• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.7
• /
• pp.2231-2245
• /
• 2014

Cognitive Radio (CR) has very promising potential to improve spectrum utilization by allowing unlicensed Secondary Users (SUs) to access the spectrum dynamically without disturbing licensed Primary Users (PUs). Mitigating interference is a fundamental problem in CR scenarios. This is particularly problematic for deploying CR in cellular networks, when users are located at the cell edge, as the inter-cell interference mitigation and frequency reuse are critical requirements for both PUs and SUs. Further cellular networks require higher cell edge performance, then SUs will meet more challenges than PUs. To solve the performance decrease for SUs at the cell edge, a novel Dynamic Spectrum Allocation (DSA) scheme based on Game Theory is proposed in this paper. Full frequency reuse can be realized as well as inter-cell interference mitigated according to SUs' sensing, measurement and interaction in this scheme. A joint power/channel allocation algorithm is proposed to improve both cell-edge user experience and network performance through distributed pricing calculation and exchange based on game theory. Analytical proof is presented and simulation results show that the proposed scheme achieves high efficiency of spectrum usage and improvement of cell edge SUs' performance.

• Journal of Sensor Science and Technology
• /
• v.24 no.4
• /
• pp.219-223
• /
• 2015

Indium free consisting of three alternating layers GTO/Ag/GTO has been fabricated by radio-frequency (RF) sputtering for the applications as transparent conducting electrodes and the structural, electrical and optical properties of the gallium tin oxide (GTO) films were carefully studied. The gallium tin oxide thin films deposited at room temperature are found to have an amorphous structure. Hall Effect measurements show a strong influence on the conductivity type where it changed from n-type to p-type at $700^{\circ}C$. GTO/Ag/GTO multilayer structured electrode with a few nm of Ag layer embedded is fabricated and show the optical transmittance of 86.48% in the visible range (${\lambda}$ = 380~770 nm) and quite low electrical resistivity of ${\sim}10^{-5}{\Omega}cm$. The resultant power conversion efficiency of 2.60% of the multilayer based OPV (GAG) is lower than that of the reference commercial ITO. GTO/Ag/GTO multilayer is a promising transparent conducting electrode material due to its low resistivity, high transmittance, low temperature deposition and low cost components.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.480.1-480.1
• /
• 2014

In this study, we suggest the new emitter formation applied solid phase epitaxy (SPE) growth process using rapid thermal process (RTP). Preferentially, we describe the SPE growth of intrinsic a-Si thin film through RTP heat treatment by radio-frequency plasma-enhanced chemical vapor deposition (RF-PECVD). Phase transition of intrinsic a-Si thin films were taken place under $600^{\circ}C$ for 5 min annealing condition measured by spectroscopic ellipsometer (SE) applied to effective medium approximation (EMA). We confirmed the SPE growth using high resolution transmission electron microscope (HR-TEM) analysis. Similarly, phase transition of P doped a-Si thin films were arisen $700^{\circ}C$ for 1 min, however, crystallinity is lower than intrinsic a-Si thin films. It is referable to the interference of the dopant. Based on this, we fabricated 16.7% solar cell to apply emitter layer formed SPE growth of P doped a-Si thin films using RTP. We considered that is a relative short process time compare to make the phosphorus emitter such as diffusion using furnace. Also, it is causing process simplification that can be omitted phosphorus silicate glass (PSG) removal and edge isolation process.

• Journal of Construction Engineering and Project Management
• /
• v.2 no.4
• /
• pp.11-19
• /
• 2012

Construction supply chain management (CSCM) has become one of the critical factors that determine the success of a construction project as it becomes increasingly complicated and mega-sized. Particularly for high-rise or mega-sized building construction, just-in-time supply chain management is required due to lack of storage space and effective logistics for construction components and materials at a construction site. Despite the fact that research and development of radio frequency identification (RFID) and wireless sensor network (WSN) technology have been performed, construction project managers still need to carry mobile devices and check material and component flow at each stage of the supply chain process. This research proposes that the equipment used in the construction supply chain process, such as movers, trailers, gates, and hoists, can become main actors in the supply chain process using RFID and WSN technologies. And the proposed equipment and process focused on a solution to the redundancy identification problem, which has been observed in operations that use RFID/WSN-based processes for construction logistics. This paper also presents issues identified through verification and validation of the research results and proposes further studies.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.6
• /
• pp.816-824
• /
• 1999

Design and performance of 18 GHz phase locked dielectric resonator oscillator(PLDRO) for Point-to-point radio link using analog phase locked loop is described which achieve high stability and low SSB phase noise. The module consists of an 18 GHz voltage controlled dielectric resonator oscillator(VCDRO), buffered amplifier, analog phase detector which are integrated to form a miniature hybrid circuit. In addition, containing a low phase noise VHF PLL has been designed to lock any other conventional N times frequency of crystal oscillator. The module achieves stable phase locked state, exhibits output power of 21 dBm at 18.00 GHz, -34 dBc harmonic suppression and -75 dBc/Hz phase noise at 10 kHz offset frequency from carrier.

• ETRI Journal
• /
• v.33 no.3
• /
• pp.326-334
• /
• 2011

This paper outlines the time jitter effect of a sampling clock on a software-defined radio technology-based digital intermediate frequency (IF) transceiver for a mobile communication base station. The implemented digital IF transceiver is reconfigurable to high-speed data packet access (HSDPA) and three bandwidth profiles: 1.75 MHz, 3.5 MHz, and 7 MHz, each incorporating the IEEE 802.16d worldwide interoperability for microwave access (WiMAX) standard. This paper examines the relationship between the signal-to-noise ratio (SNR) characteristics of a digital IF transceiver with an under-sampling scheme and the sampling jitter effect on a multichannel orthogonal frequency-division multiplexing (OFDM) signal. The simulation and experimental results show that the SNR of the OFDM system with narrower band profiles is more susceptible to sampling clock jitter than systems with relatively wider band profiles. Further, for systems with a comparable bandwidth, HSDPA outperforms WiMAX, for example, a 5 dB error vector magnitude improvement at 15 picoseconds time jitter for a bandwidth of WiMAX 3.5 MHz profile.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.1
• /
• pp.81-85
• /
• 2009

We has been analysed optical properties of OLED(organic light emitting diode) and characteristics of ITO(Indium Tin Oxide) in terms of $O_2$ plasma treatment for manufacturing high efficiency OLED, RF power of $O_2$ plasma was changed 25, 50, 100, 200 W. $O_2$ gas flow, gas pressure and treatment time were fixed. Sheet resistance and surface roughness of ITO were measured by Hall-effect measurement system and AFM, respectively. The ranges of sheet resistance and surface roughness were $5.5{\sim}6,06\;{\Omega}$ and $2.438{\sim}3.506\;nm$ changing of RF power, respectively, PM(Passive Matrix)OLED was fabricated with the structure of ITO(plasm treatment)/TPD($400\;{\AA}$)/$Alq_3(600\;{\AA})$/LiF($5\;{\AA}$)/Al($1200\;{\AA}$). Turn-on voltage of PMOLED was 7 V and luminance was $7,371\;cd/m^2$ at the RF power of 25 W, $O_2$ plasma treatment of ITO surface was result in lowering the operating voltage and improving luminance of PMOLED.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.7
• /
• pp.1115-1121
• /
• 2001

In this paper, we analyzed the performance of GFSK system that presence fading effect in indoor radio communication environments and impulsive electromagnetic noise from electronic equipments then we applied the Truncated Type- II Hybrid ARQ scheme to make satisfied in data transmission service. As a result, the system was influenced by fading and impulsive electromagnetic noise. Especially, the system was much degraded by high occurrence frequency and amplitude of impulsive electromagnetic noise than fading which has direct frequency. By adopting the Truncated Type-II hybrid ARQ technique we can also obtained the performance improvement in the low signal power(20 dB) arid over 24 dB in strong impulsive electromagnetic noise environment which is occurred error floor and terribly influenced by the system.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.4
• /
• pp.577-585
• /
• 2010

The Military Tactical Communication technology for effective network-centric warfare is developing. Targeting broadband wireless transmission, core technology for connection, and Transmission technology that secure survivability under High-speed Movement environment. On the one hand, Tactical data communication system that reflects military characteristic is developing on the base of Legacy communication equipment which is used in the field. Because almost every military units in the field have used voice to communicate which lower efficiency of operation, they have made effort to Substitute voice communication which delays military Operation Tempo to digital communication. The Communications environment of troops in Forward edge of battle field area is very poor. Especially in terms of limited frequency allocation and bandwidth. Therefore, improving the efficiency of frequency is essential for Military Tactical Communication. This paper is about The Data Compression Method for increase of Efficiency in Tactical Data Communication over Legacy Radios which are UHF, VHF, HF Radio. I proposed and proved the most efficient Data Compression Method that reflects military characteristic, after analyzing the experimentation, which simulate CAS(Close Air Support mission) data transmission between Pilot and TACP.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.11
• /
• pp.932-938
• /
• 2007

The structural, optical, and electrical properties of ZnO thin films grown on glass by radio-frequency (rf) magnetron sputtering were investigated. The mixture flow ratio of $O_2$ to Ar, which was operated with sputtering gas, was chosen as a parameter for growing high-qualify ZnO thin films. The structural properties and surface morphologies of the thin films were characterized by the X-ray diffraction and the atomic force microscope, respectively. As for the optical properties of the films, the optical absorbance was measured in the wavelength range of 300-1100 nm by using UV-VIS spectrophotometer. The optical transmittance, absorption coefficient, and optical bandgap energy of ZnO thin films were calculated from the measured data. The crystallinity of the films was improved and the bandgap energy was increased from 3.08 eV to 3.23 eV as the oxygen flow ratio was increased from 0 % to 50 %. Furthermore, The ultraviolet and violet luminescences were observed by using photoluminescence spectroscopy. The hall mobility was decreased with the increase of oxygen flow ratio.