park Won Seok
    • Nuclear Engineering and Technology
    • /
    • 제35권4호
    • /
    • pp.336-346
    • /
    • 2003
  • This study is intended to evaluate the dependency of TRU recycling characteristics on the neutron spectrum shift in a Pb-Bi cooled core. Considering two Pb-Bi cooled cores with the soft and the hard spectrum, respectively, various characteristics of the recycled core are carefully examined and compared with each other. Assuming very simplified fuel cycle management with the homogeneous and single region fuel loading, the burnup calculations are performed until the recycled core reached to the (quasi-) equilibrium state. The mechanism of TRU recycling toward the equilibrium is analyzed in terms of burnup reactivity and the isotopic compositions of TRU fuel. In the comparative analyses, the difference in the recycling behavior between the two cores is clarified. In addition, the basic safety characteristics of the recycled core are also discussed in terms of the Doppler coefficient, the coolant loss reactivity coefficient, and the effective delayed neutron fraction.

펄프섬유(纖維)의 제지특성(製紙特性)에 미치는 회수처리(回收處理)의 영향(影響) (Effect of Recycling on the Papermaking Properties of Wood Pulp Fibers)

  • 김형진;조병묵
    • Journal of the Korean Wood Science and Technology
    • /
    • 제21권1호
    • /
    • pp.21-38
    • /
    • 1993
  • In order to investigate the influence of recycling, a laboratory method simulating the papermaking process was used for assessing the effects of recycling on fiber properties. Sw-BKP, Hw-BKP and BGP were disintegrated and beaten to about 42$^{\circ}$SR-44$^{\circ}$SR by a valley beater. After beating, these pulps were dewatered by centrifuge and dried at 90$^{\circ}C$ for 72hrs. This recycling process(sequence of wetting, defiberating, dewatering and drying) was repeated seven times. Physical, mechanical and optical properties of recycled pulps were evaluated by TAPPI Standards. Morphological changes occurred through recycling process was observed by SEM. Sheet density decreased with recycling. The largest drop in density occurred during the first recycling. The porosity values decreased with recycling. Mechanical properties such as tensile, burst strength and folding endurance, decreased with recycling. However tear strength of Sw-BKP and mixtured pulp increased at the first recycling. Optical properties such as brightness, opacity and light scattering coefficient, increased with recycling. However, brightness of mixtured pulp gradually decreased with recycling. Fibrillated outer layer of the fiber was gradually removed from the surface with recycling. As a result of recycling, crinkles on the fiber surface were found to be more folded.

  • PDF

EMMC공정을 이용한 수산물 가공공장 폐수처리에서 동력학적 인자 평가와 유출수반송의 영향 (Evaluation of Kinetic Constant and Effect of Effluent Recycling in Wastewater Treatment from Fisheries Processing Plant using EMMC Process)

  • 정병곤
    • 한국해양환경ㆍ에너지학회지
    • /
    • 제12권1호
    • /
    • pp.1-8
    • /
    • 2009
  • 수산물 가공공장 폐수의 생물학적 처리를 위하여 미생물 능동포획방식의 일종인 EMMC(Entrapped Mixed Microbial Cell)공정을 적용하여 유기물 및 질소제거에 대한 동력학적 인자를 산출하였으며 전체 시스템 운전효율에 유출수 재순환이 미치는 영향을 평가하였다. 동력학적 인자 중 유기물의 세포 전환계수 Y의 경우 일반적인 활성슬러지 공정에서 보고된 Y값에 비하여 상당히 낮은 값을 나타내어 활성 슬러지 공정에 비해 슬러지 생성량을 상당히 줄일 수 있음을 확인할 수 있었다. 내생호흡 계수 $k_e$값 역시 일반적인 활성슬러지법에 있어서의 값과 비교할 때 상당히 낮은 값을 나타내었다. 질산화 미생물의 미생물 전환계수 Y 및 내생호흡계수 $k_e$, 반포화상수 $k_s$ 값을 일반적인 부유성장형 질산화 반응조에서 구한 값들과 비교하였다. Y값은 본 연구에서 구한 값과 유사하였으며 내생호흡 계수는 낮았으며 반포화 상수의 경우는 본 연구에서의 값이 훨씬 높은 값을 나타내었다. 이를 통하여 질산화 박테리아에 있어서도 포괄 고정화 공법이 일반적인 부유성장 반응조에 비하여 기질 친화도가 높은 것을 알 수 있었다. 내부 재순환이 전체 반응조 운전효율에 미치는 영향을 평가하기 위하여 내부 순환율을 1.5Q, 2.0Q, 2.5Q, 3.0Q로 변화시켜가며 운전한 결과 내부 순환을 증가는 질산화보다는 탈질화 효율의 증가에 더 큰 영향을 미치며 내부 순환율의 최적화는 anoxic조의 운전효율 증대에 초점을 맞추어야 하는 것으로 나타났다.

  • PDF

데이터 재활용 LMS equalizer의 수렴성능 분석 (Convergence analysis of data-recycling LMS equalizer)

  • 김남용
    • 한국통신학회논문지
    • /
    • 제21권8호
    • /
    • pp.1905-1913
    • /
    • 1996
  • The convergence characteristics of an LMS type Equalizer whose coefficient are multiple adapted in a symbol time period by recycling the received data are analyzed. The theoretical analysis shows that the data-recycling LMS technique can increase convergence speed by (B+1) times, where B is the number of recycled data. The results of the computer simulation demonstrate that the simulation results are in accordence with the theoretical analysis and the superiority of the equalizer algorithm.

  • PDF

A Study on the Optimal Method of Eco-Friendly Recycling through the Comparative Analysis of the Quantitative Calculation and Scope of Recycling

  • Seung-jun WOO;Eun-gyu LEE;Chul-hyun NAM;Kang-hyuk LEE;Woo-Taeg KWON;Hee-Sang YU
    • 웰빙융합연구
    • /
    • 제7권3호
    • /
    • pp.1-11
    • /
    • 2024
  • Purpose: The purpose of this study is to present an efficient emission reduction ratio of plastic to reduce carbon dioxide, the main cause of greenhouse gases. Research design, data and methodology: This study calculated the absolute value of carbon dioxide by setting an equation through the emission coefficient using the US EPA's WARM model. Results: In the recycling ratio of 70%, it was found that the energy recovery ratio was 15.6%, which was the energy recovery ratio without generating carbon dioxide. When carbon dioxide is generated by changing plastic waste emissions, optimal efficiency is achieved by reducing emissions by 10% to 30% of energy recovery ratio, 20% to 50% of energy recovery ratio, and 30% to 80% or more of energy recovery ratio. Conclusions: The recycling rate should be set at a minimum of 70%, so that a carbon dioxide-free energy recovery rate could be obtained during the recycling process, supporting an eco-friendly basis for environmental policies aimed at this rate. In addition, it was possible to suggest that it is essential to reduce emissions by at least 30% for eco-friendly recycling measures that can achieve both economic and environmental feasibility in the energy recovery process through incineration during recycling in Korea.

순환골재를 사용한 알칼리활성화 슬래그-레드머드 흙포장재의 특성 (Properties of Alkali-activated Slag-Red Mud Soil Pavement Using Recycled Aggregate)

  • 강석표
    • 한국건설순환자원학회논문집
    • /
    • 제4권3호
    • /
    • pp.276-283
    • /
    • 2016
  • 레드머드는 보오크사이트 원광석에서 생산되는 알루미나의 선광과정에서 발생되는 무기질 부산물이다. 인 레드머드를 활용하고자 하는 연구가 국내에서 이루어지고 있다. 강알카리성의 레드머드를 건설산업용 촉진제로서 활용하고자 하는 연구로서 알칼리활성화 슬래그-레드머드 시멘트가 국내외적으로 발표되고 있다. 본 논문은 순환골재 대체율에 따른 알칼리활성화 슬래그-레드머드 건식 흙포장재의 최적함수율, 압축강도, 흡수율, 백화발생 특성에 대하여 비교 검토하였다. 그 결과 순환골재 대체율이 증가할수록 알칼리활성화 슬래그-레드머드 흙포장재의 최적 함수비, 물흡수계수, 백화면적은 증가하고 압축강도는 감소하였다.

묽은 전해질용액에서 이온의 활동도계수 계산 (Calculation of the Activity Coefficients of Ions in Weak Electrolyte Solutions)

  • 이만승;손성호
    • 자원리싸이클링
    • /
    • 제27권5호
    • /
    • pp.9-13
    • /
    • 2018
  • 화학반응의 평형상수는 표준자유에너지변화와 관련된다. 평형상수는 반응물과 생성물의 활동도의 비이며 수용액에서 이온강도의 증가로 인한 용질의 비이상성을 고려할 필요가 있다. 묽은 전해질용액에서 이온의 활동도계수를 구할 수 있는 식인 Debye-$H{\ddot{u}}ckel$ 식의 유도과정과 확장식을 설명하였다. 전해질의 평균활동도계수의 실험값로부터 이온의 활동도계수를 구하는 방법을 설명하였다.

Dialysis in double-pass cross-flow rectangular membrane modules with external recycle for improved performance

  • Yeh, Ho-Ming
    • Membrane and Water Treatment
    • /
    • 제2권2호
    • /
    • pp.75-89
    • /
    • 2011
  • The predicting equations for mass transfer rate in cross-flow rectangular dialyzers with double flow and recycle, have been derived by mass balances. The recycling operation has two conflicting effects. One is the desirable effect of the increase in fluid velocity, resulting in an increased mass transfer coefficient. The other is the undesirable effect of the reduction in concentration difference due to remixing, resulting in decreased mass-transfer driving force. In contrast a single-pass device without recycling, considerable improvement in mass transfer is achieved if the cross-flow rectangular dialyzer of same size is operated with double pass and external recycling. It is concluded that recycle can enhance mass transfer, especially for larger reflux ratio.

재생용 사업의 입지적 특성 (Locational Characteristics of Recycling Industries)

  • 한주성
    • 한국지역지리학회지
    • /
    • 제10권4호
    • /
    • pp.775-786
    • /
    • 2004
  • 재생용 재료 수집 및 판매업은 동맥산업이 발달함으로서 재활용 폐기물이 다소 발생하고 인구가 어느 정도 많은 지역에 입지한다. 그리고 유해시설이기 때문에 과소지에 입지하는 것은 아니고 인구가 많은 지역의 거주지가 아닌 곳에 주로 입지하는데, 그 분포는 전국적으로 분산 입지하고 있다. 그리고 재생용 금속 비금속 가공 원료 생산업은 대도시내의 주변지역, 지방중심도시와 공업지역 인접지역에 주로 입지하고, 지역적 집중도가 높아 생산의 집적효과를 갖고 있다. 이러한 입지에 영향을 미치는 요인은 재생용 재료수집 및 판매업의 입지와 관련이 깊어 이들 원료의 수송이 운송비의 영향을 크게 받고 인구수는 영향을 거의 받지 않는다고 할 수 있다.

  • PDF