• 대한기계학회논문집
• /
• 제19권10호
• /
• pp.2678-2689
• /
• 1995

In this study, a new hot-wire anemometer which has greater sensitivity than that of a constant temperature anemometer (CTA) was proposed. In contrast to CTA, the wire working resistance of the new anemometer increases with flow velocity, that is, the operating mode of the wire becomes variable temperature. The variable temperature anemometer(VTA) was made by substituting a voltage controlled variable resistor such as photoconductive cell or transistor for one of the resistors in the bridge. By positively feeding back the bridge top signal to the input side of these electronic components, the wire overheat ratio could be increased with velocity automatically. Static response analyses of the VTA, constant voltage anemometer (CVA) and CTA were made in detail and calibration experiments were performed to validate the proposed operating principle. The wire operating resistance of the CVA decreases with velocity and this leads to lower sensitivity than that of a CTA. But the sensitivity of the newly proposed VTA is superior to that of a CTA, since the wire overheat ratio increases with velocity. Consequently, it is found that the major factor that is responsible for large sensitivity of a VTA is not the working resistance itself but the change of the wire working resistance with velocity.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2006년도 하계학술발표대회 논문집
• /
• pp.1255-1260
• /
• 2006

This present study analyzed temperature depreciation ratio of window inside surface by KS F 2295 'Procedure for determining fenestration product condensation resistance values'. it estimated window indoor surface condensation due to variable environmental condition. Performance of condensation resistance by using temperature depreciation ratio until applied Low-e and Ar glazing improved about 45% from 24 mm clear. Temperature depreciation ratio by KS F 2295 considers analytic index of window condensation due to variable boundary condition.

• 한국자동차공학회논문집
• /
• 제15권2호
• /
• pp.65-73
• /
• 2007

The use of an Exhaust Gas Recirculation(EGR) for a diesel engine with variable geometry turbocharger(VGT) has confronted how to obtain the amount of EGR for NOx reduction requirement at wide operating range and less side effect. Through a combined effort of modeling(wave action simulation) and experiment, an investigation into the effect of EGR area ratio and pipe length on EGR characteristics of common rail diesel engine with VGT has been performed. For accurate computation, calibration of constants involved in empirical and semi-empirical correlations has been performed at a specific operating point, before of its use for engine simulation. From the results of this study, it was found that EGR rate is sharply increased with increasing EGR area ratio until area ratio of 0.3. However, the effect of EGR area ratio on EGR rate is negligible beyond this criteria. This study also investigates the effect of EGR pipe length on a EGR amount and pulsating flow characteristics at EGR junction. The results showed that the longer EGR pipe length, the lower EGR amount was achieved due to the flow loss resulting in lower amplitude of pressure wave.

• The Journal of Asian Finance, Economics and Business
• /
• 제8권4호
• /
• pp.727-734
• /
• 2021

The study aims to examine and analyze the factors that affect the return on assets (ROA) by placing net interest margin (NIM) as a moderating variable in influencing ROA. This research was conducted on 27 banks listed on the Indonesia Stock Exchange (IDX) for the period 2015 to 2018 with a total sample data of 91. The data used is a combination of time series data and cross-section data. The sampling technique used was the purposive sampling method. The data analysis technique used was path analysis with multiple regression analysis technique. The results of the analysis showed that the capital adequacy ratio (CAR) and loan to deposit ratio (LDR) have a positive but insignificant effect on ROA. NIM as a moderating variable does not influence the impact of CAR on ROA. However, NIM as a moderating variable is able to influence the impact of LDR on ROA. From the results of this study, it is evident that the LDR will increase the ROA at banks that generate high NIM.

• 대한토목학회논문집
• /
• 제33권5호
• /
• pp.1935-1946
• /
• 2013

본 연구에서는 변단면 단일 현장타설말뚝의 거동 특성을 평가하고자 현장재하시험 사례를 분석하였으며, 또한 3차원 유한요소해석을 이용하여 말뚝 내부에서 발생하는 응력을 통해 심도별 휨응력을 산정하였다. 분석 결과, 단일 현장타설말뚝의 변단면 부근에서 휨응력이 집중되어 재료파괴가 발생하기 가장 쉬운 것을 알 수 있었다. 이를 토대로, 단일 현장타설말뚝의 기둥-말뚝 직경비와 수평 균열하중비 관계를 통해 최적의 기둥-말뚝 직경비를 제안하였다. 연구 결과, 최적의 기둥-말뚝 직경비는 기둥-말뚝 직경비와 수평 균열하중비 관계 곡선의 변곡점 부근에서 산정되었으며, 단일 현장타설말뚝 설계에 최적 변단면 특성을 고려한다면 개선된 설계가 이루어질 수 있을 것으로 판단되었다.

• 대한기계학회논문집
• /
• 제15권5호
• /
• pp.1433-1438
• /
• 1991

본 연구에서는 팔렛을 갖는 유한폭 변후판재 내의 모드 Ⅰ균열에 대하여 3차 원 유한요소법으로 응력확대계수를 수치해석하였다.

• 한국병원경영학회지
• /
• 제11권3호
• /
• pp.73-93
• /
• 2006

This study aims at providing necessary informations for management decision-making to the hospital manager, such as ratios of fixed and variable cost to total operating expense, and variable cost ratio to operating revenues, and determinant factors affecting cost behavior. A study model and related hypotheses were established, data were collected from 41 private university hospitals for the 6years from 1998 to 2003, and regression analyses were performed to test the hypotheses. The results of the analyses and conclusions are as follows; First, labor cost and administration cost within the same number of beds have not only fixed quality of the cost, but variable quality of that. Also, the ratio of the variable costs to operating revenue of the metropolitan was estimated 76.9% and that of other area hospitals was 80.1%. Second, the major factors affecting the increase rate of the operating expense were the increase rates of the number of inpatients, the number of employee, and the number of hospital operating bed. This result implies that maintaining a optimal hospital bed size and efficient operation of the beds are important strategic factors of hospital management.

• 항공우주시스템공학회지
• /
• 제10권4호
• /
• pp.11-16
• /
• 2016

본 논문에서 채널 안내로를 비행하는 가변스팬 날개의 공력특성에 관한 실험연구를 수행하였다. NACA 0012익형을 가진 가변스팬 날개를 제작하였으며 선형서보모터를 사용하여 작동시켰다. 날개의 가로세로비, 지면효과, 날개와 펜스사이의 거리가 날개의 공력특성에 미치는 영향을 조사하였다. 연구결과 지면 및 펜스 모두 항공기 날개의 양력을 증가시켰으며 지면효과와 달리 펜스는 날개의 항력에 큰 영향을 미치지 않았다. 가변스팬 메커니즘이 플랩사용이 제한되는 상황에서 효과적인 고양력 장치로 사용가능할 것으로 판단된다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제31권1호
• /
• pp.34-43
• /
• 2007

As a method to improve the poor torque capacity on the continuously variable transmission(CVT), power splitted devices(PSD) reducing the power entering into the transmission has been considered. But this kind of PSD requires for the variator to be a large coverage of the speed ratio (CSR) Since the CSRs of the well-known push belt or the toroidal ones are not enough large, the power splitted CVTs (PSCVTs) using them should be made with multiple modes. inevitably adding the do9 clutches and the associated accessories. In this paper a PSCVT with single mode is conceptually designed A new continuously variable unit (CVU) consisting of the paired inner and outer spherical rotors is used. The CVU has large CSR and excellent compactness. As a PSD. a variable bridge (VB) using the Planetary gear units (PGUs) is considered because it has an upper bound on the power ratio. An optimal design to minimize the effective efficiency of the PSCVT is carried out. Through the performance analysis on the designed model, good expectation on the practicability in the heavy vehicle system is shown.

• 산업경영시스템학회지
• /
• 제38권2호
• /
• pp.72-81
• /
• 2015

This paper studied the differences of the inventories asset turnover change ratio and several characteristics variable between large and small manufacturing firm group. Large and small firm group were determined based on number of labors and asset size. Several characteristics variable of firms such as assets size, sales growth rate, return on assets, leverage ratio, credit rating and age of firm were used to find out the differences of firm group. As a result, the inventory asset turnover change ratio of large firm was 5.16% and that of the middle and small firm was 9.3%. For the large firm, sales growth rate, ROA and credit rating affect inventory assets turnover change ratio. For the middle and small sized firm, Assets size, sales growth rate and credit rating affect inventory assets turnover change ratio. Using this result, we can say that manufacturing company need to consider their firm size and their characteristics to make their own operation strategy of inventory.