• Journal of Korean Physical Therapy Science
• /
• v.9 no.1
• /
• pp.1-8
• /
• 2002

This study set out to investigate what kind of effects the consistent visual stimuli and verbal and non verbal auditory stimuli have on pain alleviation, as well as to see the influence of joint application of visual and auditory stimuli at the same time on pain alleviation, according to lightness of 50lux and 200lux, ultimately providing basic data in setting up an environment in case of treating pain. The subject were comprised of 30 male and female adults with pain in the neck and back area. The subject were treated in their pain area with Transcutaneous Electrical Nerve Stimulator(TENS) 100HZ for 20 minutes in the research set where each visual, auditory, and joint visual and auditory stimuli was given. For analysis methods, Visual Analogue Scale(VAS) and McGill Pain Questionnaire were adopted to see the changes before and after treatment, and the electrocardiogram, systolic and diastolic pressure, number of heart rate and breathing frequence and endorphin were compared and analyzed using the Wilcoxon singed-rank test. And The Kreskal-walllis test was used to compare the two subgroups from each group. Wilcoxon singed-rank test and the Kreskal-walllis test was used to compare the two subgroups from each group. The results were as follows: 1. The group of 50lux and 200lux were compared given varying degrees of visual stimuli. The group of 200lux showed more reduction in pain points, average systolic and diastolic pressure and average endorphin. 2. The group of verbal and non verbal were compared given varying degrees of auditory stimuli. The group of non-verbal showed more reduction in average systolic and diastolic pressure. 3. The group of 200lux+verbal and 200lux+non verbal were compared given varying degrees of joint visual and auditory stimuli. There was found a statistical significance(p<0.05) in endorphin between the two groups, with more endorphin reduction for 200lux+non verbal group. And there was a statistically significant reduction in VAS and McGill before and after the treatment between the two groups.

• Journal of Korean society of Dental Hygiene
• /
• v.13 no.1
• /
• pp.105-113
• /
• 2013

Objectives : The purpose of this study was to perform researches and analysis on the use of dental institutions, oral health behavior, the actual conditions of oral health care, and the oral health knowledge according to the rank of soldiers and officers and then to provide the basic data for the contents development of an oral health education to the military. Methods : The subjects in this study were 380 soldiers serving in Gyeonggi, Gangwon and Chungchong provinces. Results : In terms of the use of dental institutions, the soldiers visit the dental clinics most(56.5%), and the officers visit the military dental clinics most(52.7%)(p<0.05). In the oral health behavior, the most of the soldiers(46.7%) and the officers(58.1%) answer that they thought to be in good oral health. Regarding the actual conditions of oral health care, it is investigated that the most of the soldiers brush their teeth twice a day(46.7%) and the officers three times a day(58.1%). With the oral health knowledge, the officers get a point of $2.89{\pm}1.36$, which is higher than the soldiers'($2.47{\pm}1.27$), and the person who have an experience to take an oral health education, getting a point of $2.83{\pm}1.22$, have higher level of the knowledge than the unexperienced with $2.48{\pm}1.31$(p<0.5). Conclusions : It is thought to be necessary to provide the military camps with an oral health education and to develop the contents of an oral health education customized to them.

• Journal of Family Resource Management and Policy Review
• /
• v.3 no.1
• /
• pp.1-15
• /
• 1999

The purpose of this study is to find out the tendency of the new generation’s consumer roles and green consumption behavior for the environmental conservation. This study is also to reveal some fundamental information for an environmental education program which si able to support the new generation consumers to participate voluntarily in an environmental activity. The 500 subjects of this study were selected from the new generation consumers who wre residing in Seoul, 1998. The 414 data wre finally analyzed by Mean, t-Test, ANOVA, and Multiple Regression Analysis. The major findings were as follows: 1) the purchasing roles of the new generation consumer tended to be higher than the citizen participation’s roles. The variables with the higher score for the new generation’s green consumption behavior were in the rank of the isolation of environmental waste, the purchasing behavior of green product, the recycling environmental resource, and citizen’s participating roles in environmental activity. 2) the new generation’s consumer roles showed a significant differences, according to variables for the environmental value, environmental education, and participation of the environmental and societal activity 3) the green consumption behavior for the new generation consumers showed a significant differences, according to sex, environmental value, participation of the environmental and societal activity. 4) the most influential variables for the green consumption behavior of the new generation consumers were in the rank of consumer roles, educational values, and the participation of the environmental activity. As we see above, the consumer education for the new generations needs to focus on consumer’s roles that let them participate voluntarily in environmental and societal activity, as well as practice positively to use green environmental products whenever they select some items in the markets.

• Journal of Periodontal and Implant Science
• /
• v.32 no.4
• /
• pp.721-731
• /
• 2002

Recently, soluble TNF receptor homolog osteoprotegerin(OPG) and its membrane-bound ligand osteoclast differentiation factor(ODF) were found to regulate osteoclast formation and function, and bone metabolism. It is now well established that ODF acts via RANK expressed on hematopoietic osteoclast precursor cells to facilitate their differentiation to osteoclasts, and OPG prevents the formation of osteoclasts by interfering the binding of ODF and RANK. Expression of OPG and ODF was believed to be closely related to the pathogenesis of bone resorption and destruction from osteoporosis, periodontal diseases, malignant bone tumor, and arthritis. The periodontal ligament fibroblasts (PDLF), located between the tooth and tooth socket, has been thought to play an important role in maintaining bone homeostasis of periodontal tissues. However, the exact mechanism by which bone formation and resorption are regulated by PDLF is not well understood. In this study we have prepared primary cultures of human PDLF from periodontium of malaligned tooth extracted due to orthodontic reason, and determined steady state or inflammatory signal-induced OPG and ODF expression using RT-PCR and western blot analysis. OPG and ODF mRNA and protein were expressed constitutively in the PDLF and these expression were slightly increased by osteotropic cytokine IL-1 ${\beta}$. Lipopolysaccharide-treated PDLF showed decrease in OPG mRNA and protein expression, and increase in ODF mRNA and protein expression. These results indicated that PDLF influence the osteoclastogenesis by OPG and ODF expression in the inflammatory situation as well as physiological condition, and thereby pathogenesis of periodontal alveolar bone destruction.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.3
• /
• pp.219-225
• /
• 2010

Optimal grinding condition was examined by changing only the size of screen opening with fixing other factors to produce coal fines of particle sizes required for circulating fluidized bed gasifier. At least 85 wt% of the coal particles should fall into the size range of 0.045~1.0 mm for efficient gasification. In this study, hammer mill was used to grind Chinese low rank lignite coal following grinding condition designed by Taguchi method. The analysis of signal to noise ratio showed that optimum grinding condition for the gasifier was 3 mm in primary screen size and 1.3 mm in secondary screen size on the 95% level of significance.

• Atmosphere
• /
• v.22 no.4
• /
• pp.415-427
• /
• 2012

$CO_2$ is the most important trace gas related to climate change. Therefore, understanding surface carbon sources and sinks is important when seeking to estimate the impact of $CO_2$ on the environment and climate. CarbonTracker, developed by NOAA, is an inverse modeling system that estimates surface carbon fluxes using an ensemble Kalman filter with atmospheric $CO_2$ measurements as a constraint. In this study, to investigate the capability of CarbonTracker as an analysis tool for estimating surface carbon fluxes in Asia, an experiment with a nesting domain centered in Asia is performed. In general, the results show that setting a nesting domain centered in Asia region enables detailed estimations of surface carbon fluxes in Asia. From a rank histogram, the prior ensemble spread verified at observational sites located in Asia is well represented with a relatively flat rank histogram. The posterior flux in the Eurasian Boreal and Eurasian Temperate regions is well analyzed with proper seasonal cycles and amplitudes. On the other hand, in tropical regions of Asia, the posterior flux does not differ greatly from the prior flux due to fewer $CO_2$ observations. The root mean square error of the model $CO_2$ calculated by the posterior flux is less than the model $CO_2$ calculated by the prior flux, implying that CarbonTracker based on the ensemble Kalman filter works appropriately for the Asia region.

• Journal of the Ergonomics Society of Korea
• /
• v.30 no.3
• /
• pp.409-418
• /
• 2011

Objective: This study was performed to evaluate the child-care teachers' job in relation to physical work. Background: Child-care teacher is directly related to the quality of child care. And their physical activity is higher than general education teachers because the proportion of day care is high. But analyzes of child-care teachers' job burdens and the work environment associated with physical activity is not well established. Method: To conduct this study, the child-care teachers' job was classified into 18 physical works. After classification, posture was evaluated by ergonomic posture evaluation schemes of OWAS, RULA, REBA and evaluated for each physical part. Next, musculoskeletal subjective symptoms were analyzed. Results: The results showed the following: The highest assessment on the posture evaluation was "helping children to ride a school bus", "feeding: meal/snack", "brushing children's teeth" and "arrangement of nap-stuff". The rank of high-risk assessment on the neck/trunk/leg part was arranged by: "feeding: meal/snack", "helping children to ride a school bus", "making nap", "arrangement nap-stuff" and "brushing children's teeth". The rank of high-risk assessment on the upper limbs part was arranged by: "helping children to ride a school bus", "the bust - group activity", "meal/snack time - preparing, feeding, arrangement", "nap time - preparing, arrangement", "brushing children's teeth", and "using the toilet". According to the results of each musculoskeletal subjective symptom, teachers ordered the pain area as follows: waist, shoulder, leg/feet, and neck, and they showed more pain on trunk than the upper limbs. Conclusion: To sum up the results from ergonomic posture evaluation and a subjective symptom, the following are high working pressures: "feeding: meal/snack", "the bust - group activity", "making nap", "brushing children's teeth" with deep bending and waist twisting, "helping children to ride a school bus", "brushing children's teeth" with lifting shoulder; "meal/snack time - preparing, arrangement", "nap time - preparing, arrangement", and "using the toilet" with moving or an up-down position in their job. Application: The results of this study might be information for improvement of the child-care teachers' job environment.

• Journal of Convergence for Information Technology
• /
• v.10 no.1
• /
• pp.195-202
• /
• 2020

This study is to investigate the effect of lower extremity strength exercise using biofeedback system on community-based elderly. Ten community-based elderly were exercised using the biofeedback system (with functional electrical stimulation) three times a week for six weeks. Data analysis was performed using Wilcoxon signed rank test. Physical function improved significantly, but there was no significant difference in muscle strength and muscle mass. Although elderly people were able to confirm that community-based ICT home biofeedback training could be possible and could lead to improvements in the lower extremity function, further research is needed to demonstrate a clearer effect by expanding the target population, distinguishing the sexes, and providing a personalized training method.

• The Journal of Advanced Prosthodontics
• /
• v.5 no.2
• /
• pp.179-186
• /
• 2013

PURPOSE. One of the most important factors in evaluating the quality of fixed dental prostheses (FDPs) is their gap. The purpose of this study was to compare the marginal and internal gap of two different metal-ceramic crowns, casting and selective laser sintering (SLS), before and after porcelain firing. Furthermore, this study evaluated whether metal-ceramic crowns made using the SLS have the same clinical acceptability as crowns made by the traditional casting. MATERIALS AND METHODS. The 10 study models were produced using stone. The 20 specimens were produced using the casting and the SLS methods; 10 samples were made in each group. After the core gap measurements, 10 metal-ceramic crowns in each group were finished using the conventional technique of firing porcelain. The gap of the metal-ceramic crowns was measured. The marginal and internal gaps were measured by two-dimensional and three-dimensional replica techniques, respectively. The Wilcoxon signed-rank test, the Wilcoxon rank-sum test and nonparametric ANCOVA were used for statistical analysis (${\alpha}$=.05). RESULTS. In both groups, the gap increased after completion of the metal-ceramic crown compared to the core. In all measured areas, the gap of the metal cores and metal-ceramic crowns produced by the SLS was greater than that of the metal cores and metal-ceramic crowns produced using the casting. Statistically significant differences were found between cast and SLS (metal cores and metal-ceramic crown). CONCLUSION. Although the gap of the FDPs produced by the SLS was greater than that of the FDPs produced by the conventional casting in all measured areas, none exceeded the clinically acceptable range.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.28 no.3
• /
• pp.273-282
• /
• 2018

Objectives: Dustiness of nanomaterials is considered as exposure index of essential material. Research on dustiness of nanomaterial is needed to control exposure in workplaces. Method: Dustiness measurement using vortex shaker were installed in the laboratory. Nanomaterials, 1 g, was put in the glass test tube and shaked using vortex shaker. Aerosol dispersed was measured using scanning mobility particle sizer(SMPS) and optical particle counter(OPC). Mass concentration using PVC filter and cassette was measured and TEM grid sampling was conducted. Total particle concentration and size distribution were calculated. Image and chemical composition of particles in the air were observed using transmission electron microscopy and energy dispersive X-ray spectrometer. Eleven different test nanomaterials were used in the study. Results: Rank of mass concentration and particle number concentration were coincided in most cases. Rank of nanomateirals with low concentration were not coincided. Two types of fumed silica had the highest mass concentration and particle number concentration. Indium tin oxide, a mixture of indium oxide and tin oxide, had high mass concentration and particle number concentration. Indium oxide had very low mass concentration and particle number concentration. Agglomeration of nanoparticles in the air were observed in TEM analysis and size distribution. In this study, mass concentration and particle number concentration were coincided and two index can be used together. The range of dustiness in particle number concentration were too wide to measure in one method. Conclusion: Particle number concentration ranged from low concentration to high concentration depend on type of nanomaterial, and varied by preparation and amount of nanomaterial used. Further study is needed to measure dustiness of all nanomaterial as one reference method.