• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.4
• /
• pp.99-105
• /
• 2010

This study analyzed the effects of changes in mixing factors of zero-cement mortar that only used recycled fine aggregates and fly-ash on quality of mortar, and the results are as follows. To describe the property of fresh mortar, as mix proportion and flow of mortar increased, W/B was highly selected and air content decreased. To describe compressive strength according to age as the property of hardened mortar, it was revealed that the strength did not strength until the 14 day, but strength of about 1 ~ 2 MPa strength during the 14 day through 28 day, and almost similar strength after 28 day. Also, compressive strength according to changes in mix proportion, flow and B/W was generally similar. Summarizing the above experimental results, in case of mortar that used recycled fine aggregates and fly-ash, it secured the strength for the use of landfill even though not for structural use. Especially, poor mix proved to be more useful than rich mix.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.05b
• /
• pp.101-104
• /
• 2005

It analyzed the supply status of fine aggregate and find the point of issue related alternative fine aggregate through researches and interviews. The conclusions of the study are as follows. 1. Ready mixed concrete manufacture used crushed fine aggregate (15.5$\%$) and recycled fine aggregate (1.5$\%$) for alternatives aggregate than 1.3$\%$ in 1991. It is not allowed to use a recycled fine aggregate in ready mixed concrete, but they used it. 2. All alternative aggregate are satisfied the Korean Standard, But they showed low properties of mortar compared to when it replaced with natural fine aggregate. So, it is needed to make another special Korean Standard to use alternative aggregate in normal concrete by mixing method to recover the workability and compressive strength.

• Journal of the Korea Institute of Building Construction
• /
• v.17 no.1
• /
• pp.23-30
• /
• 2017

The aim of the research is to suggest an economical and sustainable method of reducing pH of recycled aggregate as an embanking and a covering materials. Because of the unhydrated cement based materials on the surface of the recycled aggregate, it causes a severe problem on environment with leaked high alkali water from embankment and covering by using recycled aggregate. In this research, to reduce the pH of recycled aggregate, regarding the recycled fine aggregate, eight different methods were tested and analyzed with three different categorized: natural treatment, artificial treatment, and chemical treatment. From the results of experiment, it was considered that the most efficient method of reducing pH of recycled aggregate was the chemical treatment using acid such as $CO_2$ acceleration or monoammonium phosphate (MAP), and diammonium phosphate (DAP). Especially, using MAP and DAP, fertilizers, is the most efficient method of reducing pH with its time duration and performance.

• Computers and Concrete
• /
• v.24 no.1
• /
• pp.19-35
• /
• 2019

In this paper, the effect of the type and amount of fibers on the physicomechanical properties of concrete containing fine recycled refractory brick (RRB) and natural aggregate subjected to elevated temperatures was investigated. For this purpose, forta-ferro (FF), polypropylene (PP), and polyvinyl alcohol (PVA) fibers with the volume fractions of 0, 0.25, and 0.5%, as well as steel fibers with the volume fractions of 0, 0.75, and 1.5% were used in the concrete containing RRB fine aggregate replacing natural sand by 0 and 100%. In total, 162 concrete specimens from 18 different mix designs were prepared and tested in the temperature groups of 23, 400, and $800^{\circ}C$. After experiencing heat, the concrete properties including the compressive strength, ultrasonic pulse velocity (UPV), weight loss, and surface appearance were evaluated and compared with the corresponding results of the reference (unheated) specimens. The results show that using RRB fine aggregate replacing natural fine aggregate by 100% led to an increase in the concrete compressive strength in almost all the mixes, and only in the PVA-containing mixes a decrease in strength was observed. Furthermore, UPV values at $800^{\circ}C$ for all the concrete mixes containing RRB fine aggregate were above those of the natural aggregate concrete specimens. Finally, regarding the compressive strength and UPV results, steel fibers demonstrated a better performance relative to other fiber types.

• Journal of Ocean Engineering and Technology
• /
• v.18 no.1
• /
• pp.53-62
• /
• 2004

The Purpose of this study is to recycle the waste concrete, which is generated in huge quantities, from construction works. in order to achieve this goal, it is important to determine the compressive strength, workability, slump, and ultrasonic velocity of recycled aggregate concrete. Thus, several experiment parameters are considered, such as water-cement ratios, sand percentage, and fine aggregate composition ratios, in order to apply the recycled aggregate concrete to pre-cast artificial fishing reefs. From the results, it has been shown that the proper mix designs for reef concrete are W/C=45%, S/a=50%, SR50:SN50 in recycled sand and natural sand mix combination case, W/C=45%, S/a=50%, SC50:SN50 in crushed sand and natural sand mix combination case, W/C=45%, S/a=50%, SR50:SC50 in recycled sand and crushd sand mix combination case. Also, this study shows that the shape and surface roughness of fine aggregate particles have an effect on the strength, slump, ultrasonic velocity of tested concrete, and the compressive strength ratios of 7days' and 90days' curing ages of recycled aggregate concrete are about 70% and 110% of 28days' curing age.

• Resources Recycling
• /
• v.16 no.2 s.76
• /
• pp.17-22
• /
• 2007

The report of an investigation into the performance of mortar specimens made with recycled fine aggregate (RA) exposed to sodium sulfate solution for 360 days is presented in this paper. Mechanical properties of mortar specimens such as visual examination, compressive strength, expansion and mass loss were periodically monitored. From the test results, it was found that mortar specimens with higher replacement levels of Rh exhibited poor performance in sodium sulfate solution. However, compared to mortar specimens without RA, those with lower replacement levels of RA (up to 50% by mass) was more resistant to sulfate attack. Through the x-ray diffraction analysis, it was confirmed that the main products causing sulfate deterioration in RA mortar specimens were the formation of gypsum and thaumasite.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.403-404
• /
• 2009

This study has investigated application of the industrial by-product of reject ash and recycled fine aggregate to consider the economical issue to high flowing CLSM(controled low-strength material). But this high flowing CLSM is required more binder, so it has been estimated the influence of reject ash content, use of recycled fine aggregate and crushed sand, and air content about properties of CLSM.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.337-338
• /
• 2009

Use of the recycled fine aggregate as a material of structural concrete is not easy currently because there are some problems, such as of quality control and the uncertainty of chemical and physical property. Thus, the results indicate that it is possible to produce high quality recycled fine aggregate for structure by microwave heating technology, friction and abrasion action.

• Journal of the Korea Concrete Institute
• /
• v.17 no.5 s.89
• /
• pp.793-801
• /
• 2005

This study investigates fundamental properties of recycled aggregate concrete which incorporated 100% recycled coarse aggregate and various amount of recycled fine aggregate. In addition, for the purpose of the improvement of long term strength and durability, a part of cement was replaced with fly ash. Compressive strength and resistance to chloride ion penetration and carbonation were investigated. When the coarse aggregate was completely replaced with the recycled the replacement ratio of the fine aggregate with the recycled was recommended to be limited below 60% in the consideration of strength. The strength of the steam-cured specimen was very comparable to the wet-cured at 28 days. As fly ash content increased the resistance to chloride ion penetration was increased. The chloride ion penetrability based on the charge passed was found to be low at 21 days and very low at 56 days, respectively. Carbonation depth and carbonation velocity coefficient increased as the fly ash content increased and the relationship between the carbonation depth and recycled fine aggregate replacement ratio was not clear. Up to 28days, however, the measured carbonation depth was mostly less than 10mm which could be considered as low.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.609-612
• /
• 2008

This study investigated effect of recycled fine aggregate quality on strength properties of concrete. Some investigations have been carried out to study the strength properties of recycled aggregate concrete. But these have some limitation due to small-scale test in the laboratory. Therefore concrete using this study were fabricated by ready-mix concrete. Variables were quality of recycled fine aggregate(high and low quality) and replacement ratio of 0%, 30%, 60%, 100%(high quality), 35, 70%(low quality). The change of air content of recycled aggregate concrete were similar to natural aggregate concrete. Replacement ratio of recycled aggregate was not necessarily correlated with compressive strength and modulus of rupture of recycled aggregate concrete.