• ETRI Journal
• /
• v.20 no.4
• /
• pp.380-394
• /
• 1998

A numerical study has been performed to predict the characteristics on the transient operation of the heat pipe with multiple heaters for electronic cooling. The model of the heat pipe was composed of the evaporator section with four heaters, insulated transport section, and the condensor section with a conductor which is cooled with uniform heat flux condition to surrounding. The governing equations and the boundary conditions were solved by the generalized PHOENICS computational code employing the finite volume method. Two test cases are investigated in present study; Case 1 indicates that the 1st and 2nd heaters among four heating sources are heated off, while the 3rd and 4th heaters are heated on. Case 2 is the inverse situation switched from heating location of Case 1. The results show that the transient time to reach the steady state is shorter for Case 1 than for Case 2. Especially, the temperature difference of the heater during switching operation is relatively small compared to the maximum allowable operating temperature difference in electronic system. Hence, it is predicted that the heat pipe in present study operates with thermally good reliability even for switching the heaters.

• 전기의세계
• /
• v.30 no.10
• /
• pp.639-644
• /
• 1981

PVC is a kind of electric insulation polymer. But we get some deteriorations in electrical characteristics of the PVC, when it is used on the radioactive field. In order to find out the cause of the deterioration, we investigate the surface-resistance, volume-resistance, dielectric constant and dielectric loss angle of the soft and hard PVC which is irradiated by the Co$^{60}$ .gamma. radioactivity. From the experiment, we can conclude the followings 1. Radio-activity proof characteristic in the soft PVC is stronger than in the hard PVC. 2. The resistance of PVC which is irradiated by the radio-activity decrease exponentially. 3. The dielectric constant and the dielectric loss angle of PVC irradiated by Co$^{60}$ .gamma.ray reach maximum value in first few time.

• The Journal of Korean Physical Therapy
• /
• v.21 no.2
• /
• pp.15-22
• /
• 2009

Purpose: This study examined the effect of aquatic exercise on the improvement in physical and pulmonary function after stroke. Methods: Fourteen candidates, who had experienced stroke, were enrolled in this study. The program was carried out three times weekly, 1 hour per session and for 10 consecutive weeks. At pre-treatment and post-treatment, the subjects were tested with a 10 m and 100 m timed gait test, a timed get up and go test, a functional reach test, the difference in thoracic girth at inspiration and expiration, and breaths per minute. The forced vital capacity (FVC) and forced expiratory volume in one second (FEV1) were measured using a spirometer. Results: After ten weekends of an aquatic exercise program, the subjects showed a significant difference in all the test results except for the FEV1 (p<0.05). Conclusion: Intervention with this aquatic exercise program can improve the physical and pulmonary function in people who have had a stroke.

• Industrial Engineering and Management Systems
• /
• v.9 no.4
• /
• pp.303-311
• /
• 2010

In the last few years growing interest has been dedicated to supply chain management. Modeling complexity is added to supply chain coordination problem by accounting for reverse logistics activities. The objective of this paper is to extend inventory model of manufacturing factory with respect to the production of raw material of forward logistics and recycling material of reverse logistics. The proposed model is applied to a plastic recycling process plant located in Taiwan. The case study improvement scheme shows when the recycling rate of recycling material increases from 15% to 50%, the total inventory cost of manufacturing factory decreases by 12.82%, safety stock volume decreases by 41.19% and the reorder quantity is down by 50.96%. This paper finds whether the results of the model can reach the economic profit through quantitative analysis and encourages companies integrate reverse logistics into the supply chain system.

• Archives of Metallurgy and Materials
• /
• v.63 no.3
• /
• pp.1477-1480
• /
• 2018

The mechanical behavior and the change of retained austenite of nanocrystalline Fe-Ni alloy have been investigated by considering the effect of various Ni addition amount. The nanocrystalline Fe-Ni alloy samples were rapidly fabricated by spark plasma sintering (SPS). The SPS is a well-known effective sintering process with an extremely short densification time not only to reach a theoretical density value but also to prevent a grain growth, which could result in a nanocrystalline structures. The effect of Ni addition on the compressive stress-strain behavior was analyzed. The variation of the volume fraction of retained austenite due to deformation was quantitatively measured by means of x-ray diffraction and microscope analyses. The strain-induced martensite transformation was observed in Fe-Ni alloy. The different amount of Ni influenced the rate of the strain-induced martensite transformation kinetics and resulted in the change of the work hardening during the compressive deformation.

• Korean Journal of Veterinary Research
• /
• v.37 no.2
• /
• pp.291-299
• /
• 1997

In order to establish optimal dosage schedules and withdrawal times for sulfamethazine(SMZ) in pigs, pharmacokinetic and tissue distribution experiments were conducted in pigs. For comparative purposes, tissue depletion kinetics are also studied in rats. From three pigs administered with SMZ i.v., the pharmacokinetic profile of SMZ in two pigs was adequately described by a one-compartment open model whereas that in one pig was patterned after a two-compartment open model. Volume of distribution(Vd) was 0.48~0.57 L/kg and biological half-life($t_{1/2}$) was 11.8-16.8 h. From three pigs dosed with SMZ p.o., pharmacokinetic profile was explainable with a one-compartment open model. Time to reach maximum SMZ concentration in serum (Tmax) was 2.8 h, 3.2 h and 7.5 h. Elimination half-life was 2.8-7.5 h. The descending order in concentration of SMZ was plsama > kidney > liver > lung > heart > pancreas > spleen > duodenum > ileum > brain > adipsoe tissue from three pigs sacrificed at 5h, 29h and 54h after the administration of SMZ, p.o.. The protein binding of SMZ in pigs was 55.2%($2.5{\mu}g/ml$), 71.5% ($5{\mu}g/kg$) and 71.5%($10{\mu}g/ml$). The mean systemic bioavailability (F) of SMZ p.o. was 49.1 %. Meanwhile the pharmacokinetic profile of SMZ in rats was adequately described by a one-compartment open model. Absorption of SMZ p.o. in the rat was very rapid. In conclusion, the oral optimal dosage regimen of SMZ for pigs was the initial dose of 45.7 mg/kg followed by the maintenance dose of 30.2 mg/kg for high specific pathogens to SMZ. The time to reach below the stipulated residual allowable concentration (0.1 ppm) was calculated 93 h after oral administration of 200 mg/kg recommended by manufactureres.

• The Journal of Korean Medicine
• /
• v.15 no.2 s.28
• /
• pp.241-252
• /
• 1994

It is known that the pattern of combustion temperature can be classified into preheating, heating. retaining and cooling periods. In this experiment. the authors have studied the heating mechanism by the density of moxa material during the heating and retaining periods. The starting point. the point at which it begins to reach the maximum gradient temperature. the ending point of the heating period. and the ending point of the retaining period were measured in order to get effective stmulation by repetition of moxa-combustion. For the experiment. samples of 300mg. 400mg, and 500mg of moxa material were molded into conical molds with each 10mm in diameter and height resulting in the volume of $0.26cm^3$. The following results were obtained: The $300mg/0.26cm^3$ denstiy sample reached al1 points tested faster than the samples of $400mg/0.26cm^3$ and $500mg/0.26cm^3$ It dose not reveal any statistical differences between $400mg/0.26cm^3$ and $500mg/0.26cm^3$ in the ending point. the point at which it begins to reach the maximum gradient temperature of the heating period or the ending point of the reataining period The only difference shown was in the starting point of the heating period. According to the above results. it is concluded that the lower density moxa material reached each point of the the respective period faster than the high density moxa material.

• Korean Journal of Materials Research
• /
• v.27 no.9
• /
• pp.466-470
• /
• 2017

With the matters of climate change, energy security and resource depletion, a growing pressure exists to search for replacements for fossil fuels. Among various sustainable energy sources, hydrogen is thought of as a clean energy, and thus efficient hydrogen storage is a major issue. In order to realize efficient and safe hydrogen storage, various porous materials are being explored as solid-states materials for hydrogen storage. For those purposes, it is a prerequisite to characterize a material's textural properties to evaluate its hydrogen storage performance. In general, the textural properties of porous materials are analyzed by the Brunauer-Emmett-Teller (BET) measurement using nitrogen gas as a probe molecule. However, nitrogen BET analysis is sometimes not suitable for materials possessing small pores and surfaces with high curvatures like MOFs because the nitrogen molecule may sometimes be too large to reach the entire porous framework, resulting in an erroneous value. Hence, a smaller probe molecule for BET measurements (such as hydrogen) may be required. In this study, we describe a cost-effective novel cryostat for BET measurement that can reach temperatures below the liquefaction of hydrogen gas. Temperature and cold volume of the cryostat are corrected, and all measurements are validated using a commercial device. In this way, direct observation of the hydrogen adsorption properties is possible, which can translate directly into the determination of textural properties.

• Journal of Korea Port Economic Association
• /
• v.27 no.1
• /
• pp.95-109
• /
• 2011

The aim of this study is to analyze the container terminal operation by considering the key factors that fluctuates the container traffic volume using the System Dynamics (SD) method. The target area of this study is the 'A' container terminal which is located in the Port of Incheon and the simulation period is from 2004 to 2020. As evaluation indexes for container terminal operation, three factors such as 'total sales', 'operating ratio of C/Y' and 'operating ratio of G/C' are selected, and as for the key factors of fluctuating container traffic volume, 'variation ratio of world trade', 'variation ratio of trade among three countries in North-East Asia' and 'variation ratio of won-dollar rate are used. As of 2020, the result of this study is that import-export container traffic volume increases almost 880,000TEU and total sales and operating ratio of G/C each reach 7.1 bilion won and 65 percent. No changes however in loadage and operating ratio of C/Y in 'A' container terminal are indicated. The reason is that capability of C/Y is exceeded. Therefore this study suggest that decision-makers of 'A' container terminal realize the importance of additional space of C/Y.

• Korean Journal of Veterinary Service
• /
• v.39 no.3
• /
• pp.141-149
• /
• 2016

Changes in the Leydig cell from pre-puberty to adulthood were studied in Korean native cattle. Eight groups of male cattle aged 14, 17, 20, 25, 30, 35, 40 and 104 weeks (n=7 cattle per group) after birth were used. The purpose of this study was to obtain quantitative information on the Leydig cell of the Korean native cattle during postnatal development. Testes of cattle were fixed by perfusion using a fixative containing 2.5% glutaraldehyde in cacodylate buffer, processed and embedded in Epon-araldite. Using $1{\mu}m$ section stained with methylene blue-azure II, qualitative and quantitative (stereological) morphological studies were performed. The average diameter of seminiferous tubules gradually increased with age from 14 ($75.56{\mu}m$) to 104 weeks ($298.9{\mu}m$). The volume density of the seminiferous tubules increased with age from 54.2% at week 14 to 76.9% at week 104. The volume density of the interstitium represents 45.52% at week 14. This proportion progressively diminishes during development to reach a value of 23.14% at week 104. The volume density of Leydig cells decreased almost linearly from 14 (20.71%) to 104 weeks (5.28%). The absolute volume of Leydig cells per testis increased significantly from 14 to 104 weeks. The number of Leydig per testis have almost linearly increased from 14 to 104 weeks. The average volume of a Leydig cell reached maximum size by 104 weeks ($2553{\mu}m^3$). These data suggested development of Leydig cell can be classified as the fetal and immature adult Leydig cells (14~35 weeks), and the adult Leydig cells (40~104 weeks).