• Journal of Soil and Groundwater Environment
• /
• v.21 no.3
• /
• pp.58-63
• /
• 2016

The study examined the level of heavy metal contamination by dividing military rifle shooting ranges into the three areas, i.e firing, trajectory, and target. The target area was found to be contaminated at a level higher (Cu 845 mg/kg, Pb 30,487 mg/kg) than the Worrisome Level of Soil Contamination (hereinafter referred to as the “Worrisome Level”) The trajectory area was predicted to be free from contamination, but it did indicate contamination although it was pretty much lower (Cu 23 mg/kg, Pb 99 mg/kg) than Worrisome Level. This is attributed to the contamination spread when rearranging the soil of the target area during the maintenance of the shooting range. The firing area was also predicted to be free from heavy metal contamination, but the results analyzed indicated a contamination higher (Cu 201 mg/kg, Pb 2,286 mg/kg) than Worrisome Level. This is attributed to the fragments of the broken bullet scattering due to the pressure generated as the bullet leaves the muzzle. An examination of heavy metal contamination in the discharge area as well as gutters to prevent the intrusion of rain water from perimeter revealed a high level of contamination (Cu 298 mg/kg, Pb 6,497 mg/kg), which makes it necessary to take measures.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.2
• /
• pp.73-79
• /
• 2011

This paper describes a reset-free delay-locked loop (DLL) for a memory controller application, with the aid of a hysteresis coarse lock detector. The coarse lock loop in the proposed DLL adjusts the delay between input and output clock within the pull-in range of the main loop phase detector. In addition, it monitors the main loop's lock status by dividing the input clock and counting its multiphase edges. Moreover, by using hysteresis, it controls the coarse lock range, thus reduces jitter. The proposed DLL neither suffers from harmonic lock and stuck problems nor needs an external reset or start-up signal. In a 0.13-${\mu}m$ CMOS process, post-layout simulation demonstrates that, even with a switching supply noise, the peak-to-peak jitter is less than 30 ps over the operating range of 500-1200 MHz. It occupies 0.04 $mm^2$ and dissipates 16.6 mW at 1.2 GHz.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.16 no.8
• /
• pp.2627-2647
• /
• 2022

The easy scalability and low cost of range-free localization algorithms have led to their wide attention and application in node localization of wireless sensor networks. However, the existing range-free localization algorithms still have problems, such as large cumulative errors and poor localization performance. To solve these problems, an incremental strategy-based residual regression network is proposed for node localization in wireless sensor networks. The algorithm predicts the coordinates of the nodes to be solved by building a deep learning model and fine-tunes the prediction results by regression based on the intersection of the communication range between the predicted and real coordinates and the loss function, which improves the localization performance of the algorithm. Moreover, a correction scheme is proposed to correct the augmented data in the incremental strategy, which reduces the cumulative error generated during the algorithm localization. The analysis through simulation experiments demonstrates that our proposed algorithm has strong robustness and has obvious advantages in localization performance compared with other algorithms.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.322-325
• /
• 1999

We report fiber guiding experiments on the Photonic Quantum Ring(PQR) laser diode. In the 1km transmission measurements, we find that the PQR performs much better than the VCSEL. This suggests that the PQR laser is very promising candidate for LAN-range optical data communications. On the other hand, we have also fabricated 8$\times$8 PQR laser arrays and measured spatial decays for free space properties without using any guiding optics, which showed about 1m distance of spectral angle sensing.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.05a
• /
• pp.429-434
• /
• 2002

The differential equations governing in-plane free vibrations of stepped circular arcs, including the effects of axial deformation, rotatory inertia and shear deformation, are derived and solved numerically to obtain frequencies and mode shapes. Numerical results are calculated for the clamped-clamped symmetric and unsymmetric circular arcs with thickness varying in a discontinuous fashion. The lowest four natural frequencies and mode shapes are presented over a range of non-dimensional system parameters: the subtended angle, the slenderness ratio, the section ratio and the ratio of discontinuous section.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.12a
• /
• pp.150-151
• /
• 2002

In recent years, semi-metallic Bismuth (Bi) has attracted significant attention due to very large magnetoresistance (MR) at room temperature originating from long carrier mean free path l and small effective carrier mass m＊[1, 2]. In particular, the MR behavior and long carrier mean free path l in Bi thin films can be exploited for spintronic devices, e.g. magnetic field sensors and spin-valve transistors. In present work, we present the magnetotransport properties of the electroplated and sputtered Bi thin films in the temperature range 4-300 K. (omitted)

• Bulletin of the Korean Mathematical Society
• /
• v.29 no.2
• /
• pp.265-275
• /
• 1992

The characteristic free representation theory of the general linear group has found a wide range of applications, ranging from the theory of free resolutions to the symmetric function theory. Representation theory is used to facilitate the calculation of explicit free resolutions of large classes of ideals (and modules). Recently, K. Akin and D. A. Buchsbaum [2] realized the Jacobi-Trudi identity for a Schur function as a resolution of GL$_{n}$-modules. Over a field of characteristic zero, it was observed by A. Lascoux [6]. T.Jozefiak and J.Weyman [5] used the Koszul complex to realize a formula of D.E. Littlewood as a resolution of schur modules. This leads us to further study resolutions of Schur modules of a particular form. In this article we will describe some new classes of finite free resolutions associated to the Pieri type skew Young diagrams. As a special case of these finite free resolutions we obtain the generalized Koszul complex constructed in [1]. In section 2 we review some of the basic difinitions and properties of Schur modules that we shall use. In section 3 we describe certain exact complexes associated to the Pieri type skew partitions. Throughout this article, unless otherwise specified, R is a commutative ring with an identity element and a mudule F is a finitely generated free R-module.e.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.6 no.2
• /
• pp.73-82
• /
• 2003

For measurements and analysis of dielectric characteristics of planar slabs of microwave absorbing materials, I have applied a free-space method in the frequency range of 8~14 GHz. The measurement system for free-space method consists of transmit and receive antennas, mode transitions, precision coaxal cables, the network analyzer, and a computer Special Spot-focused horn lens antenna was used to eliminate diffraction effects. Diffraction effects at the edges of the sample are minimized by satisfying the condition for minimum transverse dimension of the plate and the beamwidth of the antennas at the focus. The time-domain gating feature of the network analyzer and the thru, reflect, and line(TRL) calibration technique were used to eliminate the effects of undesirable multiple reflections. The complex coefficients of reflection and transmission, $S_{11}$ and $S_{21}$, of planar samples were measured for standard materials such as Teflon, Rexolite$\textregistered$ 2200. The results were compared with existing measurement method. And I applied a free-space method for measurement to measure dielectric constants of some electromagnetic absorbing materials. Dielectric properties for the same samples were also measured with a 7mm coxial transmission line method for purposes of comparison with the free-space method.

• Radiation Oncology Journal
• /
• v.32 no.3
• /
• pp.125-131
• /
• 2014

Purpose: We reviewed treatment outcomes and prognostic factors for patients with salivary ductal carcinoma (SDC) treated with surgery and postoperative radiotherapy from 2005 to 2012. Materials and Methods: A total of 16 patients were identified and 15 eligible patients were included in analysis. Median age was 61 years (range, 40 to 71 years) and 12 patients (80%) were men. Twelve patients (80%) had a tumor in the parotid gland, 9 (60%) had T3 or T4 disease, and 9 (60%) had positive nodal disease. All patients underwent surgery and postoperative radiotherapy. Postoperative radiotherapy was delivered using 3-dimensional conformal radiotherapy or intensity-modulated radiotherapy. Locoregional failure-free survival (LRFFS), distant failure-free survival (DFFS), progression-free survival (PFS), and overall survival (OS) were calculated using the Kaplan-Meier method. Differences in survival based on risk factors were tested using a log-rank test. Results: Median total radiotherapy dose was 60 Gy (range, 52.5 to 63.6 Gy). Four patients received concurrent weekly chemotherapy with cisplatin. Among 10 patients who underwent surgery with neck dissection, 7 received modified radical neck dissection. With a median follow-up time of 38 months (range, 24 to 105 months), 4-year rates were 86% for LRFFS, 51% for DFFS, 46% for PFS, and 93% for OS. Local failure was observed in 2 patients (13%), and distant failure was observed in 7 (47%). The lung was the most common involved site of distant metastasis. Conclusion: Surgery and postoperative radiotherapy in SDC patients resulted in good local control, but high distant metastasis remained a major challenge.

• Asian-Australasian Journal of Animal Sciences
• /
• v.33 no.10
• /
• pp.1610-1616
• /
• 2020

Objective: This study was to evaluate the effect of husbandry systems and strains on cecum microbial diversity of Jingyang chickens under the same dietary conditions. Methods: A total of 320 laying hens (body weight, 1.70±0.15 kg; 47 weeks old) were randomly allocated to one of the four treatments: i) Silver-feathered hens in enrichment cages (SEC) with an individual cage (70×60×75 cm), ii) Silver-feathered hens in free range (SFR) with the stocking density of 1.5 chickens per ten square meters, iii) Gold-feathered hens in enrichment cages (GEC), iv) Gold-feathered hens in free range (GFR). The experiment lasted 8 weeks and the cecum fecal samples were collected for 16S rDNA high throughput sequencing at the end of experiment. Results: i) The core microbiota was composed of Bacteroidetes (49% to 60%), Firmicutes (21% to 32%) and Proteobacteria (2% to 4%) at the phylum level. ii) The core bacteria were Bacteroides (26% to 31%), Rikenellaceae (9% to 16%), Parabacteroides (2% to 5%) and Lachnoclostridium (2% to 6%) at the genus level. iii) The indexes of operational taxonomic unit, Shannon, Simpson and observed species were all higher in SFR group than in SEC group while in GEC group than in GFR group, with SFR group showing the greatest diversity of cecum microorganisms among the four groups. iv) The clustering result was consistent with the strain classification, with a similar composition of cecum bacteria in the two strains of laying hens. Conclusion: The core microbiota were not altered by husbandry systems or strains. The free-range system increased the diversity of cecal microbes only for silver feathered hens. However, the cecum microbial composition was similar in two strain treatments under the same dietary conditions.